The Saimaa ringed seal (Pusa hispida saimensis) is a subspecies of ringed seal, landlocked in Lake Saimaa, Finland. The small population of less than 500 seals is facing many human-induced threats, including chemical contaminants. Mercury, in particular, has previously been suggested to be one of the chemicals affecting the viability of this endangered population. We analysed mercury concentrations from placentas and lanugo pup tissues (blubber, brain, kidney, liver, and muscle) to determine current prenatal exposure levels. These pups were found dead in or near birth lairs and were less than 3 months old. Additionally, we used threshold values available in the literature to estimate the potential mercury toxicity to the Saimaa ringed seal. We also determined selenium concentrations for its potential to alleviate the adverse effects of mercury. We further supplemented our study with brain samples collected from various seal age classes. These seals were found dead by either natural causes or by being caught in gillnets. The analysed chemicals were present in all tissues. For lanugo pups, mercury concentrations were the highest in the kidney and liver, whereas the highest selenium to mercury molar ratio was observed in placentas. The toxicity evaluation suggested that, in severe cases, mercury may cause adverse effects in lanugo and older pups. In these cases, the selenium concentrations were low and selenium to mercury ratio was below 1:1 threshold ratio and thus unlikely to provide adequate protection from the adverse effects of mercury. Furthermore, adverse effects are more likely to occur in adult seals, as mercury bioaccumulates, leading to higher concentrations in older individuals. Placental mercury concentrations correlated to those in the livers and muscle tissues of lanugo pups. This, together with the fact that placentas can be collected non-invasively and in good condition, provides a potential novel method for biomonitoring mercury exposure in Saimaa ringed seals.

Under regulations such as REACH, testing of novel and established compounds for their (neuro)toxic potential is a legal requirement in many countries. These are largely based on animal-, cost-, and time-intensive in vivo models, not in line with the 3 Rs’ principle of animal experimentation. Thus, the development of alternative test methods has also received increasing attention in neurotoxicology. Such methods focus either on physiological alterations in brain development and neuronal pathways or on behavioral changes. An example of a behavioral developmental neurotoxicity (DNT) assay is the zebrafish (Danio rerio) embryo coiling assay, which quantifies effects of compounds on the development of spontaneous movement of zebrafish embryos. While the importance of embryo-to-embryo contact prior to hatching in response to environmental contaminants or natural threats has been documented for many other clutch-laying fish species, little is known about the relevance of intra-clutch contacts for zebrafish. Here, the model neurotoxin rotenone was used to assess the effect of grouped versus separate rearing of the embryos on the expression of the coiling behavior. Some group-reared embryos reacted with hyperactivity to the exposure, to an extent that could not be recorded effectively with the utilized software. Separately reared embryos showed reduced activity, compared with group-reared individuals when assessing. However, even the control group embryos of the separately reared cohort showed reduced activity, compared with group-reared controls. Rotenone could thus be confirmed to induce neurotoxic effects in zebrafish embryos, yet modifying one parameter in an otherwise well-established neurotoxicity assay such as the coiling assay may lead to changes in behavior influenced by the proximity between individual embryos. This indicates a complex dependence of the outcome of behavior assays on a multitude of environmental parameters.

The preparation of highly active, rare earth, non-platinum-based catalysts for hydrogen evolution reactions (HER) in alkaline solutions would be useful in realizing green hydrogen production technology. Perovskite oxides are generally regarded as low-active HER catalysts, owing to their unsuitable hydrogen adsorption and water dissociation. In this article, we report on the synthesis of Li2ZrO3 perovskites substituted with samarium and terbium cations at A-sites for the HER. LSmZrO3 (LSmZO) and LTbZrO3 (LTbZO) perovskite oxides are more affordable materials, starting materials in abundance, environmentally friendly due to reduced usage of precious metal and moreover have potential for several sustainable synthesis methods compared to commercial Pt/C. The surface and elemental composition of the prepared materials have been confirmed by X-ray photoelectron spectroscopy (XPS). The morphology and composition analyses of the LSmZO and LTbZO catalysts showed spherical and regular particles, respectively. The electrochemical measurements were used to study the catalytic performance of the prepared catalyst for hydrogen evolution reactions in an alkaline solution. LTbZO generated 2.52 mmol/g/h hydrogen, whereas LSmZO produced 3.34 mmol/g/h hydrogen using chronoamperometry. This was supported by the fact that the HER electrocatalysts exhibited a Tafel slope of less than 120 mV/dec in a 1.0 M alkaline solution. A current density of 10 mA/cm2 is achieved at a potential of less than 505 mV. The hydrogen production rate of LTbZO was only 58.55%, whereas LSmZO had a higher Faradaic efficiency of 97.65%. The EIS results demonstrated that HER was highly beneficial to both electrocatalysts due to the relatively small charge transfer resistance and higher capacitance values.

