Using explicit congestion notification in stream control transmission protocol in lossy networks

The Stream Control Transmission Protocol (SCTP) is a reliable transport protocol to tackle the limitations of TCP and UDP. SCTP was originally designed to transport PSTN signaling messages over IP networks, but is also capable of serving as a general-purpose transport protocol. SCTP provides attractive features such as multi-streaming and multi-homing that may be helpful in high-mobility environment. SCTP congestion control mechanisms are based upon TCP congestion principals with the exception of the fast recovery algorithm. Original SCTP congestion control can perform badly in high-speed wide area networks because of its slow response with large congestion window. We proposed a new congestion control scheme based on the simple congestion window modification for SCTP to improve its performance in high-speed wide area networks. The results of several experiments we performed proved that our new suggested congestion control scheme for SCTP in high-speed network improved the throughput of the original SCTP congestion control scheme significantly.

Stream Control Transmission Protocol (SCTP) is an emerging transport protocol for sending data from one point to another over the Internet. The two major new capabilities that are designed into SCTP are the support for multi-homed hosts and the support for multiple streams in a single SCTP association. The purpose of this paper is to investigate the performance of SCTP, measured in terms of association throughput. We analyze the throughput for two experimental scenarios: 1. Transmission of data chunks with different sizes of payload in network stable state (no packet loss). 2. Transmission of data chunks with different sizes of payload in packet loss environment. We have shown the impact of data chunk transmissions with different sizes of payload on the throughput of a multi-homed SCTP association. Our experimental results and analysis show that SCTP provides better throughput in the case of large payload data chunks transmission in both network stable state and packet loss environment.

One of only two new transport protocols introduced in the last 30 years is the Stream Control Transmission Protocol (SCTP). SCTP enables capabilities like additional throughput and fault tolerance for multihomed hosts. An SCTP implementation is included with the Linux kernel and another implementation called sctplib functions successfully in userspace on several platforms but unfortunately neither of these implementations have all of the latest features nor do they perform as well as the FreeBSD kernel implementation of SCTP. We were motivated to produce a portable implementation of the FreeBSD kernel SCTP stack that operates in userspace of any system because of both our desires to obtain a higher performance SCTP stack for Linux as well as to exploit recent developments in hardware virtualization and transport protocol onloading. Unlike any other userspace transport implementation for TCP or SCTP, our userspace SCTP stack simultaneously achieves similar throughput and latency as the Linux kernel TCP stack, without compromising on any of the transport's features as well as maintaining true portability across multiple operating systems and devices. We create a callback API and implement a threshold to control its usage; our userspace SCTP stack with these optimizations obtains higher throughput than the Linux kernel implementation of SCTP. We describe our userspace SCTP stack's design and demonstrate how it gives similar throughput and latency on Linux as the kernel TCP implementation, with the benefits of the new features of SCTP.

We characterize the operation of the SCTP transport protocol over the land mobile satellite channel (LMSC), which is subject to intermittent blockages, and contrast its performance with that of TCP. In particular, we study the ability of SCTP's multihoming capability to adjust to channel blockages. For small files, SCTP's larger connection setup overheads cause single-homed connections to complete transfers slightly slower than TCP. However, depending on the ability of alternate paths, multihoming can improve transfer times so much that SCTP is competitive with an optimized TCP gateway. For large files, quirks in the congestion control of multihomed associations cause performance to deteriorate considerably; though single-homed SCTP is faster than end-to-end TCP, none of the other options can compete with a highly optimized satellite TCP gateway operating without congestion control over the satellite channel. SCTP multihoming semantics do not lend themselves to protocol-spoofing gateways, but some changes to default parameters can help. In the LMSC environment, applications would generally do best to use multihomed SCTP (if available) for small file transfers and gateway-enhanced TCP for larger transactions.

The stream control transmission protocol (SCTP) is a relatively recent transport protocol, offering features beyond TCP. Although SCTP is an alternative transport protocol for the session initiation protocol (SIP), we do not know how SCTP features influence SIP server scalability and performance. To estimate this, we measured the scalability and performance of two servers, an echo server and a simplified SIP server on Linux, for both SCTP and TCP. Our measurements found that using SCTP does not significantly affect data transfer latency. However, the number of sustainable associations drops to 17-21% or to 50% of the TCP value if we adjust the acceptable gap size of packet reordering.

Performance evaluation of subflow capable SCTP

SCTP (Stream Control Transmission Protocol) is a general-purpose transport protocol for IP network data communications. This paper examines methods of guaranteeing multi-streaming management and fairness among streams within SCTP associations. We investigated an important aspect of fairness adjustment between streams of SCTP, the underlying congestion control mechanism. In this paper, we propose that separated congestion control with a fairness compensation module is more efficient than the standard SCTP. Proposed SCTP-SCF overcomes existing problems in the traditional SCTP when a multi-streaming feature is used.

Most current web application use HTTP (Hyper Text Transfer Protocol) and TCP (Transmission Control Protocol) to retrieve objects from the Internet. SCTP (Stream Control Transmission Protocol) is recently proposed transport protocol with congestion control mechanism similar to that of TCP. Waiting delay is an important performance criterion for when transferring web object over the Internet. In this paper, we present an analytical model of mean waiting delay for object transfers over the Internet in a wireless using the SCTP as the transport protocol and compare with the mean waiting in using TCP. Validation of the model using experimental results show that the mean waiting delay for HTTP over SCTP is less than that for HTTP over TCP. This is caused by the small slow-start time of SCTP.

