Protein oligomerization induced by oleic acid at the solid–liquid interface – equine lysozyme cytotoxic complexes

Chapter 40 - ELOA – Equine Lysozyme Complexes with Oleic Acid: Structure and Cytotoxicity Studied by Bio-Imaging Techniques

Stability of monomolecular films of archaebacterial tetraether lipids on silicon wafers: A comparison of physisorbed and chemisorbed monolayers

Interfacial gas enrichment of dissolved gases (IGE) has been shown to cover hydrophobic solid surfaces in water. The atomic force microscopy (AFM) data has recently been supported by molecular dynamics simulation. It was demonstrated that IGE is responsible for the unexpected stability and large contact angle of gaseous nanobubbles at the hydrophobic solid-water interface. Here we provide further evidence of the significant effect of IGE on an attractive force between hydrophobic solid surfaces in water. The force in the presence of dissolved gas, i.e., in aerated and nonaerated NaCl solutions (up to 4 M), was measured by the AFM colloidal probe technique. The effect of nanobubble bridging on the attractive force was minimized or eliminated by measuring forces on the first approach of the AFM probe toward the flat hydrophobic surface and by using high salt concentrations to reduce gas solubility. Our results confirm the presence of three types of forces, two of which are long-range attractive forces of capillary bridging origin as caused by either surface nanobubbles or gap-induced cavitation. The third type is a short-range attractive force observed in the absence of interfacial nanobubbles that is attributed to the IGE in the form of a dense gas layer (DGL) at hydrophobic surfaces. Such a force was found to increase with increasing gas saturation and to decrease with decreasing gas solubility.

Human α-lactalbumin made lethal to tumor cells (HAMLET) and equine lysozyme with oleic acid (ELOA) are complexes consisting of protein and fatty acid that exhibit cytotoxic activities, drastically differing from the activity of their respective proteinaceous compounds. Since the discovery of HAMLET in the 1990s, a wealth of information has been accumulated, illuminating the structural, functional and therapeutic properties of protein complexes with oleic acid, which is summarized in this review. In vitro, both HAMLET and ELOA are produced by using ion-exchange columns preconditioned with oleic acid. However, the complex of human α-lactalbumin with oleic acid with the antitumor activity of HAMLET was found to be naturally present in the acidic fraction of human milk, where it was discovered by serendipity. Structural studies have shown that α-lactalbumin in HAMLET and lysozyme in ELOA are partially unfolded, 'molten-globule'-like, thereby rendering the complexes dynamic and in conformational exchange. HAMLET exists in the monomeric form, whereas ELOA mostly exists as oligomers and the fatty acid stoichiometry varies, with HAMLET holding an average of approximately five oleic acid molecules, whereas ELOA contains a considerably larger number (11- 48). Potent tumoricidal activity is found in both HAMLET and ELOA, and HAMLET has also shown strong potential as an antitumor drug in different in vivo animal models and clinical studies. The gain of new, beneficial function upon partial protein unfolding and fatty acid binding is a remarkable phenomenon, and may reflect a significant generic route of functional diversification of proteins via varying their conformational states and associated ligands.

Solid-liquid interfaces are ubiquitous. Despite the unquestioned relevance, many scientific research fields rely on simplified or macroscopic descriptions, discarding the molecular nature of the constituents. However, it is the specific molecular interactions and the complex chemistry in the interfacial region that are fundamental in phenomena such as heterogeneous catalysis, electrochemistry, crystal growth, membrane transport and body-antibody recognition. In particular, the models used to describe the so-called electrical double layer of ionic distributions at charged surfaces in liquid, are based on continuum assumptions. For example, the Gouy-Chapman-Stern model assumes that a dense, homogenously distributed layer with a thickness of a hydrated ion (referred to as the layer), is adsorbed onto the charged surface, proceeded by an exponentially decaying diffuse ionic cloud, in which ions are point charges in a continuous dielectric media. In this thesis, I will first illustrate how the assumption of a homogeneous ion lateral density in the Stern Layer fails to describe the actual solid-water interface of several relevant surfaces. Then I will show how the lateral organization of the ions indeed plays a role as important as the vertical modulation of the charge distribution. This is because the molecular nature of the ions, the surface, and the water molecules themselves each contribute to the precise lateral organization of the constituents. As result, the ions can reside on discrete surface sites, defined both laterally and vertically in space. Moreover, the water-mediated interaction can impart a correlation in the reciprocal lateral distribution of the ions. To achieve this level of description, high-resolution atomic force microscopy (AFM) is used. Unlike most of other experimental techniques, AFM is able to characterize interfaces locally at the atomic/molecular level. In fact, in the AFM small-amplitude regime, detection of even single ions adsorbed at the surface of the solid is possible by measuring the perturbation they induce on the local solvation environment. This capability represents an invaluable tool for the exploration of phenomena occurring at the Stern layer of solid-liquid interfaces. Following, I will investigate the properties of several solid-aqueous interfaces in the presence of different ionic concentrations and species, ranging from hard (mica) to soft systems such as organic self-assembled monolayers, lipid bilayers, and the dynamic surface restructuring of calcite when covered with fatty acid molecules. The experimental study, combined with molecular dynamic simulations, reveals a water-induced ion-ion attractive interaction for some ionic species. These results show that water alone is the driving force to induce order within the Stern layer, creating hydration-correlation effects on mica, self-assembled monolayers and possibly lipid bilayers. The local modulation of the hydration properties of the surface is fundamental to highly dynamic systems such as calcite, where steps act as nucleating points for the processes of dissolution and growth. The specific interaction of foreign ions and fatty acids modify these processes as well as the equilibrium between the crystal and the solution. This thesis provides clear experimental evidence of new mechanisms developing at solid-liquid interfaces paving the way for a deeper and more conscious understanding of the colloidal properties of materials.