In Morocco, red fruit production has thrived, primarily utilizing hydroponic methods to control crops, increase fruit yield and quality, and avoid soil-related problems. However, the irrigation of these expansive hydroponic farms relies heavily on water sourced from dams, many of which are contaminated with Microcystins (MCs). To address this contamination issue, ongoing research is focused on discovering effective and cost-efficient biological solutions for eliminating MCs. In this study, we isolate and identify bacterial strains capable of degrading MCs, evaluate the rate of degradation, and investigate how soil inoculated with these bacteria affects the accumulation of MCs in plant tissue. The partial 16S rRNA analyses of three bacterial sequences were conducted, identifying them through NCBI as follows: Ensifer sp. (B1) isolated from soil, Shinella sp. (B2) from a cyanobacterial bloom, and Stutzerimonas sp. (B3) from water. These bacteria exhibited the ability to degrade MCs, with approximately 34.75%, 73.75%, and 30.1% of the initial concentration (20 µg/L) being removed after a 6-day period for B1, B2, and B3, respectively. Moreover, strawberry plants were cultivated hydroponically in a greenhouse for a duration of 90 days. These plants were subjected to extracts of cyanobacteria containing 10 and 20 µg/L of Microcystins (MC), as well as water from an artificial lake contaminated with MC, both with and without the presence of isolated bacterial strains. Among these strains, Shinella sp. exhibited the highest efficacy in mitigating MC accumulation. Specifically, it resulted in a reduction of approximately 1.159 µg of MC per kilogram of root dry weight, leading to complete elimination in the leaves and fruits. The findings also indicated that the inoculation of perlite with the three MC-degrading bacterial strains significantly enhanced growth, photosynthetic pigments, yield, biochemical constituents, and quality attributes of strawberries (p ≤ 0.05). These promising outcomes suggest the potential of this approach for addressing the adverse impacts of crops irrigated with MC-contaminated water in future agricultural practices.

Agricultural environments are becoming increasingly contaminated with plastic pollution. Plastics in the environment can also provide a unique habitat for microbial biofilm, termed the ‘plastisphere’, which can also support the persistence of human pathogens such as Salmonella. Human enteric Salmonella enterica serovar Typhimurium can enter agricultural environments via flooding or from irrigation with contaminated water. Using soil mesocosms we quantified the ability of S. Typhimurium to persist on microplastic beads in two agriculturally relevant soils, under ambient and repeat flood scenarios. S. Typhimurium persisted in the plastisphere for 35 days in both podzol and loamy soils; while during multiple flood events was able to survive in the plastisphere for up to 21 days. S. Typhimurium could dissociate from the plastisphere during flooding events and migrate through soil in leachate, and importantly could colonise new plastic particles in the soil, suggesting that plastic pollution in agricultural soils can aid S. Typhimurium persistence and facilitate further dissemination within the environment. The potential for increased survival of enteric human pathogens in agricultural and food production environments due to plastic contamination poses a significant public health risk, particularly in potato or root vegetable systems where there is the potential for direct contact with crops.

The mobility of heavy metals in natural soil systems can be affected by the properties and compositions of those systems: the content and quality of organic matter as well as the character of inorganic constituents. In this work, the diffusion of copper(II) ions in humic hydrogels with incorporated calcium(II), magnesium(II), and iron(III) ions was investigated. The methods of instantaneous planar source and of constant source were used. Experimental data yielded the time development of the concentration in hydrogels and the values of effective diffusion coefficients. The coefficients include both the influence of the hydrogel structure and the interaction of diffusing particles with the hydrogel. Our results showed that the presence of natural metal ions such as calcium, magnesium, or iron can strongly affect the diffusivity of copper in humic systems. They indicate that the mobility of copper ions depends on their concentration. The mobility can be supported by higher contents of copper in the system. While the incorporation of Ca and Mg resulted in the decrease in the diffusivity of copper ions, the incorporation of Fe(III) into humic hydrogel resulted in an increase in the diffusivity of Cu(II) in the hydrogel in comparison with pure humic hydrogel.

