Symbiotic organisms search algorithm for optimal power flow problem based on valve-point effect and prohibited zones

This paper investigates potential of modified differential evolution (MDE) algorithm, to find solution for optimal power flow (OPF) problem of power system. The performance of the proposed MDE algorithm is experienced on the modified IEEE-30 bus test systems integrating flexible ac transmission systems (FACTS) devices, that is, thyristor controlled phase shifter (TCPS) and thyristor controlled series capacitor (TCSC) at preset locations. The OPF problem of the present work is formulated with five different objective functions viz. (a) fuel cost (with valve point effect) minimization, (b) power transmission losses minimization, (c) emission reduction (d) fuel cost (without valve point effect) minimization and (e) minimization of combined economic and environmental cost. The proposed implementation exploits MDE, resulting in a much shorter execution time while retaining the best possible solution of OPF problem.

This chapter proposes a newly improved particle swarm optimization (IPSO) method for solving optimal power flow (OPF) problem. The proposed IPSO is the particle swarm optimization with constriction factor and the particle’s velocity guided by a pseudo-gradient. The pseudo-gradient is to determine the direction for the particles so that they can quickly move to optimal solution. The proposed method has been tested on benchmark functions, the IEEE 14-bus, IEEE 30-bus, IEEE 57-bus, and IEEE-118 bus systems, in which the IEEE 30-bus system is tested with different objective functions including quadratic function, valve point effects, and multiple fuels. The test results have shown that the proposed method can efficiently obtain better total costs than the conventional PSO method. Therefore, the proposed IPSO could be a useful method for implementation in the OPF problem.

The optimal power flow (OPF) problem is a well-known non-convex optimization problem that aims to minimize the cost of electric power generation subject to consumer demand, the physics of power flow, and technological constraints. To find an optimal solution to this problem, local search techniques such as interior point methods are typically used. However, due to the non-convex nature of the problem, these methods are likely to result in a sub-optimal solution. The goal of this paper is to characterize the worst-case performance of local search on the OPF problem. To accomplish this, we formulate the OPF problem as a canonical quadratically-constrained quadratic program (QCQP). Then, we study the problem of finding the worst-case local minimum of this QCQP, which is non-convex and hard to solve in general. We find a relaxation of this problem into a semidefinite program (SDP) and show that it is exact for certain cases. Using some test cases which are known to have multiple local minima, we demonstrate the effectiveness of the proposed relaxation to bound the worst-case local minimum. We compare the obtained upper bound on local minima to the lower bound provided by the standard SDP relaxation of the OPF problem to understand how much SDP outperforms local search for a given problem.

Summary This paper presents a creature-inspired stud krill herd (SKH) algorithm consisting of stud selection and crossover operators, which are augmented in the krill herd algorithm to solve the optimal power flow (OPF) problems in a power system. Due to the nonlinear and nonconvex nature of the OPF problem, it is quite difficult to find optimal solution using conventional optimization algorithms. Here in SKH, a stud-selection operator is introduced in the krill herd algorithm to further enhance the quality of the solution, and crossover operator is embedded to avoid premature convergence. To investigate the performance, the proposed SKH algorithm has been demonstrated on the OPF problems of IEEE 30-bus, Algerian 59-bus, and IEEE 118-bus systems considering various objective functions such as total production cost, L-index, power loss, and emission pollution to be minimized. The OPF results have been compared with those obtained with other methods, and it has been found that SKH algorithm is successful in providing better quality solutions in reasonable execution times.

Recent years have witnessed the success of employing convex relaxations of the AC optimal power flow (OPF) problem to find global or near-global optimal solutions. The majority of the effort has focused on solving problem formulations where variables live in continuous spaces. Our focus here is in the extension of these results to the co-optimization of network topology and the OPF problem. We employ binary variables to model topology reconfiguration in the standard semidefinite programming (SDP) formulation of the OPF problem. This makes the problem non-convex, not only because the variables are binary, but also because of the presence of bilinear products between the binary and other continuous variables. Our proposed convex relaxation to this problem incorporates the bilinear terms in a novel way that improves over the commonly used McCormick approximation. We also address the exponential complexity associated with the discrete variables by partitioning the network graph in a way that minimizes the impact on the optimal value of the relaxation. As a result, the problem is broken down into several parallel mixed-integer problems, reducing the overall computational complexity. Simulations in the IEEE 118-bus test case demonstrate that our approach converges to solutions which are very close to the lower bound of the mixed-integer OPF problem.

For operating electrical power networks, the Optimal Power Flow (OPF) problem plays a central role. The problem is nonconvex and NP hard. Therefore, designing efficient solution algorithms is crucial, though their global optimality is not guaranteed. Existing semi-definite programming relaxation based approaches are restricted to OPF problems for which zero duality holds, whereas for non-convex problems there is a lack of solution methods of provable performance. In this paper, an efficient novel method to address the general nonconvex OPF problem is investigated. The proposed method is based on alternating direction method of multipliers combined with sequential convex approximations. The global OPF problem is decomposed into smaller problems associated to each bus of the network, the solutions of which are coordinated via a light communication protocol. Therefore, the proposed method is highly scalable. The convergence properties of the proposed algorithm are mathematically and numerically substantiated.

