Large-size (4–5 µm) superficially porous particles yield lower plate heights (e.g., the minimal reduced plate height or hmin ≈ 1.5) than fully porous particles of a similar size when packed into large-bore columns. This property allows for better chromatographic performance without the higher pressures required for smaller particles. This study explores the use of such particles in microfluidic LC columns where materials and fitting pressure limits can constrain the size of particle used. The theoretically predicted performance improvements compared to fully porous particles were not demonstrated in capillary columns (with hmin ≈ 2 for both particle types), in agreement with previous studies that examined smaller superficially porous particles. Microfluidic columns were then compared to capillary columns. Capillary columns significantly outperformed microfluidic columns due to imperfections imposed by microfluidic channel asymmetry and world-to-chip connection at the optimal flow rate; however, superficially porous particles packed in microfluidic LC columns had flatter plate height versus flow rate curves indicating potential for better performance at high reduced velocities.

The use of a novel micro pressurized liquid extraction (µPLE) method for the isolation of 16 priority pollutant polycyclic aromatic hydrocarbons (PAHs) from various solid samples is explored. The technique employs rapid heating in a single static extraction mode to remove analytes in a matter of seconds from 5–10 mg samples using only 125 µL of solvent. For example, results show that 30 s extractions with toluene at 200 °C produce respective PAH recovery ranges of 90%–130% and 88%–114% from samples of soil and smoked chicken. Comparatively, solids containing significant amounts of biochar were more challenging to extract from. For instance, when using a pure biochar sample matrix, recoveries for the 16 PAHs range from only 33%–66% after 60 s of extraction with toluene at 200 °C. Overall, these extraction results agree very well with those reported when using conventional methods on similar samples. Therefore, the findings indicate that µPLE can potentially provide an alternative sample preparation method for PAHs that is both very rapid and requires little solvent.

We developed an improved model for predicting the steric-entropic effect on the separation behaviors of rod-like particles in flow field-flow fractionation. Our new model incorporates the “pole-vault” rotation of a rod-like particle near a wall under shear flow into the original model developed by Beckett and Giddings which considered only Brownian rotation. We investigated the effect of the aspect ratio on the retention ratios and the cross-sectional concentration distribution in the separation of rods in field-flow fractionation (FFF). Our analyses involved comparing the results predicted using the original model and those from the new model under various rod geometries and flow conditions. We found that the new model can show the aspect ratio-enhanced elution trend in certain flow conditions for the assumption of non-constant cloud thickness (ratio between the cross flow rate and the rod diffusivity). We also deducted that the flow conditions allowing for the aspect ratio-enhanced elution are related to the interplay among the axial flow rate, cloud thickness, and rod geometry. The new model can be viewed as a prototype to qualitatively show the aspect ratio-enhanced trend since its quantitative agreement with the experimental data must be improved for our future work.

Information on the surface properties of three novel chemically bonded phase packing materials for High performance liquid chromatography (HPLC) were obtained using spectra obtained by solid state cross-polarization (CP) magic-angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopic experiments for the 29Si, and 13C nuclei. These packing materials were: Cogent bidentate C18 bonded to type-C silica, hybrid packing materials XTerra MS C18, and XBridge Prep. C18. The spectra obtained using cross-polarization magic angle spinning (CP-MAS) on the Cogent bidentate C18 bonded to type-C silica show the surface to be densely populated with hydride groups (Si-H), with a relative surface coverage exceeding 80%. The hybrid packing materials XTerra and XBridge gave spectra that reveal the silicon atoms to be bonded to organic moieties embedded in the molecular structure of these materials with over 90% of the alkyl silicon atoms found within the completely condensed silicon environments. The hydrolytic stability of these materials were investigated in acidic aqueous solutions at pHs of 7.0 and 3.0, and it was found that while the samples of XTerra and XBridge were not affected by hydrolysis at this pH range, the sample of Cogent lost a significant proportion of its Si-H groups after five days of treatment in acidic aqueous solution.

Spherical polyimide particles have been synthesized as an extraction medium of volatile organic compounds (VOCs) in air samples. The polyimide was prepared with the starting materials of pyromellitic dianhydride (PMDA) and 4,4'-diaminodiphenyl ether (4,4'-oxydianiline, ODA), resulting spherical particles having an average diameter of about 5 µm. Packed into a laboratory made mini-extraction tube, the synthesized PMDA-ODA particles were employed as the adsorbent for the subsequent analysis in capillary gas chromatography. The extraction capacities for acetone, hexane, toluene are 0.42, 0.24, 0.78 µmol/g, respectively. The recoveries for these typical organic compounds are more than about 95%. The results clearly showed a good adsorption ability of the PMDA-ODA particles to typical VOCs frequently found in indoor environments, suggesting a future possibility to develop a more miniaturized sample preparation device specially-designed for on-site sampling of indoor air samples.

