East Paris Institute of Chemistry and Materials Science

A non-steady state mathematical model of an amino acid (phenylalanine (Phe)) and mineral salt (NaCl) solution separation by neutralization dialysis (ND) carried out in a batch mode is proposed. The model takes into account the characteristics of membranes (thickness, ion-exchange capacity, and conductivity) and solutions (concentration, composition). As compared to previously developed models, the new one considers the local equilibrium of Phe protolysis reactions in solutions and membranes and the transport of all the phenylalanine forms (zwitterionic, positively and negatively charged) through membranes. A series of experiments on ND demineralization of the NaCl and Phe mixed solution was carried out. In order to minimize Phe losses, the solution pH in the desalination compartment was controlled by changing the concentrations of the solutions in the acid and alkali compartments of the ND cell. The validity of the model was verified by comparison of simulated and experimental time dependencies of solution electrical conductivity and pH, as well as the concentration of Na+, Cl− ions, and Phe species in the desalination compartment. Based on the simulation results, the role of Phe transport mechanisms in the losses of this amino acid during ND was discussed. In the experiments carried out, the demineralization rate reached 90%, accompanied by minimal Phe losses of about 16%. Modeling predicts a steep increase in Phe losses when the demineralization rate is higher than 95%. Nevertheless, simulations show that it is possible to achieve a highly demineralized solution (by 99.9%) with Phe losses amounting to 42%.

New techniques and modifications of old procedures appear and disappear in the history of Orthopaedics and Medicine. A brief summary of the articles published in history sections and topical collections are useful to understand the linkages between past and present A brief review of a Journal published 20 or 30 years ago describes the trends and facts valid for that time.

The study of the transition from high-entropy alloys (HEAs) to conventional alloys (CAs) composed of the same alloying components is apparently important, both for understanding the formation of HEAs and for proper evaluation of their potential with respect to that of the corresponding CAs. However, this transition has thus far been studied in only two types of alloy systems: crystalline alloys of iron group metals (such as the Cantor alloy and its derivatives) and both amorphous (a-) and crystalline alloys, TE-TL, of early (TE = Ti, Zr, Nb, Hf) and late (TL = Co, Ni, Cu) transition metals. Here, we briefly overview the main results for the transition from HEAs to CAs in these alloy systems and then present new results for the electronic structure (ES), studied with photoemission spectroscopy and specific heat, atomic structure, thermal, magnetic and mechanical properties of a-TE-TL and Cantor-type alloys. A change in the properties of the alloys studied on crossing from the HEA to the CA concentration range mirrors that in the ES. The compositions of the alloys having the best properties depend on the alloy system and the property selected. This emphasizes the importance of knowing the ES for the design of new compositional complex alloys with the desired properties.

Hexagonal La2Ni7 and rhombohedral Y2Ni7 are weak itinerant antiferromagnet (wAFM) and ferromagnet (wFM), respectively. To follow the evolution between these two compounds, the crystal structure and magnetic properties of A2B7 intermetallic compounds (A = La, Y, B = Ni) have been investigated combining x-ray powder diffraction and magnetic measurements. The La2−xYxNi7 intermetallic compounds with 0 ⩽ x ⩽ 1 crystallize in the hexagonal Ce2Ni7-type structure with Y preferentially located in the [A2B4] units. The compounds with larger Y content (1.2 ⩽ x < 2) crystallize in both hexagonal and rhombohedral (Gd2Co7-type) structures with a substitution of Y for La in both [A2B4] and [AB5] units. Y2Ni7 crystallizes in the rhombohedral structure only. The average cell volume decreases linearly versus Y content, whereas the c/a ratio presents a minimum at x = 1 due to geometric constrains. The magnetic properties are strongly dependent on the structure type and the Y content. La2Ni7 displays a complex metamagnetic behavior with split AFM peaks. Compounds with x = 0.25 and 0.5 display a wAFM ground state and two metamagnetic transitions, the first one toward an intermediate wAFM state and the second one toward a FM state. TN and the second critical field μ0Hc2 increase with the Y content, indicating a stabilization of the AFM state. LaYNi7, which is as the boundary between the two structure types, presents a very wFM state at low field and an AFM state as the applied field increases. All the compounds with x > 1, and which contains a rhombohedral phase are wFM with TC = 53(2) K. In addition to the experimental studies, first principles calculations using spin polarization have been performed to interpret the evolution of structural phase stability for 0 ⩽ x ⩽ 2.

We report the use of efficient visible-light sensitive allyl (QA) and epoxidized (QE) quinizarin derivatives as photoinitiating systems when combined with an appropriate electron donor (methyldiethanol amine, MDEA), an electron acceptor (iodonium salt, Iod), or a H donor (thiol derivative), for free-radical photopolymerization (FRP), cationic photopolymerization (CP), and a thiol–ene process. These systems have demonstrated excellent initiating properties under air or in laminated conditions under visible-light irradiation (LEDs@405, 455, and 470 nm or Xe lamp) for FRP, CP, or the thiol–ene process and appear more efficient than the well-known camphorquinone-based photoinitiating systems. As highlighted by electron paramagnetic resonance (EPR) and laser flash photolysis experiments, QA (or QE) acts either as an electron donor via a photoinduced electron transfer pathway with Iod or as a proton/proton-coupled electron transfer promoter with MDEA or a thiol derivative. Two types of interpenetrated polymer n...

O desenvolvimento de materiais para aplicação e aumento da eficiência de equipamentos submetidos a altas temperaturas de trabalho, como turbinas aeronáuticas, tem motivado o estudo de materiais à base de metais refratários, dentre os quais o nióbio, o cromo, o háfnio e o titânio. O conhecimento das relações de fases nesses materiais através da elaboração de diagramas de fases é fundamental para a determinação de suas propriedades mecânicas e térmicas. Com o objetivo de determinar a seção isotérmica a 1200 ºC dos sistemas Nb-Si-Ti e Cr-Hf-Nb, foi realizada a caracterização microestrutural de ligas tratadas termicamente a 1200 ºC por 720 horas, utilizando-se de difratometria de raios-X, imagens de microscopia eletrônica de varredura e análise em microssonda eletrônica. A identificação das fases e das regiões de equilíbrio de fases foi feita com os dados obtidos pelos três métodos acima de forma conjugada. O objetivo deste artigo é apresentar uma forma de analisar os dados de EPMA com a utilização de ferramenta gráfica, o que facilita sua interpretação.

Two-dimensional crystals of semimetallic van der Waals materials hold much potential for the realization of novel phases, as exemplified by the recent discoveries of a polar metal in few layer 1T'-WTe$_2$ and of a quantum spin Hall state in monolayers of the same material. Understanding these phases is particularly challenging because little is known from experiment about the momentum space electronic structure of ultrathin crystals. Here, we report direct electronic structure measurements of exfoliated mono-, bi-, and few-layer 1T'-WTe$_2$ by laser-based micro-focus angle resolved photoemission. This is achieved by encapsulating with monolayer graphene a flake of WTe$_2$ comprising regions of different thickness. Our data support the recent identification of a quantum spin Hall state in monolayer 1T'-WTe$_2$ and reveal strong signatures of the broken inversion symmetry in the bilayer. We finally discuss the sensitivity of encapsulated samples to contaminants following exposure to ambient atmosphere.