Security aware hybrid precoding based peak‐to‐average power ratio reduction Approaches for telecommunication systems

In this paper, a novel scheme of the weighted distortion-to-signal ratio (WDSR) based partial transmit sequence (PTS) is proposed to enhance the bit error rate (BER) performance in nonlinear distorted orthogonal frequency-division multiplexing (OFDM) systems, and its key idea is to employ the WDSR metric to predict the nonlinear distortion caused by high power amplifier (HPA). Furthermore, several alternative signals can be generated by the PTS technique, and the signal with the minimum WDSR is selected as the transmitted OFDM signal. Since the WDSR metric predicts the nonlinear distortion of OFDM systems, the BER performance of nonlinear distorted OFDM systems can be significantly improved. Simulation results show that the proposed WDSR-PTS scheme offers better BER performance than the conventional peak-to-average power ratio (PAPR) based PTS scheme.

In this paper, we propose a new PAPR reduction by using a partial transmit sequences (PTS) method with coded side information (SI) technique. These methods are used in an orthogonal frequency division multiplexing (OFDM) system. The OFDM employs orthogonal sub-carriers for data modulation. These sub-carriers unexpectedly present a large peak to average power ratio (PAPR) in some cases. In order to reduce PAPR, the sequence of input data is partitioned into disjoint sub-block of PTS. If number of sub-block increases, high efficiency of PAPR reduction can be obtained. However, a quite large calculation cost must be demanded and thus it is impossible to obtain the optimum PTS. In the proposed method, we introduce a coded side information technique assuming the pseudo-optimum condition into the PTS. The total calculation cost becomes drastically reduced and side information bits for recovering original data in demodulation. In simulation results, the proposed method demonstrated the improvement of PAPR and bit error rate (BER) performance.

High Peak to Average Power Ratio (PAPR) in the transmitted signal is still a very important challenge in Orthogonal Frequency Division Multiplexing (OFDM) systems. In this paper, we present a new Zadoff-Chu matrix Transform (ZCT) precoded Selected Mapping (SLM) based OFDM (SLM-OFDM) system for PAPR reduction. The proposed system is based on precoding the constellation symbols with ZCT precoder after the multiplication of phase rotation factor and before the Inverse Fast Fourier Transform (IFFT) in SLM-OFDM Systems. At the clipping probability of 10−3, simulation results show that our proposed system can reduce the PAPR up to 5.0 dB with N=64 (System subcarriers) and V=16 (Dissimilar phase sequences) for QPSK modulation. Additionally, ZCT based SLM-OFDM systems also take advantage of frequency variations of the communication channel and can also offer substantial performance gain in fading multipath channels.

The technology has been growing rapidly in the form of portable wireless devices that can perform multiple functions to cope with the state-of-the-art technology and synchronization. A total device capacity must be increased to accommodate new wireless applications. This can be achieved by leveraging new technologies, with higher data rates. Spectrum pooling has gained immense popularity, with increased demand for frequency range and bandwidth availability constraints. Statistics suggest that much of the spectrum licensed is not used all the time. Because of the transmitter's nonlinearity nature, the large (peak to average power ratio (PAPR)) phenomenon is a drawback in orthogonal frequency division multiplexing (OFDM). Several hybrid approaches have recently been implemented to minimize PAPR's high value, at the expense of increasing the level of computational complexity in the system. In this paper, a new hybrid approach has been introduced in parallel to combine the selective mapping approach (SLM) with the partial transmit sequence (PTS) approach to improve the efficiency of PAPR reduction with lower numerical method complexity. The findings reveal that the OFDM systems with the proposed hybrid approach have better efficiency in terms of PAPR elimination, side-information, and computational complexity compared to current hybrid methods. Also, a hybrid approach proposed output could be maintained without degradation. Index Terms: OFDM, PTS, PAPR, SLM

This article presents a novel peak-to-average power ratio (PAPR) reduction scheme based on the insertion of dummy random Gaussian (IDRG) subcarriers to the data constellation points in the frequency domain integrated with a partial transmit sequence (PTS) technique. The dummy signals are Gaussian random signals which have the same statistical distribution as that of the output signals of the conventional orthogonal frequency division multiplexing (OFDM) system. The integration of IDRG with PTS technique reduces the overall complexity of the OFDM system. Compared to the conventional PTS which requires several inverse fast Fourier transform (IFFT) operations, the proposed IDRG–PTS scheme requires only half as many IFFT operations with comparable PAPR performance. Simulation results have been examined with 16 quadrate amplitude modulation OFDM signals.

