A Cluster based Key Management Scheme for Underwater Wireless Sensor Networks

In the past few decades, optical communication with high data rates up to Gb/s in underwater wireless sensor networks (UWSN) has been extensively investigated. However, now a days researchers are highly focused on proposing/implementing localization algorithms for underwater optical wireless sensor networks (UOWSN) that are both fast in computation and cost efficient in terms of hardware design. In this paper we have used two different setups, one consisting of one led as a transmission node Tx. Where we exploit the effects of different angle on optical communication by implementing Lambert cosine law in a (UOWSN). The second setup is made of a led clutch which can communicate in 360 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">0</sup> . Both setups are used to estimate the location of a sensor node Rx in (UOWSN). To complete the task of localization estimation, a multilateration algorithm based on Euclidean distance between the Tx and Rx nodes is used, where as Gauss–Newton method was used to find the minimum of the function.

Communication in the underwater wireless sensor networks (UWSNs) faces many challenges due to the acoustic wave characteristics. Acoustic wave has very limited bandwidth, long propagation delay, high bit error rate (BER), and unreliable communication compared to the radio wave. Therefore, media access control (MAC) protocols proposed in terrestrial wireless sensor networks (TWSNs) cannot be implemented underwater as TWSNs rely on radio waves and enables multiple transmissions at a time without causing a collision. Besides, underwater nodes operate in a half-duplex mode and only allows one transmission at a time. Designing an efficient MAC protocol for underwater time-sensitive applications, such as the oil/gas pipeline and climate change prediction applications is necessary. While each application has its own requirements, the software-based approach promises great enhancements to meet more than one application's requirements. The software-based approach allows us to reconfigure the variables through a software without additional hardware requirements. To address the above issues, this paper proposes a software-based MAC protocol that utilizes optical and acoustic wave for communication and allows multiple transmissions at a time in different directions. This study aims to maximize throughput, packet delivery ratio (PDR), network utilization while minimizing latency.

Earth is solitary among the rocky planets revolving in the solar system. It is the only planet that is 3/4 covered with oceans of liquid water. In today's era, wireless sensor network is used in almost places and also is an interesting topic for researchers too. But with the advancement in technology, a network similar to wireless sensor network can be deployed under the water with acoustic signals for data transmission. Because of harsh environment and some more challenges, underwater communication becomes tricky. Underwater wireless sensor networks (UWSNs) is an advanced technology for underwater explorations and have demonstrated their quality in underwater applications. UWSN is a blend of wireless technology with sensor technology that has some extraordinary features like smart sensing, intelligent computing, and communication capabilities. Further, to maintain the secure communication underwater, it becomes more and more tricky. This chapter presents an expansive analysis of challenges, attacks, and security techniques of UWSNs.

Underwater wireless sensor networks (UWSNs) are a subclass of wireless sensor networks. Underwater sensor deployment is a significant challenge due to the characteristics of UWSNs and underwater environment. Recent researches for UWSNs deployment mostly focus on the maintenance of network connectivity and maximum communication coverage. However, the broadcast nature of the transmission medium incurs various types of security attacks. This paper studies the security issues and threats of UWSNs topology. Based on the cluster-based topology, an underwater cluster-based security scheme (U-CBSS) is presented to defend against these attacks. and safety.

Underwater Wireless Sensor Network (UWSN) is a newly emerging wireless technology in which small size sensors with limited energy and limited memory and bandwidth are deployed in deep sea water and various monitoring operations like tactical surveillance, environmental monitoring, and data collection are performed through these tiny sensors. Underwater wireless sensor networks are used for the exploration of underwater resources, oceanographic data collection, flood or disaster prevention, tactical surveillance systems, and unmanned underwater vehicles. Sensor nodes consist of a small memory, a central processing unit, and an antenna. Underwater networks are much different from terrestrial sensor networks as radio waves cannot be used in underwater wireless sensor networks. Acoustic channels are used for communication in deep sea water. Acoustic signals have many limitations, such as limited bandwidth, higher end-to-end delay, network path loss, higher propagation delay, and dynamic topology. Usually, these limitations result in higher energy consumption with a smaller number of packets delivered. The main aim nowadays is to operate sensor nodes having a smaller battery for a longer time in the network. This survey has discussed the state-of-the-art localization based and localization-free routing protocols. Routing associated issues in area of underwater wireless sensor networks have also been discussed.

