Rate Maximization Using Cooperative Ratio Over Rayleigh Fading Channels

In this paper, we consider an amplify-and-forward wireless relay system where multiple source nodes communicate with their corresponding destination nodes with the help of relay nodes. Conventionally, each relay equally distributes the available resources to its relayed sources. This approach is clearly sub-optimal since each user experiences dissimilar channel conditions, and thus, demands different amount of allocated resources to meet its quality-of-service (QoS) request. Therefore, this paper presents novel power allocation schemes to i) maximize the minimum signal-to-noise ratio among all users; ii) minimize the maximum transmit power over all sources; iii) maximize the network throughput. Moreover, due to limited power, it may be impossible to satisfy the QoS requirement for every user. Consequently, an admission control algorithm should first be carried out to maximize the number of users possibly served. Then, optimal power allocation is performed. Although the joint optimal admission control and power allocation problem is combinatorially hard, we develop an effective heuristic algorithm with significantly reduced complexity. Even though theoretically sub-optimal, it performs remarkably well. The proposed power allocation problems are formulated using geometric programming (GP), a well-studied class of nonlinear and nonconvex optimization. Since a GP problem is readily transformed into an equivalent convex optimization problem, optimal solution can be obtained efficiently. Numerical results demonstrate the effectiveness of our proposed approach.

In this paper, we present a novel algorithm for partner selection and power allocation in the amplify-and-forward cooperative diversity that minimizes the required total transmit power by given outage probability constraint. We represent the problem with new formulation and solve the optimal power allocation by KKT method for a fixed set of partners. For optimal partner selection, we use a novel algorithm with low complexity to find the best set with minimum required power. We present simulation results to demonstrate that the outcomes of the proposed algorithm are very close to results of full search for optimal set.

This paper considers the wiretap channel in which a source node communicates with a destination node with the aid of a single helper and in the presence of an eavesdropper. The helper can apply either amplify-and-forward (AF) relaying or jamming. The secrecy capacity and respective optimal power allocation schemes at the source and the helper are investigated under both individual and joint power constraints. Given that the links among the nodes might not always be available for transmission (e.g., due to heavy shadowing), several network topologies are considered for relaying. To deal with the related nonconcave optimization problems in solving the optimal power allocation schemes, we first propose an analytical approach based on Descartes' rule of signs. Using this approach, optimal power allocation strategies are derived for some relay topologies and for the jamming system. Insights into the proposed schemes for different transmission power ranges and comparisons to the optimal information rate power allocations are also discussed. Simulation results are finally provided to quantify the optimality of the proposed schemes.

We consider the power and rate allocation for a transmission in a wireless network where the transmitter knows the channel state of the desired receiver but only knows the statistics of the interferes. While this scenario is often encountered in practice, and extremely important in dense networks, its optimal solution was not yet known. The analysis considers nodes that are distributed according to a homogeneous Poisson point process, and hence applies both to cellular and to ad‐hoc networks. We derive (for the first time) the optimal power allocation at a node, based only on the channel gain to its desired receiver. We also derive the optimal rate allocation in networks that are characterized by the outage rate model. Considering sub‐optimal allocations, we advocate the use of the simple threshold scheduling scheme for power allocation and linear rate adaptation for rate allocation. We prove that these suboptimal schemes are close to optimal, for any channel fading. We also present simulation results over Rayleigh fading channels that show a maximum loss of 1.5% between the advocated schemes and the optimal schemes.

Multi-hop cooperative MIMO network that consists of multiple nodes each equipped with single antenna is introduced and investigated. Optimal power allocation scheme with selective decode-and-forward (SDF) cooperative strategy is formulated and solved by means of optimization method with the purpose of minimization of system’s symbol error rate (SER), which are derived and analyzed with numerical results presented. Distributed space-time block Code (DSTBC) in multi-hop cooperative MIMO is analyzed and compared with optimal power allocation scheme with SDF strategy. Simulation results reveal that, cooperative diversity could be achieved with optimal power allocation. Optimum power allocation scheme depends on the relay’s position and channel quality between source to relay and relay to destination. Novel performance comparison between optimal power allocation and DSTBC are researched and presented. Simulation results confirm our theoretical analysis, which indicates that multi-node DSTBC outperforms optimal power allocation scheme due to the fact that cooperative diversity gain and coded gain could be obtained simultaneously for DSTBC in multi-hop cooperative MIMO network.

