Phase Pattern Switching by Pulse Stimulation in Coupled Oscillators Networks

Coupled oscillator networks (CONs) occur in various domains such as biology and electronics. The nonlinear phenomenon of “injection locking” leads to frequency synchronization among the oscillators in a CON. In this chapter, we first obtain simplified tools to analyze the phenomenon of injection locking and present the Generalized Adler’s equation. The Generalized Adler’s equation is applicable for analyzing the injection locking in any type of oscillator. We demonstrate the use of Generalized Adler’s equation for injection locking analysis on a ring oscillator and a Hodgkin-Huxley neuronal oscillator. Next, we describe efficient system-level simulation techniques (synchronized steady state and transient) for coupled oscillator networks using the Perturbation Projection Vector (PPV) phase macromodel of the oscillator. The coupled oscillator simulation techniques are generic in nature and can be applied for the simulation of any coupled oscillator network, like the ones found in biological or electronic systems. We apply our system-level techniques on a −G m LC (harmonic) and a Hodgkin-Huxley (non-harmonic) CON.

The oscillators star-coupled by one resistor exhibit the phase-shift synchronization and there exist many different steady phase patterns according to their initial states. Therefore we have suggested that these systems can be use as structural elements of neural networks and large scale memories. In such cases, to get appropriate phase patterns, controlling the phase patterns should be an important problem. In this study, we propose the Wien-bridge oscillators star-coupled by one resistor driven by the periodic pulse train. In this system, the phase pattern switching is caused by the stimulation of the pulse. From the results, we suggest that the pulse stimulation is one of the ways to control the phase patterns in coupled oscillators systems.

Coupled oscillator networks occur in various domains such as biology, astrophysics and electronics. In this paper, we present a comprehensive procedure for rapid and accurate simulation of large coupled oscillator networks using widely accepted, fully-nonlinear perturbation projection vector (PPV) phase macromodels. We validate our method against full simulation of 20times20 coupled network of Brusselator biochemical oscillator and obtain computational speedups of 170x over full simulation. Furthermore, we apply the method to study self-organization phenomenon of Brusselator under asymmetric coupling and time period variations.

This study presents three EEG/MEG applications in which the modeling of oscillatory signal components offers complementary analysis and an improved explanation of the underlying generator structures. Coupled oscillator networks were used for modeling. Parameters of the corresponding ordinary coupled differential equation (ODE) system are identified using EEG/MEG data and the resulting solution yields the modeled signals. This model-related analysis strategy provides information about the coupling quantity and quality between signal components (example 1, neonatal EEG during quiet sleep), allows identification of the possible contribution of hidden generator structures (example 2, 600-Hz MEG oscillations in somatosensory evoked magnetic fields), and can explain complex signal characteristics such as amplitude-frequency coupling and frequency entrainment (example 3, EEG burst patterns in sedated patients).

Coupled oscillator networks often display transitions between qualitatively different phase-locked solutions—such as synchrony and rotating wave solutions—following perturbation or parameter variation. In the limit of weak coupling, these transitions can be understood in terms of commonly studied phase approximations. As the coupling strength increases, however, predicting the location and criticality of transition, whether continuous or discontinuous, from the phase dynamics may depend on the order of the phase approximation—or a phase description of the network dynamics that neglects amplitudes may become impossible altogether. Here we analyze synchronization transitions and their criticality systematically for varying coupling strength in theory and experiments with coupled electrochemical oscillators. First, we analyze bifurcations analysis of synchrony and splay states in an abstract phase model and discuss conditions under which synchronization transitions with different criticalities are possible. In particular, we show that such conditions can be understood by considering the relative contributions of higher harmonics to the phase dynamics. Second, we illustrate that transitions with different criticality indeed occur in experimental systems. Third, we highlight that the amplitude dynamics observed in the experiments can be captured in a numerical bifurcation analysis of delay-coupled oscillators. Our results showcase that reduced order phase models may miss important features that one would expect in the dynamics of the full system. Published by the American Physical Society 2024

A recurrent hippocampal network model was constructed using mapped clock oscillators (MCOs) and shown to reliably generate spontaneous epileptiform activity under simulated hyperexcitable conditions. Such a network may prove useful as a platform for launching investigations into seizure control, and for complementing in vitro and animal models of epilepsy. More importantly, the therapeutic potential of MCO networks in the treatment of neurological disorders like epilepsy is only beginning to be realized

Coupled electronic oscillator networks, under second harmonic injection, have recently been shown to behave as Ising machines capable of solving computationally hard combinatorial optimization problems. In this work, we experimentally investigate the dynamical properties of a reconfigurable network of up to 30 oscillators ( $\equiv $ spins) configured as an Ising machine. Specifically, we analyze the characteristics of the solutions to the Ising model produced by the oscillators and show that as the system evolves towards the ground state through the high-dimensional phase space, it gets trapped in local minima resulting in sub-optimal solutions. Moreover, the exact local minima where the system gets trapped also changes implying that the trajectory of evolution of the system also changes with each trial. Finally, we illustrate experimentally how an appropriately designed annealing scheme can help the coupled oscillators escape a local minimum and attain a lower energy state.

