Power-saving scheduling algorithm for multiple target coverage in wireless sensor networks

Coverage in wireless sensor networks is a critical issue since it reflects the cost and detection capability of the network. Sensor coverage model is closely to the sensing functions of different types of sensors while network coverage is a collaborative measure from geographically distributed sensors. The coverage problems in wireless sensor networks have been formulated in various ways with different assumptions, constraints and objectives. In this work, a collaborative coverage model is proposed in the target surveillance application, while sensor sensing probabilistic model is introduced. Furthermore, a collaborative target coverage optimization algorithm (CTCOMSN) is presented to prolong the network lifetime in energy constraint mobile sensor networks. Simulation results show that CTCOMSN can prolong the lifetime greatly while improving the sensing quality.

Underwater wireless sensor networks nodes deployment optimization problem is studied and underwater wireless sensor nodes deployment determines its capability and lifetime. If no underwater wireless sensor node is available in the monitoring area of underwater wireless sensor networks due to used up energy or any other reasons, the monitoring area where is not detected by any underwater wireless sensor node forms coverage holes. In order to improve the coverage of the underwater wireless sensor networks and prolong the lifetime of the underwater wireless sensor networks, based on the perception model, establish nodes detection model, combining with the data fusion. Because the underwater wireless sensor networks nodes coverage holes appear when the initial randomly deployment, a nodes deployment algorithm based on perception model of underwater wireless sensor networks is designed in this article. The simulation results show that this algorithm can effectively reduce the number of deployment underwater wireless sensor networks nodes, improve the efficiency of underwater wireless sensor networks coverage, reduce the underwater wireless sensor networks nodes energy consumption, prolong the lifetime of the underwater wireless sensor networks.

Target Coverage and Network Connectivity in Wireless Sensor Networks (WSNs) plays a momentous role in the field of monitoring environment, habitant observing, disaster recovery, surveillance, etc. Coverage and Network Connectivity collectively can be considered as a proportion of Quality of Service (QoS) in a sensor network. It implies the coverage of each point in the detecting field while in the meantime fulfilling the measure that each node is surrounded by the equivalent neighbourhood of at least one other node. Many primary issues influence the outline and performance of WSN. A Comprehensive survey is made based on the scheduling algorithm and set cover approach, in which we analyze various approaches and their algorithm complexity. Firstly, the scheduling algorithm intermittently provides the required data service with guaranteed efficiency. This methodology can efficiently reduce the entire number of active nodes in the network, resulting in maximizing the network lifetime. Secondly, the set cover approach plays a major role in solving target coverage problem which group sensors into each cover set thereby, target coverage was achieved. Typical issues and open research challenges are addressed by classifying the approaches available in literature into three broad categories namely, adaptable coverage radius, coverage deployment strategy, and sleep scheduling. This survey aims to provide a better perceptive of the existing open challenges and possible futuristic approaches for target coverage and network connectivity in wireless sensor networks.

Finding an optimal node deployment strategy in wireless sensor networks (WSNs) that would reduce cost, be robust to node failures, reduce computation, and communication overhead, and guarantee a high level of coverage along with network connectivity is a difficult problem. In fact, sensing coverage and network connectivity are two of the most fundamental problems in WSNs as they can directly impact the network lifetime and operation. In this paper, we consider deriving optimal conditions for connectivity with coverage in WSNs. Most versions of this problem are (NP-complete), while approximation algorithms cannot be developed for some versions of polynomial time, unless P = NP. Hence, we also develop a heuristic for some versions of the problem and the efficacy of the heuristic will be evaluated through extensive simulations. We are also interested in determining the probability of finding a path between a given pair of nodes over a given topology of WSNs. This will serve as a measure of connectivity with coverage of the network. Hence, we derive necessary and sufficient conditions for connectivity with coverage over a clustered structure in WSNs. Then, employing queuing networks modeling techniques, we present a dynamic programming study of the connectivity with coverage of clustered structure and its effect on routing in generalized WSNs. The performance evaluation of the proposed schemes shows that availability of nodes, sensor node coverage, and the connectivity were sufficiently enhanced to maximize network lifetime.

Division of the entire wireless sensor network geographic area into number of equal sized regions by applying virtual grid and strategy to appoint head node of the cluster in each region improves stability, consistency, and lifetime of the wireless sensor network. Applying the same size of grid to the different size of wireless sensor networks will not give consistent performance. In this paper, we are presenting a protocol which will dynamically determine the size of the virtual grid, which will give optimal performance of any geographic sized wireless sensor network. The protocol also allows to place sink node to any location and not at some fixed specific location. Protocol discussed in this paper can also support multiple sink nodes. Protocol dynamically takes decision to transmit the data directly to the sink node or by using multi-hop transmission by considering distances between sensor nodes internally and sink node(s), which will optimize energy efficiency of the sensor nodes and increases the lifetime of wireless sensor network.

