Simulation research on direct sequence spread spectrum communication system over Rayleigh Fading Channels

Deployment of wireless sensor networks (WSNs) with a large number of nodes have reinstated interest in spread spectrum (SS) technologies as they allow to establish multiple access for nodes with simple hardware and limited power budget. Chaotic spreading is one of the still insufficiently explored areas which can lead to higher security and lower multiple access interference (MAI). This research is intended to bring new information about the performance of binary direct sequence spread spectrum (DSSS) and frequency hopping spread spectrum (FHSS) communication systems which employ chaos-based spreading codes and compare them against classical systems employing m-sequences. Unlike existing research, this investigation is based on the simulation of passband communication systems with up/down-conversion and respective filtering. Performance comparison in terms of bit error ratio (BER) versus signal-to-noise ratio (SNR) at the different number of users and MAI dependence on carrier frequency offset among users in case of additive white Gaussian noise (AWGN) channel are presented. Obtained results highlight several scenarios where chaotic-sequences-based binary DSSS and FHSS systems have advantages over classical solutions.

The performance of anti narrowband noise of direct sequence spread spectrum (DSSS) communication system is investigated in this paper. The new result given in the paper shows that performance of anti noise in DSSS system is different from classic result. The attenuation of narrowband noise in DSSS system is the function of the relative distance between the narrowband noise and carrier frequency of DSSS system, and it is discontinuous. The attenuation of broadband noise is little, and the process gain is about 0.46dB. The results can be utilized in design and application of spread spectrum system.

Clock and carrier recovery are very critical in high speed digital wireless communication for achieving high data rate with low packet error rate. In this paper, we propose a linear estimator for both clock and carrier recovery in a direct sequence spread spectrum (DSSS) communication system and show that this is also the maximum likelihood (ML) estimator. We present simulation results to illustrate the convergence of the estimator under different multipath channel conditions.

To address the inability to quantitatively analyze the performance of the direct sequence spread spectrum (DSSS) communication system in the presence of short-period pseudo-noise (PN) sequences, this study derives the interference components resulting from correlation processing of single-frequency interference. Given the short period of the spread spectrum sequence used in underwater acoustic systems, a theoretical expression is proposed for analyzing the anti-single-frequency interference performance of DSSS communication systems in underwater acoustics. This expression combines the interference power output by the system to enable quantitative analysis. Simulations are conducted to validate the accuracy of the theoretical expression. The results reveal that the interference sequence generated by correlation processing assumes either a direct current (DC) or sinusoidal distribution. The bit error rate (BER) of the system is influenced by signal-to-interference ratio (SIR), interference frequency offset, phase deviation, and the structure of the spreading code itself. The BER exhibits regular variation with changes in the interference phase. In all working conditions where the interference frequency offset is an integer multiple of the bit bandwidth, single-frequency interference with a frequency offset equivalent to the bit bandwidth has the greatest impact on the system. The concise theoretical expression presented in this study has significant practical value as it allows for quick prediction of variation in the anti-single-frequency interference performance of underwater acoustic DSSS communication systems using short-period PN sequences.

A novel method of multipath diversity signal combination is proposed for mobile direct sequence spread spectrum (DS-SS) communications. Multiple transmissions are made for each spread signal. Each transmission is independently delayed and amplified in the complex domain according to the delay profile and the estimated path strength of the channel. This is done to facilitate reception of a signal at the mobile unit which is already a RAKE combination of the multipath signals. This method is called a pre-RAKE combination system because the RAKE combination function is performed pre-transmission. Using this method the size and complexity of the mobile unit can be kept to a minimum. The pre-RAKE method retains the advantages of diversity reception in a multi-path fading environment. An examination of the SNR for the traditional RAKE and the pre-RAKE systems and computer simulations show that the performance of the pre-RAKE system is equivalent to that of the RAKE system. >

