Association of French Motorway Companies

Pengklasifikasian dokumen teks sangatlah diperlukan di tengah-tengah perkembangan teknologi. Efektifitas dan biaya dalam pengelompokan manual menjadi faktor utama diperlukannya pengelompokan secara otomatis. Pengelompokan dokumen adalah proses pengkategorian dokumen-dokumen teks berdasarkan kategori isi dokumen. Dalam mengklasifikan judul-judul tugas akhir mahasiswa ke dalam kelas-kelas tertentu sesuai dengan kajiannya masing-masing dan memberikan rekomendasi dosen pembimbing dan penguji yang keahliannya sesuai dengan kajian judul tugas akhir tersebut.

A thermo-mechanical simulation of the wire + arc additive manufacturing (WAAM) process is presented in this work. The simulation consists in the deposition of 5 successive layers of 316 L stainless steel on a 316 L base plate. The thermo-mechanical analysis is solved in two dimensions under plane stress assumption. Nonetheless, the metal addition is taking into account in this numerical analysis. An increment of material is added at each time step. This numerical approach allows reducing the computational time. The temperature and residual stress fields are computed at each time step. Two patterns of deposition strategy are also investigated. It is shown that the longitudinal stress varies mainly along the vertical axis. A sample with 5 overlaid layers has been scanned with neutron diffraction technique in order to measure the final residual stresses. Both numerical and measured residual stresses are in good agreement. The Aster finite element software is employed for the numerical analysis.

Abstract Marine fisheries target and catch fish both for direct human consumption (DHC) as well as for fishmeal and fish oil, and other products. We derived the fractions used for each for 1950–2010 by fishing country, and thus provide a factual foundation for discussions of the optimal use of fisheries resources. From 1950 to 2010, 27% (~20 million tonnes annually) of globally reconstructed marine fisheries landings were destined for uses other than DHC. Importantly, 90% of fish destined for uses other than DHC are food‐grade or prime food‐grade fish, while fish without a ready market for DHC make up a much smaller proportion. These findings have implications for how we are using fish to feed ourselves or, more appropriately, how we are not using fish to feed ourselves.

In this paper, non-contact measurements are presented to observe droplet oscillations and to measure surface temperature during Pulsed GMAW. The techniques enable to investigate in situ the behavior of mild steel liquid metal surrounded by Ar + 8%CO2 plasma and then to measure temperature dependence of surface tension. Different temperatures are obtained by changing the process parameters. Surface tension values are a little higher than values found in the literature but the results demonstrate the interest of the developed setup. To conclude, a non-dimensional analysis is carried out, based on experimental results, to investigate the relative importance of the different phenomena acting during the transfer.