High output power density millimeterwave (mm-wave) signal sources are demonstrated at 60 and 140 GHz by a magnetic plasmon waveguide (MPW) based in-phase coupled oscillator network (CON) in 65-nm CMOS. Each oscillator unit-cell is designed by an MPW-based low-loss inter-digital zero-phase coupler (ZPC). With multiple in-phase coupled ZPC unit-cells, a high output power mm-wave signal is generated at the center of the CON by an in-phase power combination. A 60-GHz CON-based signal source is implemented with four in-phase CON unit-cells at 60 GHz in a compact core chip area of 0.11 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> . It is measured with 2-mW peak differential output power, 2.2% power efficiency, 18.2-mW/mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> output power density, -113.9-dBc/Hz phase noise at 10-MHz offset, and 15.8% frequency tuning range (FTR) centered at 63.1 GHz. Moreover, a 140-GHz signal source is implemented by the combination of second-order harmonics of four in-phase coupled ZPC unit-cells at 70 GHz in a compact core chip area of 0.13 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> . It is measured with 3.5-mW peak output power, 2.4% power efficiency, 26.9-mW/mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> output power density, -104.9-dBc/Hz phase noise at 25-MHz offset, and 9.7% FTR centered at 133.5 GHz.

A metamaterial-based zero-phase coupler (ZPC) is proposed for coupled oscillator network (CON) to build high output power density and low phase noise 60GHz signal source in CMOS. The ZPC itself is both high-Q resonator and low-loss zero-phase shifter. The unit-cell oscillator of CON can be implemented by the ZPC, which has minimized loss for in-phase coupling when connecting with other ZPC-based unit-cells. The frequency tuning range is realized by inductive tuning at each ZPC unit-cell. A 4-unit-cell ZPC-based CON is demonstrated at 60GHz in 65nm CMOS process with measured maximum output power of 2mW, power efficiency of 2.2%, phase noise of -116.7dBc/Hz at 10MHz offset and frequency tuning range of 15.8% centered at 63.5GHz.

A set of N identical oscillators (clocks) are connected to form a mutually synchronous network. General matrix expressions are derived for the phase error spectrum at each oscillator when the network operates in the linear regime. For certain topologies of practical interest the phase error variance and the correlation between the errors at different oscillators is computed and compared in their behavior for large N . The results presented assume no thermal noise and no delay between the oscillators. However, the theory can be easily extended to include these two effects.

In this chapter we describe phenomenon of ragged synchronizability. First we give a theoretical introduction about detecting of the complete synchronization in the network of coupled systems. As an example we choose a network of non-diagonally coupled forced van der Pol oscillators.We present construction of the single electrical van der Pol oscillator and array of such systems. We show numerical and experimental results of the existence of the complete synchronization in the array and we discuss it in the very detailed way. We also consider the synchronization in clusters, experimentally in the small array and numerically in the larger network. Our numerical simulations show good agreement with the experimental observations.

This paper focuses on the collective dynamics of multisynchronization among heterogeneous genetic oscillators under a partial impulsive control strategy. The coupled nonidentical genetic oscillators are modeled by differential equations with uncertainties. The definition of multisynchronization is proposed to describe some more general synchronization behaviors in the real. Considering that each genetic oscillator consists of a large number of biochemical molecules, we design a more manageable impulsive strategy for dynamic networks to achieve multisynchronization. Not all the molecules but only a small fraction of them in each genetic oscillator are controlled at each impulsive instant. Theoretical analysis of multisynchronization is carried out by the control theory approach, and a sufficient condition of partial impulsive controller for multisynchronization with given error bounds is established. At last, numerical simulations are exploited to demonstrate the effectiveness of our results.

The dynamical tolerance of coupled oscillator networks against local failures is studied. As the fraction of failed oscillator nodes gradually increases, the mean oscillation amplitude in the entire network decreases and then suddenly vanishes at a critical fraction as a phase transition. This critical fraction, widely used as a measure of the network robustness, was analytically derived for random failures but not for targeted attacks so far. Here we derive the general formula for the critical fraction, which can be applied to both random failures and targeted attacks. We consider the effects of targeting oscillator nodes based on their degrees. First we deal with coupled identical oscillators with homogeneous edge weights. Then our theory is applied to networks with heterogeneous edge weights and to those with nonidentical oscillators. The analytical results are validated by numerical experiments. Our results reveal the key factors governing the robustness and fragility of oscillator networks.

In modern times, satellite-based global positioning and navigation systems, such as the GPS, include precise time-keeping devices, e.g. atomic clocks, which are crucial for navigation and for a wide range of economic and industrial applications. However, precise timing might not be available when the environment renders satellite equipment inoperable. In response to this critical need, we have been carrying out, over the past three years, theory and preliminary experiments [Buono et al., 2018a; Buono et al., 2018b; Palacios et al., 2020], towards developing a novel and inexpensive precision timing device that can function independently of GPS availability. The fundamental idea is to exploit collective behavior generated by networks of coupled nonlinear oscillators. Common sense may suggest that synchronized oscillations may lead to higher accuracy. Previous works show, however, that it is not synchronization but rather, traveling wave patterns, in which consecutive oscillators are out of phase by a constant amount, that can better reduce the negative effects of noise and material imperfections which cause phase drift. In this work we advance the state-of-art in the network-based concept by studying, mainly computationally, collective behavior in networks of Colpitts oscillators. These type of oscillators are chosen because they offer a wide range of advantages (such as the ability to tune up the oscillations over a broad frequency range). The results highlight the regions of parameter space, including coupling strength, where traveling wave patterns have the largest basins of attraction and the ability to reduce phase drift by a [Formula: see text] scaling law, where [Formula: see text] is the number of oscillators in the network. The results should also provide guidelines for follow-up design and fabrication tasks of a network-based technology for precision timing.

The synchronization problems of networks of coupled harmonic oscillators are addressed by the edge event-triggered approach in this paper. The network dynamics with respect to edge states are presented and a new edge event-triggered control protocol is designed. Combined with the periodic event-detecting and edge event-triggered approach, sufficient conditions that guarantee the synchronization of coupled harmonic oscillators are presented. Two event-detecting rules are given to achieve the synchronization of coupled harmonic oscillators with low resource consumption. Finally, simulations are conducted to illustrate the effectiveness of the edge event-triggered control algorithm.