Performance enhanced DDO-OFDM system with adaptively partitioned precoding and single sideband modulation.

A data clipping and normalization technique is employed to improve the performance of the overall direct detection optical orthogonal frequency division multiplexing (DCO-OFDM) system. A detailed analysis of clipping distortion introduced by digital clipping and normalization is provided. The normalization operation amplifies the clipped data signal to the maximum input amplitude of a digital-to-analog converter (DAC). Based on the analysis, a BER formula of the proposed scheme is derived over the AWGN channel and single fiber channel. Performance of an optical clipped OFDM with normalization is assessed through numerical simulations and Monte Claro simulation over the AWGN channel. Theoretical analysis and simulation results both show that the clipping and normalization scheme can greatly improve the BER of an optical OFDM. In particular, BER performance of the proposed transmission scheme was measured in a practical OFDM transmission platform. The measured experimental results show that the clipped and amplified OFDM signal exhibits superior performance in comparison with the conventional OFDM signal. The received sensitivity at a BER of 10−3 for a 4 Gsamples/s (2.6667 Gbits/s) clipped and normalized OFDM signal with clipping ratio of 4 after 100 km standard single-mode fiber (SMF) transmission was improved by 4.3 dB when compared with the conventional OFDM system. The measured results also showed that the clipped OFDM signal exhibits superior performance in comparison with the conventional OFDM signal. Therefore, a clipping and normalization at the transmitter is most effective, and a substantial performance improvement can be obtained by a simple normalization after clipping.

An optical single sideband modulator without generating both the −2nd- and +2nd-order sidebands is presented. It is based on a parallel operation of two dual-drive Mach–Zehnder modulators (DDMZMs) where one is operated as a conventional single sideband (SSB) modulator and the other is operated as a single-drive Mach–Zehnder modulator (MZM) biased at the maximum transmission point. The 2nd-order sidebands generated by the SSB modulator and the maximum-biased MZM can be cancelled by controlling the sideband amplitude and phase. Canceling the 2nd-order sidebands eliminates the second-order harmonic component presented at the output of a long-reach fiber optic link. The new SSB modulator can be implemented using standard off-the-shelf components and has a wide bandwidth. Experimental results show >20 dB 2nd-order sidebands suppression for different modulation indexes and 22.6 dB reduction in the fiber optic link output second-order harmonic component, compared to using a conventional SSB modulator formed by a DDMZM and a 90° hybrid coupler. Results also demonstrate that the performance of the new SSB modulator is insensitive to the optical carrier frequency and the input RF signal frequency.

In this paper, we propose a new peak-to-average power ratio reduction technique based on a constant envelope orthogonal frequency division multiplexing (CE-OFDM) approach to mitigate fiber induced nonlinearities in direct-detection optical OFDM (DDO-OFDM) systems. Simulation results show that the proposed 10 Gbps DDO-CE-OFDM system using 16-quadrature amplitude modulation (16-QAM), 2.66 GHz signal bandwidth, and different values of electrical phase modulation index outperforms DDO-OFDM systems as it increases the fiber nonlinearity tolerance in fiber links without optical dispersion compensation. The bit error rate of the proposed transmission scheme is decreased by a factor of 1000 if compared to conventional DDO-OFDM systems, for 10 dBm of optical input power and considering a span of 960 km of standard single-mode fiber.

We propose an optical signal-to-noise ratio (OSNR) estimation method for direct-detection optical orthogonal frequency division multiplexing (DDO-OFDM) systems by calculating the electrical SNR of one pilot subcarrier based on correlation. Simulation and experiment are conducted to verify this OSNR estimation method in a 15-Gb/s DDO-OFDM system. The maximum OSNR estimation error is 0.8 dB within an OSNR range of 8-28 dB for 100- and 200-km transmission distances.

