Power-Based Call Admission Control Scheme Supporting Multi-Class Services in CDMA Systems

This paper studies detecting matrices in random dense and sparse Code Division Multiple Access (CDMA) systems. Detecting matrices were originally introduced in the coin weighing problem. Such matrices can be used in CDMA systems in over-loaded scheme where the number of users is greater than the number of chips. We drive some conditions in the large system limit for binary and bipolar random CDMA systems to ensure that any random matrix is a detecting matrix. Furthermore, we extend our results to sparse random ternary matrices that have been using in the sparse CDMA literature. Finally, a construction method for the sparse detecting matrices is introduced.

Chaotic sequences have good correlation properties and they can be used as address sequences in Spread Spectrum Communication. Chaotic functions are highly sensitive to initial condition and exhibit non-linear behavior. In Chaotic spread spectrum communication systems, different user may be assigned different sequences generated with different initial conditions. Set of binary sequences with good pair wise cross- correlation property finds applications in Direct Sequence- Code Division Multiple Access (DS-CDMA) systems. Security in Direct Sequence-Code Division Multiple Access systems is relatively limited. To enhance security in Direct Sequence- Code Division Multiple Access systems, chaotic sequences are generated. In this paper we analyze the generation of chaotic binary sequences and study of auto correlation and cross correlation properties.

For high-speed code division multiple access (CDMA) systems, interchip interference that is caused by multipath propagation becomes severe and cannot be ignored. Together with the multiple access interference due to nonideal conditions in CDMA, they become major obstacles to overall system performance. In this paper, both batch and adaptive algorithms based on linear prediction are proposed for joint blind equalization and multiuser detection for asynchronous CDMA systems. It is shown that the new methods are insensitive to estimation error of propagation delay or chip timing. In addition, the adaptive algorithm is computationally efficient. Simulation results show that the proposed methods are also near-far resistant and compare favorably to many existing methods.

Multiple access interference (MAI) appears in Code Division Multiple Access (CDMA) systems when the communication channel is a multi-path channel and the spreading codes are not orthogonal. Orthogonality between spreading codes cannot be maintained at the CDMA receiver because the codes may be asynchronous due to channel delay and multi-path spread. The receiver cannot perfectly separate the different signals of the multiple access users, and the resultant MAI limits the capacity of CDMA systems. MAI is a function of the cross correlation property between used spreading codes. In this paper we focus on the cross correlation of the spreading codes, we propose a method to find spreading codes with minimum magnitude of cross correlation. Employing these codes will reduce the resultant MAI in the CDMA system; hence it will increase the system capacity. A great enhancement is shown by comparing found minimum cross correlation spreading codes (MCCSC) with Hadamard and Gold codes.

This paper carries comprehensive comparison of Interleave Division Multiple Access (IDMA) and Code Division Multiple Access (CDMA) systems in terms of performance (BER) and behavior to different number of users. Performance analysis of two systems whose transmitter and receiver structures are almost same are studied under Additive White Gaussian Noise (AWGN) and performance differences are illustrated by simulation results. Although Multiple Access Interference (MAI) and Intersymbol Interference (ISI) can affect the performance of the CDMA system, simulation results illustrates that IDMA system model achieves this type of problem using their interleavers. Results also show that large number of users can easily be adapted by the IDMA scheme much easier than CDMA scheme.

The use of multiple antennas at the transmitter or receiver provides a powerful means, of increasing the capacity of wireless systems. The goal of this paper is to illustrate ways in which analogies with multiuser code division multiple access (CDMA) systems may be used to provide design insights for space-time communication systems, for both single and multiple users. Three examples are considered: (a) noncoherent space-time codes for transmit antenna diversity against Rayleigh fading, constructed using an analogy with a CDMA downlink; (b) optimal multiuser transmit beamforming on a cellular downlink, where the algorithm for computing beamforming weights is obtained by transforming the problem into a CDMA uplink with MMSE interference suppression and power control; (c) design of high bandwidth efficiency systems exploiting both transmit and receive antenna arrays, using analogies with CDMA systems with random and slowly time-varying spreading waveforms.

