A wave tank test was conducted with a circular Cylinder mounted on a sloped foundation. The cylinder was 6 ins. in diameter and was instrumented to measure the local load on the cylinder, the pressure distribution around the cylinder and the foundation load. The test was designed to investigate the effect of the boundary slope, wave angle of attack and cylinder/boundary gap on the hydrodynamic loads on the cylinder. This paper describes the hydrodynamic coefficients, e.g., inertia, force and lift coefficients for the cylinder placed at right angles to the waves as a function of the cylinder gap, foundation slope and Keulegan-Carpenter (KC) parameter. The test results are limited to low values of KC. INTRODUCTION Considerable research has been performed on the effects of fluid flow around a pipe adjacent to a plane horizonta1 boundary. Analytica1 studies based on potential flows and experimental studies on separated osci11atory flows around pipes near these boundaries have been performed. Many of these works have been reviewed in a textbook by Sarpkaya and Isaacson (1981). A few at-sea tests on seafloor mounted pipelines have also been conducted [Grace, et ale (1979)]. However, experiments on pipes mounted on a sloped plane in the presence of waves and currents have not been considered. The parameters which influence the forces due to waves on a cylinder near a sloped boundary are the local maximum water particle velocity at the cylinder, um, the wave period, T, the cylinder diameter, D, the gap between the cylinder and the bottom, e, the boundary slope, ?, the boundary layer thickness, ?, and the properties of the fluid, i.e., the mass density of the fluid, p, and the kinematic viscosity, v. Thus, the maximum (time independent) force is given as a function of:If a simple dimensional analysis is performed, then a no dimensional force may be written as and the force coefficient(Mathematical Equation Available In Full Paper)The Morison (1950) equation may be used with the water particle kinematics given by the linear wave theory to write the nondimensional force, where ? = wave frequency and f = force as a function of time, t. The expression of the force coefficient can be derived in terms of inertia and drag coefficients, CM and CD, respectively, as and the force coefficient
Read more