The optimal power flow (OPF) problem minimizes the operating cost of an electric power system. Applications of convex relaxation techniques to the non-convex OPF problem have been of recent interest, including work using the Lasserre hierarchy of "moment" relaxations to globally solve many OPF problems. By preprocessing the network model to eliminate low-impedance lines, this paper demonstrates the capability of the moment relaxations to globally solve large OPF problems that minimize active power losses for portions of several European power systems. Large problems with more general objective functions have thus far been computationally intractable for current formulations of the moment relaxations. To overcome this limitation, this paper proposes the combination of an objective function penalization with the moment relaxations. This combination yields feasible points with objective function values that are close to the global optimum of several large OPF problems. Compared to an existing penalization method, the combination of penalization and the moment relaxations eliminates the need to specify one of the penalty parameters and solves a broader class of problems.

In this paper, we consider the Optimal Power Flow (OPF) problem which consists in determining the power production at each bus of an electric network by minimizing the production cost. Our contribution is an exact solution algorithm for the OPF problem. It consists in a spatial branch-and-bound algorithm based on a compact quadratically-constrained convex relaxation. It is computed by solving the semidefinite rank relaxation of OPF once at the root node of the algorithm. An important result is that the optimal value of our compact relaxation is equal to the rank relaxation value. Then, at every sub-nodes of our branch-and-bound, the lower bound is obtained by solving a quadratic convex problem instead of an SDP. Another contribution is that we add only O(n+m) variables that model the squares of the initial variables, where n is the number of buses in the power system and m the number of transmission lines, to construct our relaxation. Then, since the relations between the initial and auxiliary variables are non-convex, we relax them to get a quadratic convex relaxation. Finally, in our branch-and-bound algorithm, we only have to force a reduced number of equalities to prove global optimality. This quadratic convex relaxation approach is here tailored to the OPF problem, but it can address any application whose formulation is a quadratic optimization problem subject to quadratic equalities and ring constraints. Our first experiments on instances of the OPF problem show that our new algorithm Compact OPF (COPF) is more efficient than the standard solvers and other quadratic convex relaxation based methods we compare it with.

The AC optimal power flow (OPF) problem is essential for the schedule and operation of power systems. Convex relaxation methods have been studied and used extensively to obtain an optimal solution to the OPF problem. When the exactness of convex relaxations is not guaranteed, it is important to recover a feasible solution for the convex relaxation methods. This paper presents an alternative convex optimisation (ACP) approach that can efficiently recover a feasible solution from the result of second‐order cone programming (SOCP) relaxed OPF in mesh networks. The OPF problem is first formulated as a difference‐of‐convex programming (DCP) problem, then efficiently solved by a penalty convex concave procedure (CCP). By using the solution of a tightened SOCP OPF as an initial point, the proposed algorithm is able to find a global or near‐global optimal solution to the AC OPF problem. Numerical tests show that the proposed method outperforms those semi‐definite programming (SDP) and quadratically constrained quadratic programming (QCQP)–based algorithms.

This study proposes an improved particle swarm optimization method to find optimal power flow by using the power transmission loss as an objective function. In the literature, PSO is a well — known intelligent search method to handle the solution of optimal power flow problem. A novel scheme which is called Improved PSO (IPSO) is defined by modifying the initialization step of PSO algorithm and choosing the load bus voltages, generator active and reactive powers, line flow capacities as penalty functions in the objective function. PSO and IPSO-based optimal power flow solutions are compared with each other on IEEE 118 and 300 bus systems. According to the test results, the power loss obtained by IPSO-based solution has less power loss than PSO-based solution. This proposed method can be used to obtain faster desirable solutions and better power loss results for the optimal power flow problem in case of power loss minimization.

The symbiotic organisms search (SOS) algorithm is an effective metaheuristic developed in 2014, which mimics the symbiotic relationship among the living beings, such as mutualism, commensalism, and parasitism, to survive in the ecosystem. In this study, three modified versions of the SOS algorithm are proposed by introducing adaptive benefit factors in the basic SOS algorithm to improve its efficiency. The basic SOS algorithm only considers benefit factors, whereas the proposed variants of the SOS algorithm, consider effective combinations of adaptive benefit factors and benefit factors to study their competence to lay down a good balance between exploration and exploitation of the search space. The proposed algorithms are tested to suit its applications to the engineering structures subjected to dynamic excitation, which may lead to undesirable vibrations. Structure optimization problems become more challenging if the shape and size variables are taken into account along with the frequency. To check the feasibility and effectiveness of the proposed algorithms, six different planar and space trusses are subjected to experimental analysis. The results obtained using the proposed methods are compared with those obtained using other optimization methods well established in the literature. The results reveal that the adaptive SOS algorithm is more reliable and efficient than the basic SOS algorithm and other state-of-the-art algorithms. Highlights Correlation between organisms, optimization and engineering. Adaptive symbiotic organisms search (SOS) algorithm is proposed. Implementation on structural design problems. Effective over other methods.