In this treatise, the performance of Code division multiple access (CDMA) system is investigated using multi-user transmitter pre-processing (MUTP). The MUTP is promising signal processing technique which is carried out at the transmitter side to reduce the burden of detector and hence low complexity receiver is made feasible at mobile station (MS) in the context of downlink (DL) communication. Further, the unique signature sequence is considered to support more user population. In particular, the performance of MMSE-MUTP assisted CDMA system is investigated for realistic channel specifications based on Stanford University Interim (SUI) channel model. It has been demonstrated that the MMSE-MUTP assisted CDMA system provides achievable bit error rate with low complexity of receiver for DL transmission.

A dispersive finite impulse response (FIR) channel model is often considered for indoor wireless channels. For the FIR channel model in this paper, we consider the joint estimation of channel parameters and data symbols in indoor code division multiple access (CDMA) systems. The least squares formulation is constructed for the joint estimation incorporating the decision feedback technique. This formulation is suitable for indoor CDMA systems that usually have a small processing gain. The formulation is further modified to provide a recursive approach to estimate the channel vector.

The W-CDMA system plays an important role in the 3G cellular systems because of its compatible networking architecture to the present popular Global System for Mobile Communications (GSM) systems as well as the salient features of a Code Division Multiple Access (CDMA) system, including multi-path fading tolerance, high system capacity, low power consumption, good performance and coverage. In CDMA system, a procedure used by a Mobile Station (MS) to search for the best cell site and achieve code, time, and frequency synchronization with it is referred as cell search. Fast cell search is essential to reduce switch on delay (initial cell search), increase stand by time (idle mode search) and maintain good link quality (active-mode search). This is particularly true for the Wideband Code Division Multiple Access-Frequency Division Duplex (W-CDMA-FDD) system since it employs nonsynchronous base stations instead of synchronous ones of other CDMA systems to extend coverage from outdoor to indoor. Cell search is critical for achieving code and time synchronization. The main process of achieving cell search is divided into three stages followed by code verification, tracking and carrier frequency adjustment: 1) slot synchronization, 2) frame synchronization and code group identification, 3) primary scrambling code identification. This paper addresses slot synchronization in downlink as cell search algorithm in W-CDMA. In the three step search, the receiver searches for the slot timing by correlating the received signal with the Primary Synchronization (PSCH) code using Matched Filter (MF). This paper propose a design for a hierarchical matched filter for Primary Synchronization Code (PSC). The aim is to reduce the hardware complexity using Field Programmable Gate Array (FPGA) logic resources required to realize the filter.

In the underwater passive positioning systems (UPPS), it involves a key technology of multi-user communication that the beacons synchronously send positioning messages to the targets. Interferences from other users, referred to multi-access interferences (MAIs), can induce significant bit errors for the desired user. In this paper, we designed an underwater acoustic Code Division Multiple Access (CDMA) system using the coded cyclic shift key (CCSK) modulation, and proposed a hybrid MAI cancellation scheme based on cyclic shift inverse matrix transform (CSIMT) and recursive least square (RLS) in the CDMA system. The hybrid scheme can suppress MAI better than RLS or CSIMT, and meets the requirements of strong stability to support reliable transmission for UPPS. The CSIMT interference cancellation performs well under the far-near effects, which doesn’t depend on the accuracy of the estimation of transmitted data, and the strong MAI can be reduced by transformation of the zero-forcing correlation values using m sequence cyclic shift inverse matrix. The RLS interference cancellation is used to mitigate MAI form the detected users with comparable power, by using the estimated the channel impulse response between the receiver and the detected users, and the regenerated signal of detected users form decoder output, which allows of strong error-correcting codes, and it’s robust in an asynchronous environment. The theoretical analysis and experimental result show that the hybrid MAI cancellation scheme can effectively suppress MAI better. The shallow water sea trial was carried out near Dalian Tiger Beach Ocean Park in China, at a distance of about 5 km, the data rates of 100bps, where three users could communicate asynchronously with low failure ratio and can match the UPPS application.