In this paper, we investigate the optical power fluctuation of the output in optical comb generator using an optical single sideband (SSB) modulator with a fiber loop. This fluctuation is caused by undesired sidebands of the SSB modulator. We show that the fluctuation can be suppressed by stabilizing the fiber loop length. In experiment, the averaged peak-to-peak power fluctuation of 23 comb outputs was suppressed from 0.86 dB to 0.13 dB.

Real-valued neural network nonlinear equalization for complex-valued signals combined with single sideband (SSB) modulation is proposed to be a promising scheme for long-reach passive optical networks (LR-PONs). With the assist of neural network equalizer (NNE), fiber nonlinearity induced by large launch power can be mitigated. We experimentally demonstrate a transmission of 120 Gbps 16-QAM SSB signal in C-band over an 80-km single mode fiber (SMF) without optical inline amplifier and pre-amplifier.

The branch-line coupler (BC) circuit of miniaturized configuration using periodically installed open circuit stabs was designed onto an electro-optic (EO) crystal, LiNbO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> , substrate at 10 GHz. The operation as the 90 degree hybrid was confirmed at around the center frequency by the experiment. By using this BC circuit as the signal power divider, we proposed a compact EO single sideband (SSB) modulator. The SSB modulator was designated and fabricated for 1550 nm light wavelength. In the experiment, the optical SSB signal with the sideband suppression ratio of about 30 dB was observed.

Carrier generation and IF signal up-conversion using optical injection locking and stimulated Brillouin scattering

High speed transmission systems (> 10 Gb/s) for cost-sensitive applications such as metropolitan network have attracted extensive interest due to the explosive data traffic growth in such applications. Optical orthogonal frequency division multiplexing (OFDM) based on direct modulation and direct detection for single-mode fiber (SMF) and multi-mode fiber (MMF) without optical amplification and chromatic dispersion (CD) compensation was proposed. Recent research has also shown that optical OFDM can be used with electronic dispersion compensation using direct detection in SMF. However, laser frequency chirp has been identified as a key limiting factor of capacity-versus-reach performance. In this paper, we present a novel concept of low cost optical OFDM with direct modulation of distributed feedback (DFB) lasers and coherent detection at 51.4 Gb/s and 64 QAM. A comprehensive theoretical model of the proposed system is developed. The proposed optical OFDM system concept and performance is based upon using electronic precompensation of laser frequency response, and electronic post compensation of DFB laser frequency chirp and CD. A numerical simulation of the transmission performance of the aforementioned system is conducted using different fiber lengths (40 km, 60 km, 120 km) and chirp parameters, which shows its attractiveness for access and metro applications.

We propose a scheme for a direct-detection optical orthogonal frequency-division multiplexing (OFDM) system based on blockwise signal-phase-switching (SPS). Experimental demonstration of 61 Gbits/s SPS direct-detection optical OFDM signal transmission over 80 km standard single-mode-fiber was successfully achieved with single polarization and a single photodetector.

Nonlinear effect mitigation based on PAPR reduction using electronic pre-distortion technique in direct-detection optical OFDM system

Symbol synchronization and sampling frequency synchronization techniques in real-time DDO-OFDM systems

Gain switching for the optical generation of modulated millimetre waves

Two setups for the optical generation of broadband microwave signals are using double sideband (DSB) and single sideband (SSB) modulation. While DSB is easy to generate, the dispersion tolerance is severely limited. The penalties due to chromatic dispersion in both systems are tested for 10 Gbps data signals.

Using a hyperfine blocking filter based on a virtually imaged phased-array as the spectral disperser, we present a novel scheme of optical carrier-suppressed single sideband (SSB) modulation. Our experiments demonstrate sideband suppression of /spl sim/28 dB at only a 2.9-GHz offset for single subcarrier amplitude modulated at 622 Mb/s. Furthermore, the hyperfine blocking filter can be tuned for simultaneous optical SSB and strong carrier suppression to /spl sim/30 dB lower in optical power than the unsuppressed sideband.