Performance Analysis of LDPC Code with Spatial Diversity

In previous works, density evolution schemes have been used to design an irregular low-density parity-check (LDPC) code for the multi-input multi-output (MIMO) systems. However the code design based on the density evolution can be used only for simple code structure like LDPC codes and repeat-accumulate (RA) codes. Recently simple and accurate irregular LDPC code design method based on the extrinsic information transfer (EXIT) chart was introduced for an AWGN channel. This code design scheme is much flexible, therefore it can be used for any kind of code structure like turbo codes. In this paper we design an irregular LDPC code for a MIMO system using the EXIT chart based scheme. The EXIT charts are used to obtain the optimal edge degree distribution of the irregular LDPC code combined with the MMSE-SIC MIMO detector. This scheme can be generalized for designing the optimal iterative MIMO detector combined with any kind of channel codes including turbo codes.

Low Density Parity Check (LDPC) codes have capacity-approaching performance over several channels of interest. In practice, for good block-error rate performance, the girth of the Tanner graph of an LDPC code needs to be as high as possible. In theory, to show that block-error rate approaches zero for increasing block-lengths, the girth of the Tanner graph sequence needs to tend to infinity with block-length. To meet these requirements, we construct sequences of large-girth irregular LDPC codes for a given degree-distribution pair (DDP) by applying a general node splitting algorithm on large girth graphs. The obtained Tanner graph meets the required DDP up to a suitable approximation. By optimizing the node-splitting method and using suitable large-girth graphs, we show code constructions with smaller block length for the same girth, when compared to previous constructions. Similar gains in block length are observed in the construction of sequences of large-girth protograph LDPC codes. Simulations, over a binary erasure channel, confirm the gains in block-error rate obtained by the large girth construction.

This letter gives a random construction for Low Density Parity Check (LDPC) codes, which uses an iterative algorithm to avoid short cycles in the Tanner graph. The construction method has great flexible choice in LDPC code’s parameters including codelength, code rate, the least girth of the graph, the weight of column and row in the parity check matrix. The method can be applied to the irregular LDPC codes and strict regular LDPC codes. Systemic codes have many applications in digital communication, so this letter proposes a construction of the generator matrix of systemic LDPC codes from the parity check matrix. Simulations show that the method performs well with iterative decoding.

In this letter, we obtain lower and upper bounds on the minimum distance $d_{\min }$ of low-density parity-check (LDPC) codes. The bounds are derived by categorizing the non-zero code words of an LDPC code into two categories of elementary and non-elementary. The first category contains code words whose induced subgraph has only degree-2 check nodes. We propose an efficient search algorithm that can find the elementary code words of an LDPC code with weight less than a certain value $a_{\max }$ , exhaustively. We also derive a lower bound $L_{ne}$ on the weight of non-elementary code words. By performing the search with $a_{\max } = L_{ne}$ , we either obtain an elementary code word with the smallest weight $d_{\min }$ , or establish the lower bound of $L_{ne}$ on $d_{\min }$ . For the upper bound, we modify our search algorithm to reach elementary codewords of larger weights at the cost of being non-exhaustive. Once such a codeword is found, its weight acts as an upper bound on $d_{\min }$ . We examine a large number of regular and irregular LDPC codes, and demonstrate the efficiency and versatility of our technique in finding lower and upper bounds on, and in many cases the exact value of, $d_{\min }$ . Finding $d_{\min }$ , or establishing search-based lower or upper bounds, for many of the examined codes are out of the reach of any existing algorithm.

Low-density parity-check (LDPC) codes have been widely considered as error-correcting codes for next generation communication systems. A good LDPC decoder design requires both implementation friendly LDPC codes and efficient decoder architectures. The quality of LDPC code is crucial in determining the coding gain and implementation complexity of LDPC hardware decoders. This paper presented a genetic algorithm (GA) based LDPC code search algorithm with hardware considerations. Regular quasi-cyclic LDPC codes are used due to its friendliness to hardware implementation. Our hardware architecture design schedules pipeline LDPC decoding operation to boost the hardware utilization efficiency (HUE) of LDPC decoder. A LDPC decoder with a block size of 12288 is implemented in FPGA to validate our code and architecture design.

In this paper, we propose a concatenated code by combining a Recursive Systematic Convolutional (RSC) code with a Low-Density Parity-Check (LDPC) code. The proposed concatenated code is encoded in parallel by an RSC encoder and an LDPC encoder without interleavers between them. When decoding the proposed concatenated code, the information bits are decoded by two decoding algorithms, and soft information is exchanged between the RSC decoder and the LDPC decoder. This allows for the elimination of wrong codewords output by each decoder. The use of an LDPC code allows us to halt the decoding process when the valid codeword is obtained. We evaluate the error rate performance of the proposed concatenated code by computer simulations. We show that the proposed concatenated code does not have a high error floor, and achieves better BLock Error Rate (BLER) performance than either conventional LDPC codes or conventional turbo codes in the high Eb/No region. We also show that since the proposed concatenated code can correct wrong codewords output by each decoder, it achieves better BLER than the regular LDPC code at the same Bit Error Rate (BER).