Recently, underwater wireless sensor networks have gained a lot of attention of research from both academic world and industry and in the order to explore the immense underwater environment. To design network routing protocol is very challenging task in underwater wireless sensor networks since UWSN has peculiar features like large propagation delay, dynamic topology change, more latency and then terrestrial sensor network, low packet delivery ratio, high error rate, low bandwidth and less energy. In underwater wireless sensor network, improving energy efficiency is one of the most important challenges because substitution of batteries of sensor nodes is very costly due to harsh underwater environment. Energy consumption in UWSNs is still an open issue to be investigated, and further research should be conducted to increase the energy efficiency of UWSNs. This paper presents energy-efficient approaches used in three layer of protocol stack of underwater wireless sensor network architecture.

Underwater Wireless Sensor Networks (UWSNs) is an emerging technology for the monitoring of aquatic assets and frequently applied in several domains like underwater information gathering, ocean sampling network, anonymous vehicles, disaster prevention and submarine detection. Recently, UWSNs have been getting significant attention of researchers from both academia and industry. As a result, several studies have been carried out to perform certain improvements in UWSNs techniques, tools, protocols and architectures. In this regard, there is a dire need to investigate and summarize the modern UWSNs trends altogether within a single study. To achieve this, a Systematic Literature Review (SLR) is performed in this article to comprehensively analyze the latest developments in UWSNs. Particularly, 34 research studies published during 2012-2020 have been selected and examined in the area of UWSNs. This leads to the identification of 21 modern routing protocols and 11 tools. Furthermore, 5 different architecture types and 3 communication media technologies are presented in the context of UWSNs. Finally, a comparative analysis of routing protocols is done on the basis of important evaluation metrics. It has been concluded that there exist adequate approaches, protocols and tools for the monitoring of UWSNs. However, the design verification capabilities of existing approaches are insufficient to meet the growing demands of UWSNs. In this context, the findings of this article provide solid platform to enhance the current UWSNs tools and techniques for large and complex networks.

The underwater wireless sensor network (UWSN) is considered a promising technology for collecting valuable data from underwater areas, particularly for aiding military operations and environmental predictions. UWSNs consist of underwater sensor nodes that have limited energy and use acoustics for communication. Routing in underwater sensor nodes is one of the challenging issues in UWSNs because of the need to forward data packets with minimal energy consumption and a high packet delivery ratio. Selecting the next forwarding nodes is one of the key components of routing in UWSNs and has a direct effect on energy consumption and the packet delivery ratio. Therefore, this problem has gained much attention from the research community with the intent of enhancing the performance of UWSNs. This paper qualitatively reviews routing protocols for UWSNs, focusing on the next-hop selection method and its strengths and weaknesses. A taxonomy is presented for reviewing routing protocols under different categories of the classification. A summary of the qualitative investigation is presented highlighting aims, the next-hop selection method, metrics, and priority considerations. A comprehensive investigation is carried out focusing on energy, link quality, void awareness, reliability, and shortest path characteristics. Finally, we discuss potential future research directions in UWSNs for forwarding node selection.

The large-scale mobile Underwater Wireless Sensor Network (UWSN) is a useful networking paradigm to explore underwater environments. The characteristics of mobile UWSNs, such as low communication bandwidth, large propagation delay, and floating node mobility are significantly different from wireless sensor networks. In this paper, we propose a new efficient routing protocol, called multi-path routing (MPR) protocol, for UWSNs to improve the transmission delay. Multi-path is utilized during the path construction from the source node to the destination node, which is composed of a series of multi-subpaths. Each multi-subpath is a sub-path from a sending node to its two-hop neighboring node, called receiving node, by one more relay nodes, where these relay nodes simultaneously are neighboring nodes of sending and receiving nodes. Due to the different propagation delay of UWSN, the packet arrival time along the different sub-path is different; thus it may avoid the data collision in the receiving node when receiving different packets from different relay nodes. It surely sends the different packet along different sub-path to significantly improve delay time and packet delivery ratio. Finally, simulation results illustrate the performance achievements of the MPR protocol in improving delay time, packet delivery ratio, throughput and reducing overhead ratio.

Performance modeling and analysis of void-handling methodologies in underwater wireless sensor networks

With the enormous growth of sensor networks, information seeking from such networks has become an invaluable source of knowledge for various organizations to enhance the comprehension of people interests. Not only wireless sensor networks (WSNs) but its various classes also remain the hot topics of research. In this chapter, the primary focus is to understand the concept of sensor network in underwater scenario. Various mechanisms are used to recognize the activities underwater using sensor which examines the real-time events. With these features, a few challenges are also associated with sensor networks, which are addressed here. Machine learning (ML) techniques are the perfect key of success to resolve such issues due to their feasibility and adaption in complex problem environment. Therefore, various ML techniques have been explained to enhance the operational performance of WSNs, especially in underwater WSNs (UWSNs). The main objective of this chapter is to understand the concepts of UWSNs and role of ML to address the performance issues of UWSNs.

