Transient Stability Enhancement Strategy for Islanded Microgrids Based on Energy Storage–Virtual Synchronous Machine Control

This paper develops the transient stability enhancement of the inverter-based resources (IBRs) with the virtual synchronous generator (VSG) control employed. Firstly, based on the large-signal model, the instability phenomenon of the VSG control during voltage dips is fully analyzed. It is found that the frequency deviation Δω in the active power control loop (APCL) of VSG is always positive when the VSG is transiently unstable. Then, for guaranteeing stronger transient stability, an additional integral controller with the frequency deviation is added to the APCL in the VSG control. Moreover, a large-signal model of the proposed strategy is established. Then, the phase portraits with an integral controller in the APCL disabled/enabled are presented. It is seen that the improved control strategy has better transient stability under voltage dips. Finally, the simulation results verify the effectiveness of the proposed method.

This paper investigates transient angle stability of parallel system of two virtual synchronous generators (VSGs) and hybrid system comprised by VSG and diesel generator (DG). Compared to single grid-connected VSG, the paralleled VSGs system and hybrid system are facing larger challenges on stability aspect during serious faults. Although there exist several publications on transient stability, the transient instability mechanism is rather ambiguous, especially for paralleled systems. Besides, swing equations of paralleled VSGs system and paralleled DG-VSG system are established to discuss the dynamic characteristics of the system during short-circuit fault. The increase of power angle between DG and VSG is caused by the different angular accelerations, which deteriorates the transient angle stability of paralleled DG-VSG system. Thus, paralleled DG-VSG system is more prone to instability than paralleled VSGs system, which can be illustrated by power angle (P-δ) characteristic curves. Finally, simulation results validate the correctness of theoretical analyses.

A novel grid-forming technology for transient stability enhancement of power system with high penetration of renewable energy

Transient stability analysis of a grid-connected type-4 wind turbine with grid-forming control during the fault

Since the wide application of virtual synchronous generators (VSGs), the power grid faces great challenges in the safe and stable operation due to their limited thermal capacity and weak anti-disturbance ability. During transient period, for example, a fault occurs in the transmission line, the VSG may lose the transient angle stability and provoke the current hard limit. Even if the fault is cleared by tripping of line, it still faces the problem of instability and voltage dips. To address this problem, in this paper, the post-fault large-signal model of VSG is derived first via the travelling waves based fault information acquisition. Subsequently, with the effect of both active and reactive power loops taken into account, a two-stage simultaneous control scheme is proposed for improving the transient stability of VSG, while considering the current limitation during fault state and voltage support after fault clearance. This method is fulfilled by mode switching and an additional feedback control based on the fault signal. Finally, the effectiveness of the proposed method under both symmetrical and asymmetrical faults is verified. Moreover, the application of the proposed method in a multiple VSGs system is also verified. Besides, the robustness to parameter mismatch and the feasible operating region for the method are discussed.

This article presents an improved virtual synchronous generator (VSG) control strategy of doubly-fed induction generator (DFIG) during symmetrical voltage fault. Based on VSG control, DFIG can behave like a conventional synchronous generator (SG), which can support frequency and voltage in grid-connected mode. Moreover, when microgrid disconnects from grid, DFIG can provide voltage and power for local loads. However, during symmetrical voltage fault, the transient components in DFIG cannot be controlled properly by VSG. To solve this problem, the air-gap flux feedback is designed in VSG control to accelerate the decay of transient components, and rotor current limiting method is also introduced in the article. In the proposed method, there is no need to switch the control structure or control targets. DFIG always works in the VSG control. Therefore, DFIG can operate in the standalone mode when the connection to grid is cut off. The decay time constant, the voltage control, current limiting control and parameter variation of the improved VSG control are analyzed in detail. Finally, the simulation and experimental results in both normal and fault grid condition are given to validate the effectiveness of proposed VSG control strategy.

A relevant question related to the regulation provided by power electronics-based devices is how to utilize efficiently their active and/or reactive control loops and which control signals to dedicate to which control objectives. These devices are faster and, at least with respect to control capabilities, more versatile than conventional synchronous machines. Power-electronic converter represents thus both a great challenge and an unprecedented opportunity for the dynamic performance of power systems. This chapter focuses on the opportunities and describes a set of control schemes that improve the overall power system dynamic response through a combined voltage-frequency regulation strategy. The schemes described in this chapter are intended for any power electronics-based devices, including distributed energy resources (DERs) and energy storage systems (ESSs), as well as flexible AC transmission system (FACTS) devices. The performance of the control schemes in this chapter is illustrated through examples based on benchmark test systems as well as on a realistic model of the Irish transmission system.

As one of the most promising control strategies, virtual synchronous generators (VSG) control is studied worldwide and impedance models have been built for VSG by some papers, but most of them overlook the inner loops which can make significant difference to impedance of VSG. This paper establishes the sequence impedance models of VSG with and without inner loops and demonstrates the negative influence of inner loops on dynamic performances in the range of low frequency by the comparison of impedance models of VSG with and without inner loops. Then the paper gives suggestion that virtual resistance should be adopted to the VSG with inner loops to improve stability. Finally, all the theoretical analysis is verified by simulation results.

