Two-Color One-Way Frequency Transfer in a Metropolitan Optical Fiber Data Network

We present a simple model of the signals transmitted by global positioning system (GPS) satellites and of the reception of these signals by a GPS receiver, neglecting atmospheric effects. The model idealizes the receiver and transmitter as electric dipole antennas. We derive the open-circuit voltage induced in the antenna of the receiver as a function of time, position, velocity, and orientation of the respective antenna. As an application of this model, we show that by using a single dipole antenna, a user of the GPS can compute his position, time, and two angles of attitude, by tracking the phases of the open-circuit antenna voltages for six GPS satellites.

Lockheed Martin Mission Systems is developing a high fidelity simulator for the Air Force's Global Positioning System (GPS) satellite command and control operations. To accomplish this goal, each spacecraft subsystem was broken down into a series of algorithms that describes the subsystem dynamic behavior. The measurable effects produced by these algorithms were compared to actual GPS satellite data for algorithm validation. Several subsystems that posed particular difficulty include orbit determination, thermal control, and reaction control. The primary algorithms used to simulate these subsystems are included herein as well as a discussion pertaining to issues surrounding the development of these algorithms. Finally, some of the required anomalies are discussed along with their relation to the derived algorithms.

International audience

: Software GPS receiver development has been undertaken. We are particularly interested in improving the GPS signal-to-noise/interference ratio using beam forming techniques. The phase relationship among the antenna array elements requires careful calibration. In this study, we will report a phase calibration technique for a 2 by 2 GPS antenna array using both simulated and real GPS signals. This technique is based on the GPS signal-processing algorithm developed for the software GPS receiver. A four-channel digital data collecting system was used in the experiment. For a simulated GPS signal, the experiment was conducted in an anechoic chamber in which a GPS simulation system was facilitated. For real GPS signals, we conducted the experiment on a rooftop to receive the signal from GPS satellites. The calibration verified the coherent nature of the signals among the elements. The results also allowed the source's direction to be determined.

The chemistry of sol-gel derived silica and refractive metal oxide has been systematically studied. Sol-gel processes have been developed for preparing porous silica and semiconductor metal oxide materials. Micelle/reversed micelle techniques have been developed for preparing nanometer sized semiconductor metal oxides and noble metal particles. Techniques for doping metal ions, metal oxides and nanosized metal particles into porous sol-gel material have also been developed. Optical properties of sol-gel derived materials in ambient and high temperature gases have been studied by using fiber optic spectroscopic techniques, such as fiber optic ultraviolet/visible absorption spectrometry, fiber optic near infrared absorption spectrometry and fiber optic fluorescence spectrometry. Fiber optic spectrometric techniques have been developed for investigating the optical properties of these sol-gel derived materials prepared as porous optical fibers or as coatings on the surface of silica optical fibers. Optical and electron microscopic techniques have been used to observe the microstructure, such as pore size, pore shape, sensing agent distribution, of sol-gel derived material, as well as the size and morphology of nanometer metal particle doped in sol-gel derived porous silica, the nature of coating of sol-gel derived materials on silica optical fiber surface. In addition, the chemical reactions of metal ion, nanostructured semiconductor metal oxides and nanometer sized metal particles with gas components at room temperature and high temperatures have also been investigated with fiber optic spectrometric methods. Three classes of fiber optic sensors have been developed based on the thorough investigation of sol-gel chemistry and sol-gel derived materials. The first group of fiber optic sensors uses porous silica optical fibers doped with metal ions or metal oxide as transducers for sensing trace NH{sub 3} and H{sub 2}S in high temperature gas samples. The second group of fiber optic sensors uses sol-gel derived porous silica materials doped with nanometer particles of noble metals in the form of fiber or coating for sensing trace H{sub 2}, NH{sub 3} and HCl in gas samples at for applications ambient temperature. The third classes of fiber optic sensors use sol-gel derived semiconductor metal oxide coating on the surface of silica optical fiber as transducers for selectively sensing H{sub 2}, CH{sub 4} and CO at high temperature. In addition, optical fiber temperature sensors use the fluorescence signal of rare-earth metal ions doped porous silica optical fiber or the optical absorption signal of thermochromic metal oxide materials coated on the surface of silica optical fibers have also been developed for monitoring gas temperature of corrosive gas. Based on the results obtained from this project, the principle of fiber optic sensor techniques for monitoring matrix gas components as well as trace components of coal gasification derived syngas has been established. Prototype sensors for sensing trace ammonia and hydrogen sulfide in gasification derived syngas have been built up in our laboratory and have been tested using gas samples with matrix gas composition similar to that of gasification derived fuel gas. Test results illustrated the feasibility of these sensors for applications in IGCC processes.

