Throughput analysis of extended ARQ schemes

We propose and analyze a scheme for wireless channels, which is a combination of a hybrid type I automatic repeat request (ARQ) scheme and a power ramping. In the hybrid type I ARQ scheme, the same redundancy bits for error correction is transmitted repeatedly when a negative acknowledgment (NAK) is obtained. In addition to the ARQ scheme, the power ramping is considered for more reliable downlink data transmission, in which the transmission power is gradually changed from a small level to large levels when the number of retransmission increases. This is done without any knowledge of the channels at the transmitter. Simulation results show that by applying the combined hybrid ARQ and power ramping scheme with properly selected parameters, it has a throughput advantage of 3-5%.

Sequential decoding is analyzed in conjunction with an efficient incremental redundancy automatic repeat request (ARQ) scheme using punctured convolutional coding. With the incremental redundancy ARQ scheme, whenever the decoding time of a given data packet exceeds some predetermined value T/sub max/, decoding of that data packet is stopped and incremental redundancy bits are provided by the transmitter, a few bits at a time, as needed. It is shown that the incremental redundancy ARQ scheme provides throughput improvement over the partial retransmission code combining ARQ scheme. The advantage of the incremental redundancy ARQ scheme is that the throughput increases as the starting coding rate increases over all ranges of signal-to-noise ratios. >

In an automatic repeat request (ARQ) scheme, a packet is retransmitted if it gets corrupted due to transmission errors caused by the channel. Here we describe a ready-to-implement ARQ scheme with packet combining. An analytical description of the scheme in random error channel shows excellent agreement with simulation results. An upper bound for type-II schemes is defined. For smaller packet sizes, throughput of the proposed scheme is sufficiently close to the upper bound till a very high bit error rate.

Power-line communication (PLC) networks have been increasingly used for constructing industrial IoT (internet of things) and home networking systems due to their low-cost installation and broad coverage feature. To guarantee the transmission reliability, ARQ (automatic repeat request) scheme is introduced into the link layer of reliable PLC networks, which allows the retransmission of a data frame several times so that it has a higher probability to be correctly received. However, current studies of performance analysis for PLC MAC (medium access control) protocol (i.e., IEEE 1901) do not take into account of the impact of ARQ scheme. To resolve this problem, we propose an analytical model to investigate the MAC performance of IEEE 1901 protocol for reliable PLC networks with ARQ scheme. In the modeling process, we first establish a PLC channel model to reflect the impacts of PLC channel types (containing Rayleigh fading and Log-normal fading), additive non-Gaussian noise feature and ARQ scheme on data transmission at link layer. Next, we employ Renewal theory and Queueing dynamics to capture the transmission attempt behavior of executing IEEE 1901 protocol in the unsaturated environment with finite transit buffer size. On the basis of combining these two models, we derive the closed-form expressions of 1901 MAC metrics considering the influence of the ARQ scheme. Furthermore, we prove that the proposed analytical model has the convergence property. Finally, we evaluate the MAC performance of 1901 protocol for reliable PLC networks with ARQ scheme and verify the proposed analytical model.

A new hybrid automatic repeat request (ARQ) scheme that utilises reliability estimates generated by soft-input, soft-output (SISO) decoders is proposed. The proposed ARQ scheme transmits additional information for the unreliable bits, and this information is used to perform additional decoding. Results are presented that show this ARQ technique can provide performance close to the channel capacity.

A cooperative automatic repeat request (ARQ) scheme is proposed for cognitive radio networks with full duplex capability. Its performance is studied for ARQ and hybrid ARQ (HARQ) modes, in terms of data link layer packet error rate (PER) and the primary and secondary throughputs. It is shown that activity of the secondary network during primary’s retransmission does not affect primary’s performance in ARQ mode, and would even improve it in HARQ mode.

This paper proposes a new automatic repeat request (ARQ) scheme for reliable broadcasting in distributed wireless LANs. Unlike traditional ARQ schemes for reliable broadcasting, the proposed scheme is highly efficient in its ARQ control information delivery and only introduces light control overhead in the network. Our simulation results show that as compared with traditional ARQ schemes, the proposed scheme improves the LAN throughput by from several tens to more than one hundred percent, depending on the number of nodes in the LAN.

It is generally impossible to avoid occurrences of errors of the data transmission because of the disturbing factors such as disconnections, noises or distortions in a communication line. Therefore, the error‐control procedure is indispensable to trnnsmit high‐quality data and its various techinques have been considered from the viewpoints of high reliability data transmission. the main techniques in the error‐correcting strategies are classified into the following three categories: (i) forward‐error‐correction (FEC) scheme; (ii) automatic‐repeat‐request (ARQ) scheme; and (iii) hybrid ARQ scheme. the hybrid ARQ scheme is the system combined FEC scheme with ARQ scheme. This aims to reduce the frequency of retransmissions as much as possible and to gain a constant data throughput, even in a worse communication environment, by coding error patterns that would be expected to occur frequently. However, when the first data of transmission has failed, the hybrid ARQ is removed to the ARQ policy with the same FEC, i.e., its data throughput decreases because of bit increments, such as codes to correct errors in the data transmission. This is called type‐I hybrid ARQ and its modified systems, which are called type‐II hybrid ARQ, have been studied and proposed by many authors. This paper suggests a new type‐II hybrid ARQ system from the viewpoint of improving the data throughput and derives the mean time to success of the data transmission. Then, the mean times of the system are compared analytically with those of the usual ARQ and the type‐I hybrid ARQ, and an evaluation is done.

