Performance and Power Consumption Analysis of a Hybrid Optical Core Node

Optical Circuit Switching (OCS) provides a good support for the services requiring high bandwidth and Quality of Service (QoS). When the character of network traffic changes from voice-oriented to data-oriented, OCS must cooperate with new switching mechanisms such as Optical Burst Switching (OBS) to improve performance. So a Hybrid Optical Switching (HOS) system is proposed. In HOS, different traffics are classified and both OBS and OCS can be processed. At the same time, delay buffer mechanisms, which are Fiber Delay Line (FDL) and electronic buffering, are introduced in HOS to solve the contention of OBS bursts. And a wavelengths classification mechanism, which assigns some wavelengths dedicated to OCS traffics, is provided to guarantee the QoS of OCS. To analyze the performance in theory, models based on Markovian theory and iterative method are provided. The results got by theory are accurate compared with simulations. The use of delay buffer can decrease the blocking probability of OBS and increase resource utilization. Wavelength classification mechanism benefits to improve OCS's performance.

The service evolution and the rapid increase in traffic levels fuel the interest toward switching paradigms enabling the fast allocation of Wavelength Division Multiplexing WDM channels in an on demand fashion with fine granularities (microsecond scales). For this reason, in the last years, different optical switching paradigms have been proposed (Sabella et al., 2000): optical-packet switching (OPS), optical-burst switching (OBS), wavelength-routed OBS, etc. Among the various all-optical switching paradigms, OPS attracts increasing attention. Owing to the high switching rate, Semiconductor Optical Amplifier (SOA) is a key technology to realize Optical Packet Switches. We propose some Optical Packet Switch (OPS) architectures and illustrate their realization in SOA technology. The effectiveness of the technology in reducing the power consumption is also analyzed. The chapter is organized in three sections. The main blocks (Switching Fabric, Wavelength Conversion stage, Synchronization stage) of an OPS are illustrated in Section 2 where we also show some examples of realizing wavelength converters and synchronizers in SOA technology. Section 3 introduces SOA-based single-stage and multi-stage switching fabrics. Finally the SOA-based OPS power consumption is investigated in Section 4.

In optical switching paradigm, there are three approaches; optical circuit switching, optical packet switching, and optical burst switching (OBS). OBS is a technology that takes the best features of packet switching and circuit switching by providing a flexible infrastructure for carrying IP traffic and at the same time ensuring efficient utilization of the fiber link. In this paper we propose an effective contention resolution scheme to achieve minimum burst loss at core nodes. Algorithm of zero burst loss for bimodal burst switching is extended from single node star network topology to two node star topology. Scheduling at the core node, typically an optical cross connect (OXC), is performed in two modes i.e., Mode 0 & Mode 1. Mode 0 is for burst transmission between all directly connected edge nodes whereas Mode 1 is for burst transmission through remote core node to a particular destination edge node. Synchronization of the reservation request between the core nodes is a critical task in such a topology. In order to achieve minimum burst loss, using a small length of fiber delay line in recirculation mode results in an effective strategy.

Optical burst switching (OBS) is a switching technology that can efficiently operate in the optical core network using WDM technology and can also develop the future optical internet. The OBS switching technology presents a trade-off between the two switching technologies: optical circuit switching (OCS) and optical packet switching (OPS). This switching approach increases resource utilization compared with OCS technology and avoids the technological barriers of OPS networks. In OBS networks, many packets are assembled into one data burst at the edge node and a burst header packet (BHP) is sent before the burst transmission by an offset time in order to reserve the required resources in core nodes. This can cause security issues in the network and more specifically denial of service attacks that can occur if a source node is compromised. In this paper, we study a specific denial of service attack which we refer to as "BHP flooding attack", which prevents legitimate traffics from reserving the required resources at intermediate core nodes. We also propose the design of a reconfigurable BHP flooding countermeasure module that allows to counter against this type of attacks in an OBS network.

We propose implementation methods to realize an optical hybrid switching combining OCS(Optical Circuit Switching)/OBS(Optical Burst Switching) and indicate the necessity of testbed. Then we discuss how to use optical hybrid switching for various applications.

Parallel Optical Burst Switching (POBS) is a variant of Optical Burst Switching (OBS) which is proposed as a new optical switching strategy for Ultra-Dense Wavelength Division Multiplexing (U-DWDM) to support the enormous bandwidth demand of the next generation Internet. As opposed to OBS, POBS transmits bursts in two dimensions: the wavelength dimension and the time dimension. POBS network uses an one-way resource reservation mechanism to set up the resources for each data burst transmission. The use of this mechanism may cause bursts to contend for the same resources at the same time at core (intermediate) nodes of the network. Therefore, the performance of POBS networks depends on the contention resolution policies to reach acceptable levels for bandwidth usage. These policies may increase both the cost and complexities of the core nodes in POBS networks. Most literatures on OBS networks apply contention resolution at the core nodes based on reactive strategies that are activated after contention takes place in core nodes. This study proposes the use of a proactive contention resolution technique at ingress nodes of POBS network as well as reactive contention resolution technique at core nodes for reducing the probability of burst drop in the network in order to increase the performance of the network. The simulation results show that the use of POBS network with the proposed Reactive Odd/Even Node ID Wavelength Assignment Technique (POBS-ROENIDWAT) shows a better performance in terms of reduced data loss rate and increased throughput compared to the performances of both POBS network with Sequential Wavelength Assignment Technique (POBS-SWAT) and OBS network with Burst Segmentation (OBS-BS).