Although most of the studies on coverage and connectivity in wireless sensor networks (WSNs) considered two-dimensional (2D) settings, such networks can in reality be accurately modeled in a three-dimensional (3D) space. The concepts of continuum percolation theory best fit the problem of connectivity in WSNs to find out whether the network provides long-distance multihop communication. In this paper, we focus on percolation in coverage and connectivity in 3D WSNs. We say that the network exhibits a coverage percolation (respectively, connectivity percolation) when a giant covered region (respectively, giant connected component) almost surely spans the entire network for the first time. Because of the dependency between coverage and connectivity, the problem is not only a continuum percolation problem but also an integrated continuum percolation problem. Thus, we propose an integrated-concentric-sphere model to address coverage and connectivity in 3D WSNs in an integrated way. First, we compute the critical density lambdaC con above which coverage percolation in 3D WSNs will almost surely occur. Second, we compute the critical density lambdac con above which connectivity percolation in 3D WSNs will almost surely occur. Third, we compute the critical density lambdac cov-con above which both coverage and connectivity percolation in 3D WSNs will almost surely occur. For each of these three problems, we also compute their corresponding critical network degree. Our results can be helpful in the design of energy-efficient topology control protocols for 3D WSNs in terms of coverage and connectivity.

Limited energy supply (battery-powered) is a crucial problem in wireless sensor networks (WSNs). Sensor node placement schemes and routing protocols are mostly proposed to address this problem. In this paper, we first present how to place sensor nodes by use of a minimal number of them to maximize the coverage area when the communication radius of the sensor node is different from the sensing radius, which results in the application of regular topology to WSNs deployment. With nodes placed at an equal distance and equipped with an equal power supply, the problem of unbalanced energy consumption in 2-D regular topologies becomes more severe and much more difficult to tackle than that in 1-D chains, though the latter is known as an already quite hard problem. We address this problem and propose an adaptive data collection scheme by employing different communication radii for nodes in different locations to balance the energy consumption in WSNs. In order to achieve the ultimate goal of maximizing network lifetime in grid-based WSNs, we give a mathematical formulation, which shows the problem of maximizing network lifetime is a nonlinear programming problem and NP-hard even in the 1-D case. We discuss several heuristic solutions and show that the halving shift data collection scheme is the best solution among them. We also generalize the maximizing network lifetime problem to the randomly-deployed WSNs, which shows the significance of our mathematical formulation for this crucial problem in WSNs.

Wireless sensor network is an emerging technology capable of having low-cost and low-power and battery-powered sensor node. At this point the protocol concentric clustered power-efficient gathering in sensor information systems and clustered general self organized tree based energy-balance routing protocol energy efficient protocol are used to increase the energy and to extend network lifetime. For these achievement of clustering techniques, optimization technique particle swarm optimization is used for data transmission through base station. If the base station is inaccessible region from the cluster-head, energy consumption will be augmented and it can shrink the lifetime of wireless sensor network. To conquer these, multi-hop gateway node is implemented with both protocol to achieve maximum lifetime and energy efficiency of wireless sensor network. To improve the quality-of-service (QoS) placing more number of gateways is required. So we propose a new algorithm nearer optimal algorithm which recursively computes least possible adequate dominating sets, at the time constantly preserving QoS requirements across iterations. In this paper comparison is done in terms of throughput, packets delivery ratio and number of nodes alive.

Efficient coverage and connectivity are two important factors that ensures better service quality especially during tracking targets or monitoring events in wireless sensor network. Although massive amount of studies has been carried out in the past to enhance coverage and connectivity issues, till date very few studies have witnessed a significant and standard outcomes that can opt further. Hence, this paper introduces a computationally efficient technique for jointly addressing both coverage and connectivity problems in large-scale wireless sensor network that ensures optimal network lifetime too. The proposed system has been empirically designed, and algorithms formulated to ensure energy efficient monitoring of event. The outcomes of the study are compared with standard energy efficient hierarchical protocol to benchmark the results.

In this paper, we consider the problem of wireless sensors deployed in a circular area to achieve a desired degree of coverage. To this end, we propose a coverage algorithm based on polar coordinates to enhance the coverage after an initial random deployment. The desired positions of neighbor nodes along different directions are defined, Thus, the virtual radius and the virtual angle of a sensor node in the polar coordinate plane are calculated, and then the sensor node moves to the desired position in the radial direction and the circumferential direction, respectively. We adjust the nodes' polar coordinates via their radii and angles (in node ID sequence as much as possible) to reduce overlap in the node sensing area and improve the coverage of Wireless Sensor Networks (WSNs).

Aiming at the uneven random coverage distribution of wireless sensor networks sensor nodes, the sparrow search algorithm (SSA) is used to optimize the node coverage of wireless sensor networks. To improve the global search capability of SSA, the algorithm is improved and applied to the wireless sensor networks of bridge monitoring. For enhancing the coverage of the wireless sensor networks, this article uses two improved methods. One is to use the good point set theory to make the initial population evenly distributed; another is to introduce a weight factor to speed up its convergence. The experiments have proved the reliability and rationality of the algorithm. The improved algorithm is superior to other meta-heuristic algorithms and provides a new idea for optimizing bridge monitoring wireless sensor networks coverage.

