A New Distributed Routing Protocol for Wireless Sensor Networks with Mobile Sinks

SUMMARYIntroduction of mobile sinks into a wireless sensor network can largely improve the network performance. However, sink mobility can cause unexpected changes of network topology, which may bring excessive protocol overhead for route maintenance and may offset the benefit from using mobile sinks. In this paper, we propose an efficient data‐driven routing protocol (DDRP) to address this problem. The design objective is to effectively reduce the protocol overhead for data gathering in wireless sensor networks with mobile sinks. DDRP exploits the broadcast feature of wireless medium for route learning. Specifically, each data packet carries an additional option recording the known distance from the sender of the packet to target mobile sink. The overhearing of transmission of such a data packet will gratuitously provide each listener a route to a mobile sink. Continuous such route‐learning among nodes will provide fresh route information to more and more nodes in the network. When no route to mobile sink is known, random walk routing simply is adopted for data packet forwarding. Simulation results show that DDRP can achieve much lower protocol overhead and longer network lifetime as compared with existing work while preserving high packet delivery ratio. Copyright © 2012 John Wiley & Sons, Ltd.

In view of the routing protocols for wireless sensor networks with mobile sink, the paper classifies the protocols from the network structure and the node mobility pattern respectively. This paper analyzes the design requirements of routing protocols, introduces the characteristics of various protocols and the typical protocols, and analyzes the research ideas of the routing protocols for wireless sensor networks with mobile sink.

QoSNET: An integrated QoS network for routing protocols in large scale wireless sensor networks

The existing routing protocols for wireless sensor networks were not reasonable in design, which limited their application. Most of the existing studies did not take into account the energy consumption of the network and the balanced use of the energy of sensor nodes, which led to the unsatisfactory application effect of wireless sensor networks in some fields. Therefore, from the perspective of energy balance in wireless sensor networks, this paper proposed a construction method of an energy balance routing protocol in wireless sensor networks based on a fuzzy control strategy. Firstly, based on the analysis of the basic composition of wireless sensor networks and the structure of sensor nodes, this paper expounded the basic process of wireless data transmission and summarized the classification and characteristics of routing protocols in wireless sensor networks from different angles. Secondly, according to the node data transmission characteristics of wireless sensor networks, the energy balance use model of sensor nodes was established, and the design method of the energy balance routing protocol based on fuzzy control strategy was proposed, and the data transmission link was optimized. Finally, through experimental comparative analysis, the results showed that the energy balanced routing protocol proposed in this paper can effectively realize the energy balanced use of the network data transmission process. Compared with other common routing protocols, the wireless sensor network routing protocol proposed in this paper can not only improve the data transmission efficiency and reduce the data redundancy but also save energy consumption and prolong the network running time. The design method of routing protocol proposed in this paper will be conducive to the optimization and application of routing protocol in wireless sensor networks and provide a theoretical basis for the related research of wireless sensor networks.

Wireless sensor networks congestion occurs easily due to its centralized traffic pattern. Normally, mono-sync wireless sensor network experiences multiple traffic flow congestion in the dense environment of the network, which leads to excess energy consumption and severe packet loss. To overcome these issues, a congestion detection and alleviation mechanism using cluster based heuristic optimized hierarchical routing protocol is proposed in this paper. Here, congestion detection and alleviation utilize the features of sensor nodes. The congestion is categorized into two types: (i) node level congestion and (ii) link level congestion. The node level congestion is detected by assessing the buffer utilization and the interval amid the consecutive data packets. The link level congestion is considered with computing link usage utilizing back-off step of round robin carrier sense multi-access with collision avoidance. Congestion detection and alleviation reactively affected node/link through cuckoo hosted rider search multi-hop routing algorithm. It has two phases: the cluster head selection and multi-path routing. Cluster head selection is performed through Taylor multiple random forest kernel fuzzy C-means clustering algorithm and multi-path routing is performed through cuckoo hosted rider search multi-hop routing algorithm. The simulation of the proposed method is done in network simulator tool. Here, the performance metrics, like packet delivery ratio, delay, energy consumption, packet drop, overhead, network lifetime and throughput are calculated. The experimental outcomes of the proposed technique shows 11.6%, 18.4% and 28.1% lower delay, 78.2%, 65.4% and 52.6% higher packet delivery ratio, and 29.2%, 37.4% and 40.8% lower packet drop compared with the existing methods, like congestion detection and alleviation using multi-attribute decision-making in optimization-based hybrid congestion alleviation routing protocol in wireless sensor networks, congestion detection and alleviation using hybrid K-means with greedy best first search algorithms in packet rate reduction utilizing adaptive weight firefly algorithm ant colony optimization based routing protocol in wireless sensor networks and congestion detection and alleviation using multi-input time on task optimization algorithm for altered gravitational search algorithm routing protocol in wireless sensor networks.

