- Research Article
- 10.1016/j.ekir.2026.105200
WCN26-2913 SERUM ACTIVIN A AND MORTALITY IN PATIENTS UNDERGOING HEMODIALYSIS
- Mar 25, 2026
- Kidney International Reports
- Yosuke Nakagawa + 9 more +9
Publications from 2021 to 2026
Showing 10 of 103 papers
WCN26-2913 SERUM ACTIVIN A AND MORTALITY IN PATIENTS UNDERGOING HEMODIALYSIS
Elevated Glycerol-3-Phosphate in Patients Undergoing Hemodialysis: Associations with Phosphate and Fibroblast Growth Factor 23
Introduction: Fibroblast growth factor 23 (FGF23) levels are markedly elevated in patients with kidney failure, but the mechanisms are incompletely understood. Recent evidence suggests that kidney-derived glycerol-3-phosphate (G-3-P), a glycolytic byproduct, mediates FGF23 production in response to dietary phosphate loading. However, the role of G-3-P is unknown in patients with kidney failure. Methods: Serum G-3-P levels were quantified by LC/MS in 35 healthy individuals and 650 patients undergoing hemodialysis. Association between serum phosphorus and G-3-P was examined using unadjusted and multivariable linear regression models. We next analyzed the associations of G-3-P and known regulators of FGF23 production with serum FGF23. Results: Median serum G-3-P level in patients undergoing hemodialysis was 220 ng/mL (IQR, 118–325), 2.2-fold higher than that of healthy individuals (98 ng/mL; IQR, 80–129). In patients undergoing hemodialysis, higher serum phosphorus was strongly associated with increased G-3-P in the unadjusted model; this association persisted after multivariate adjustment and when restricted to patients undergoing hemodialysis for over 10 years. In univariate analyses, higher serum phosphorus, calcium, intact PTH, G-3-P, and active vitamin D use were each significantly associated with higher FGF23. Multivariate analysis identified G-3-P as an independent predictor of FGF23. Further adjustment for transferrin saturation, ferritin, and C-reactive protein did not change these findings. Conclusion: Even in patients with kidney failure, G-3-P may rise in response to phosphate retention and act as a regulator of FGF23 production. Further studies are needed to test these hypotheses and determine whether the apparently nonfunctioning kidney retains the capacity to produce G-3-P.
Read moreTheoretical Analysis and Experiments on the Sound Absorption Properties of Foam Sound Absorbers with Thin Membranes Naturally Present in Foams Using Nano-Computed Tomography Scan Images
Foam sound-absorbing materials develop a fine cellular structure during manufacturing, resulting in variations in porosity, cell size, and the proportion of naturally occurring thin membranes that obstruct skeletal openings. This membrane proportion significantly affects sound absorption. In this study, we utilized cross-sectional images obtained from a submicron resolution computer tomography (CT) scanner (nano-CT) that can capture membrane structures to theoretically assess the sound absorption of foam materials with membranes. We processed these cross-sectional images using techniques, including binarization, to extract the contours of the foam skeletons and the cross-sectional areas of the voids. By modeling the foam’s cross-section as the clearance between two planes, we were able to determine the propagation constant and characteristic impedance within this clearance. The effective density was adjusted based on measured tortuosity. The normal-incidence sound absorption coefficient (SAC), derived from the transfer matrix method, was then compared with experimental values obtained from a two-microphone impedance tube. Image processing techniques helped extract the skeleton cross-section and reduce residual noise, thereby minimizing the effect of variations in the binarization threshold on theoretical values. The accuracy of the theoretical model was enhanced by incorporating a correction factor for the skeleton surface area.
Read moreAdapt & Align: Continual Learning with Generative Models’ Latent Space Alignment
EVALUATION ON VARIOUS DURABILITY OF CONCRETE MIXED WITH FINE POWDER OF COAL GASIFICATION SLAG
本研究は、石炭ガス化スラグを微粉化し、混和材(CGS微粉末)として用いたコンクリートの諸物性、および実物大構造物における耐久性について実験的に検討したものである。まず、CGS微粉末を用いたコンクリート供試体を作製し、フレッシュ性状および塩分環境下での各種耐久性について要素試験レベルで評価した。次に、実機プラントにてプレキャストコンクリート(PCa)を製造し、表層品質および耐久性について評価した。その結果、CGS微粉末がコンクリートの強度発現性および耐久性向上に寄与する材料であることを明らかとした。さらに、CGS微粉末は養生方法によらずコンクリートの表層品質を向上し得ること、PCaとしても所要の耐久性を有することを示した。
Read moreDemonstration Test of Triaxial Superconducting Cable System Installed in Commercial Chemical Plant Grid
A triaxial high-temperature superconducting (HTS) cable for practical cable systems was installed in the chemical plant of a private company (BASF Japan), and a large-scale demonstration test was performed. An HTS (REBa2Cu3O7-d) triaxial cable with a length of 200 m was used, and it was laid at a height of approximately 6 m above the ground and cooled using circulating liquid nitrogen. The test was performed from November 2020 to September 2021. In this paper, we report the results of the demonstration test and the energy-saving effects of the cable system.