In this paper, we propose a genetic-simulated annealing algorithm (GSAA) with partial transmit sequence (PTS) technique (GSAA-PTS) to reduce the peak-to-average power ratio (PAPR) for orthogonal frequency division multiplexing (OFDM) system. Genetic algorithm based PTS method (GA-PTS) is a novel and suboptimal PAPR reduction approach, which has lower computational load than original PTS method. However, researchers still focus on how to improve the PAPR performance. The proposed method GSAA-PTS takes the advantages of genetic algorithm and simulated annealing algorithm to search the best phase factors of PTS. In this method, we initialize the population firstly, and then selection, crossover and mutation are used to generate the new population, finally using the simulated annealing algorithm to update each chromosome in the population. The simulation results show that the better performance of PAPR have been achieved by adopting GSAA-PTS scheme.

OFDM (Orthogonal Frequency Division Multiplexing) 시스템에서 SLM (Selected Mapping)은 전송신호의 왜곡 없이 PAPR (Peak-to-Average Power Ratio)을 효율적으로 줄일 수 있는 기법이다. 하지만, 충분한 후보 OFDM 신호를 생성하기 위해서는 많은 양의 IFFT (Inverse Fast Fourier Transform) 연산을 필요로 하고, 이는 SLM 기법을 매우 복잡하게 만든다. 따라서 본 논문에서는 첫 번째 후보 OFDM 신호를 변환하여 나머지 IFFT 연산들을 대체하는 새로운 SLM 기법을 제안한다. 제안된 기법은 기존의 SLM 기법과 비교하여 거의 같은 PAPR 저감 성능을 보임과 동시에 계산 복잡도는 크게 감소 시킬 수 있다. SLM (Selected Mapping) is an efficient PAPR (Peak-to-Average Power Ratio) reduction scheme without transmitted signal distortion in OFDM (Orthogonal Frequency Division Multiplexing) systems. However, enormous IFFTs (Inverse Fast Fourier Transforms) are needed to generate sufficient candidate OFDM signals, which cause the SLM to become quite complex. In this paper, we propose a new SLM scheme that replaces the IFFT operations with a conversion of the first candidate OFDM signal. The proposed scheme significantly reduces computational complexity, while it shows almost the same PAPR performance as the conventional SLM scheme.

A three-dimensional (3D) orthogonal frequency division multiplexing (OFDM) system with peak-to-average power ratio (PAPR) reduction method for the wireless sensor networks (WSNs) is presented. The transmit power of wireless nodes in an ad hoc network is strictly limited. Thus, high PAPR of the 3D OFDM system is a possible drawback when it is considered as a physical layer transmission scheme for the WSNs. Here, we propose an improved partial transmit sequence (PTS) technique to reduce PAPR of the OFDM system with 3D modulation formats. In the proposed algorithm, the components of 3D signals are assigned to different subblocks using a diagonal rule (DR), increasing randomness of the signals in the disjoint subblocks forcibly. As a result, the proposed method reduces PAPR of the 3D OFDM system significantly without increase in computational complexity. Hence, the proposed algorithm makes the 3D OFDM system be a possible candidate for a physical layer transmission scheme in future WSNs.

In response to the inefficiency of power amplifier in conventional Orthogonal Frequency Division Multiplexing (OFDM) system, a low Peak-to-Average Power Ratio (PAPR) scenario can be obtained by implementing several PAPR reduction techniques. Partial Transmit Sequence (PTS) is a well-known instance to provide zero distortion for the system, while clipping is one of the simplest methods but it is sacrificing the error rate performance. In this work, Authors focused on analyzing the implementation of PTS and Palm Date Leaf clipping technique on OFDM system with 16-, 64-, 256-, and 1024-QAM under various Nakagami channel. In addition, the High-Power Amplifier (HPA) was also considered by using Solid State Power Amplifier (SSPA) model. It was found that linear HPA serves as the lower boundary for non-linear HPA, and system under high saturation level performs similarly. In physical properties, high saturation level is equivalent to higher power consumption in amplifier. Thus, optimal level was obtained by considering taking the one with moderate BER performance. After the system’s PAPR was reduced, the optimum saturation level of HPA was found to be 5 dB, 8 dB, 9 dB, and 11 dB for each Quadrature Amplitude Modulation (QAM) under Nakagami channel with m value of 1.5. However, this value was found to be ample for lower m value such as 1 or 0.7. In this case, the system required lower saturation level on the HPA for Nakagami channel with lower m value.

