Uniform waveband assignment in optical mesh networks

Elastic optical network (EON) is a promising candidate for the next generation optical transport network because of its high spectrum efficiency and flexible spectrum allocation. However, to migrate from today’s dense wavelength division multiplexing (DWDM) network to EON, optical nodes such as reconfigurable optical add/drop multiplexers (ROADMs) should be replaced with the ones with expensive flexi-grid wavelength selective switches (WSSs). Thus, whether and how today’s optical network will be evolved to EON is still under debate. Meanwhile, with the technical maturity of optical super-channels that transmit bit rates at the level of 1 Tb/s, super-channels are expected to dominate the future optical transport network because of their attractiveness of high spectrum efficiency and superior cost effectiveness. In this paper, we propose a new quasi-coarse wavelength division multiplexing (Quasi-CWDM) optical network architecture that is compatible to today’s WDM network in spectrum operation, while still maintaining the flexibility of adaptation between the bit rate and the transparent reach of an optical super-channel, but not requiring expensive flexi-grid WSSs. Specifically, the Quasi-CWDM optical network employs large fixed frequency grids, whose spacing falls between the traditional CWDM and DWDM, e.g., 200 GHz or 400 GHz. To maintain the flexibility between the bit rate and the transparent reach of an optical super-channel, different modulation formats are chosen according to channel physical distances. To minimize network hardware cost and maximize carried user traffic demand, we develop a mixed integer linear programming (MILP) model and a heuristic algorithm that can efficiently groom upper-layer IP traffic onto the optical layer by optical super-channels. We compare the design based on the Quasi-CWDM network to those based on the DWDM network and the advanced EON. It is found that the proposed Quasi-CWDM network has a much lower hardware cost than the other two types of networks, while achieving spectrum efficiency close to EON.

We study the problem of providing real-time service to hard and soft real-time messages in wavelength division multiplexing (WDM) optical networks. We propose and evaluate a set of scheduling algorithms which schedule message transmissions in single-hop WDM passive star networks based on specific time constraints. We compare the performances of our algorithms with that of the typical WDM scheduling algorithm which does not consider the time constraint of the transmitted messages by discrete-event simulations and an analytical model. We find that the improvement on real-time performance can be attributed to our scheduling algorithms where the time constraint of messages has been taken into consideration. This study suggests that when scheduling real-time messages in WDM networks, one has to consider not only the problem of resources allocation in the network but also the problem of sequencing messages based on their time constraints.

To utilize the wavelength resources of Internet protocol (IP) over wavelength division multiplexing (WDM) optical networks, a multi-constrained multicast traffic grooming algorithm is proposed in this paper. This algorithm can achieve multicast traffic grooming in IP over WDM optical networks under multi-constraints, including the number of optical transceivers, wavelength conversion capability and wavelength splitting capability. We simulated the traffic grooming algorithm using the topology of GEANT. Emulation results show that our algorithm has a lower blocking proportion compared with the multi-hop traffic grooming algorithm, which can achieve multicast traffic grooming more effectively.

Addresses the problem of efficient communication in unreliable multi-hop optical networks supported by wavelength division multiplexing (WDM). We first define a new cost model for routing in (optical) WDM networks that is more general and realistic than the existing models. Our model takes into consideration not only the cost of wavelength access and conversion but also the cost for wavelength switching when several optical channels of the same wavelength arrive at the same node. We then propose a set of efficient algorithms in both reliable and unreliable WDM networks on the new cost model respectively for each of three important communication patterns-multiple point-to-point routing, multicast and multiple multicast.

In a many-to-many session, a participant distributes and receives traffic flows to/from all others in the same session. It is desirable to achieve both high resource utilization and low power consumption when such sessions are provisioned. In wavelength division multiplexing (WDM) optical networks, traffic grooming has been widely applied as the key technology for aggregating sessions to improve resource utilization. However, the current many-to-many grooming approaches, the lightpath circle and hubbed light-tree, do not make an effort to reduce the power consumption of many-to-many sessions. In this paper, we formulate the green routing and aggregation of many-to-many sessions problem and prove its NP-completeness. For problem solving in WDM optical networks, we apply a rational combined method of lightpaths. Both an integer linear programming-based approach and a novel graph-based heuristic are devised. We further provide an illustrative comparison between our heuristic and the existing benchmarks in terms of power consumption. Extensive simulation results demonstrate that, compared with the benchmarks, our heuristic improves the average power efficiency in the range of 13-19%.