Position determination using satellite navigation system has grown significantly. It provides geospatial with global coverage called GNSS (Global Navigation System Satellite). GNSS satellites consists of GLONASS, GPS (Global positioning system) and Galileo.GPS is the most commonly used system and it is known to its capability to determine 3D position on the surface of the earth. In order to determine the position, a GPS receiver must be able to receive signals from at least four GPS satellites. However, the determination of position in condensed areas such as tunnels, area surrounded by high rise buildings, highly forested and in other closely-knit areas is not achieved because satellite signals cannot reach the receiver in the above-mentioned areas and also others where the signals are reflected before being received by a GPS receiver. In this paper, we present the algorithm to fuse GPS and the inertial measurement unit (IMU) to enable positioning in the above-mentioned Condensed Areas. The standard deviations of the two measurements show that GPS-IMU is better than GPS alone, the standard deviation when satellite outages occurred is - 4.57475 for GPS-IMU measurements and 0.218675 for GPS observations. We presented the results in graphics and it shows that GPS measurements are easily disturbed by external influence such as multipath but GPS-IMU graphic is continuous and robust. The advantages and disadvantages of GPS and INS are complementary and make them work together to enable the accurate measurements in the areas mentioned above. Integration of INS and GNSS can be classified into three types, loosely coupled Kalman filter, tightly coupled Kalman filters and ultratight coupled Kalman filter. In this research we used loosely coupled Kalman filter and tightly coupled Kalman filters to combine GPS and INS in one system.

The Differential Global Positioning System (DGPS) is a marine navigation system operating at frequencies of 283.5–325 kHz, which is now the primary method for locating vessels in coastal shipping, as well as hydrography and mapping systems worldwide. Its positioning accuracy is determined by the following: the pseudorange error to Global Positioning System (GPS) satellites, the age of pseudorange corrections, and the value of the Horizontal Dilution of Precision (HDOP), which, in terms of accuracy, is crucial in positioning using GPS satellites. In 2020, the International Hydrographic Organization (IHO) introduced a new (the highest) order of hydrographic surveys, i.e., the Exclusive Order, which requires a positioning system to provide an accuracy of 1 m (p = 0.95). The aim of this article is to provide an answer to the question as to whether the maritime DGPS system, whose positioning accuracy is constantly increasing with that of the GPS system, fulfils the requirements for the hydrographic surveys of harbours. To this end, an extensive experimental study on the maritime DGPS system, involving a total of nearly 3.5 million fixes, was conducted. Statistical analyses showed that when ensuring the HDOP values range from 0.8 to 1.4, the DGPS system can be used in hydrographic surveys of harbours.

In this paper1 we derive formulas for relativistic corrections for one-way and two-way time and frequency transfer in optical fibres with accuracy of 1 ps for time transfer and relative accuracy of 10−18 for frequency transfer. The formulas can be used e.g. for comparisons of distant optical clocks connected by optical fibres.

Ionospheric imaging at mid-latitudes using both GPS and ionosondes

The Global Positioning System (GPS) provides satellite-based navigation signals, which are employed in many fields, including agriculture, transportation, aviation, and military/personal navigation. In an effort to minimize interference among GPS satellites and to enable GPS receivers to discern satellite identity, each satellite is assigned a specific pseudorandom noise (PRN) sequence that is used to modulate the phase of the corresponding signal. The codes that modulate the current GPS landscape are constructed in such a way that cross-correlation among codes is kept to a bounded minimum, which should significantly limit harmful signal interference. In this study, the efficacy of the current PRN-based modulation system is called into question as GPS signal amplitude and carrier phase data over the past decade show frequent interference between satellite signals.

This study investigated the effects of solar flare activity using a baseline during solar minimum from July 2019 through December 2019 to determine a threshold and then assessing the impacts during the solar maximum period from January 2022 through May 2022 on Global Positioning System (GPS) timing sources. GPS satellite data received at the National Institute of Standards and Technology (NIST) was collected and overlaid with the solar activity archive data from SpaceWeatherLive.com to determine whether any correlation existed to showcase effects of solar flare activity on GPS satellite timing sources. Focus of the resulting data was on M-class and X-class flares due to the severity based on prior research papers on the topic. The resulting data analysis of the datasets indicates that each flare class not only impacted the GPS satellite offset value in nanoseconds, but that after each M-class and X-class flare, it was determined that GPS offset value in nanoseconds remains high for several days after the event. Given that the sun is entering solar maximum, more research is needed to better understand the impacts of higher-class solar events on GPS satellite technology (i.e., timing, navigation, etc.) to ensure systems are better protected before events occur especially upon a direct impact from a solar flare.

