Precoded GFDM system for self-interference mitigation

DHT-based GFDM and STC-GFDM systems for beyond 5G wireless networks

PAPR analysis of wavelet based multitaper GFDM system

Generalized frequency division multiplexing (GFDM) and circular filter bank multicarrier (C-FBMC) are two contender waveforms with circular pulse-shaping that are recently proposed for the physical layer of the fifth generation of wireless communication networks (5G). This paper puts these waveforms under the microscope and conducts an analysis on their practical feasibility and performance. In addition, we present a transmitter structure for both GFDM and C-FBMC and show that this structure has the same complexity for both systems. In this paper, GFDM receiver with successive interference cancellation (SIC) is considered as it can get a performance close to that of OFDM (orthogonal frequency division multiplexing). Our bit error rate (BER) performance analysis reveals that GFDM has limitations in terms of the total number of symbols per data packet. When the number of symbols in a packet has an even value, GFDM suffers from a high error floor in BER. For the small constellation sizes, GFDM and C-FBMC reach the same BER performance as that of OFDM. As the constellation size increases, a gap between the BER curve of GFDM and OFDM starts to appear while C-FBMC keeps the same performance as OFDM. Finally, our computational complexity analysis reveals that C-FBMC receiver is simpler than GFDM.

Generalized frequency division multiplexing (GFDM) and circular filter bank multicarrier (C-FBMC) are two contender waveforms with circular pulse-shaping that are recently proposed for the physical layer of the fifth generation of wireless communication networks (5G). This paper puts these waveforms under the microscope and conducts an analysis on their practical feasibility and performance. In addition, we present a transmitter structure for both GFDM and C-FBMC and show that this structure has the same complexity for both systems. In this paper, GFDM receiver with successive interference cancellation (SIC) is considered as it can get a performance close to that of OFDM (orthogonal frequency division multiplexing). Our bit error rate (BER) performance analysis reveals that GFDM has limitations in terms of the total number of symbols per data packet. When the number of symbols in a packet has an even value, GFDM suffers from a high error floor in BER. For the small constellation sizes, GFDM and C-FBMC reach the same BER performance as that of OFDM. As the constellation size increases, a gap between the BER curve of GFDM and OFDM starts to appear while C-FBMC keeps the same performance as OFDM. Finally, our computational complexity analysis reveals that C-FBMC receiver is simpler than GFDM.

In this paper, a new WHT-LWT-GFDM waveform obtained by combining Walsh–Hadamard Transform (WHT), Lifting Wavelet Transform (LWT), and Generalized Frequency Division Multiplexing (GFDM) is presented for use in next-generation wireless communication systems. The proposed approach meets the requirement of 5th-generation (5G) and beyond communication schemes in terms of low latency, low peak-to-average-power ratio (PAPR), and low bit-error rate (BER). To verify the performance of the presented waveform, PAPR and BER simulation results were obtained in additive white Gaussian noise (AWGN) and flat Rayleigh fading channels, and the performance of the proposed system was compared with conventional Orthogonal Frequency Division Multiplexing (OFDM), GFDM, and Walsh–Hadamard transform-based GFDM (WHT-GFDM). Simulation results show that the proposed waveform achieves the best BER and PAPR performances and it provides considerable performance gains over the conventional waveforms.

One of the challenges of modulation techniques used in Fifth-Generation (5G) is their robustness in noisy environment. Conventional Orthogonal Frequency Division Multiplexing (OFDM) cannot be considered as a 5G waveform in its original form because of its certain limitations, such as performance degradation by impulsive noise (IN) and high peak to average power ratio (PAPR). Numerous modulation schemes proposed for 5G communications are able to overcome these drawbacks. Generalised Frequency Division Multiplexing (GFDM) is one of them. This paper analyses the performance of GFDM in presence of Additive White Gaussian Noise (AWGN), IN and Narrow Band Interference (NBI). It is found that GFDM is able to perform better than OFDM and Vector Orthogonal Frequency Division Multiplexing (VOFDM) in presence of noises, which can potentially be present in 5G applications. Simulation results show that GFDM achieve lower PAPR and Symbol Error Rate (SER) and an average of 10.73 dB and 4.73 dB gain in Signal to Noise Ratio (SNR) in presence of IN and combined IN and NBI respectively, as compared to OFDM and VOFDM.