In this paper, we compare performance of fixed-grid Wavelength Division Multiplexing (WDM) and Elastic Optical Networks (EONs) in dynamic provisioning of many-to-many (m2m) flows. Currently, with a growth of services relying on many-to-many communication paradigm such as distributed computing, inter-Data Center communication, content delivery networking or other requiring high-bandwidth in group communication, it is vital to deliver new solutions facilitating these demanding transmissions. Therefore, the authors investigate provisioning of m2m traffic in high-performance optical networks. This work focuses on dynamic Routing and Wavelength Assignment (RWA) problem in WDM networks as well as Routing and Spectrum Allocation (RSA) problem in EONs for m2m flows using replicated communication through auxiliary rendezvous servers.

The subject of the study is an application of evolutionary algorithms to optical node optimization in dense wavelength division multiplexing optical networks. The wider context of the presented research is in essence an improvement of service flexibility and achieving savings in capital expenditures in DWDM networks. Thus, the main objective of the optimization is to minimize capital expenditure, which includes the costs of optical node resources, such as transponders and filters used in new generation of reconfigurable optical add drop multiplexers, etc. For this purpose a model based on integer programming is proposed. The efficiency of the integer programming based software is compared with that of evolutionary algorithms. The results obtained show that there is a large advantage in using evolutionary algorithms for optimizing large optical networks when compared with integer programming and mixed integer programming, whereby the two latter algorithms fail to find the optimal solution within reasonable computational time. The numerical experiments were carried out for realistic networks of different dimensions and traffic demand sets.

We address the issue of inapproximability of the wavelength assignment problem in wavelength division multiplexing (WDM) optical networks. We prove that in an n-node WDM optical network with m lightpaths and maximum load L, if NP ≠ ZPP, for any constant δ>0, no polynomial time algorithm can achieve approximation ratio n1/2−δ or m1−δ, where NP is the class of problems which can be solved by nondeterministic polynomial time algorithms, and ZPP is the class of problems that can be solved by polynomial randomized algorithms with zero probability of error. Furthermore, the above result still holds even when L=2. We also prove that no algorithm can guarantee the number of wavelengths to be less than $$(\sqrt{n}/2)L$$ or (m/2)L. This is the first time inapproximability results are established for the wavelength assignment problem in WDM optical networks. We also notice the following fact, namely, there is a polynomial time algorithm for wavelength assignment which achieves approximation ratio of O(m(log log m)2/(log m)3). Therefore, the above lower bound of m1−δ is nearly tight.

The widespread deployment of wireless telecommunication networks and growing Internet traffic globally leads to a substantial increase in signal traffic demands in fiber optic networks. This demand surge places significant pressure on the survivability of optical networks, specifically when faced with fiber cable failures that prevent failed optical fibers from satisfying connection requests. To address this challenge, in this paper, we consider integrated planning of regenerator installation, optical connection routing, and wavelength assignment (RWA) for wavelength division multiplexing (WDM) optical networks under link failures. To the best of our knowledge, we are the first to consider such an integrated problem. We minimize the number of backup regenerators required to fulfill all connection requests under all potential link failures while accounting for the wavelength and routing constraints. We formulate the problem as an integer program, while its size exponentially increases with the network size by nature. To solve large-scale instances for practical uses in the industry, we propose efficient algorithms to generate near-optimal solutions that are practically implementable. We perform extensive numerical experiments to demonstrate the effectiveness of our approach in solving real-world instances provided by our industry partners. The results show that our approach can efficiently obtain high-quality solutions while ensuring a minimal increase in backup regenerators as the network grows. Our solutions also offer valuable insights into planning a cost-effective and reliable fiber optic network for network operators.