This paper proposes an algorithm that improves the mean code acquisition time using an energy estimation mode (EEM) and dwell time values from direct-sequence spread spectrum (DS-SS) System. Until recently, DS-SS System has been used in many areas from Wireless LAN, cellular phone, and GPS to telecommunication. Meanwhile, the development of reducing of pseudonoise (PN) code acquisition time, the core technique of DS-SS system, is continuously explored. The algorithm in this paper added the EEM before a search mode (SM) from the conventional PN code acquisition system, which is composed of a SM and a verification mode (VM). In the EEM, dwell time and threshold values are determined for use in the SM and the VM depending on the correlation energy. This paper applies the proposed technique under Rayleigh-fading channel in performing a simulation of PN code acquisition time by a mathematical modeling to evaluate the proposed algorithm. Numerical results show that the proposed method improves the detection performance and the rejection performance of false code phases not only in the VM but also in the SM. Furthermore, the proposed algorithm reduces the mean code acquisition time by maximum 29% than the conventional algorithm.

This study introduces the group delay and its characteristics in satellite channel, meanwhile, the model of the impact of group delay ripple on performance of direct sequence spread spectrum communication system is established and simulated for analysis. The simulation results indicate the specific impact of group delay ripple on system, as well as the impact of group delay ripple on the transmission and reception signals in the spread spectrum communication system. For transmission signals in the spread spectrum system, the group delay ripple can worsen the EVM and Eye-diagram of spread spectrum signal, cause signal distortion and the deterioration of noise tolerance. For the reception performance of the spread spectrum system, the group delay ripple has little effect on the spread spectrum acquisition using incoherent accumulation and energy judgment, but it can cause a deterioration in the error performance of the reception signal. For example, when relative group delay increases from 0.011 to 0.9, the error performance decreases by about 2 dB. When designing satellite spread spectrum communication systems, power resources are extremely precious, it is necessary to consider the impact of group delay on the communication system, and take certain measures to reduce the impact of group delay ripple to the system.

This paper presents performance evaluation and comparison analysis of Direct Sequence Spread Spectrum (DSSS) and Frequency Hopping Spread Spectrum (FHSS) systems. The evaluation and analysis are done based on the systems performance against wideband interferences. The interferences are signals with similar spectrum characteristic to the transmitted signals of DSSS and FHSS systems. Bit Error Ratio (BER) is used as evaluation parameter to assess the performance of both systems. Simulation and mathematical analysis are performed to test and verify the performance of both systems. Mathematical analysis also verifies that increasing Spreading Frequency on certain conditions will reduce the BER. This research also points out that FHSS system has a better performance compared to DSSS system indicated by smaller BER.

Direct sequence spread spectrum (DSSS) communication has been extensively adopted in military and civilian fields because of its high processing gain, anti-jamming capability and low probability of interception (LPI). In this paper, non-cooperative interception of DSSS signal in multiple signals environment is presented. The proposed algorithm is based on the fluctuations of autocorrelation, and also banks upon proper thresholding criteria. This methodology comes out to be a robust practical method for blind detection of DSSS signals in a dense multiple signals environment. In the proposed approach, firstly DSSS signals are blindly detected by leveraging the variations in autocorrelation of the received signal. Then, the presence of desired DSSS signal is confirmed when correlation peaks cross the threshold at multiple positions after a fixed period. In a real-time environment, signals other than spread spectrum with much better signal-to-noise ratio (SNR) can also co-exist. Among these multiple signals, the high SNR signals disturb the threshold selection criteria for detection. Consequently, this leads to erroneous or miss detection of the DSSS signal. The proposed scheme aims to reduce the effect of better SNR signals on the blind detection of DSSS signal. In order to validate the proposed algorithm, QPSK and 16-QAM signals are considered to co-exist with the desired DSSS signal. Analytical and numerical analysis signify the efficiency of the proposed algorithm with acceptable computational complexity, making it suitable for real-time practical systems.