Optical burst switching (OBS) is a new optical switching paradigm where traffic can be switched and groomed at a lower level compared to optical switched circuit (OCS). While OCS is useful in carrying highly aggregated long-lived streams that require absolute quality of service (QoS) guarantees, OBS has a role in efficiently carrying bursty best-effort traffic. In this paper, we investigate further the comparative goodput and bandwidth efficiency of OBS and OCS using, on one hand, an adaptive deflection OBS routing that aims at minimizing the burst loss rate and, on the other hand, a routing and wavelength OCS strategy using the best possible routing paths for minimizing the blocking rate.

We develop an integrated optical packet and circuit switching node in which signaling via optical packet switching is implemented. We demonstrate 80 (8λ × 10) Gbit/s optical packet switching with <;1E-4 packet-loss-rate, 8-lightpaths establishment, and dynamic wavelength-resources control.

In this paper a novel control plane for hybrid opticalswitching (HOS) networks is proposed. The control plane employsgeneralized multiprotocol label switching (GMPLS) for configuringthe virtual topology, and for establishing and tearing downthe label switched paths. The management of the different trafficgranularities, including resource reservation and data scheduling,is yielded by the HOS control layer. Furthermore, the architectureof a node that can be managed by the proposed control plane isintroduced, and a model for its power consumption evaluation ispresented. The power consumption of the considered architectureis then compared with the power consumption of a current IPelectronic router. Performance and power consumption of theproposed HOS network are evaluated through the use of anevent-driven simulator.

We compare three optical transport network architectures—optical packet switching (OPS), optical flow switching (OFS), and optical burst switching (OBS)—based on a notion of network capacity as the set of exogenous traffic rates that can be stably supported by a network under its operational constraints. We characterize the capacity regions of the transport architectures, and show that the capacity region of OPS dominates that of OFS, and that the capacity region of OFS dominates that of OBS. We then apply these results to two important network topologies—bidirectional rings and Moore graphs—under uniform all-to-all traffic. Motivated by the incommensurate complexity/cost of comparable transport architectures, we also investigate the dependence of the relative capacity performance of the switching architectures on the number of switch ports per fiber at core nodes.

Next-generation high-speed Internet backbone networks will be required to support a broad range of emerging applications which may not only require significant bandwidth, but may also have strict quality of service (QoS) requirements. Furthermore, the traffic from such applications are expected to be highly bursty in nature. For such traffic, the allocation of static fixed-bandwidth circuits may lead to the over-provisioning of bandwidth resources in order to meet QoS requirements. Optical burst switching (OBS) is a promising new technique which attempts to address the problem of efficiently allocating resources for bursty traffic. In OBS, incoming data is assembled into bursts at the edges of the network, and when the burst is ready to be sent, resources in the network are reserved only for the duration of the burst. The reservation of resources is typically made by an out-of-band one-way control message which precedes the burst by some offset time. By reserving resources only for the duration of the burst, a greater degree of utilization may be achieved in the network. This book provides an overview of optical burst switching. Design and research issues involved in the development of OBS networks are discussed, and approaches to providing QoS in OBS networks are presented. Topics include: - Optical burst switching node and network architectures - Burst assembly - Signaling protocols - Contention resolution - Burst scheduling - Quality of service in OBS networks

Statistical multiplexing at the optical layer has been considered a critical requirement in order to build the next generation of ultra-high capacity optical transport networks in a cost-efficient manner. However, even today, the state of the art of commercially available optical core networks is based on mature wavelength switching and routing technologies, which lack a transport and control plane architecture that can support statistical traffic multiplexing with guaranteed Quality of Service (QoS) across a wide range of QoS parameters even if they can support fast reconfiguration at msec time scales. For several years, most research efforts have focused on the concepts of Optical Burst Switching (OBS) and Optical Packet Switching (OPS), which are based on the hybrid use of electronic nodes and optical switches to exploit Time Division Multiplexing (TDM) in order to achieve statistical multiplexing and dynamic resource reservation over optical networks. While burst switching has been experimentally proven as a technically feasible technique, its performance suffers especially under strict requirements for QoS guarantees. In this paper we evaluate the performance gains that can be achieved exploiting statistical multiplexing over a large scale core optical network and we demonstrate the efficiency of the CANON architecture (Clustered Architecture for Nodes in an Optical Network) as a viable alternative to OBS, which can achieve both targets for statistical multiplexing gains and QoS guarantees at the same time.

The present work analyzes the performance of photonic switching networks, optical packet switching (OPS) and optical burst switching (OBS), in mesh topology of different sizes and configurations. The “lossless” photonic switching node is based on a semiconductor optical amplifier, demonstrated and validated with experimental results on optical power gain, noise figure, and spectral range. The network performance was evaluated through computer simulations based on parameters such as average number of hops, optical packet loss fraction, and optical transport delay (Am). The combination of these elements leads to a consistent account of performance, in terms of network traffic and packet delivery for OPS and OBS metropolitan networks. Results show that a combination of highly connected mesh topologies having an ingress e-buffer present high efficiency and throughput, with very low packet loss and low latency, ensuring fast data delivery to the final receiver.

On burst assembly in optical burst switching networks—A performance evaluation of just-enough-time

In this paper the end-to-end TCP performance of a hybrid network composed of multiple Ethernet Passive Optical Networks (EPONs) in the access segment connected to the same edge node of a core network is evaluated. Three possible core network paradigms are considered: Optical Circuit Switching (OCS), Optical Burst Switching (OBS) and Optical Packet Switching (OPS). TCP performance is evaluated through simulations with ns-2. The hybrid network scalability is assessed by varying the number of EPONs connected to the same edge node and the number of Optical Network Units (ONUs) per EPON. Interoperability issues between access and core are investigated and the impact of the most important network parameters is highlighted. The three transfer modes considered for the core network are properly compared under different input conditions, discussing the related trade-offs that may lead to the most suitable choice based on the specific application scenario. Finally, some design issues are investigated with reference to emerging Long-Range EPON (LR-EPON) solutions.