Generalized frequency division multiplexing (GFDM) is a recent physical layer scheme proposed for next-generation cellular systems. Like orthogonal frequency division multiplexing (OFDM), it is based on multicarrier modulation, but the filter shape is no longer rectangular (roll off &#x2260; 0) and the orthogonality between subcarriers is lost. With higher flexibility, low peak to average power ratio (PAPR) and reduced out-of-band emissions compared with OFDM, GFDM modulation is an attractive candidate for 5G application scenarios. This paper explores the performance of 10 Gb&#x002F;s GFDM system over the optical link in terms of PAPR, quality factor (<italic>Q</italic> factor), and mean squared error using a third-order adaptive Volterra filter with 3 and 5 taps. The impact of linear impairments (chromatic dispersion, polarization mode dispersion), laser line width, and Mach&#x2013;Zehnder non-linearity have been addressed. The results of our simulations indicate that the transmitted 10 Gb&#x002F;s GFDM signal through an optical fiber can reach 930 Km and <italic>Q</italic> &#x003D; 11.9 dB after 700 Km at &#x2013;8 dBm of launch power using 5 taps third-order adaptive Volterra equalizer with an improvement of approximately 210 Km and 1.25 dB compared with the same equalizer with 3 taps.

Orthogonal frequency division multiplexing (OFDM) is a type of digital modulation technique which is used in wireless communication systems. It is an efficient multicarrier modulation technique, in which large bandwidth is divided into parallel narrow bands each of which is modulated by different subcarriers. All the subcarriers are orthogonal to each other and hence it reduces the interference among various subcarriers. But OFDM suffers from high peak to average power ratio(PAPR), high complexity in design. The performance parameter of OFDM can be measured in terms of Bit error rate (BER). Lower the BER value, higher is the efficiency of OFDM system. Various methods are used to enhance the BER performance. Channel coding is the one way of enhancing the BER. This paper discusses the performance of OFDM using linear & cyclic block coding for different digital modulation techniques. Bit error rate (BER) is used to measure the performance of OFDM systems.

Due to the evolution of mobile phone technology which enables the use of Internet, the demand for data rates has increased tremendously. Therefore, current 4G-LTE (long-term evolution) technology needs to be replaced in near future. Hence, currently possible solutions for 5G technology are heavily investigated. Generalized frequency division multiplexing (GFDM) is one such technique which is based on multi-carrier filters and uses time-frequency structure to optimize delay and out-of-band emission (OOB). Still GFDM is very much similar to orthogonal frequency division multiplexing (OFDM) with much improved spectral and peak-to-average power ratio (PAPR) performance. This paper presents a detailed description of GFDM technique, along-with its comparison to OFDM method. This paper further investigates the non-linear companding scheme which can be used to further reduce PAPR. Simulation results are presented to obtain (Power Spectral Density) PSD and PAPR performance.

Generalized Frequency Division Multiplexing (GFDM) is a non-orthogonal multicarrier transmission scheme proposed for fifth (5G) and future generation wireless networks. Due to its attractive properties, it has been recently discussed as a candidate waveform for the future wireless communication systems. GFDM is introduced as a generalized form of the widely used Orthogonal Frequency Division Multiplexing (OFDM) modulation scheme and it uses only one cyclic prefix (CP) for a group of symbols. The main focus of this work is to present like impact on the system performance the coefficient quantity of the subcarrier filter. A simple method for the computation of the coefficients of the prototype filter is employed. Besides, it is presented a structure for the GFDM by taking advantage of the arrangement in the modulation matrix. We evaluated the Bit Error Rate (BER) using the receiver models presented in this work. The results showed that the BER is affected according to the coefficients quantity of the prototype filter. Based on the obtained results, the coefficients quantity has a relation with the number of time slots of the GFDM system.