User scheduling and multiuser multi-antenna (MU-MIMO) transmission are at the\ncore of high rate data-oriented downlink schemes of the next-generation of\ncellular systems (e.g., LTE-Advanced). Scheduling selects groups of users\naccording to their channels vector directions and SINR levels. However, when\nscheduling is applied independently in each cell, the inter-cell interference\n(ICI) power at each user receiver is not known in advance since it changes at\neach new scheduling slot depending on the scheduling decisions of all\ninterfering base stations. In order to cope with this uncertainty, we consider\nthe joint operation of scheduling, MU-MIMO beamforming and Automatic Repeat\nreQuest (ARQ). We develop a game-theoretic framework for this problem and build\non stochastic optimization techniques in order to find optimal scheduling and\nARQ schemes. Particularizing our framework to the case of "outage service\nrates", we obtain a scheme based on adaptive variable-rate coding at the\nphysical layer, combined with ARQ at the Logical Link Control (ARQ-LLC). Then,\nwe present a novel scheme based on incremental redundancy Hybrid ARQ (HARQ)\nthat is able to achieve a throughput performance arbitrarily close to the\n"genie-aided service rates", with no need for a genie that provides\nnon-causally the ICI power levels. The novel HARQ scheme is both easier to\nimplement and superior in performance with respect to the conventional\ncombination of adaptive variable-rate coding and ARQ-LLC.\n

An automatic repeat-request (ARQ) scheme with memory and soft error detectors has been recently proposed by Benelli. Its performance was studied mainly through computer simulation. In this paper, a generalized version of this ARQ scheme is examined. The selection of certain thresholds and weights to minimize the bit error rate in systems using a fixed number of packet repeats is considered. Finally, the evaluation of the average number of transmissions per packet in systems in which negatively acknowledged packets are retransmitted until successfully received is described.

We propose a new data link control protocol for wireless ATM networks. This new protocol can support both real time and non-real-time services by adopting different error control mechanisms. For real-time traffic, only forward error control (FEC) is used for error correction. For non-real-time traffic, a hybrid automatic repeat request (ARQ) scheme is adopted to reduce the cell loss ratio to a minimum level. In both the FEC and hybrid ARQ schemes, the coding rate is adapted to the channel conditions. When the signal-to-noise ratio (SNR) is high, the coding rate may be higher; while when the channel is bad, the coding rate is adjusted to be lower. The automatic coding rate adaptiveness guarantees the high utilization of the scarce wireless channel resources.

A new hybrid automatic repeat request (HARQ) scheme is proposed for multiple-input multiple-output (MIMO) systems when the acknowledgment (ACK) bundling is applied for packet retransmissions. In the proposed HARQ scheme, both Chase combining (CC) and incremental redundancy (IR) are utilised for a retransmission request, and the proposed HARQ scheme is called a multiple retransmission strategy-based HARQ (MRS-HARQ). During the reception process of the MRS-HARQ, IR packets obtain signal-to-noise ratio gains using the extended detection with CC packets and the improved IR packets are utilised to eliminate the interference from the CC packets. This sequential reliability improvement allows the MRS-HARQ to decrease the occurrence of the deficient transmissions, and the proposed MRS-HARQ can achieve an improved error performance and throughput over the conventional CC-based and IR-based HARQ schemes with the ACK bundling.

In this paper, we propose a data-driven joint modulator and demodulator based on meta-learning for hybrid automatic repeat request (HARQ) schemes, which include Type-I HARQ, HARQ with chase combining (HARQ-CC), and HARQ with incremental redundancy (HARQ-IR). Data-driven deep learning (DL) techniques have proven particularly effective for enabling wireless systems to adapt to complex scenarios with unknown or imperfect channel conditions that are difficult to characterize analytically. Most existing DL approaches to realize data-driven communication frameworks are based on joint source-channel coding (JSCC). However, the difficulty in detecting transmission errors makes JSCC unsuitable for HARQ systems. To address this limitation, we propose a novel architecture that combines classical channel coding with DLbased modulation and demodulation. Specifically, we employ an autoencoder to implement both the modulator and demodulator. To quickly adapt to time-varying fading channels, the ModelAgnostic Meta-Learning (MAML) algorithm is leveraged to accelerate the convergence of the model as well as enhance the reliability of HARQ. The MAML framework is divided into two phases, including the pre-training phase to acquire shared initialization parameters across various channel conditions and the fine-tuning phase to rapidly adapt to specific channel states. Simulation results demonstrate that the proposed architecture offers dramatic improvements in convergence speed and generalization capabilities, and meanwhile boosts the reliability of HARQ schemes.

An adaptive control procedure is proposed for the go-back-N and selective-repeat automatic repeat-request (ARQ) schemes. The procedure is to dynamically vary the number and length of continuously transmitted data blocks according to the bit error rate. The throughput of the adaptive ARQ schemes for a half-duplex transmission line is compared with the throughput of corresponding conventional schemes. Numerical results indicate that adaptive ARQ schemes are superior to conventional ARQ schemes when the bit error rate is not known or varies with time.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>

There are two kinds of technique used for error control: FEC (forward error correction) and ARQ (automatic repeat request). Combining these two schemes, which is called HARQ (hybrid ARQ), makes it possible to increase the channel throughput. The error of the channel quality estimate that is used to select the MCS (modulation coding scheme) in type I HARQ can be a serious problem in scenarios when the mobile station moves at high speeds. Furthermore, in a system dominated by packet services, the interference level may be bursty, and thus it is difficult to predict the interference level. Therefore, the type II HARQ scheme is a more robust solution compared with type I HARQ. In order to improve channel throughput while at the same time satisfying quality of service (QoS) under various channel conditions, an efficient hybrid ARQ type II scheme is proposed. The optimum redundancy size for every transmission is calculated to maximize the throughput using QoS parameters, the performance of LDPC code and channel conditions. The proposed scheme, together with such benefits as QoS support, provides a way of achieving higher throughput in wireless communication systems.