- Research Article
- 10.1016/j.engstruct.2025.121503
Cyclic performance and analytical study of novel energy-consuming brace using rubber strips for suspended pipe system restraints
- Dec 01, 2025
- Engineering Structures
- Lei Guo + 2 more +2
Publications from 2021 to 2026
Showing 10 of 19 papers
Cyclic performance and analytical study of novel energy-consuming brace using rubber strips for suspended pipe system restraints
Dynamic Performance of a Geosynthetic-Reinforced Soil Bridge Abutment in a Shaking Table Test
With the widespread application of geosynthetic reinforced soil (GRS) bridge abutment technology, the construction of GRS bridge abutments in seismically active areas has become commonplace. To assess the dynamic response of GRS bridge abutments to earthquakes, this study uses a half-scale GRS bridge abutment model, in which longitudinal vibrations with different peak ground accelerations (PGAs) are applied to obtain the acceleration, deformation, soil stress, and reinforcement strain. The natural frequency and damping ratio trends are obtained using spare time-domain identification. In addition, the Hilbert and marginal spectra of the signals are obtained based on the Hilbert–Huang transform, and the damage evolution state is analyzed from both the time-frequency domain and energy perspectives. The results show that damage occurs at the top of the GRS abutment under dynamic conditions, the overall natural frequency of the abutment decreases, and the damping ratio increases. When the input motion PGAs were ≤0.4g, the abutment displacement and soil stress recover after the vibration, indicating that the bridge abutment performs well in this strength range. The amplitude of the Hilbert spectrum is positively correlated with the PGA amplitude of the input seismic wave, and no significant change is observed under smaller PGA conditions. By analyzing the trend of the amplitude of the marginal spectra of the different layers with the peak PGA value, the top of the bridge abutment is damaged, which verifies the spare time-domain identification results. This study provides a novel approach for the seismic damage identification and design optimization of GRS bridge abutments.
Read moreComparison of several seismic active earth pressure calculation methods for retaining structures
Abstract Earthquake earth pressure is one of the key parameters for the seismic design of retaining structures. In this work, the seismic earth pressure calculation methods used in the design specifications of retaining walls, bridge abutments, and other retaining structures in various countries are summarized. Moreover, different calculation methods and examples are analysed and compared. A comparison shows that most of the specifications used or modified the M-O method for calculating seismic active earth pressure, and the calculation approach is basically consistent. The difference in the seismic active earth pressure at the bottom of the retaining walls calculated with various specifications gradually increases with increasing seismic peak acceleration. The coefficient of seismic active earth pressure and the resultant force of seismic active earth pressure both increase with increasing seismic peak acceleration. The calculation method, which considers the additional load at the top, results in a seismic earth pressure resultant force point at a height of above 1/3 H . When calculating the seismic active earth pressure of reinforced soil structures under various specifications, the effect of reinforcement materials on the reduction in wall back earth pressure is not considered, and the calculation results are relatively conservative. The comparison results can provide a reference for the optimization and improvement of the seismic design of retaining structures, such as reinforced earth retaining walls.
Read morePrediction model for generation trend of axial deformation of saturated coral sand under cyclic loading
Experimental study on the static rolling friction coefficient of a flat-roller-flat configuration considering surface roughness
Fixed-axis shear characteristics of marine coral sand under various consolidation conditions
Temporal distribution model and occurrence probability of M ≥ 6.5 earthquakes in North China Seismic Zone
The temporal distribution of earthquakes provides important basis for earthquake prediction and seismic hazard analysis. The relatively limited records of strong earthquakes have often made it di cult to study the temporal distribution models of regional strong earthquakes. However, there are hundreds of years of complete strong earthquake records in North China Seismic Zone, providing abundant basic data for studying temporal distribution models. Using the data of M ≥ 6.5 earthquakes in North China as inputs, this paper estimates the model parameters using the maximum likelihood method with exponential, Gamma, Weibull, Lognormal and Brownian passage time (BPT) distributions as target models. The optimal model for describing the temporal distribution of earthquakes is determined according to Akaike information criterion (AIC), determination coe cient R 2 and Kolmogorov-Smirnov test (K-S test). The results show that Lognormal and BPT models perform better in describing the temporal distribution of strong earthquakes in North China. The mean recurrence periods of strong earthquakes (M ≥ 6.5) calculated based on these two models are 8.1 years and 13.2 years, respectively. In addition, we used the likelihood pro le method to estimate the uncertainty of model parameters. For the BPT model, the mean and 95% con dence interval of recurrence interval µ is 13.2 (8.9-19.1) years, and the mean and 95% con dence interval of α is 1.29 (1.0-1.78). For the Lognormal model, the mean value and 95% con dence interval of v is 2.09 (1.68-2.49), the mean value exp (v) corresponding to earthquake recurrence interval is 8.1 (5.4-12.1) years. In this study, we also calculated the occurrence probability of M ≥ 6.5 earthquakes in North China Seismic Zone in the future, and found that the probability and 95% con dence interval in the next 10 years based on the BPT model is 35.3% (26.8%-44.9%); the mean value and 95% con dence interval of earthquake occurrence probability based on the Lognormal distribution is 35.4% (22.9%-49.7%); the mean probability and 95% con dence interval based on the Poisson model is 53.1% (41.1%-64%). The results of this study may provide important reference for temporal distribution model selection and earthquake recurrence period calculation in future seismic hazard analysis in North China.
Read moreEcological response of land use change in a large opencast coal mine area of China
Study on Response Spectrum of Seismic Design of Ultra High Voltage Converter Valves in Bedrock Site
It is difficult to evaluate seismic performance of ultra-high voltage (UHV) converter valves reasonably because the response spectrum period used in seismic design of electrical equipment fails to cover the structural period of UHV converter valves at present. Bedrock response spectrum is the basis of seismic design response spectrum. 471 records of long period strong earthquakes in bedrock were analysed. The amplification power spectra and average spectra of all records were calculated. The seismic hazard analysis of 17 typical UHV converter stations was carried out, and the bedrock response spectra with exceedance probability of 10% and 2% in 50 years were proposed. The structural forms of the existing main response spectrum descending segments were compared and analysed. The corresponding response spectra of the long period strong earthquake records and the bedrock response spectra of the UHV converter station were fitted. The bedrock response spectrum of the UHV converter valves with the period range of 0-10s was determined, which lays a foundation for the seismic performance evaluation of the UHV converter valves.
Read moreGeochemical characteristics of Holocene loess-paleosol sequences in central Chinese Loess Plateau and their implications for East Asian monsoon evolution