Harvesting energy from radio frequency signals along with transmitting data through them is appealing for different wireless communication scenarios, such as radio frequency identification (RFID) systems and implantable devices. In this paper, we propose a technique to design nonlinear codes for the use in such systems taking into account both energy transmission and error rate requirements. In particular, we propose using concatenation of a nonlinear trellis code (NLTC) with an outer low-density parity-check (LDPC) code. We design the NLTC based on maximization of its free distance. We give necessary and sufficient conditions for its catastrophicity; in order to avoid catastrophic codes, we connect each designed NLTC to a corresponding linear convolutional code allowing for the use of simpler conditions for verification. Furthermore, we use EXIT charts to design the outer LDPC code while fixing the inner NLTC. Via examples, we demonstrate that our designed codes operate at ∼ 0.8 dB away from the information theoretic limits, and they outperform both regular LDPC codes and optimized irregular LDPC codes for additive white Gaussian noise (AWGN) channels. In addition, we show that the proposed scheme outperforms the reference schemes of concatenating LDPC codes with nonlinear memoryless mappers and using classical linear block codes in a time switching mode. © 2016 IEEE.

Recently, multicarrier modulation in the form of orthogonal frequency division multiplexing (OFDM) has been shown feasible for underwater acoustic communications via effective algorithms to handle the channel time-variability. In this paper, we propose to use nonbinary low density parity check (LDPC) codes to address two other main issues in OFDM: (i) plain (or uncoded) OFDM has poor performance in fading channels, and (ii) OFDM transmission has high peak to average power ratio (PAPR). We develop new methods to construct nonbinary regular and irregular LDPC codes that achieve excellent performance, match well with the underlying modulation, and can be encoded in linear time and in a parallel fashion. Based on the fact that the generator matrix of LDPC codes has high density, we further show how to reduce the PAPR considerably with minimal overhead. Experimental results confirm the excellent performance of the proposed nonbinary LDPC codes in multicarrier underwater acoustic communications.

This paper is concerned with density evolution for iterative decoding of low-density parity-check (LDPC) codes. We first study the problem of density evolution computation for regular LDPC codes. For this, we propose a simple computational algorithm based on the ergodicity theory. This method is shown to match very well with explicit calculations of density functions. The second problem we study is about the approach of Gaussian approximation to density evolution. We point out that it is inappropriate to use the mean of the density only to model the iterative decoding process. Instead, both the mean and variance are needed for Gaussian approximation. Finally, we consider the problem of density evolution for irregular LDPC codes. For this, we extend the density evolution algorithm for regular LDPC codes to irregular LDPC codes. We then illustrate that Gaussian approximation is also valid provided that the degree distributions are not wide. A dynamic model is also presented based on Gaussian approximation.

In this paper, in order to improve bit error performance, bandwidth efficiency and reduction of complexity compared to related schemes such as turbo codes, we combine low density parity check (LDPC) codes and continuous phase frequency shift keying (CPFSK) modulation and introduce a new scheme, called ‘low density parity check coded‐continuous phase frequency shift keying (LDPCC‐CPFSK)’. Since LDPC codes have very large Euclidean distance and use iterative decoding algorithms, they have high error correcting capacity and have very close performances to Shannon limit. In all communication systems, phase discontinuities of modulated signals result extra bandwidth requirements. Continuous phase modulation (CPM) is a powerful solution for this problem. Beside CPM provides good bandwidth efficiency; it also improves bit error performance with its memory unit. In our proposed scheme, LDPC and CPFSK, which is a special type of CPM, are considered together to improve both error performance and bandwidth efficiencies. We also obtain error performance curves of LDPCC‐CPFSK via computer simulations for both regular and irregular LDPC code. Simulation results are drawn for 4‐ary CPFSK, 8‐ary CPFSK and 16‐ary CPFSK over AWGN, Rician and Rayleigh fading channels for maximum 100 iterations, while the frame size is chosen as 504. Copyright © 2006 John Wiley & Sons, Ltd.

Turbo codes are attractive compared with Low Density Parity Check (LDPC) codes for Forward Error Correction (FEC) applications mainly due to their superior performance, especially at low Signal-to-Noise Ratio (SNR) such as are common in Powerline channels. For example, IEEE 1901-FFT PHY used the Turbo coding scheme defined in the HomePlug AV standards. However, patent fees are usually required for each turbo-code enabled manufactured device. The objective of this paper is to examine whether unlicensed LDPC codes, with optimized choices of block lengths, could be a viable alternative for future Powerline Communications (PLC) applications. The paper shows that the performance of the LDPC codes can approximate that of the Turbo codes with higher block lengths, on channels with typical and realistic PLC characteristics. The paper also shows that the additional complexity associated with this increase in block length can be mitigated by the use of Quasi-Cyclic LDPC (QC-LDPC) codes.