The stream control transmission protocol (SCTP) is a transport protocol that is robust against network failure. However, it cannot select routes for packet rerouting unless the receiver is a multi-homed host. We propose a method that allows single-homed hosts to support SCTP multi-path access; it allows hosts in a local network to select routes to single-homed severs on the Internet. In this method, a single-homed client constitutes a virtual multi-homed client with a Multi-path gateway (MPGW) and communicates with a single-homed server over multiple routes. Our experiments show that a virtual multi-homed client can communicate with a normal SCTP server and that the method establishes connections that experience the same network failure to recover at different times, whereas IP dynamic routing recovers them at the same time.

The Stream Control Transmission Protocol (SCTP) is a relatively new transport protocol. It has several underlying mechanisms that are similar to the Transmission Control Protocol (TCP), as well as several improvements that are important in certain classes of applications. The timeout scheme of SCTP, however, is almost identical to that used in TCP. With dynamics of today's Internet, that timeout scheme may be too passive. This paper presents an algorithm which dynamically adjusts the overall context of the retransmission timeout process without changing the fundamental retransmission mechanisms. This approach manages the impact of fast retransmissions and timeouts to significantly improve the throughput of SCTP applications. The algorithm avoids spurious retransmissions and provides better throughput by intelligently managing RTO boundaries and allowing conventional timeout schemes to participate more actively in the retransmission process.

The stream control transmission protocol (SCTP) is a reliable transport protocol to tackle the limitations of TCP and UDP. SCTP is specified informally in request for comments (RFC) 2960, but it still lacks a formal specification. Coloured Petri net (CPN) is suitable to modeling a system from the dynamic perspective, and has the ability to analyze it in a formal way. We present a formal model of SCTP association management using the CPN. The model is used to examine some properties of SCTP and to check the internal consistency of RFC 2960. Through CPN Tools analysis, we find a problem with some informal descriptions in RFC 2960 and solve it by modifying our original CPN model.

In recent years, a lot of performance evaluation methodologies and tools have been developed within disparate research communities for the purposes of evaluation, design, and model reduction. Among those as a free and powerful evaluation tool, ns2 has attracted more and more users who focus on developing/designing various network protocols. On the other hand, stream control transmission protocol (SCTP) natively supports multi-streaming feature and reorders the out-of-order data chunks, which are stored in stream buffer, based on the stream sequence number (SSN) as per individual stream. Nevertheless, SSN has a 16-bit size and the SCTP receiver of ns2 simply arranges the stored data chunks by the order of their SSNs without other preconditions. In the long-lived SCTP association, however, this may result in a permanent reordering confusion in stream buffer while SSN of any stream wraps back to zero and the stream buffer is not empty then. Eventually, this problem will lead to traffic interruption because of the overflow of the whole receiving buffer and unfortunately impact the evaluation result of the related ideas. This paper points out the potential fatal reordering problem and introduces a simple solution to permanently eliminate this issue. The feasibility of this solution has been proven in our simulations.

SCTP is a transport layer protocol mainly designed for transferring public switched telephone network signalling over IP networks. Some of the protocols that support data transmission are transmission control protocol (TCP), user datagram protocol (UDP), and stream control transmission protocol (SCTP). SCTP is a newly invented reliable, message-oriented transport protocol. It is similar to TCP and UDP with some additional features such as multi-streaming and multi-homing. Even though it is a new protocol with some advanced features, there is a security loophole issue in data transmission using SCTP. Hence, we proposed a new technique to transmit a secret message by hiding it in a secret matrix using the advanced features of SCTP. The simulation of our proposed method provides better performance and high security for secret message transmission against network attacks.

Stream Control Transmission Protocol (SCTP) is an emerging transport protocol for sending data from one point to another over the Internet. SCTP provides innovative features beyond TCP, such as multihoming and multistreaming in a single SCTP association. With the explosive growth of Internet users, it remains an unsecured environment; hence the data protection from the malicious interception becomes a crucial issue. In this paper, we present how the multihoming feature of SCTP can be exploited to implement a multihomed web client and server for providing resilience to network failure and a certain level of data protection against the malicious interception as well as achieving high throughput by utilizing the multiple paths that exist between the multihomed web client and server. We discuss the potential threats during data transmission and the way of defense using multihoming in this aspect.

The Internet-wide deployment of new transport protocols such as the Stream Control Transmission Protocol (SCTP) is a difficult matter. While SCTP could be beneficial in many cases, it is still a major challenge to enable applications to use the new protocol. We believe that its deployment could be significantly accelerated by introducing an intermediate step: transparent usage below TCP, such that TCP-based applications automatically obtain a benefit. We have implemented a Linux based TCP-SCTP mapping tool that exploits SCTP's multi-streaming feature, and carried out measurements which show that such an approach can significantly improve the performance of TCP applications. However, and perhaps more importantly, we also encountered difficulties, which lead us to make some concrete recommendations regarding future research and the implementation and specification of SCTP itself.