This paper addresses the problem of makespan minimization on unrelated parallel machines with sequence dependent setup times. The symbiotic organisms search (SOS) algorithm is a new and popular global optimization technique that has received wide acceptance in recent years from researchers in continuous and discrete optimization domains. An improved SOS algorithm is developed to solve the parallel machine scheduling problem. Since the standard SOS algorithm was originally developed to solve continuous optimization problems, a new solution representation and decoding procedure is designed to make the SOS algorithm suitable for the unrelated parallel machine scheduling problem (UPMSP). Similarly, to enhance the solution quality of the SOS algorithm, an iterated local search strategy based on combining variable numbers of insertion and swap moves is incorporated into the SOS algorithm. More so, to further improve the SOS optimization speed and performance, the longest processing time first (LPT) rule is used to design a machine assignment heuristic that assigns processing machines to jobs based on the machine dynamic load-balancing mechanism. Subsequently, the machine assignment scheme is incorporated into SOS algorithms and used to solve the UPMSP. The performances of the proposed methods are evaluated by comparing their solutions with other existing techniques from the literature. A number of statistical tests were also conducted to determine the variations in performance for each of the techniques. The experimental results showed that the SOS with LPT (SOS-LPT) heuristic has the best performance compared to other tested method, which is closely followed by SOS algorithm, indicating that the two proposed algorithms’ solution approaches are reasonable and effective for solving large-scale UPMSPs.

In the paper, a modified coyote optimization algorithm (MCOA) is proposed for finding highly effective solutions for the optimal power flow (OPF) problem. In the OPF problem, total active power losses in all transmission lines and total electric generation cost of all available thermal units are considered to be reduced as much as possible meanwhile all constraints of transmission power systems such as generation and voltage limits of generators, generation limits of capacitors, secondary voltage limits of transformers, and limit of transmission lines are required to be exactly satisfied. MCOA is an improved version of the original coyote optimization algorithm (OCOA) with two modifications in two new solution generation techniques and one modification in the solution exchange technique. As compared to OCOA, the proposed MCOA has high contributions as follows: (i) finding more promising optimal solutions with a faster manner, (ii) shortening computation steps, and (iii) reaching higher success rate. Three IEEE transmission power networks are used for comparing MCOA with OCOA and other existing conventional methods, improved versions of these conventional methods, and hybrid methods. About the constraint handling ability, the success rate of MCOA is, respectively, 100%, 96%, and 52% meanwhile those of OCOA is, respectively, 88%, 74%, and 16%. About the obtained solutions, the improvement level of MCOA over OCOA can be up to 30.21% whereas the improvement level over other existing methods is up to 43.88%. Furthermore, these two methods are also executed for determining the best location of a photovoltaic system (PVS) with rated power of 2.0 MW in an IEEE 30-bus system. As a result, MCOA can reduce fuel cost and power loss by 0.5% and 24.36%. Therefore, MCOA can be recommended to be a powerful method for optimal power flow study on transmission power networks with considering the presence of renewable energies.

In this paper, a new method to incorporating FACTS devices in optimal power flow (OPF) problem is presented. This method can provide an enhanced economic solution with the use of controllable FACTS devices. Two types of FACTS devices, thyristor controlled series compensators (TCSC) and thyristor controlled phase shifters (TCPS), are considered in this method. The specified power flow control constraints due to the use of FACTS devices are included in the OPF problem. The proposed method decomposes the solution of such modified OPF problem into two subproblems' iteration. The first subproblem is a power flow control problem and the second subproblem is a conventional OPF problem. The two subproblems are solved iteratively until convergence. Case studies are presented to show the effectiveness of the proposed method.

This paper illustrates an application of adaptive tabu search (ATS) to optimal power flow (OPF) problems in comparison with some effective mathematical and evolutionaryoptimization methods. Although, the ATS was originally developed for solving a combinatorial optimization problem whose parameters are discrete, it has the ability to handle continuous variables by treating them as discrete ones with a very small variable step-size to gain accuracy. The proposed algorithm was tested with 9-bus and 300-bustest systems to represent a small-scale and a comparatively large-scale power system, respectively. Each test power system was challenged by performing three test cases. The first test case was given by applying a quadratic function to generators’ fuel-cost curve, whereas a non-smooth fuel-cost function was assigned to the second. In addition, the system voltage profile was considered and set as the objective function to be minimized in the last test case. The comparisons among solutions obtained by sequential quadratic programming (SQP), evolutionary programming (EP) and the ATS were carried out, from which satisfactory results and the selection of solution methods to OPF problems were summarized. Key words: Optimal power flow problem, sequential quadratic programming, evolutionary programming, adaptive tabu search, quadratic fuel cost, non-smooth fuel cost.