This paper deals with fading and/or near-far effects with or without power control on the evaluation of the sum capacity of finite dimensional Code Division Multiple Access (CDMA) systems. CDMA systems under consideration have binary or finite non-binary inputs and signature matrices. Important results of this paper are that the knowledge of the received power variations due to input power differences, fading and/or near-far effects can significantly improve the sum capacity.

A call admission control (CAC) scheme and a resource reservation estimation (RRE) method suitable for the wide-band code division multiple access (W-CDMA) systems are proposed in this work. The proposed CAC scheme gives preferential treatment to high priority calls, such as handoff calls, by pre-reserving a certain amount of channel margin against the interference effect. It is called the interference guard margin (IGM) scheme. The amount of guard margin is determined by the measurement performed by the RRE module in base stations. Each RRE module dynamically adjusts the level of guard margin by referencing traffic conditions in neighboring cells based upon users' requests. A comprehensive service model is adopted to accommodate the scenario of multiple services supported in the W-CDMA system. The service model of consideration includes not only mobile terminal's service rate (source rate) but also different levels of priorities, mobility and rate adaptivity characteristics. Simulations are conducted with OPNET to study the performance of the proposed scheme in term of the objective function under different traffic conditions.

A universal scheme is developed to reproduce the effect of bipolar signaling in a unipolar optical channel. Without any hardware modification, the electro-optic/opto-electronic (EOE) system proposed enables the transmission of any bipolar code sequence through the unipolar optical channel while maintaining the correlation properties of the codes. The bit error rate performance of the EOE system is shown to be identical to that of an optimal baseband bipolar phase shift keying code-division multiple access (CDMA) system. Hence, the maximum spectral efficiency of an incoherent optical CDMA system using bipolar codes is the same as that of an optimal bipolar baseband CDMA system.

Channel estimation techniques for code-division multiple access (CDMA) systems need to combat multiple access interference (MAI) effectively. Most existing estimation techniques are designed for CDMA systems with short repetitive spreading codes. However, current and next generation wireless systems use long spreading codes whose period is much larger than the symbol duration. In this paper, we derive the maximum likelihood channel estimate for long code CDMA systems over multipath channels using training sequences and approximate it using an iterative algorithm to reduce the computational complexity in each processing window. The asymptotic convergence of the mean of the iterative estimate to the actual channel is also shown. The effectiveness of the iterative channel estimator is demonstrated in terms of squared error in estimation as well as the bit error rate performance of a multistage detector based on the channel estimates. Finally, the proposed iterative channel estimation technique is extended to track slowly varying multipath fading channels using decision feedback. Thus, an MAI resistant multiuser channel estimate with reasonable computational complexity is derived for long code CDMA systems over multipath fading channels.

By calibrating the inter-system bias (ISB), an inter-system model can be achieved to improve the performance of multi-global navigation satellite system (GNSS) positioning. A number of studies were carried out to compose inter-system models among code division multiple access (CDMA) systems. However, due to the frequency division multiple access (FDMA) technique, GLONASS phase and code observations suffer from inter-frequency phase bias (IFPB) and inter-frequency code bias (IFCB) respectively, which make it difficult to obtain the ISB among GLONASS and CDMA systems. In addition, most of the current inter-system models are unable to handle mixed frequencies. A new single difference-based uniform inter-system model suitable for all of the CDMA and FDMA frequency combinations is proposed in this study. We first utilize a particle filter approach to extract the IFPB rate. Afterwards, the multi-ISB parameters can be estimated by the proposed model simultaneously. Four short baselines containing the signals of GLONASS, GPS, BDS3, BDS2, Galileo, and QZSS are selected to validate the model. The quantitative results indicate that the IFPB rate can be extracted precisely by a particle filter within ten epochs. The inter-system phase bias valuations are sufficiently stable on a daily scale and have standard deviation near 0.01 cycles. After de-weighting the GLONASS code observations to reduce the influence of IFCB, the inter-system code bias is also stable. Furthermore, imposing the stable ISB on the multi-GNSS inter-system model can effectively improve the single-frequency real-time kinematic positioning accuracy and reliability for severely obstructed situations with only a small number of satellites observed.