Toward the end of the 20th century, the Internet has been able to provide a large number of users with the ability to move diverse forms of information readily and thus has revolutionized business, industry, defense, science, education, research, and human interactions. In the last 10 years, sensor networking combines the technology of modern microelectronic sensors, embedded computational processing systems, and modern computer networking methodology. It is believed that sensor networking in the 21st century will be equally significant by providing measurement of the spatial-temporal physical phenomena around us, leading to a better understanding and utilization of this information in a wide range of applications. Sensor networking will be able to bring a finer-grained and fuller measurement and characterization of the world around us to be processed and communicated, so the decision makers can utilize the information to take actions in near-real-time. The potential applications enabled by SNs include security and surveillance, environmental monitoring and control, target detection and tracking, etc. Wireless sensor networks utilize the extensive networking concepts of ad hoc networks and apply them to specific sensor network scenarios. This mini-special issue comprises three papers covering three quiet diverse aspects of wireless sensor networks. The first paper, “Lifetime Maximization Based on Coverage and Connectivity in Wireless Sensor Networks,” is by T. Zhao et al. They studied the problem of network lifetime maximization for QoS specific information retrieval for the reconstruction of a spatially correlated signal field in a wireless sensor network for two wireless transmission cases. In one case, they assumed there exist single-hop transmissions between sensors and the access point, and in the other case, the measurements are sent to the access point through multi-hop transmissions. To address both of these problems, they formulated the problems using integer programming based on the theories of coverage and connectivity in sensor networks and then derived upper bounds for the network lifetime that provides benchmarks for the performance of suboptimal methods. Several lowcomplexity suboptimal algorithms for joint node scheduling and data routing were then proposed to approach the performance upper bounds. The second paper, “Using Heterogeneity to Enhance Random Walk-based Queries,” is by M. Zuniga et al. They presented a study of the impact of heterogeneous node connectivity on random walk-based queries. The main contribution of the work is showing that with a small percentage (e.g., 10%) of high-degree nodes in the network and using a simple distributed push-pull mechanism, significant cost savings can be obtained (e.g., between 30% and 70%) depending on the coverage of the high-degree nodes. Their work provides interesting theoretical results for line topologies showing that when cluster-heads have a coverage of k nodes to the right and left and are uniformly distributed, a fraction of 4/5k J Sign Process Syst (2009) 57:381–383 DOI 10.1007/s11265-009-0377-9

We analyze the impact of the structure of the Data Gathering (DG) trees on node lifetime (round of first node failure) and network lifetime (minimum number of rounds by which the network gets either disconnected due to node failures or the fraction of coverage loss reaches a threshold) in wireless sensor networks through extensive simulations. The two categories of DG trees studied are: the Bottleneck Node Weight-Based (BNW-DG) trees and Bottleneck Link Weight-Based (BLW-DG) trees. The BNW-DG trees incur a smaller diameter and a significantly larger fraction of nodes as leaf nodes: thus, protecting a majority of the nodes in the network from simultaneously being exhausted of the energy resources (contributing to a significantly larger network lifetime); nevertheless the nodes that serve as intermediate nodes in the first few instances of the BNW-DG trees are bound to lose their energy more quickly than the other nodes, leading to a smaller node lifetime compared to that of the BLW-DG trees (that incur a larger diameter and a relatively lower fraction of nodes as leaf nodes).

Minimizing the energy consumption of battery-powered sensors is an essential consideration in sensor network applications like coverage, and sleep/wake scheduling mechanism has been proved to an efficient approach to handling this issue. Nevertheless, the frequent switching between states, during scheduling, leads also to significant energy consumption. In this article, a coverage-guaranteed distributed sleep/wake scheduling scheme is presented with the purpose of prolonging network lifetime while guaranteeing network coverage. Our scheme mitigates scheduling process to be more stable by avoiding useless transitions between states without affecting the coverage level required by the application. The simulation results illustrate that out scheme outperforms some other existed algorithms in terms of coverage guarantee, energy conservation and stability.

Deployment is an important issue in wireless sensor networks (WSNs). Most recent researches focus on the optimal deployment strategy to achieve full coverage in WSNs. However, the sensing devices in practical applications are finite, and cannot achieve full coverage in the whole monitored region. Moreover, the monitored objects distribute unevenly, and thus the monitored significance differs from region to region. How to deploy limited number of sensors efficiently has been to an important issue. In this study, we propose a new coverage problem in WSNs, named N-node coverage, to acquire the maximum information about monitored objects with N sensors. In this problem, the captured information is used as the new evaluation metric for network coverage. On the basis of the metric, we establish the N-node network coverage model, and prove that the N-node coverage problem is NP-hard. The authors propose a heuristic algorithm for deployment, named optimisation schEme of N-node (OPEN), to obtain the near-optimal solution of the problem. Experimental results show that the OPEN can effectively improve the coverage performance of the WSNs, and is able to provide practical guideline for deployment of WSNs with limited number of nodes.