Big data storage demands larger cluster. The increasing size of the cluster may lead to failures of larger number of nodes. To provide reliable big data storage, replications are not cost-effective and does not provide a robust solution to prevent data loss. Traditional erasure codes applied in the RAID system such as Reed-Solomon (R-S) based solutions have limitations in providing high reliability. This is because higher reliability requires erasure codes with larger size. The computational cost of the R-S codes increase quadratically with the number of failures the R-S codes can tolerate for the same redundancy rate. It has been shown that Low Density Parity Check (LDPC) codes have lower computational cost and repair network traffic compared with R-S based solutions. Unfortunately, there does not exist a construction method for LDPC codes with larger size to control the computational cost and repair traffic. In this paper, a novel method is proposed to construct a family of LDPC codes - expanCodes with expandable sizes. The proposed expanCodes allows the encoding and decoding complexity remain unchanged with the increase of the size of the LDPC codes. As a result, increased reliability can be achieved without additional computation and repair traffic. The proposed expanCodes is integrated with the Hadoop system. Simulations show that more than 29% decrease in terms of encoding and decoding latency compared with R-S based solutions.

DOI: 10.1049/cp:20061337 ISBN: 0 86341 644 6 Location: Hangzhou, China Conference date: 6-9 Nov. 2006 Format: PDF The BER performance of presented quasi-cyclic (QC) low-density parity-check (LDPC) codes is not good as that of randomly constructed LDPC codes, while the lack of structure of randomly constructed LDPC codes implies serious disadvantages in terms of storing and accessing a large parity-check matrix. To solve the problems, this paper proposes a design of good quasi-cyclic (QC) low-density parity-check (LDPC) codes, the obtained algebraically structured codes have large minimum distances and good BER performance. The proposed design is based on index matrices, which determines the shifts of the circulant matrices of the sparse parity-check matrices. Compared with the presented design of QC LDPC codes, the designed QC LDPC codes are free from girth 4, sometimes free from girth 6, and have much larger minimum distances. Based on the algebraic code structure, the conditions of the girth and minimum distance of the codes are found. The BER performance of the designed QC LDPC block codes compares with that of randomly constructed LDPC codes for any block lengths. Better BER performance is obtained by increasing the circulant size of the base QC code. Simulations verify the construction of the QC LDPC codes to be valid. (4 pages) Inspec keywords: AWGN channels; error statistics; channel coding; algebraic codes; parity check codes; sparse matrices Subjects: Algebra; Other topics in statistics; Codes

In order to solve high encoding complexities of irregular low-density parity-check (LDPC) codes, a deterministic construction of irregular LDPC codes with low encoding complexities was proposed. And the encoding algorithms were designed, whose complexities are linear equations of code length. The construction and encoding algorithms were derived from the effectively encoding characteristics of repeat-accumulate (RA) codes and masking technique. Firstly, the new construction modified parity-check matrices of RA codes to eliminate error floors of RA codes. Secondly, the new constructed parity-check matrices were based on Vandermonde matrices, this deterministic algebraic structure was easy for hardware implementation. Theoretic analysis and experimental results show that, at a bit-error rate of 10×10−4, the new codes with lower encoding complexities outperform Mackay’s random LDPC codes by 0.4–0.6 dB over an additive white Gauss noise (AWGN) channel.

This paper extends the work on density evolution for binary low-density parity-check (LDPC) codes with Gaussian approximation to LDPC codes over GF(q) . We first generalize the definition of channel symmetry for nonbinary inputs to include q-ary phase-shift keying (PSK) modulated channels for prime q and binary-modulated channels for q that is a power of 2. For the well-defined q-ary-input symmetric-output channel, we prove that under the Gaussian assumption, the density distribution for messages undergoing decoding is fully characterized by (q-1) quantities. Assuming uniform edge weights, we further show that the density of messages computed by the check node decoder (CND) is fully defined by a single number. We then present the approximate density evolution for regular and irregular LDPC codes, and show that the (q-1) -dimensional integration involved can be simplified using a dimensionality reduction algorithm for the important case of q=2p. Through application of approximate density evolution and linear programming, we optimize the degree distribution of LDPC codes over GF(3) and GF(4). The optimized irregular LDPC codes demonstrate performance close to the Shannon capacity for long codewords. We also design GF(q) codes for high-order modulation by using the idea of a channel adapter. We find that codes designed in this fashion outperform those optimized specifically for the binary additive white Gaussian noise (AWGN) channel for a short codewords and a spectral efficiency of 2 bits per channel use (b/cu).