Preconcentration of aqueous solution of aromatic compounds was successfully carried out with an extraction capillary packed with a bundle of polymer-coated filaments. The extracted analytes were sequentially eluted with a flow of pure water using programmed temperature elevation of the extraction capillary. The results clearly suggest that the polymer-coated fiber-packed capillary could be employed as a sample preparation medium for the analysis of aqueous matrices. The fraction of interest could be transferred to conventional microcolumn liquid chromatography (LC) allowing a heart cutting analysis of aqueous matrices. Stability of the fiber-packed capillary was confirmed with pure water as the mobile phase at elevated temperatures.

Because of the structural similarity between long linear polyamine isomers, it is often very difficult to differentially quantify each hexaamine found in thermophilic bacteria. To quantify thermohexamine and homothermohexamine, for which separation has not been previously achieved, we analyzed a mixture of the heptafluorobutyryl derivatives of the two authentic hexaamines using gas chromatography-mass spectrometry (GC-MS). We found a correlation between the ratio of the hexaamines and the ratio of the intensities of two unique fragment ions in the MS spectra detected at m/z 774 in thermohexamine and m/z 1027 in homothermohexamine. The ratio of m/z (774/1027) vs. thermohexamine/homothermohexamine and m/z (1027/774) vs. homothermohexamine/thermohexamine calibration lines showed high linearity (r = 0.9997 and 0.9990, respectively) for hexaamine mixing ratios in the range of 0–2.33. These data indicate that the ratio of the hexaamines in a mixed solution can be determined by using the appropriate calibration line, depending on which hexaamine is present in greater quantity.

The effect of the modifier concentration and flow rate on the chromatographic performance of a second generation Chromolith® RP-18e column, under isocratic and gradient elution with acetonitrile-water mixtures, was examined using four sulphonamides as probe compounds. The acetonitrile concentration was varied between 5 and 55% (v/v), and the flow rate between 0.1 and 5.0 mL/min, keeping the other factors constant. The changes in both retention and peak profile were modelled, and used to build simple plots, where the logarithm of the retention factor was represented against the modifier concentration (in gradient elution, against the initial modifier concentration), and the half-widths or widths against the retention time (in gradient elution, against the time at the column outlet). A particular plot was needed for describing the retention of each sulphonamide, but due to the similar interaction kinetics, a unique plot described the changes in the half-widths for all four sulphonamides. The changes in retention with the flow showed that allegedly in the second generation Chromolith, the column deformation observed for the first generation Chromolith, with the applied pressure at increasing flow, is decreased.

Odour profiling of decomposed remains is important for understanding the mechanisms that cadaver dogs and forensically-relevant insects use to locate decomposed remains. The decomposition odour profile is complex and has been documented in outdoor terrestrial environments. The purpose of this study was to perform longitudinal analysis of the volatile organic compound (VOC) profile in soils associated with decomposed remains across all stages of decomposition. Two VOC collection techniques (sorbent tubes and solid phase microextraction) were used to collect a wider analyte range and to investigate differences in collection techniques. Pig carcasses were placed in an outdoor research facility in Australia to model the decomposition process and VOCs were collected intermittently over two months. VOCs of interest were identified over the duration of the trial, showing distinct trends in compound evolution and disappearance. The collection techniques were complementary, representing different subsets of VOCs from the overall profile. Sorbent tubes collected more decomposition-specific VOCs and these compounds were more effective at characterising the matrix over an extended period. Using both collection techniques improves the likelihood of identifying the complete VOC profile of decomposition odour. Such information is important for the search and recovery of victim remains in various stages of decomposition.

Exhaled breath condensate (EBC) has been established as a potential source of respiratory biomarkers. Compared to the numerous small molecules identified, the protein content of EBC has remained relatively unstudied due to the methodological and technical difficulties surrounding EBC analysis. In this review, we discuss the proteins identified in EBC, by mass spectrometry, focusing on the significance of those proteins identified. We will also review the limitations surrounding mass spectral EBC protein analysis emphasizing recommendations to enhance EBC protein identifications by mass spectrometry. Finally, we will provide insight into the future directions of the EBC proteomics field.