• Home
  • Search
  • Practical Application of Calculated Multiphase Flowing Bottom-Hole Pressures
  • Cite Icon1
  • https://doi.org/10.2118/1218-paCopy DOI Icon

Practical Application of Calculated Multiphase Flowing Bottom-Hole Pressures

Show More
  • Abstract
  • Literature Map
  • Citations
  • Similar Papers
Abstract

Abstract Flowing bottom-hole pressures accurately calculated from surface measurements can define both well and reservoir parameters from routine well tests. Heretofore, the practicality of this has been questionable due to the large number of well tests and the time required for each calculation. With the advent of high speed digital computers to make these calculations, this method has become most useful. Producing rate, reservoir pressure and fluid properties in conjunction with flowing bottom-hole pressure form the basis for calculating productivity index, effective permeability and well capacity. Calculated effective permeability combined with future well capacity has been used to improve sweep model studies. A comparison is included of a sweep model study using these principles, as opposed to using constant well capacity and average permeability. The effects of chokes on surface flowing pressures can be predicted and several examples are included. A technique to predict gas lift performance is given. When the reservoir producing mechanism has been determined, a prediction on an individual well basis can now be made. Introduction During the 1930's, with the work of Uren and Moore et al., an investigation into the principles and factors involved in defining multiphase flow in vertical conduits was begun. This work is not yet finished. However, today many correlations are found in the literature which make calculated flowing bottom-hole pressures sufficiently accurate to have practical applications. Use of high speed digital computers enables the engineer to analyze the results of past test data in a new light. Of the many contemporary methods of calculating flowing bottom-hole pressures, the correlations of Ros more nearly approximate the measured pressures in the fields under consideration. In this paper, the Ros method has been used exclusively. Presented are applications of productivity indices and effective permeability derived from calculated flowing bottom-hole pressures. Reliable individual well and reservoir performance predictions can now be made. Calculation of Flowing Bottom-Hole Pressure A comparison between a flowing bottom-hole pressure calculated by a computer program based upon the Ros method compared to a field-measured flowing bottom-hole pressure is included in Table 1. The first three lines of the table serve as identification and general information while the succeeding five lines (tubing pressure, oil, gas and water production rates with gas-oil ratio) form the field-measured basic input data for the calculation. This routine information is normally maintained as a matter of company records or is publicly available from the various state regulatory bodies. In addition to the test information, it is necessary to have knowledge of pressure-volume-temperature relationships of the hydrocarbon system, the depth to which the calculation is to be made, conduit size and whether annular or tubing flow. Shown next is the calculated flowing bottom-hole pressure which differs by 55 psi from the measured pressure. Usually, flowing bottom-hole pressures can be calculated to an accuracy within 5 to 10 per cent of the pressure drop in the flow conduit. This discrepancy will produce usable data in a reservoir which demonstrates a large wellbore drawdown. JPT P. 1373

Similar Papers
  • Research Article
  • Citations1

A Short Cut to Stabilized Gas Well Productivity

  • May 01, 1970
  • Journal of Petroleum Technology
  • H.G Riley
  • Research Article

Future Production Prediction for Ghani Oil Field by using Prosper Software with Decline Curve Analysis

  • Mar 20, 2026
  • AlQalam Journal of Medical and Applied Sciences
  • Adel Ragib Traki
  • Research Article

Significance of Declining Productivity Index

  • Dec 01, 1945
  • Transactions of the AIME
  • C.V Millikan +1
  • Conference Article
  • Citations1

Comparison of Wellbore Hydraulics Models to Maximize Control of BHP and Minimize Risk of Formation Damage

  • Mar 25, 2003
  • Isabel C Gil +1
  • Research Article

ANALISIS PRESSURE BUILD-UP RESERVOIR GAS KONDENSAT DALAM FORMASI KARBONAT

  • Jan 01, 2020
  • PETRO:Jurnal Ilmiah Teknik Perminyakan
  • Jodica Jodica +2
  • Conference Article
  • Citations3

Downhole Electrical Heating Dynamic Model Assessment in Faja Extraheavy Oil Reservoir Application

  • Jul 20, 2020
  • Richard Velasquez +3
  • Conference Article
  • Citations1

Gas-Oil Ratio GOR Characterization of Unconventional Wells in Eagle Ford

  • Apr 18, 2022
  • Yajie Zhao +6
  • Research Article

Optimizing gas injection in high-pressure carbonate reservoirs: controlling bottomhole and tubing head pressures to avoid formation fracturing

  • Sep 26, 2025
  • Kazakhstan journal for oil & gas industry
  • Bakhytzhan K Khassanov +2
  • Research Article

Analytical Decline Curve Analysis Model for Water Drive Gas Reservoirs

  • Jan 01, 2017
  • Journal of Petroleum & Environmental Biotechnology
  • Mostafa S Abdelkhalek +2
  • Research Article

Evaluation of Chemical Application as Pilot to Improve Oil Production from High Viscous Oil in Sandstone Reservoir

  • Jan 01, 2022
  • Journal of Petroleum Engineering & Technology
  • Samih Mohieldin Hassan +2
  • Conference Article

A Systematic Approach of Bottomhole Pressure History Matching for the Giant Carbonate Kashagan Field

  • Nov 26, 2024
  • Medet Madalimov +3
  • Research Article
  • Citations33

History matching and production prediction of a horizontal coalbed methane well

  • Sep 03, 2012
  • Journal of Petroleum Science and Engineering
  • Fengde Zhou
  • Conference Article
  • Citations4

Pressure Drawdown and Buildup Analysis in Gas Condensate Reservoirs

  • May 20, 2002
  • Sarfraz A Jokhio +1
  • Research Article
  • Citations33

Prediction of SAGD Performance Using Response Surface Correlations Developed by Experimental Design Techniques

  • Sep 01, 2008
  • Journal of Canadian Petroleum Technology
  • J.W Vanegas Prada +1
  • Conference Article
  • Citations33

Reservoir Variability and Modeling with Fractals

  • Sep 23, 1990
  • S D Crane +1
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.