Mobile network operators are facing ever-increasing traffic demands because of the numerous data-hungry applications used by subscribers nowadays. As a result, technologies that support high bandwidth and network availability have become essential. One such technology is dense wavelength division multiplexing (DWDM). This study investigated the evolution of an optical add/drop multiplexer (OADM), which is one of the key components of DWDM technology. The goal of this research was to investigate how the evolution of an OADM has contributed to network survivability and bandwidth enhancement in DWDM optical networks. A thorough search of the literature on an OADM was undertaken using data sources like Google Scholar, Elsevier, ResearchGate, ScienceDirect, Springer, and DWDM vendor manuals. The study found that in order to address present and future DWDM optical network demands, a reconfigurable optical add/drop multiplexer (ROADM) deployed over flexgrid spectrum is essential. The most advanced iteration of a ROADM supports colorless, directionless, contentionless, and flex-grid functionalities, resulting in the most robust, flexible, and future-proof DWDM optical network. The study further found that flex-grid technology supports uplinks with high line rates and has superior spectral efficiency.

Due to widespread applications and rapid development of cloud computing and Internet services, hyperscale data centers have experienced an unprecedented demand for networking. Data center networks are required not only to handle fast-growing traffic, which doubles almost every one to two years, but also to provide high flexibility and availability to support rapidly changing businesses as well. Therefore, hyperscale data center networks have become one of the main drivers for optical interconnect technologies in recent years. In this article, technologies for scaling optical interconnects for inter-data center interconnects (DCIs) are presented. We first describe hyperscale data center network architectures and requirements, as well as the differences between carrier’s optical transport networks and DCI optical networks, with the main focus on metro-DCI and campus-DCI networks. The scale and fast growth rates of DCI networks require innovations not only in data plane technologies but also in control and management planes as well. In data planes, high-capacity flexible coherent technology, pluggable wavelength-division-multiplexing (WDM) optical transponders, including 100G direct-detection four-level pulse-amplitude modulation (PAM4) and coherent 400ZR/800ZR, and flex-grid and disaggregated reconfigurable optical add-drop multiplexer (ROADM) optical networks are described. Control and management planes are an integral part of optical transport networks and crucial for effectively operating DCI networks. We show that standard protocols, data models, and modular design of a software platform are essential to building a scalable open and disaggregated optical network, which is fundamental to enabling high automation and intelligence in an optical network. An example control and management platform is discussed in detail. With current fiber capacity approaching the nonlinear Shannon limit, challenges to further scale DCI networks and some potential technologies to support ever-increasing traffic growth are discussed at the end.

In all-optical Wavelength Division Multiplexing (WDM) technique, data contention is an inevitable challenge. For reliable data transmission, contention resolution is very much essential. There are different contention resolution techniques that are used in optical WDM network. In this paper, wavelength converter is used for contention resolution in optical WDM network. Here Semiconductor Optical Amplifier (SOA) is used to implement wavelength converter based on a special third-order nonlinear susceptibility phenomenon of silica fiber, called Four-Wave Mixing (FWM) technique. Realization of wavelength converter is done for two different sets of WDM networks. Performance of the wavelength converter was estimated in terms of number frequencies generated, number of new wavelength generated, its corresponding power, etc. Result shows that four-wave mixing is a very effective technique to generate new wavelengths at the output to overcome the problems due to contention in an optical WDM network. OptiSystem of Optiwave is used to design schematic layout for the wavelength converter using SOA.

Survivability in waveband switching optical networks: Challenges and new ideas

Dynamic survivable mapping through reconfiguration in IP over WDM network

This chapter discusses the causes of impairments in the optical network and how one takes them into account in the design, followed by the survivability issues in optical networks. It outlines the basic concepts of survivability and different protection and restoration schemes used in optical networks. Survivability can be provided in different layers in network: logical layers and optical layer. The fault‐management schemes in each layer have their own functionalities and characteristics. The chapter also discusses the survivability in the multilayer wavelength division multiplexing (WDM) optical networks. The protection techniques in the synchronous optical network and synchronous digital hierarchy networks are briefly described, which are still used in many of the current protocols in the WDM networks. It looks at protection functions in the optical layer and discusses how protection functions in the different layers of the network can work together.