- Research Article
1
- 10.1016/j.bioorg.2026.109692
Green MW/US route from lignocellulose to FDCA-based thiadiazol scaffolds: DPP-4/COX-1 inhibition and antioxidant evaluation.
- Jun 01, 2026
- Bioorganic chemistry
- Sameh A Rizk + 2 more +2
Publications from 2021 to 2026
Showing 10 of 570 papers
Green MW/US route from lignocellulose to FDCA-based thiadiazol scaffolds: DPP-4/COX-1 inhibition and antioxidant evaluation.
Sensitivity and detection range-tailored self-powered sensing enabled by gradient porous nanocomposites for posture monitoring
Dual-redox cycling driven charge transfer in CuxO/CeO2 heterojunction for photocatalytic activation of peroxymonosulfate toward tetracycline degradation.
What drives methane emissions from sanitation containment systems?
Onsite sanitation coverage has expanded significantly since 2020, driven by global commitments to eliminate open defecation and the need for adaptable solutions in rapidly urbanising small- and medium-sized cities (<1 million inhabitants) in Low- and Middle-Income Countries. Currently, 53% of individuals with access to a toilet depend on onsite sanitation systems. Despite this prevalence, the contribution of greenhouse gas emissions from household-level excreta storage to climate change remains poorly quantified due to limited empirical evidence. We addressed this gap by conducting direct measurements of methane emissions from 146 onsite sanitation containment units locally referred as pit latrines, holding tanks and septic tanks, across Senegal, Ethiopia, Uganda and Nepal. Methane emission rates exhibited strong skewness with a geometric mean of 7.9 g CH₄ capita⁻¹ day⁻¹, indicating that onsite sanitation containment units alone may account for approximately 3.8% of global anthropogenic CH₄ emissions.
Read moreSignificant Thickness Dependence of In-Plane Thermal Conductivity in Poly(3-hexylthiophene-2,5-diyl) Thin Films
Conjugated polymers are promising materials for flexible electronics, with poly(3-hexylthiophene) (P3HT) standing out for its ease of solution-based processing. However, the influence of the molecular arrangement on thermal transport remains less understood, particularly with respect to thin-film thickness. Here, we investigate the in-plane thermal conductivity of P3HT thin films with thicknesses ranging from 12 to 136 nm using transient thermal grating (TTG) spectroscopy, a precise noncontact optical technique. A pronounced thickness dependence is observed, with the highest thermal conductivity of 0.88 W/m·K in the thinnest film and the lowest value of 0.25 W/m·K in the thickest film. The enhancement in thermal conductivity in thinner films is attributed to denser lamellar packing in face-on configurations, an increased contribution of face-on domains, and spatial confinement-induced improvements in short-range ordering within the amorphous regions of thinner films. These findings demonstrate that the film thickness is an effective parameter for tuning in-plane thermal conductivity in P3HT thin films.
Read moreLow-Spin State Single-Atom Ni Catalyst for Electrochemical Carbon Dioxide Reduction at Ampere-Level Current.
Developing earth-abundant, selective, and low-overpotential electrocatalysts for the reduction of carbon dioxide represents a novel paradigm for a sustainable carbon economy. Here, we present advances in the understanding of trends in the reduction of CO2 to CO of Ni single-atom catalysts (SACs) supported by ordered mesoporous carbon (OMC). Characterizations using X-ray absorption spectroscopy (XAS), temperature-dependent magnetic susceptibility (M-T), and density functional theory (DFT) calculations show that the spin-state transitions from high-spin (HS) to low-spin (LS) for Ni SACs are induced by an asymmetric trigonal bipyramidal NiN2O3 configuration. Combined with surface-enhanced infrared absorption spectroscopy in the attenuated total reflection mode (ATR-SEIRAS), kinetic isotope effect (KIE), and density functional theory calculations, the rate-determining step is demonstrated to be the formation of *COOH. The unique NiN2O3 structure with a low-spin state significantly enhances the adsorption of *COOH due to the formation of stable Ni-C bonds and intermolecular hydrogen bonding. In electrocatalytic CO2 reduction to CO, the low-spin Ni SAC achieved an industrial-level performance, with a current density toward the CO product (JCO) up to 1 A cm-2, a turnover frequency (TOF) of 107,200 h-1 at ∼99% Faradaic efficiency (FE), and a half-reaction energy efficiency of 66%. This study establishes an electronic structure mechanistic framework for CO production from M-N/Ox moieties, thereby providing guidelines for the design of CO2 reduction catalysts.
Read moreNew benzimidazole-alkanesulfonate conjugates as cholinesterase inhibitors with in vitro and in silico validation.
Alzheimer's disease, the leading cause of dementia, is strongly associated with impaired cholinergic neurotransmission due to excessive acetylcholine degradation by acetylcholinesterase (AChE) and butyrylcholinesterase (BChE). Because current medications provide only symptomatic relief without modifying disease progression, there is an urgent need for more effective therapeutic agents. Dual inhibitors targeting both AChE and BChE represent a promising strategy. In this study, we designed and synthesized a novel series of benzimidazol-alkanesulfonate conjugates (4a-r) and evaluated their dual inhibitory activity against AChE and BChE. The results indicated that most compounds exhibited moderate to high inhibitory activity toward the target enzymes; however, derivatives 4b, 4h, 4i, 4q, and 4r showed promising AChE inhibitory activity with IC50 values of 0.91 ± 0.02, 0.89 ± 0.02, 0.54 ± 0.05, 0.37 ± 0.01, and 0.41 ± 0.009 µM, respectively, comparable to that of the reference drug donepezil (IC50 = 0.67 ± 0.00 µM). The antioxidant potency (represented by TAC and IRP) and scavenging activity (represented by DPPH, ABTS, NO, OH, and H2O2) revealed that compounds 4q and 4r possess remarkable antioxidant potential, comparable to the reference antioxidant ascorbic acid. Furthermore, in silico ADME prediction and molecular docking studies were performed to predict their binding modes and interactions in the AChE binding pocket; the results revealed that derivatives 4q and 4r showed the highest binding affinity among the tested series and the reference drug donepezil, which validated the obtained in vitro results.