Orthogonal frequency division multiplexing (OFDM) system has been widely used for the high speed digital communication area and it is very promising for the next generation communication standard because of high data rate capability. However, OFDM system has inherent serious problem of high peak-to-average power ratio (PAPR) that makes the OFDM signal be distorted in the nonlinear HPA (high power amplifier). In this paper, CI (carrier interferometry)-OFDM system is considered to overcome this problem and is newly analyzed in the selective fading and narrow-band interference channel. CI-OFDM system distributes each parallel data to all sub-carriers in differently phase-rotated form. So, PAPR becomes lowered and it shows the frequency diversity effects. BER (bit error rate) performance is analyzed in the selective fading and narrow-band interference environment. From the simulation results, it is confirmed that CI-OFDM system calms down the high PAPR problem and CI-OFDM system is more robust than the ordinary OFDM system in the selective fading and narrow-band interference channel.

Orthogonal Frequency Division Multiplexing (OFDM) is typically a system used in encoding digital data. It has huge benefits among which primary are high spectral efficiency upon Inter Symbol Interference (ISI) and robustness. It also has some drawbacks, the main hitch in OFDM system is High Peak to Average Power Ratio (PAPR). In order to minimize PAPR, many techniques are available among which some common and efficient are Partial Transmit Sequence (PTS), Selected Mapping (SLM), Coding, Interleaving, Companding, Peak windowing, Peak reduction, Envelope Scaling. Every method has both edge and snag. The simplest is clipping. There are also some complex techniques like PTS, SLM. In this paper the proposed method is a hybrid combination of Repeated Frequency Domain Filtering and Clipping (RFDFC) and Absolute Exponential Companding (AEC). This method not only bring PAPR to 3.5 dB as compared to 10.5 dB in original, but is also easy to implement.

This paper proposes a partial transmit sequence (PTS) scheme with applying a stochastic optimization technique for peak-to-average power ratio (PAPR) reduction in the orthogonal frequency division multiplexing (OFDM) system. PTS technique combining can improve the PAPR statistics of an OFDM signals, but the considerable computational complexity for the required search through a high-dimensional vector space is a potential problem for implementation in the practical systems. Differential evolution (DE) is an efficient and powerful population-based stochastic search technique for solving optimization problems over continuous space, which has been widely applied in many scientific and engineering fields. Thus, to reduce the complexity for searching phase weight vector and to improve the PAPR statistics, we introduce the DE, an effective algorithm that solves various combinatorial optimization problems, to search the optimal phase weight factors. The simulation results show that the proposed DE-based PTS obtains the excellent PAPR performance with a low computational complexity.

Based on superposition of signals in the time domain, we propose a new low-complexity scheme for the reduction of the peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. The proposed scheme first generates signal candidates by combining an OFDM signal and its cyclically delayed versions with different delays and phases, and then selects the candidate signal with minimum PAPR. It is shown that the complexity of the proposed scheme is significantly lower than that of the selective mapping (SLM) at the cost of some degradation in the bit error rate (BER) performance and, at similar PAPR and coded BER performance, is lower than that of the low-complexity SLM proposed recently.

OFDM (orthogonal frequency division multiplexing) is widely used in 4th generation applications owing to its robustness in fading environments. The major issues with OFDM systems is the high PAPR (peak-to-average power ratio) of the transmitted signals, it leads to in and out of band distortion. SLM (selective mapping) and PTS (partial transmit sequence) are two key methods for PAPR reduction. Both the methods require exhaustive searching of phase factors to optimize the PAPR, these searches lead to high computational complexity. This paper discusses using optimization based PAPR reduction methods which an be used with PTS for the reduction of computational complexity and search space. In this paper we have analyzed PTS and SLM with particle swarm optimization (PSO), Artificial Bee Colony (ABC) and differential evolution (DE). PAPR and BER (bit error rate) comparison is done for both the cases.

Orthogonal frequency division multiplexing (OFDM) is the advanced transmission scheme utilized in 4G. Nevertheless, it has several shortcomings like guard band, peak-to-average power ratio (PAPR), high power consumption, incapable to accommodate various other devices (an IOT application). Hence, OFDM cannot be considered in 5G due to the several disadvantages mentioned above. Filter bank multi-carrier (FBMC) is believed to be one of the most promising technologies which can be used in 5G. FBMC and OFDM are multi-carrier system. It is obvious that it agonizes from PAPR which hamper the efficiency of the system. The conventional peak reduction methods utilized in OFDM cannot be used in FBMC due to the overlapping structure of FBMC. In this work, a novel selective mapping (SLM) and partial transmit sequence (PTS) PAPR reduction technique is suggested for FBMC. The proposed techniques are implemented by using an elementary successive optimization technique that upsurge the PAPR performance and ensure the design difficulty is taken low. PAPR and bit error rate (BER) parameters are analyzed and simulated for the proposed and conventional PAPR reduction techniques. The simulation results show that the SLM and PTS accomplished an excellent PAPR reduction up to 2.8 and 4.8 dB as compared to other peak power minimization techniques.