Probing the interactions between collector molecules and hydrophobic graphite surfaces using chemical force microscopy

In Alzheimer disease, amyloid beta, a 39-43-residue peptide produced by cleavage from a large amyloid precursor protein, undergoes conformational change to form amyloid fibrils and deposits as senile amyloid plaques in the extracellular cerebral cortices of the brain. However, the mechanism of how the intrinsically linear amyloid fibrils form spherical senile plaques is unknown. With total internal reflection fluorescence microscopy combined with the use of thioflavin T, an amyloid-specific fluorescence dye, we succeeded in observing the formation of the senile plaque-like spherulitic structures with diameters of around 15 microm on the chemically modified quartz surface. Real-time observation at a single fibrillar level revealed that, in the absence of tight contact with the surface, the cooperative and radial growth of amyloid fibrils from the core leads to a huge spherulitic structure. The results suggest the underlying physicochemical mechanism of senile plaque formation, essential for obtaining insight into prevention of Alzheimer disease.

Contact between water droplets with hydrophobic surfaces is a common phenomenon at functional interfaces, and it has been extensively studied. However, quantifying the charge transfer between the liquid-solid interfacial contacting, especially for the charge density distribution throughout the movement of liquid droplet on a dielectric surface, remains to be investigated. Here, we developed a pixeled droplet triboelectric nanogenerator (pixeled droplet-TENG) array with high-density electrode array as a probe for measuring the charge transfer at a liquid-solid interface when a water drop moves on the hydrophobic surface. To intuitively observe the charge transfer between the liquid-solid interface, we "imaged" the transferred charges along movement trajectory of a water droplet as it slides along a tilted solid surface at a spatial resolution of 0.4 mm and time sensitivity of 0.02 s. Our study shows that the transferred charges are not uniformly distributed along the path, which is possibly due to the two-step model of electron transfer and ion adsorbed on the solid surface, and thus the formation of an electric double layer will inevitably shield the net surface on the solid surface. Our study presents a probe technology with potential applications in surface chemistry, physics, material science, and cell biology.

The use of nanobubbles, the common surfactant sodium dodecyl sulfate (SDS), and nanobubbles in combination with SDS as cleaning agents to remove lysozyme from the solid-liquid interface has been investigated using a quartz crystal microbalance on both hydrophobic and hydrophilic surfaces. On the hydrophobic surface, significant amounts of protein remained on the surface after 10 cycles of nanobubble treatment for 10 s periods in phosphate buffer. The cleaning efficiency of SDS was far superior and was shown to remove approximately 90% of the protein. The use of nanobubbles in combination with SDS failed to improve the cleaning efficiency further. On the other hand, lysozyme on the hydrophilic surface cannot be removed effectively by either 10 cycles of cleaning with nanobubbles or 10 cycles of cleaning with SDS. Nevertheless, the protein can be removed completely after 6 cycles of cleaning with nanobubbles in combination with SDS.

Smooth spherical micro glass particles are the reference particle system to demonstrate the correlation between single contacts and the particle packing properties. To investigate the influence of the van der Waals attraction force, the particles will be functionalized to obtain hydrophilic and hydrophobic surfaces. To remove the impurities and hydrophilize the particle surfaces a very strong oxidizing agent is used—the peroxymonosulfuric acid. In order to generate a hydrophobic glass surface, the process of silanization is applied. The comprehensive force displacement model of elastic-plastic and adhesive contacts are discussed. Therefore the model ‘stiff particles with soft contacts’ is used to quantify and compare the elastic-plastic contact properties. In this work, the particle contacts are experimentally investigated by means of atomic force microscopy (AFM), nanoindentation and shear tests. While the AFM and nanoindenter measurements are aimed to analyse single particle contacts, shear tests are used for particle packing studies. The fundamental challenge and question is addressed and answered: How do the micro mechanical material properties change when the glass surfaces are functionalized? Do we obtain the same behavior for the used micro glass particles when we compare the different methods?