While GPS (Global Positioning System) navigation and GPS based autonomous car driving techniques are mature, the security of GPS signal has not been a primary system concern. In fact, it has been shown that an ordinary GPS can be easily spoofed by a low-cost, open-source based software defined radio (SDR) system such as bladeRF and HackRF [3, 4] which can cause serious complications to the navigation system of the car especially for self-driving cars which are driven based on the information from sensors, cameras, and GPS. In this work, we design a new GPS authentication system called lightweight authentication GPS (AuthGPS) to authenticate GPS signal against GPS spoofing and LTE base station broadcast message spoofing. In the past, there have been many successful attempts on GPS spoofing which resulted in shifting the destination of the car to the spoofer's desired location. In a case where the car is connected to the Internet via LTE network, the navigation system can find out if the GPS is spoofed by acquiring the correct GPS satellite information from LTE base stations' location information. However, a skillful attacker can spoof the LTE base station signals [7] as well using another SDR which will produce spoofed LTE base station information. Hence giving wrong information about GPSinformation according to the will of the attacker. Currently, there are defense methods against the GPS spoofing [6]. One of them is signal-processing-based methods. By monitoring unusual or unreasonable signal changes at GPS receivers, GPS spoofing attack can be detected. Received Power Monitoring (RPM) looks at all the received amplitude and automatic gain control (AGC) setpoint [1]. The receiver will sense drastic power jump if a spoofing attack occurs. However, an overly powerful spoofing attack with noise is not detectable in the case of this mechanism. Another way to detect spoofing is the symmetric-key encryption mechanism of GPS signals. According to previous research [2], encrypted precision code for anti-spoofing referred to as P(Y) code, might not be able to be spoofed. A spoofing attack can be detected by calculating cross-correlation between spoofed coarse/acquisition code, referred to as C/A code, and P(Y) code. Unfortunately, this P(Y) code is only for military purpose while the C/A code can be publicly accessible. This method requires knowledge of specific key which is not revealed to the public to decrypt P(Y) code. Monitoring the direction of arrival of the signals can be one of the methods [6]. A GPS receiver measures the direction-of-arrival vector with more than 3 antennas. Even though this signal-geometrybased system with multiple antennas makes GPS robust, an attacker can spoof signals from multiple directions, which is more difficult to detect the spoofing. The idea here is to develop a system that can discriminate the spoofed signal without complex computation or heavy message exchange. An important component of AuthGPS is a verification of valid GPS satellite information via LTE base stations' location information. We propose 6-digit one-time password-based authentication system in this paper.

Since the beginning of the International Global Navigation Satellite System (GLONASS) Experiment, IGEX, in October 1998, the Center for Orbit Determination in Europe (CODE) has acted as an analysis center providing precise GLONASS orbits on a regular basis. In CODE's IGEX routine analysis the Global Positioning System (GPS) orbits and Earth rotation parameters are introduced as known quantities into the GLONASS processing. A new approach is studied, where data from the IGEX network are combined with GPS observations from the International GPS Service (IGS) network and all parameters (GPS and GLONASS orbits, Earth rotation parameters, and site coordinates) are estimated in one processing step. The influence of different solar radiation pressure parameterizations on the GLONASS orbits is studied using different parameter subsets of the extended CODE orbit model. Parameterization with three constant terms in the three orthogonal directions, D, Y, and X (D = direction satellite–Sun, Y = direction of the satellite's solar panel axis), and two periodic terms in the X-direction, proves to be adequate for GLONASS satellites. As a result of the processing it is found that the solar radiation pressure effect for the GLONASS satellites is significantly different in the Y-direction from that for the GPS satellites, and an extensive analysis is carried out to investigate the effect in detail. SLR observations from the ILRS network are used as an independent check on the quality of the GLONASS orbital solutions. Both processing aspects, combining the two networks and changing the orbit parameterization, significantly improve the quality of the determined GLONASS orbits compared to the orbits stemming from CODE's IGEX routine processing.

The author describes a procedure for instantaneous GPS (Global Positioning System) attitude determination, i.e., a solution for the GPS integrated carrier Doppler wavelength ambiguities using only measurements at a single epoch. Most previous techniques for solving the phase ambiguity problem have required some form of time history processing relying on GPS satellite and/or user motion to provide enough geometry change to eliminate false solutions. The algorithm described assumes three nonlinear antennas and integrated carrier Doppler measurements from four or more satellites. Double-difference processing provides at least three independent observables for the two antenna separation vectors to compute the three attitude Euler angles. The results obtained also suggest that arbitrarily large separations can be resolved since unambiguous carrier-smoothed pseudorange measurements could provide a coarse measurement with an accuracy falling within the resolution range of the algorithm presented.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>

The traditional approach to both earthquake and Global Positioning System (GPS) location problems in a homogeneous half-space produces a nonlinear relationship between a set of known positions, seismic stations or GPS satellites, and an unknown point, an earthquake hypocenter or GPS receiver. Linearization, followed by an iterative inversion, is typically used to solve both problems. Although sources and receivers are swapped in the earthquake and GPS location problems, the obser- vation equation is the same for both, due to the principle of reciprocity. Consequently, the mechanical part of the solution of the equations is the same and single-step closed- form solutions for the GPS location problem, such as the Bancroft algorithm, can also be used to solve for earthquake hypocenters in a homogeneous half-space. This article applies the Bancroft algorithm to synthetic and real data for the Charlevoix seismic zone and compares the location of ∼1200 events estimated with both the Bancroft algorithm and HYPOINVERSE. The Bancroft algorithm shows quantifiable improve- ments in accuracy compared with traditional methods. We also show how tools com- monly used by the GPS community, such as the geometric dilution of precision, can be used to better estimate the precision of the results obtained by a seismic network.