- Research Article
- 10.1149/ma2025-031122mtgabs
Co-Electrolysis of Steam and Carbon Dioxide in Solid Oxide Electrolysis Cell Under Pressurized Conditions for Fischer-Tropsch Synthesis
- Nov 24, 2025
- Electrochemical Society Meeting Abstracts
- Takumi Imabayashi + 3 more +3
OutlineSOEC (Solid Oxide Electrolysis Cell) in the co-electrolysis of H2O and CO2 can produce syngas and, when integrated with Fischer-Tropsch (FT) synthesis, liquid fuel can be obtained in a clean and efficient process. Pressurizing SOEC in co-electrolysis can potentially enhance SOEC performance and improve efficiency in an integrated process with FT synthesis. However, pressurizing SOEC may lead to issues such as carbon deposition in the fuel electrode, which can damage the electrode microstructure, and the undesired promotion of methanation reaction. In this study, SOEC operating conditions which prevent these problems were determined by thermodynamic equilibrium calculations under pressurized conditions. In addition, the performance of the SOEC single cells, including the gas manifold and end separator, which are the same as those in a stack, was evaluated under pressurized conditions to examine the performance factors of the SOEC.Thermodynamic equilibrium calculationIn this study, the water gas shift reaction and methanation reaction were only considered in the thermodynamic equilibrium calculations of the gas composition in SOEC. In fact, the outlet gas composition at the fuel electrode was analyzed experimentally, and it was confirmed that it was almost at equilibrium. Therefore, the outlet gas composition was assumed to be in thermodynamic equilibrium. In this calculation, it was considered that carbon deposition occurred when the calculated pressure equilibrium constants of Boudouard reaction (Kb) from the equilibrium gas composition were smaller than the calculated Kb from thermodynamic parameters.Water-gas shift reaction: CO2+H2=CO+H2O, Kw = [CO]×[H2O] / ([CO2]×[H2])Methanation reaction: CO+3H2=CH4+H2O, Km = [CH4]×[H2O] / ([CO]×[H2]3×P 2)Boudouard reaction: 2CO=C+CO2, Kb = [CO2] / ([CO]2×P)K: pressure equilibrium constant, P: gas pressurePerformance evaluation methodTo examine the performance factors of SOEC, the performance evaluation method of SOEC has been already developed based on Eq. (1)-(4) in Central Research Institute of Electric Power Industry (CRIEPI)[1]. Eq. (2) can be applied in the region of the linear relationship in the current-voltage (IV) characteristics under a constant gas utilization rate, as shown in Fig. 1. In Eq. (3), the fuel electrode reaction resistance depends on the partial pressures of hydrogen and steam in the fuel electrode. These partial pressures were calculated by assuming the equilibrium between the water-gas shift reaction and methanation reaction. V = E +η ne+η ir+η f+η o (1)≈ E +η ne+ (R ir+ R f+ R o) × J (2) R f = f 0 × P H2 α × P H2O β (3) R o = o 0 × P O2 γ (4) V: cell voltage, E: OCV, η ne: Nernst loss, η ir: internal resistance loss, η f, η o: fuel, oxygen electrode overvoltage, R ir: internal resistance, R f, R o: reaction resistance at fuel, oxygen electrode, J: current density, f 0,o 0: resistance parameter, P i: gas partial pressure of “i”, α, β, and γ: degree of gas partial pressureThe values of α, β, and γ were determined by obtaining the gas partial pressure dependencies. These values change depending on the cell specifications but do not change with the cell degradation. To evaluate the SOEC performance, it is necessary to measure the cell voltages under approximately ten different conditions, including variations in the inlet gas composition at the fuel electrode, reactant gas utilization (U re) at the fuel electrode, and inlet gas composition at the oxygen electrode. The R ir was measured using electrochemical impedance spectroscopy (EIS). The R ir value is defined as the intersection of the real axis and the measurement result of the highest-frequency side in the Cole-Cole plot. Performance was evaluated by calculating the current density and gas partial pressure distribution in the cell based on the measured values.Results and discussionThe following criteria were used in this study to determine the SOEC operating conditions: Gas compositions in SOEC outlet were H2/CO≈2.0 (for FT synthesis)High yield of H2 and CO (for FT synthesis)Low methane formation (for FT synthesis)No carbon deposition in SOEC (for SOEC) From these criteria and the results of the thermodynamic equilibrium calculations, the SOEC operating conditions in this study were determined as follows: Fuel inlet gas composition: H2O/CO2/H2 = 56.7/33.3/10% ((H2+H2O)/CO2=2.0) U re at the fuel electrode: 70%Operating temperature: 750-800 ˚C The SOEC performance under various pressures based on the determined operating conditions was evaluated using the performance evaluation method. The results indicated that the open-circuit voltages under pressurized conditions increased but the fuel electrode overvoltage and oxygen electrode overvoltage decreased under the same conditions. It was revealed that SOEC performance was also improved under pressurized conditions, which is favorable for SOEC and FT synthesis.These results of this study suggest that the efficiency of the integrated SOEC and FT synthesis processes can potentially be enhanced under pressurized conditions.AcknowledgementThis work is based on results obtained from project, JPNP16002, commissioned by the New Energy and Industrial Technology Development Organization (NEDO).
Read more