Multiscale modeling and simulations of protein adsorption: progresses and perspectives

The interaction forces between layers of the triblock copolymer Pluronic F108 adsorbed onto hydrophobic radio frequency glow discharge (RFGD) thin film surfaces and hydrophilic silica, in polymer-free 0.15 M NaCl solution, have been measured using the atomic force microscope (AFM) colloid probe technique. Compression of Pluronic F108 layers adsorbed on the hydrophobic RFGD surfaces results in a purely repulsive force due to the steric overlap of the layers, the form of which suggests that the PEO chains adopt a brush conformation. Subsequent fitting of these data to the polymer brush models of Alexander-de Gennes and Milner, Witten, and Cates confirms that the adsorbed Pluronic F108 adsorbs onto hydrophobic surfaces as a polymer brush with a parabolic segment density profile. In comparison, the interaction between Pluronic F108 layers adsorbed on silica exhibits a long ranged shallow attractive force and a weaker steric repulsion. The attractive component is reasonably well described by van der Waals forces, but polymer bridging cannot be ruled out. The weaker steric component of the force suggests that the polymer is less densely packed on the surface and is less extended into solution, existing as polymeric isolated mushrooms. When the surfaces are driven together at high piezo ramp velocities, an additional repulsive force is measured, attributable to hydrodynamic drainage forces between the surfaces. In comparing theoretical predictions of the hydrodynamic force to the experimentally obtained data, agreement could only be obtained if the flow profile of the aqueous solution penetrated significantly into the polymer brush. This finding is in line with the theoretical predictions of Milner and provides further evidence that the segment density profile of the adsorbed polymer brush is parabolic. A velocity dependent additional stepped repulsive force, reminiscent of a solvation oscillatory force, is also observed when the adsorbed layers are compressed under high loads. This additional force is presumably a result of hindered drainage of water due to the presence of a high volume fraction of polymer chains between the surfaces.

Bacterial adhesion and colonization are complicated processes that depend on many factors, including surface chemistry, hydrophobicity, and surface roughness. The contribution of each of these factors has not been fully elucidated because most previous studies used different polymeric surfaces to achieve differences in properties. The objective of this study was to modify hydrophobicity and roughness on one polymeric surface, eliminating the confounding contribution of surface chemistry. Mechanically assembled monolayer (MAM) preparation methods (both one- and two-dimensional) were used to impart different degrees of hydrophobicity on fluoroalkylsilane (FAS)-coated silicone. Surface roughness was varied by casting the silicone to templates prepared with different abrasives. Surface hydrophobicity was determined by contact angle measurement, whereas surface roughness was determined by scanning electron microscopy (SEM) and atomic force microscopy (AFM). Bacterial adhesion and colonization were analyzed using a direct colony-counting method and SEM images. Hydrophobicity increased as a function of stretched length or width (Deltax or Deltay); it reached a maximum at Deltax = 60% with one-dimensional MAM and decreased as Deltax further increased to 80 and 100%. The same trend was observed for the two-dimensional MAM. After 12-h incubation, all the FAS/silicone surfaces had significantly reduced adherence of Staphylococcus epidermidis by 42-89%, compared to untreated silicone, and the degree of which is inversely related to surface hydrophobicity. On the other hand, surface roughness had a significant effect on bacterial adhesion and colonization only when the root-mean-square roughness was higher than 200 nm.

Electrowetting-induced microwater droplet detachment from hydrophobic surface has been studied numerically. The governing equations for transient microfluidic flow are solved by a finite volume scheme with a two-step projection method on a fixed computational domain. The free surface of the droplet is tracked by the volume-of-fluid method with the surface tension force determined by the continuum surface force (CSF) model. The static contact angle has been implemented using a wall-adhesion boundary condition at the solid–liquid interface, while the dynamic contact angle is computed assuming a fixed deflection from the static contact angle. The results of the numerical model have been validated with published experimental data and the physics of stretching, recoiling, and detachment of the droplet have been investigated. A parametric study has been performed in which the effects of droplet volume, voltage amplitude, and voltage pulse width have been examined.

Competitive protein adsorption studied with atomic force microscopy and imaging ellipsometry