For data services over satellite networks, the efficient management of satellite downlink communication resources is crucial for economic competitiveness of the medium. To support a broad spectrum of users with small terminals at high rates, narrow transmit spotbeams on the satellite will be used. Since satellite transmitter resources are expensive and there can be many spotbeam-coverage cells within the satellite service area, it is attractive to use some form of agile scanning beam system and to time-share these precious resources. An optimized design of the multibeam antenna pattern and scheduling can further improve the efficiency of transmission and power management. In this paper, the advantage of parallel multibeams in terms of spectral efficiency and power gain is shown, and the issue of multibeam power allocation based on traffic demands and channel conditions over satellite downlinks with power and delay constraints is addressed. The study indicates that the use of a parallel multibeam scheme with optimum power allocation can achieve a substantial power gain and reasonable proportional fairness. By coupling power allocation with multibeam scheduling when the number of active beams is smaller than the number of cells, the authors show that a modest number of active parallel beams are sufficient to cover many cells efficiently.

Network coding can improve the information transmission rate, which is an effective technology to improve the performance of wireless relay network. Based on cooperative diversity and network coding, the paper propose a two-way communication system model of vehicle and study the three-slot amplification and forwarding network coding scheme with direct link. The optimal power allocation scheme is obtained by analyzing the optimal power allocation based on the system outage probability. We analyze the influence of distance, speed and time on the probability of interruption. Simulation results show that the power optimization scheme proposed in this paper can obtain a lower outage probability than the equal power allocation scheme.

Cooperative transmission is one of the promising techniques in wireless communication systems that enables the cooperating node in a wireless sensor network to share their radio resources by employing a distributed transmission and processing operation. This technique offers significant diversity gains as several cooperating nodes forward source node's data to the destination node over independently fading channels. The benefits offered by cooperative transmission can only be exploited fully if the power is allocated between source and cooperating nodes in an optimal manner instead of equal power allocation (EPA). Therefore, in this paper using moment generating function (MGF) approach a closed-form expression of probability of error has been derived for multi-hop cooperative network employing amplify-and-forward (AF) over rayleigh fading channel. Moreover, using two different network scenarios, optimal power allocation (OPA) scheme has been further investigated on the basis of channel link qualities between the communicating nodes. Numerical and simulation results validate the performance improvement of OPA over EPA and further the improvement due to relay location in the cooperative network.

Cognitive radio is able to share the spectrum with primary licensed user, which greatly improves the spectrum efficiency. We study the optimal power allocation for cognitive radio to maximize its ergodic capacity under interference outage constraint. An optimal power allocation scheme for the secondary user with complete channel state information is proposed and its approximation is presented in closed form in Rayleigh fading channels. When the complete channel state information is not available, a more practical transmitter-side joint access ratio and transmit power constraint is proposed. The new constraint guarantees the same impact on interference outage probability at primary user receiver. Both the optimal power allocation and transmit rate under the new constraint are presented in closed form. Simulation results evaluate the performance of proposed power allocation schemes and verify our analysis.

To improve the bandwidth efficiency, a semi-blind channel estimation method using data nulling superimposed pilots (DNSP) is designed for orthogonal frequency division multiplexing (OFDM) system without data rate loss. However, the data distortion is introduced by rank-deficient precoding. To minimize the data distortion, the optimal precoder is found to minimize the Euclidean distance between precoded sequence and source sequence. Further, the impact of power allocation between training sequence and data information on effective signal noise ratio (SNR) is analytically derived, effective SNR is found to be a quadratic function for the percentage allocated for training sequence, and the optimal power allocation is provided to maximize the effective SNR. Simulation results show that our optimal precoder design and power allocation scheme obtain the optimal performance of symbol detection.