The increasing penetration of renewable energy, such as photovoltaic generation, makes it essential to enhance power system dynamic performance through improved grid-forming control strategies. In the grid-forming control system, the virtual synchronous generator control (VSG) is currently widely used. However, the inertia (J) and damping (D) in the traditional VSG are fixed values, which can result in large overshoots and long adjustment times when dealing with disturbances such as load switching. To address these issues, this paper proposes an adaptive virtual synchronous generator (VSG) control strategy for grid-side inverters, which is accomplished by adaptively adjusting the VSG’s inertia and damping. Firstly, we established a photovoltaic-storage VSG grid-forming system; here, the photovoltaic power is boosted through a DC-DC converter, and the energy storage is connected to the common DC bus through a bidirectional DC-DC converter. We analyzed how J and D shape the system’s output characteristics. Based on the power-angle characteristic curve, the tanh function was introduced to design the control function, and a JD collaborative adaptive control (ACL) strategy was proposed. Finally, simulation experiments were conducted under common working conditions, such as load switching and grid-side voltage disturbance, to verify the results. From the results shown, the proposed strategy can effectively improve the response speed of the system, suppress system overshoot and oscillation, and, to a certain extent, improve the dynamic performance of the system.

For a VSC-HVDC transmission system based on a hybrid topology converter of full-bridge and half-bridge, a kind of virtual synchronous generator (VSG) control strategy which can be applied to modular multilevel converter (MMC) grid-connected structure was researched and proposed. First, based on the conventional VSG control strategy, the energy stored in the equivalent capacitor of MMC power module was used to imitate the rotor inertia of synchronous generator. The characteristics of generator can be simulated during transient frequency fluctuations and it can help relieve the power fluctuations. Secondly, with respect to the structural characteristics of the direct grid connection through the reactor on the AC side of the MMC, which is unlike the microgrid inverter, there are no additional filter capacitors. So, the existing commonly used VSG control strategy of the microgrid inverter and double-closed-loop structure composed of filter capacitor voltage and AC current cannot be directly applied. For this, a method where the given values of inner current loop are calculated by grid impedance matrix was used. So, a double-closed-loop control structure composed of a power outer loop based on VSG control and a current inner loop is obtained. It can effectively improve the current control capability during the transient process. Finally, a hybrid MMC simulation model was built based on PSCAD to verify the correctness and effectiveness of the proposed methods.

An enhanced second-order-consensus-based distributed secondary frequency controller of virtual synchronous generators for isolated AC microgrids

With the continuous development of wind power capacity, a large number of wind turbines connected by power electronic devices make the system inertia lower, which leads to the problem of system frequency stability degradation. The virtual synchronous generator (VSG) control can make wind turbines possess inertia and damping. However, the stochastic dynamic behavior of wind generation results in the stochastic changing of operating condition; this paper presents an adaptive subsynchronous oscillation (SSO) damping control method for the wind generation with VSG control. Firstly, the small signal model of the permanent magnet synchronous generator (PMSG) with VSG is built, and the model of state space is derived and built. The active power of PMSG is selected as the variable parameter vector to establish a polytopic linear variable parameter system model. Then, based on the hybrid H2/H∞ control method, each vertex state feedback matrix is solved by linear matrix inequality, and a subsynchronous oscillation adaptive damping controller with polytope is obtained. Finally, the 4-machine 2-area system connected to two PMSGs with VSG control is used as the test system for time domain simulation. The simulation results demonstrate that the LPV based adaptive damping controller could provide enough damping under the circumstances of wider changes of wind power outputs.

The hybrid AC/DC microgrid gains a great attention in recent years as it can improve the energy efficiency and ensure the reliability of the system. This paper makes an investigation on the operation mode switching performance of an AC/DC combined hybrid microgrid based on a real system at Griffith University, Queensland, Australia. An improved virtual synchronous generator (VSG) control strategy is developed to optimize the switching performance from the grid-tied mode to the islanding mode. The basic VSG principle is described and the improved VSG model is introduced. Based on the improved model, a pre-synchronization method is proposed. Comparison of the microgrid performance between conventional droop control and the improved VSG control is carried out by simulation on Matlab/SIMULINK environment. Simulation results show the advantage of VSG control strategy and the validity of the pre-synchronization method.

The conventional synchronous generator (SG) can regulate the active and reactive power for frequency and voltage stability, when the system fluctuates. In renewable energy generation system (RES), the stability problem of RES can be solved by adding virtual inertia and damping in the control strategy of the grid-connected inverter. The grid-connected inverter and renewable energy system with this kind of control strategy, called as virtual synchronous generator (VSG), acts as a synchronous generator. In this paper, the topology of grid-connected PV array and energy storage system is proposed. The VSG used in grid-connected inverter, is modelled as stator and rotor model by stator voltage equation and rotor motion equation, respectively. Meanwhile, the VSG control mechanism, based on droop control and model of VSG, can be divided as active power-frequency and reactive power-voltage control. Besides, the system stability is analyzed based on small signal model, for the design of inertia and damping. The simulation model is designed by MATLAB/Simulink for the implementation of VSG. In simulation, it is compared that the dynamic regulation performance of VSG with different control coefficient, such as virtual inertia, virtual damping, droop coefficient and integral coefficient. The optimization for regulation performance in simulation provides an appropriate selection method of the control coefficient for VSG.

In recent researches on inverter-based distributed generators, disadvantages of traditional grid-connected current control, such as no grid-forming ability and lack of inertia, have been pointed out. As a result, novel control methods like droop control and virtual synchronous generator (VSG) have been proposed. In both methods, droop characteristics are used to control active and reactive power, and the only difference between them is that VSG has virtual inertia with the emulation of swing equation, whereas droop control has no inertia. In this paper, dynamic characteristics of both control methods are studied, in both stand-alone mode and synchronous-generator-connected mode, to understand the differences caused by swing equation. Small-signal models are built to compare transient responses of frequency during a small loading transition, and state-space models are built to analyze oscillation of output active power. Effects of delays in both controls are also studied, and an inertial droop control method is proposed based on the comparison. The results are verified by simulations and experiments. It is suggested that VSG control and proposed inertial droop control inherits the advantages of droop control, and in addition, provides inertia support for the system.