Recently, underwater wireless sensor network (UWSN) has paved the way for researchers towards a new era of exploring ocean realm targeting envisioned landscape of underwater applications. These applications can be made viable through underwater communication by using acoustic waves, giving rise to several design challenges like limited bandwidth, large and variable propagation delay, frequent connectivity loss, etc. Reliable data delivery in UWSN is always a tempting issue to be addressed, which is jeopardised by link failures and communication void. Under this context, Link failure Avoidance and Void Recovery (LAVR) routing protocol is proposed that uses link quality as forwarding factor, computed using Triangle Metric, to achieve reliability. A void node recovery procedure is proposed to displace the void node to a new depth to increase the packet delivery ratio. Simulations are performed in Aqua-Sim simulator and LAVR outperforms other existing protocols in terms of packet delivery ratio and network lifetime.

In the recent past, a significant increase has been observed in the use of underwater wireless sensor networks for aquatic applications. However, underwater wireless sensor networks face several challenges including large propagation delays, high mobility, limited bandwidth, three-dimensional deployments, expensive manufacturing, and energy constraints. It is crucial for underwater wireless sensor networks to mitigate all these limitations primarily caused by the harsh underwater environment. To address some of the pertinent challenges, adaptive hop-by-hop cone vector-based forwarding routing protocol is proposed in this article which is based on the adaptive hop-by-hop vector-based forwarding. The novelty of adaptive hop-by-hop cone vector-based forwarding includes increasing the transmission reliability in sparse sensor regions by changing the base angle of the cone according to the network structure. The number of duplicate packets and end-to-end delay is also reduced because of the reduced base angle and a smart selection criterion for the potential forwarder node. The proposed routing protocol adaptively tunes the height and opening of the cone based on the network structure to effectively improve the performance of the network. Conclusively, this approach significantly reduces energy tax, end-to-end delay, and packet delivery ratio.

In the realm of underwater wireless communication, vast oceanic expanses often demand large-scale deployment of Underwater Wireless Sensor Networks (UWSNs). UWSNs rely on acoustic communication channels, presenting distinct challenges like prolonged propagation delays, restricted bandwidth, and dynamic topologies. Furthermore, the far-reaching and multi-path nature of acoustic signals results in significant hidden terminal problems and ubiquitous interference between neighboring nodes. Therefore, an efficient medium access control (MAC) protocol is crucial for optimizing UWSN performance. This article proposes IC-MAC, a MAC protocol tailored for UWSNs to avoid collisions and improve network performance. IC-MAC employs distributed clustering to group sensor nodes and the cluster head degree is defined for each node, which is a coefficient that accentuates nodes characterized by a higher incidence of collision associations. To identify interfering nodes and construct an interference-free graph, an interference identification algorithm is proposed. In addition, a heuristic graph coloring technique, guided by particle swarm optimization, allocates time slots efficiently to achieve collision-free transmission scheduling and enhanced spatial reuse. Simulations demonstrate the effectiveness of the IC-MAC protocol in enhancing throughput, reducing delay, and improving packet delivery ratio and energy efficiency. This is achieved through efficient spatial resource utilization and robust management of collisions and interference, specifically tailored for underwater acoustic channels, outperforming existing MAC protocols.

Underwater acoustic communication is a method of sending and receiving messages beneath the water&#x2019;s surface that has been extensively researched for long-distance communication and localization. While, in this paper we will focus on medium range optical communication localization and short range Magneto Inductive (MI) communication localization. Both optical wireless sensor networks (OWSNs) and magneto inductive wireless sensor networks (MIWSNs) are investigated for localization of sensor nodes using a received signal strength indicator (RSSI) based localization technique for underwater environment/medium. Location information for MI nodes is obtained directly from mutual coupling measurement with a proposed localization scheme. Where as the localization of optical sensor nodes is done by exploiting the Lambert cosine law which gives values for luminous intensity in different distances and orientations. A simulation environment for both underwater optical wireless sensor networks (UOWSNs), and underwater magneto inductive wireless sensor networks (UMIWSNs) consisting of eight Tx anchor nodes and ten Rx sensor nodes is created to elaborate the localization estimation results.