In this paper, we assess the performance of a generalized frequency division multiplexing (GFDM) transceiver for underwater acoustic high data-rate transmission. We also present a comprehensive overview of the work done in the field of next generation multicarrier techniques beyond orthogonal frequency division multiplexing (OFDM) for underwater acoustic (UWA) channels. Since very little work has been done in determining the feasibility of acoustic GFDM, we evaluate the performance of proposed GFDM transceiver in terms of spectral efficiency, peak to average power ratio, error rates and complexity using simulations. We employ two types of receivers - matched filter and zero forcing and evaluate their performances for several system configurations. Results presented show that the zero forcing receiver outperforms the matched filter receiver at high SNR values for almost all the configurations; exceptions being the cases where 1 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">st</sup> and 4 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">th</sup> Xia pulse shapes are employed with higher values of the roll off factor. We also compare the performance of the proposed GFDM transceiver with that of OFDM and show that GFDM outperforms OFDM by almost 4 dB for a symbol error rate of 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-2</sup> . It is concluded that while GFDM is computationally more demanding than OFDM, it is still an appealing technique for future UWA communications due to its higher spectral efficiency, flexibility, and better error performance.

The 4G up-gradation was essential because of the exponential increment of the wireless applications. So, 5G was introduced with large capacity, small latency, improved reliability, high data rate, and better quality of services (QoS). 4G uses orthogonal frequency-division multiplexing (OFDM) which has a decent quality of long-distance communication, by eliminating intersymbol interference (ISI) and improving the signal-to-noise ratio (SNR), but it has a spectrum wastage problem. However, the improved data rate is possible by spectrum utilization. 5G adopted various techniques for the better utilization of spectrum in current scenarios. The new generation waveforms, i.e., filtered orthogonal frequency-division multiplexing (F-OFDM), generalized frequency-division multiplexing (GFDM), universal filtered multicarrier (UFMC), and filter bank multicarrier (FBMC), are one of them. This paper will discuss FBMC which is the alternative technology of OFDM with better features by building subcarrier waveform based on prototype filters. Here, FBMC is investigated in terms of BER (bit error rate) by varying several parameters such as the size of inverse fast Fourier transforms/fast Fourier transform (IFFT/FFT), length of guard band, and length of symbols. Results of simulation will show that the bit error rate (BER) of FBMC is not affected by the variation of symbol length, while advancement in the size of IFFT/FFT increases BER, on the given parameter while the BER reduces for large size of the guard band of each subcarrier.KeywordsFilter Bank MulticarrierIFFT/FFTOffset QAMOrthogonal Frequency-Division MultiplexingBit Error Rate

Generalized Frequency Division Multiplexing (GFDM) is a recently proposed multicarrier waveform which is being considered as one of the possible candidates for 5G wireless access technology. Key advantages of GFDM are flexibility and low spectral side-lobes which render it the ability of carrier aggregation and reduced adjacent channel interference. However due to its non-orthogonal nature GFDM suffers from the problem of self-inter-carrier interference (self-ICI) which occurs between time-slots of adjacent subcarriers in the signal. Due to self-ICI, the bit-error rate (BER) performance of GFDM is severely affected under low SNR regime. Moreover application of MIMO technique to GFDM further adversely affects the BER due to inter-antenna interference (IAI) between the transmit antennas. To mitigate this problem, spatial modulation has been applied to GFDM and its BER performance with respect to V-BLAST based GFDM is studied under flat Rayleigh fading channel condition through computer simulations.

This article addresses linear precoder design for the peak‐to‐average power ratio (PAPR) reduction of the generalized frequency division multiplexing (GFDM) scheme. This design relies on minimizing various statistical parameters of the instantaneous power of the GFDM signal—including variance, second and third moments—using gradient‐based optimization methods. In this regard, a general framework of four different scenarios, which employs the steepest descent and conjugate‐gradient methods and utilizes two different approaches of fixed and dynamic step‐sizing, is proposed. In the case of fixed step‐sizing, the results demonstrate that the algorithm diverges in some scenarios and provides low‐speed convergence for the others due to its inability in meeting the terminating threshold regarding minimizing objective function to a desirable level. However, dynamic step‐sizing using the Wolf line search rule circumvents these drawbacks, outperforms the existing research, and converges in all scenarios to a precoder providing advantages in terms of design speed and achievable PAPR, while keeping the symbol error rate and out‐of‐band emissions at the ranges of the un‐precoded GFDM systems. Moreover, the results confirm the comprehensiveness of the proposed framework in adapting to various GFDM statistical parameters and gradient methods.

Novel hybrid PAPR reduction schemes for the MGFDM system