Wireless Sensor Networks (WSNs) play a necessary position in todays actual world applications. WSNs are a team of autonomous sensor nodes that are geographically distributed to accumulate information and monitor events. WSNs are similarly sense that they rely on wireless connectivity and spontaneous formation of networks so that sensor information can be transported via wireless. Sometimes called dust network, minute sensors as small as dust referring to smart dust. WSNs are spatially distributed two to screen or bodily temperature, sound, pressure, etc. and to cooperatively ignore their data via the network to different locations. Each such sensor network node has typically various parts. Routing in WSNs in one of the important technique, because all node executes its battery power, if may be one node failure it collapse entire networks. Routing in WSNs is in reality difficult due to the intrinsic characteristics that differentiate these networks from different networks. The plan of routing protocols in WSN is affected via number of exigent factors. In this paper, a review on routing protocols for Wireless Sensor Networks (WSNs) and performance of its execution.

Wireless sensor networks are a new emerging area where swarm intelligence can be applied with interesting implications. In fact, a strong analogy between unicellular organism colonies and wireless sensor networks can be emphasized: a sensor network can be viewed as a “colony” of simple, scarce resource nodes that, autonomously, are able only to perform simple tasks, but all together can accomplish very complex problems. In this paper we propose a routing protocol for multisink Wireless Sensor Networks with interesting properties: self organization, fault tolerance and environmental adaptation. The proposed protocol was inspired by the well known behavior (in artificial life studies) of “Slime Mold”. Such colony of unicellular organisms organizes itself in clusters by pheromone generation and evaporation mechanisms. In a similar manner our protocol manages the data traffic towards multiple sink nodes using the gradient concept and reaching high levels of autonomy and fault tolerance. We analyze the proposed protocol to examine the performances, the signalling overhead and the adaptation properties to environmental changes or nodes faults using simulation techniques.

<span lang="EN-US">Recent developments and widespread in wireless sensor network have led to many routing protocols, many of these protocols consider the efficiency of energy as the ultimate factor to maximize the WSN lifetime. The quality of Service (QoS) requirements for different applications of wireless sensor networks has posed additional challenges. Imaging and data transmission needs both QoS aware routing and energy to ensure the efficient use of sensors. In this paper, we propose an Efficient, Energy-Aware, Least Cost, (ECQSR) quality of service routing protocol for sensor networks which can run efficiently with best-effort traffic processing. The protocol aims to maximize the lifetime of the network out of balancing energy consumption across multiple nodes, by using the concept of service differentiation, finding lower cost by finding the shortest path using nearest neighbor algorithm (NN), also put certain constraints on the delay of the path for real-time data from where link cost that captures energy nodes reserve, energy of the transmission, error rate and other parameters. The results show that the proposed protocol improves the network lifetime and low power consumption.</span>

Throughout the use of the small battery-operated sensor nodes encourage us to develop an energy-efficient routing protocol for wireless sensor networks (WSNs). The development of an energy-efficient routing protocol is a mainly adopted technique to enhance the lifetime of WSN. Many routing protocols are available, but the issue is still alive. Clustering is one of the most important techniques in the existing routing protocols. In the clustering-based model, the important thing is the selection of the cluster heads. In this paper, we have proposed a scheme that uses the bubble sort algorithm for cluster head selection by considering the remaining energy and the distance of the nodes in each cluster. Initially, the bubble sort algorithm chose the two nodes with the maximum remaining energy in the cluster and chose a cluster head with a small distance. The proposed scheme performs hierarchal routing and direct routing with some energy thresholds. The simulation will be performed in MATLAB to justify its performance and results and compared with the ECHERP model to justify its performance. Moreover, the simulations will be performed in two scenarios, gateway-based and without gateway to achieve more energy-efficient results.

Due to miniaturization of hardware and availability of low-cost, low-power sensors, Wireless Sensor Network and Multimedia Sensor Network applications are increasing day by day. Each application has a specific quality of service and experience requirements. The design of routing and MAC protocol which can fulfill the requirements of the application is challenging given the constrained nature of these devices. Considerable efforts are directed towards the design of energy efficient QoS-aware routing protocols. In this article, we present state of the art review of routing protocols for Wireless Multimedia Sensor Networks while addressing the challenges and providing insight into research issues.

