Acoustic Feedback Cancellation in hearing aids using two microphones employing variable step size affine projection algorithms

An improved block adaptive system for effective feedback cancellation in hearing aids

In this contribution we describe an adaptive feed-back cancellation (FBC) system realized with 48 sub-band filters. As core procedure we propose a combination of two decorrelation measures to stabilize and optimally control the adaptation. We show that especially this combination of pre-whitening and frequency shift allows realizing three major steps for a fast and reliable FBC in real hearing aids. First, the adaptation bias is removed. Second, an optimal adaptation control can be realized, and third, we show that a differentiation between feedback and tonal input signals is possible. The latter can be used for an additional improvement of the adaptation control.

Based on the variable step-size afiine projection algorithm, the idea of multiple forgetting factors and variable projection order is proposed. On the one hand, the accurate estimation of error energy is realized in order to achieve faster convergence rate and lower final misalignment. On the other hand, the reduction of computational complexity can be achieved. The simulation results show that the proposed algorithm achieves significant improvement in the convergence rate, misalignment and computational complexity compared with variable step-size affine projection algorithm, variable projection order affine projection algorithm and variable step-size and rojection order affine projection algorithm without multiple forgetting factors.

Approximated affine projection algorithm for feedback cancellation in hearing aids

In feedback cancellation in hearing aids, an adaptive filter is used to model the feedback path. The output of the adaptive filter is subtracted from the microphone signal to cancel the acoustic and mechanical feedback picked up by the microphone, thus allowing more gain in the hearing aid. In general, the feedback cancellation filter adapts on the hearing-aid input signal, and signal cancellation and coloration artifacts can occur for a narrowband input. The goal in feedback cancellation is to design an algorithm that is computationally efficient, provides 10 dB or more of additional amplifier headroom, and is free from processing artifacts.This chapter begins with a steady-state analysis of the effects of acoustic feedback on the hearing-aid response. This analysis illustrates the factors that can affect the accuracy of the adaptive filter and the filter convergence for systems adapting with or without a probe signal. The characteristics of the feedback path being modeled are then described. An additional concern in designing signal processing for a hearing aid are the processing constraints imposed by a low-power portable device, and these concerns are discussed next. Two forms of constrained adaptation are then derived, and simulation results are used to give a comparison of the constrained adaptation with the conventional unconstrained approach for a system adapting without a probe signal. Further improvements in feedback cancellation performance, particularly a reduction in audible processing artifacts, can be achieved by using the filtered-X algorithm, and this approach is described next.The performance of feedback cancellation is ultimately limited by the characteristics of the room in which the listener is located since the room reflections form part of the feedback path. The chapter concludes with a study of the feedback path in a room along with the feedback cancellation performance for an 8-, 16-, or 32-tap adaptive FIR filter in series with a five-pole nonadaptive filter, and the performance limitations imposed by the room reverberation are discussed.KeywordsImpulse ResponseFeedback PathAdaptive FeedbackAcoustic FeedbackRoom ReverberationThese keywords were added by machine and not by the authors. This process is experimental and the keywords may be updated as the learning algorithm improves.

Adaptive feedback cancellation in hearing aids

In feedback cancellation in hearing aids, an adaptive filter is used to model the feedback path. The output of the adaptive filter is subtracted from the microphone signal to cancel the acoustic and mechanical feedback picked up by the microphone, thus allowing more gain in the hearing aid. In general, the feedback-cancellation filter adapts on the hearing-aid input signal, and signal cancellation and coloration artifacts can occur for a narrow-band input. In this paper, two procedures for LMS adaptation with a constraint on the magnitude of the adaptive weight vector are derived. The constraints greatly reduce the probability that the adaptive filter will cancel a narrow-band input. Simulation results are used to demonstrate the efficacy of the constrained adaptation.

The adaptive feedback canceller (AFC) based on the least mean square (LMS) or normalized LMS (NLMS) algorithm shows poor convergence for sparse impulse response, since they do not consider the characteristics of the impulse response. The acoustic feedback path of the hearing aid exhibits sparse characteristics consisting of few active coefficients and many non active (near to zero) coefficient values. This paper proposes an improved gradient controlled improved proportionate NLMS (IGC-IPNLMS) algorithm for cancelling the feedback phenomenon in hearing aids. The IGC-IPNLMS algorithm employs a variable convergence factor, an estimate of the gradient vector for allocating step size, the controlling parameter of the IGC-IPNLMS algorithm is also updated in each iteration based on the sparseness measure. Further, the reduction in computational complexity is achieved by using sparse partial update method along with the IGC-IPNLMS algorithm (SIGC-IPNLMS) for feedback cancellation. The simulation results show the superior performance of the proposed method for white noise and speech segment as input.

The feedback cancellation scheme in hearing aids mainly employs Filtered-XLMS (FXLMS) algorithm However, the conventional FXLMS algorithm doesnot provide satisfactory performance in the presence of outliers acquired by the microphone. In this paper, Filtered-X Wilcoxon LMS (FXWLMS) and Filtered-X least mean log square (FXLMLS) are being introduced as two robust learning algorithms for effective feedback cancellation in the presence of outliers. The simulation studies demonstrate the superior feedback cancellation performance of FXLMLS and FXWLMS over FXLMS in the presence of outliers.

A new subband feedback cancellation scheme is proposed, capable of providing additional stable gain without introducing audible artifacts. The subband feedback cancellation scheme employs a cascade of two narrow-band filters Ai(Z)and Bi(Z)ng with a fixed delay, instead of a single filter Wi(Z)and a delay to represent the feedback path in each subband. The first filter, Ai(Z), is called the training filter, and models the static portion of the feedback path in ith subband, including microphone, receiver, ear canal resonance, and other relatively static parameters. The training filter can be implemented as a FIR filter or as an IIR filter. The second filter, B?I?(Z), is called a tracking filter and is typically implemented as a FIR filter with fewer taps than the training filter. This second filter tracks the variations of the feedback path in the i?th? subband caused by jaw movement or objects close to the ears of the user.

Acoustic Feedback Cancellation in Hearing Aids Exploiting an Inertial Sensor

Howling is very annoying problem to the hearing-aid users and it limits the maximum usable gain of hearing-aid devices. In this paper, we present an efficient feedback cancellation system where a time-varying all-pass filter together with a delay in the forward path is used for decorrelating the input and output signals of the hearing aid plant. The adaptive filter in the hearing aid performs continuous adaptation based on the input signal. The output signal of the hearing aid is processed by a 2nd-order APF whose frequency is varied using a low-frequency modulator. Simulation results show that the proposed algorithm can significantly reduce the weight-vector misalignment with a small delay in the forward path.

Fast exact variable order affine projection algorithm

Low-rank enhanced Hammerstein-spline adaptive filter for sparsity-aware nonlinear feedback cancellation in hearing aids

Publication in the conference proceedings of EUSIPCO, Poznan, Poland, 2007