Read moreTHERMAL-MECHANICAL COUPLED BEHAVIOR OF TIN RUBBER SEISMIC ISOLATION BEARINGS
The authors focus on the thermal-mechanical coupled behavior of tin rubber bearings (SnRBs) under cyclic loading. The research consists of three phases. First, the tests providing a large number of cyclic deformations to the SnRBs were performed. Second, an analysis model considering the thermal-mechanical coupled behavior was constructed by combining a seismic response analysis and thermal conductivity analysis. Finally, seismic response analyses using the model were conducted to evaluate the dynamic behavior of seismically isolated buildings with SnRBs. The authors conclude that characteristic change due to cyclic deformations of the SnRBs should be considered for long-duration earthquake ground motions.
Read moreBiodiversity Conservation through Various Citizen Activities in a Flood Control Basin
Abstract Flood control basins (FCBs) are artificially constructed facilities with the potential to conserve the biodiversity of floodplain ecosystems. However, the intensity of disturbance in FCBs is generally lower than that in natural floodplains; thus, habitats for plants with disturbance-dependent life histories and for animals that use temporary waters or mudflats can be lost in the years following FCB construction. Here, the Asahata FCB in Shizuoka city, Japan, was studied as an example, where the species diversity of wetland plants has been conserved as a result of diverse activities. Although most activities had objectives other than biodiversity conservation, they contributed to conserving plant diversity and providing habitats for endangered plants. The FCB is a green infrastructure that not only enables flood control but also supports activities for various purposes. Additionally, its proper use contributes to biodiversity conservation.
Read moreDemonstration of a Triaxial Superconducting Cable in a Private Chemical Plant
A large-scale demonstration test of a triaxial high-temperature superconducting (HTS) cable for a practical cable system was performed in a chemical plant of a private company. The 200 m-long HTS (REBCO: REBa <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> Cu <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> O <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">7-δ</sub> ) triaxial cable, which was manufactured by connecting 3 cables using 2 joints via a snake-shaped layout, was laid approximately 5 m higher than ground level, and the cable was cryocooled by circulating liquid nitrogen. For the preverification test, the rise-up test of the liquid nitrogen and the development of technology for bending the cable, joining it, as well as laying and installing it, were conducted. No leakage of liquid nitrogen at the terminal due to damage caused by heat shock or liquid nitrogen drop impact was observed. The pressure required for the liquid nitrogen to achieve a 5 m height was from 27.5 to 33 kPa, which is in good agreement with the calculated pressure of 33.6 kPa. The cooling rate was well controlled, and the desired level of 4 K/h was achieved. The economic challenges and methods of achieving market penetration were also discussed. The goal was to realize a superconducting cable for practical applications, and it was thought that the energy and costs necessary for cryocooling could be drastically reduced by using the existing cold system in the plant. In this way, it is expected HTS cables can achieve low costs and high energy-saving effects and penetrate markets in the future.
Read moreMeasurements of Magnetic Field Fluctuations for Plasma Wave Investigation by the Search Coil Magnetometers (SCM) Onboard Bepicolombo Mio (Mercury Magnetospheric Orbiter)
This paper describes the design and performance of the search coil magnetometers (SCM), which are part of the Plasma Wave Investigation (PWI) instrument onboard the BepiColombo/Mio spacecraft (Mercury Magnetospheric Orbiter), which will measure the electric field, plasma waves and radio waves for the first time in Mercury’s plasma environment. The SCM consists of two low-frequency orthogonal search coil sensors (LF-SC) measuring two components of the magnetic field (0.1 Hz – 20 kHz) in the spacecraft spin plane, and a dual-band search coil sensor (DB-SC) picking up the third component along the spin axis at both low-frequencies (LF: 0.1 Hz – 20 kHz) and high-frequencies (HF: 10 kHz – 640 kHz). The DB-SC and the two LF-SC sensors form a tri-axial configuration at the tip of a 4.6-m coilable mast (MAST-SC) extending from the spacecraft body, to minimize artificial magnetic field contamination emitted by the spacecraft electronics. After the successful launch of the spacecraft on 20 October 2018, an initial function check for the SCM was conducted. The nominal function and performance of the sensors and preamplifiers were confirmed, even with the MAST-SC being retracted and stowed in the spacecraft body, resulting in the detection of large interference signals likely from spacecraft electronics. The MAST-SC is scheduled for deployment after the Mercury orbit insertion of Mio in 2025, allowing the SCM to make the first higher frequency measurements of magnetic fluctuations in the Hermean magnetosphere and exosphere, and the local solar wind. These measurements will contribute to the investigation of fundamental problems in the Hermean plasma environment, including turbulence, magnetic reconnection, wave-particle interactions and particle acceleration.
Read more