There are different applications of Wireless Sensor Networks (WSNs). It can be deployed in various application areas such as monitoring of environment, surveillance, industrial automation, health-care, agriculture etc. A sensor node is usually a resource constrained device which has limited energy, processing power and memory. One of the important aspects of QoS aware routing protocols in WSNs is to send the delay sensitive data to a control station known as sink. In this paper, a delay sensitive cluster based routing protocol for wireless sensor networks is proposed. The purpose of clustering is to reduce energy consumption among the sensor nodes. The data forwarding mechanism of the protocol attempts to reduce end to end delay of delay sensitive traffic in reaching the sink. The protocol is evaluated through simulation using NS2.

The optimized link state routing (OLSR) protocol is widely used in wireless ad hoc networks. With OLSR, only one routing path from source to destination is established at a time. However, links of wireless networks are very unreliable, and network topologies might vary rapidly. These features may cause frequent data retransmissions or the route rebuilding. Hence, improving the network throughput becomes a big challenge. This paper designs a new high-throughput routing protocol (HTRP) for wireless sensor networks, which combines the OLSR protocol with opportunistic routing and network coding. Opportunistic routing is able to leverage the wireless channel's characteristic of broadcasting and opportunistically deliver data through multiple routing paths. And OLSR can provide the information about network topologies and other parameters that opportunistic routing needs but cannot gain by itself. We evaluate the performance through both simulation and empirical experiments. The throughput of the HTRP is more than 10× and 2× of the OLSR protocol respectively in simulation and experiments.

Minimization of energy consumption is the main attention of researchers while developing a routing protocol for wireless sensor networks, as sensor nodes are equipped with limited power supply. Virtual topology is an integral part of routing, and grid-based routing protocols are quite popular due to their simplified and efficient virtual grid topology construction. Although a list of surveys exists that either focus on routing protocols in a broader way or on other virtual topologies, none of these surveys are concerned about grid topology and grid-based routing protocols. Having this motivation in mind and considering the impact of these routing protocols on controlling and managing the energy consumption of wireless sensor networks, this article provides an expansive assessment of grid-based routing protocols based on their methodology. In this survey, the existing grid-based routing protocols are classified into two categories from the perspective of sink mobility: static sink and mobile sink. A phase-wise comprehensive overview of these routing protocols is provided in chronological order, along with their comparative analysis. Furthermore, the characteristics, design issues, and challenges of grid-based routing protocols are also provided.

Wireless sensor networks (WSNs) have gained much attention in today’s research domain for supporting a wide variety of applications including the multimedia applications. Multimedia applications that are regarded as the quality-of-service (QoS)-aware, delay sensitive, and bandwidth hungry applications require enough energy and communication resources. WSNs being the energy-scarce network have now been designed in such a way that they can support these delay-sensitive and time-critical applications. In this paper, we propose an energy-efficient routing protocol for heterogeneous WSNs to support the delay sensitive, bandwidth hungry, time-critical, and QoS-aware applications. The proposed QoS-aware and heterogeneously clustered routing (QHCR) protocol not only conserves the energy in the network, but also provides the dedicated paths for the real-time and delay sensitive applications. The inclusion of different energy-levels for the heterogeneous WSNs also provides the stability in the networks while minimizing the delay for the delay-sensitive applications. Extensive simulations have been performed to validate the effectiveness of our proposed scheme. Our proposed routing scheme outperforms other state-of-the-art schemes in terms of the delay performances.

Wireless sensor networks (WSNs) include small sensor nodes with battery and processing power and limited memory units then improving power consumption is a major design challenge for any sensor network. In this paper, a new algorithm for routing in the wireless sensor network is proposed using the ultra-innovative algorithm for bacterial Foraging and mobile sink, which leads to energy efficiency. In the proposed method, the number of sensor nodes is determined according to two criteria: the amount of energy on the battery surface and the distance to the sink ahead, which leads to the formation of regular clusters in the network. Nodes adopt a multi-step routing scheme within the network to communicate with the sink. also, the mobile sink is used to balance the load and help consume uniform energy throughout the network. The simulation results show better performance of the proposed method in terms of energy consumption by 17.99%, throughput rate by 30.04%, end-to-end delay by 46.04%, signal-to-noise ratio by 32.81%, delivery rate successfully Data to the sink is 0.80 times higher than the AFSRP (Artificial Fish Swarm Routing Protocol).