In an effort to transmit information over communication channels that contain both Gaussian and non-Gaussian noise components, military and commercial applications frequently rely upon the use of direct sequence spread spectrum (DSSS) techniques. Whilst DSSS is an interference tolerant modulation scheme, situations may be encountered when the processing gain offered by the pseudonoise (PN) spreading code is inadequate. Enhancements to the interference immunity of a DSSS system can be accomplished through the use of signal processing techniques that suppress unwanted interference prior to despreading. To date, the majority of interference suppression techniques developed for DSSS applications, have concentrated on improving detector performance exclusively, and perfect synchronisation between transmitter and receiver is assumed. However, the process of PN code acquisition and tracking within a DSSS receiver is arguably one of the most critical functions within the receiver structure since, if it fails to operate correctly, the wanted signal will not be successfully recovered. An evaluation of the benefits of any interference suppression technique within a DSSS receiver would not be complete without considering at least one level within the synchronisation hierarchy. We examine the improvements in receiver performance, when the process of PN code tracking and detection employs a novel wavelet packet denoising (WPD) procedure for a variety of non-Gaussian channel scenarios.

Performance of a direct sequence spread spectrum communication system operating in an impulsive noise and multipath channel is evaluated using computer simulation techniques. The results indicate that the direct sequence spread spectrum receiver tends to convert the block error pattern in to random error pattern and further application of convolutional coding with Viterbi decoding gives substantial improvement in performance. Balanced Gold codes are found to perform better than Gold codes and m-sequences.

The direct sequence (DS) spread spectrum communication technique is widely regarded as one of the most effective methods of mitigating the effects of a repeating jammer in military communications systems. The proposed system coupled DS with multiple frequency shift keying (DS/MFSK). It is comprised of a transmitter and a receiver. Non-coherent demodulation is examined, as are the spreading sequences in question. The effect of AWGN and Rayleigh fading channels on the proposed approach's bit error rate (BER) is examined. The investigation demonstrates that even with an 8 dB signal-to-noise ratio, superior outcomes can be achieved; this study's suggested endeavor is to create a novel transceiver system built on the DS/MFSK modular architecture. MFSK modulation prevents multiple-access interference, while DS is typically employed to boost system efficiency across erratic fading. Test results show that reliability on the AWGN channel decreases a little while reliability is greatly enhanced by Rayleigh fading. Moreover, notable improvements in bandwidth efficiency are achieved.

The performance of a direct sequence spread spectrum (DS/SS) communication system in land mobile satellite channels is evaluated with experiments. Field test results in the L-band with the ETS-V satellite are presented, in which the use of a multibit-quantized coherent matched filter receiver improves the initial acquisition and the bit error rate performances. The bit error rate characteristics in urban and suburban environments are found to agree with those of non-SS BPSK (binary phase-shift keyed) on a nonselective Rician fading channel.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>

At the transmitter of a Direct Sequence Spread Spectrum (DSSS) communication system, data bits are spread using a spreading sequence. To demodulate the transmitted data bits, the received signal should be de-spread using the same spreading sequence. However, there are many non-cooperative communication systems, where a receiver does not have the information on the spreading sequence. In such systems, to demodulate the transmitted data bits across a wide area, it is necessary to blindly estimate the spreading sequence at low Signal-to-Noise Ratio (SNR). Furthermore, for real-time processing, the computational complexity for the blind estimation should be minimized. In this paper, a novel algorithm is proposed to blindly estimate a spreading sequence and data bits based on turbo processing for both synchronous and asynchronous cases. The proposed algorithm can significantly improve the error rates of estimated data bits and the chips in the spreading sequence compared to an Eigen-Value Decomposition (EVD) based algorithm. Furthermore, compared to the EVD-based algorithm, the proposed algorithm drastically reduces the number of required multiplications.

The effects of filtering in transmitters on the bit error performance of a binary asynchronous direct sequence spread spectrum communication system are examined in a multiple access environment. Computer simulations are carried out to evaluate the effects of non-linear phase Chebyshev and Butterworth filters and linear phase Bessel, Gauss and Nyquist roll-off filters. The performance degradation of the system is compared and discussed in terms of the BT product of the filter or the transmitted spectrum. >