Read moreDeep Eutectic Solvent-Assisted Synthesis of NiCuO <sub> <i>x</i> </sub> Catalyst with Enhanced Low-Temperature CO-SCR Performance: A Structure–Activity Relationship Study
Nitrogen oxides (NOx) are harmful air pollutants, and their selective catalytic reduction by CO (CO-SCR) offers the dual benefit of removing both NO and CO, thus realizing the concept of “waste-to-value”. However, most CO-SCR catalysts are effective only at ≥300 °C, limiting low-temperature applications. Herein, we explore Ni–Cu mixed oxides (NiCuOx) that leverage the synergistic roles of Cu+ species and the Ni3+/Ni2+ redox cycle and the surface synergistic oxygen vacancies (SSOVs) that facilitate NO dissociation. NiCuOx catalysts were synthesized using three conventional methods─sol–gel, coprecipitation, and hydrothermal─as well as a less conventional microwave-assisted deep eutectic solvent (DES) method, and their CO-SCR performance was systematically evaluated. Among them, the DES-derived catalyst (DES-NiCuOx) exhibits superior catalytic performance, achieving 100% NO conversion above 120 °C and 100% N2 selectivity above 150 °C, ranking among the highest reported to date for nonprecious metal catalysts. This outstanding activity is attributed to its larger specific surface area; enriched Cu+ species and OVs, particularly SSOVs; and improved redox properties. In situ DRIFTS analysis reveals that interfacial Ni3+–□–Cu+ (where □ represents an OV) structures in DES-NiCuOx promote NO dissociation and CO adsorption. Moreover, the concurrent involvement of Langmuir–Hinshelwood and Mars–van Krevelen mechanisms, facilitated by excellent oxygen mobility and redox properties, plays a vital role in enhancing low-temperature CO-SCR efficiency. This work highlights the advantages of the DES synthesis route for preparing highly dispersed mixed metal oxides and provides new insights into the rational design of efficient catalysts for low-temperature NOx abatement.
Read moreSelf-assembled fluorescent nanosensor for ultrafast and field-deployable monitoring of herbicide fomesafen in multiple matrices.
The rising demand for ultrasensitive, field-deployable detection technologies has intensified interest in nanoprobe-based monitoring of environmental contaminants. Fomesafen (FSA), a widely used post-emergence agricultural herbicide, poses significant ecological and health risks due to its slow degradation and prolonged environmental persistence. Addressing the need for rapid in situ detection, we propose a novel turn-on fluorescent nanoprobe (RBO) that combines small-molecule self-assembly, target-triggered disassembly, and adaptive signal amplification to achieve highly sensitive and quantitative detection of FSA. This "immediate-response" system exhibits exceptional performance, including high selectivity, sub-minute response time (< 1min), high sensitivity (LOD = 0.39 µM), and a dual fluorescent-colorimetric readout that enhances detection reliability. Field applications demonstrate that the nanoprobe supports diverse use cases, enabling on-site quantification of FSA on food surfaces and in soil, as well as real-time visualization and localization of FSA in plant tissues and zebrafish models for accurate assessment of pesticide-induced crop damage and ecological risk. Additionally, RBO has been adapted into test strips and hydrogel-based portable sensors and integrated with smartphone-imaging workflows, substantially improving on-site detection efficiency and device miniaturization. Collectively, this nanoprobe offers a powerful and reliable platform for monitoring FSA across agricultural, environmental, and biological matrices.
Read moreBenzene Methylation by the Coupled Protolytic Cracking Reaction of C <sub>5+</sub> Alkanes
Producing high-value-added toluene and xylene via benzene methylation technology is a promising route to valorize C5+ nonaromatic (C5+NA), optimize the structure of aromatic products and reduce benzene content. In this study, the methylation process of benzene with C5+NA into toluene and xylene was carried out using SSZ-13, ZSM-5, USY, and Beta zeolite-based catalysts, respectively, in a fixed-bed flow reactor under high pressure (3.0 MPa) in a hydrogen atmosphere. Among the various zeolite-based catalysts tested, medium-pore ZSM-5 shows the best catalytic activity due to its appropriate pore structure and acidity. Furthermore, ZSM-5 zeolite-based catalysts with varying SiO2/Al2O3 ratios (denoted as HZ-X, where X represents the SiO2/Al2O3 ratios of the ZSM-5 zeolite, with values of 24, 35, 93, and 239) were well-characterized by NH3-TPD and Py-IR. HZ-24 displays high conversion, selectivity, and stability in the methylation of benzene with C5+NA. The lower SiO2/Al2O3 ratios of ZSM-5 zeolite-based catalysts give higher acidity and superior catalytic activity, where HZ-24 is 2.18 times larger in the conversion to benzene than HZ-239 and shows the highest yield to toluene and xylene. Similarly, the reaction temperature, weight hourly space velocity (WHSV) and reaction pressure have a significant effect on the benzene methylation process. Moreover, the alkylation of benzene with C5+NA obeys the carbenium ion mechanism, following the protolytic cracking, the electrophilic substitution, and the deprotonation processes. More importantly, HZ-24 exhibits a long lifetime and good stability, which allows it to be used for at least 200 h without a significant loss of conversion and selectivity at 500 °C and 10 h–1. Our findings pave the way for large-scale industrial applications in enhancing the value-added chemical products.
Read more