We propose the Optimum Power Allocation (OPA) scheme for Distributed Antenna Systems(DAS) in the time-varying Rayleigh fading channel. Recently, the OPA schemes which uses the Channel State Information (CSI) including a small scale (fast) fading have been proposed. However, the channel is changing vary fast over time due to small scale fading, therefore Bit Error Rate (BER) increases. Because of this reason, we derive the OPA for minimizing BER in DAS, which only uses a large scale fading to CSI and excepts a small scale fading. The simulation results show that the proposed OPA achieves better BER performance than conventional OPA considering a small scale fading in time-varying Rayleigh fading channel, and also has similar performance in Rayleigh flat-fading environment. The BER performance of proposed OPA which derived in Rayleigh fading channel is similar to minimum BER of Ricean fading channel which has small Line-of-Sight (LOS).

In this paper, power allocation is done for source and relay terminal in a cooperative communication system based on the required Bit Error Rate (BER) at the destination node over Rayleigh Fading Channel. Power Allocation is done for both Amplify-and-Forward and Decode-and-Forward Relaying system using BPSK Modulation, and compared with direct transmission (DT) using QPSK modulation for fair comparisons. Total minimum power required by source and relay is plotted. Results can be compared with BER based power allocation done over AWGN channel to show the amount of increase in average power required over Rayleigh Fading channel.

<para xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> Although there has been a growing literature on cooperative diversity, the current literature is mainly limited to the Rayleigh fading channel model, which typically assumes a wireless communication scenario with a stationary base station antenna above rooftop level and a mobile station at street level. In this paper, we investigate cooperative diversity for intervehicular communication based on cascaded Nakagami fading. This channel model provides a realistic description of an intervehicular channel where two or more independent Nakagami fading processes are assumed to be generated by independent groups of scatterers around the two mobile terminals. We investigate the performance of amplify-and-forward relaying for an intervehicular cooperative scheme assisted by either a roadside access point or another vehicle that acts as a relay. Our diversity analysis reveals that the cooperative scheme is able to extract the full distributed spatial diversity. We further formulate a power-allocation problem for the considered scheme to optimize the power allocated to the broadcasting and relaying phases. Performance gains up to 3 dB are obtained through optimum power allocation, depending on the relay location. </para>

This paper presents an optimal energy-efficient power allocation scheme for a point-to-point multicarrier link over frequency-selective fading channel subject to a delay-outage probability constraint. For a target delay-outage limit, the energy efficiency (EE) objective function is formulated as the ratio of the achieved link effective capacity to the total expenditure power, expressed in units of b/J/Hz. We first prove that this objective function is quasi-concave in the transmission power, and, hence, the global maximum solution of the underlying optimization problem can be obtained using fractional programming. Subsequently, we develop a two-step optimal power allocation algorithm by first obtaining the average sum power level corresponding to the maximum achievable EE, followed by jointly distributing this obtained average power over time and frequency. Analytical results show that the EE-based power allocation has a structure similar to that of the QoS-driven spectral-efficient scheme, but with a different cut-off threshold below which no transmission power is allocated. Simulation results show that the proposed joint optimal power allocation scheme provides significant EE gains over the simple independent subcarrier optimization scheme, where these performance advantages become more pronounced with tighter delay constraints and in fading channels with more severe frequency selectivity.

Transmission collision is one of the main reasons of performance degradation in dense wireless sensor networks (WSNs). Transmission collision can cause throughput reduction, excessive delay and packet loss. One of the methods to minimize the probability of packet collision is the reduction of the collision area (area around sending nodes where collision may take place). In this study we investigate the problem of collision probability minimization through the use of cooperative transmissions and optimal power allocation in WSNs. We formulate the problem as a constrained optimization problem subject to an outage probability constraint. We determine the optimal transmission power of the source and the relay nodes which minimizes the collision area. Results show that the proposed technique significantly reduces the collision area while keeping the outage performance below the targeted value. Results also show that the proposed technique outperforms the direct transmission system as well as the cooperative system with equal transmission power.