Leveraging date palm spikelets (DPS) as a precursor, this study developed a DPS-derived composite (ZnO@DPS-AC) for water treatment, focusing on methyl orange (MO) removal. The composite was synthesized through ZnCl2 activation and pyrolysis at 600 °C. Comprehensive characterization was conducted using TGA, FTIR, XRD, SEM/EDS, and pHPZC. Characterization revealed a highly carbonaceous material (> 74% carbon) with significant porosity and surface functional groups. ZnO@DPS-AC demonstrated rapid MO removal, achieving over 45% reduction within 10 min and up to 99% efficiency under optimized conditions. The Langmuir model-calculated maximum adsorption capacity reached 226.81 mg/g at 20 °C. Adsorption mechanisms involved hydrogen bonding, π-π interactions, and pore filling. The composite showed effectiveness in treating real wastewater and removing other pollutants. This study highlights the potential of agricultural waste valorization in developing efficient, sustainable adsorbents for water remediation, contributing to circular bioeconomy principles.

In Fiji, 90% of the population has access to basic sanitation; however, there are still persistent health risks from endemic faecal-oral diseases such as typhoid fever. There is a need to assess the contribution of existing sanitation facilities in the faecal pathogen transmission pathway. This study was conducted as part of a larger planetary health study across 29 rural communities within five river catchments. This specific research aimed to characterise latrine front-ends, both infrastructure and usage behaviour, and to assess the faecal contamination levels on various frequently contacted latrine surfaces in rural Fiji. A sanitation survey, along with observation and latrine swab sampling, was conducted in households over three phases: baseline (n = 311) (Aug–Dec 2019), endline (n = 262) (Jun–Sep 2022) and an in-depth front-end study (n = 12) (Oct–Nov 2022). Of 311 households, almost all had pedestal-type latrines, predominately cistern-flush (83%), followed by pour-flush (13%), and then hole-type (pit) latrines (4%). Washable latrine floors had significantly higher E. coli densities (6.7 × 102 CFU/25 cm2) compared to non-washable floors (1.3 × 102 CFU/25 cm2) (p = 0.05), despite washable floors indicating improved latrines. The in-depth front-end analysis found that moist latrine surfaces had significantly elevated E. coli densities (1.2 × 103 CFU/25 cm2) compared to the dry ones (14.3 CFU/25 cm2) (p < 0.001), highlighting the importance of maintaining dry latrine surfaces. Latrine floors and mid-walls were the most frequently contaminated surfaces, emphasising the need to clean and disinfect these surfaces. Only 46% of the households reported always using soap for handwashing after defecation, exacerbating the risk of transmitting faecal pathogens. This study highlights that latrine cleanliness and hygiene are as crucial as latrine infrastructures for the effective disruption of faecal pathogens transmission during latrine use.

New Zealand relies on imported fossil fuels for about 38% of its primary energy. The country’s energy demand is expected to grow due to population and economic growth, which will put more pressure on the energy system. Besides, resource scarcity, energy price volatility, and environmental challenges have made energy security a major concern for New Zealand and other countries. Given the lack of significant research on the effects of energy security factors in New Zealand, this study aims to shed light on the primary determinants of energy security using the dynamic autoregressive distributed lag method based on time series data from 1978 to 2021. The study found that a long-run link exists between energy security and energy intensity (energy efficiency), renewable energy use, fossil fuel consumption, and global oil prices. Real GDP, renewable energy consumption, and energy security were found to improve energy security, while fossil fuel consumption and world oil prices had a negative impact. The study also revealed a one-way causality from real GDP, fossil fuel consumption, and renewable energy use to energy security. In contrast, the relationship between energy intensity and energy security is bidirectional. Simulation results showed that global crude oil prices have a lower impact on energy security compared to other variables and are most responsive to a 5% shock in fossil fuel consumption, followed by economic growth.

Passive sampling is a crucial method for evaluating concentrations of hydrophilic organic compounds in the aquatic environment, but it is insufficiently understood to what extent passive samplers capture the intermittent emissions that frequently occur for this group of compounds. In the present study, silicone sheets and styrene-divinyl benzene-reversed phase sulfonated extraction disks with and without a polyethersulfone membrane were exposed under semi-field conditions in a 31 m3 flume at three different flow velocities. Natural processes and spiking/dilution measures caused aqueous concentrations to vary strongly with time. The data were analyzed using two analytical models that account for these time-variable concentrations: a sampling rate model and a diffusion model. The diffusion model generally gave a better fit of the data than the sampling rate model, but the difference in residual errors was quite small (median errors of 19 vs. 25% for silicone and 22 vs. 25% for SDB-RPS samplers). The sampling rate model was therefore adequate enough to evaluate the time-integrative capabilities of the samplers. Sampler performance was best for SDB-RPS samplers with a polyethersulfone membrane, despite the occurrence of lag times for some compounds (0.1 to 0.4 days). Sampling rates for this design also spanned a narrower range (80 to 110 mL/day) than SDB-RPS samplers without a membrane (100 to 660 mL/day). The effect of biofouling was similar for all compounds and was consistent with a biofouling layer thickness of 150 µm.