Algorithms for Optimal Power Flow Extended to Controllable Renewable Systems and Loads

A new hybrid evolutionary algorithm for multi-objective optimal power flow in an integrated WE, PV, and PEV power system

This paper investigates potential of modified differential evolution (MDE) algorithm, to find solution for optimal power flow (OPF) problem of power system. The performance of the proposed MDE algorithm is experienced on the modified IEEE-30 bus test systems integrating flexible ac transmission systems (FACTS) devices, that is, thyristor controlled phase shifter (TCPS) and thyristor controlled series capacitor (TCSC) at preset locations. The OPF problem of the present work is formulated with five different objective functions viz. (a) fuel cost (with valve point effect) minimization, (b) power transmission losses minimization, (c) emission reduction (d) fuel cost (without valve point effect) minimization and (e) minimization of combined economic and environmental cost. The proposed implementation exploits MDE, resulting in a much shorter execution time while retaining the best possible solution of OPF problem.

This study proposes an improved particle swarm optimization method to find optimal power flow by using the power transmission loss as an objective function. In the literature, PSO is a well — known intelligent search method to handle the solution of optimal power flow problem. A novel scheme which is called Improved PSO (IPSO) is defined by modifying the initialization step of PSO algorithm and choosing the load bus voltages, generator active and reactive powers, line flow capacities as penalty functions in the objective function. PSO and IPSO-based optimal power flow solutions are compared with each other on IEEE 118 and 300 bus systems. According to the test results, the power loss obtained by IPSO-based solution has less power loss than PSO-based solution. This proposed method can be used to obtain faster desirable solutions and better power loss results for the optimal power flow problem in case of power loss minimization.

The optimal power flow (OPF) problem is a well-known non-convex optimization problem that aims to minimize the cost of electric power generation subject to consumer demand, the physics of power flow, and technological constraints. To find an optimal solution to this problem, local search techniques such as interior point methods are typically used. However, due to the non-convex nature of the problem, these methods are likely to result in a sub-optimal solution. The goal of this paper is to characterize the worst-case performance of local search on the OPF problem. To accomplish this, we formulate the OPF problem as a canonical quadratically-constrained quadratic program (QCQP). Then, we study the problem of finding the worst-case local minimum of this QCQP, which is non-convex and hard to solve in general. We find a relaxation of this problem into a semidefinite program (SDP) and show that it is exact for certain cases. Using some test cases which are known to have multiple local minima, we demonstrate the effectiveness of the proposed relaxation to bound the worst-case local minimum. We compare the obtained upper bound on local minima to the lower bound provided by the standard SDP relaxation of the OPF problem to understand how much SDP outperforms local search for a given problem.

Recent years have witnessed the success of employing convex relaxations of the AC optimal power flow (OPF) problem to find global or near-global optimal solutions. The majority of the effort has focused on solving problem formulations where variables live in continuous spaces. Our focus here is in the extension of these results to the co-optimization of network topology and the OPF problem. We employ binary variables to model topology reconfiguration in the standard semidefinite programming (SDP) formulation of the OPF problem. This makes the problem non-convex, not only because the variables are binary, but also because of the presence of bilinear products between the binary and other continuous variables. Our proposed convex relaxation to this problem incorporates the bilinear terms in a novel way that improves over the commonly used McCormick approximation. We also address the exponential complexity associated with the discrete variables by partitioning the network graph in a way that minimizes the impact on the optimal value of the relaxation. As a result, the problem is broken down into several parallel mixed-integer problems, reducing the overall computational complexity. Simulations in the IEEE 118-bus test case demonstrate that our approach converges to solutions which are very close to the lower bound of the mixed-integer OPF problem.

For operating electrical power networks, the Optimal Power Flow (OPF) problem plays a central role. The problem is nonconvex and NP hard. Therefore, designing efficient solution algorithms is crucial, though their global optimality is not guaranteed. Existing semi-definite programming relaxation based approaches are restricted to OPF problems for which zero duality holds, whereas for non-convex problems there is a lack of solution methods of provable performance. In this paper, an efficient novel method to address the general nonconvex OPF problem is investigated. The proposed method is based on alternating direction method of multipliers combined with sequential convex approximations. The global OPF problem is decomposed into smaller problems associated to each bus of the network, the solutions of which are coordinated via a light communication protocol. Therefore, the proposed method is highly scalable. The convergence properties of the proposed algorithm are mathematically and numerically substantiated.

In this paper, we consider the Optimal Power Flow (OPF) problem which consists in determining the power production at each bus of an electric network by minimizing the production cost. Our contribution is an exact solution algorithm for the OPF problem. It consists in a spatial branch-and-bound algorithm based on a compact quadratically-constrained convex relaxation. It is computed by solving the semidefinite rank relaxation of OPF once at the root node of the algorithm. An important result is that the optimal value of our compact relaxation is equal to the rank relaxation value. Then, at every sub-nodes of our branch-and-bound, the lower bound is obtained by solving a quadratic convex problem instead of an SDP. Another contribution is that we add only O(n+m) variables that model the squares of the initial variables, where n is the number of buses in the power system and m the number of transmission lines, to construct our relaxation. Then, since the relations between the initial and auxiliary variables are non-convex, we relax them to get a quadratic convex relaxation. Finally, in our branch-and-bound algorithm, we only have to force a reduced number of equalities to prove global optimality. This quadratic convex relaxation approach is here tailored to the OPF problem, but it can address any application whose formulation is a quadratic optimization problem subject to quadratic equalities and ring constraints. Our first experiments on instances of the OPF problem show that our new algorithm Compact OPF (COPF) is more efficient than the standard solvers and other quadratic convex relaxation based methods we compare it with.

The AC optimal power flow (OPF) problem is essential for the schedule and operation of power systems. Convex relaxation methods have been studied and used extensively to obtain an optimal solution to the OPF problem. When the exactness of convex relaxations is not guaranteed, it is important to recover a feasible solution for the convex relaxation methods. This paper presents an alternative convex optimisation (ACP) approach that can efficiently recover a feasible solution from the result of second‐order cone programming (SOCP) relaxed OPF in mesh networks. The OPF problem is first formulated as a difference‐of‐convex programming (DCP) problem, then efficiently solved by a penalty convex concave procedure (CCP). By using the solution of a tightened SOCP OPF as an initial point, the proposed algorithm is able to find a global or near‐global optimal solution to the AC OPF problem. Numerical tests show that the proposed method outperforms those semi‐definite programming (SDP) and quadratically constrained quadratic programming (QCQP)–based algorithms.

In this paper, a new method to incorporating FACTS devices in optimal power flow (OPF) problem is presented. This method can provide an enhanced economic solution with the use of controllable FACTS devices. Two types of FACTS devices, thyristor controlled series compensators (TCSC) and thyristor controlled phase shifters (TCPS), are considered in this method. The specified power flow control constraints due to the use of FACTS devices are included in the OPF problem. The proposed method decomposes the solution of such modified OPF problem into two subproblems' iteration. The first subproblem is a power flow control problem and the second subproblem is a conventional OPF problem. The two subproblems are solved iteratively until convergence. Case studies are presented to show the effectiveness of the proposed method.

This paper presents the semismooth Newton-type algorithms for solving optimal power flow (OPF) problems. Considering that there exist plentiful bounded constraints in OPF, the paper treats general inequality constraints and bounded constraints separately. By introducing a diagonal matrix and the nonlinear complementarity function, the Karush-Kuhn-Tucker (KKT) system of the OPF is transformed equivalently to a system of nonsmooth bounded constrained equations. Comparing with the classical OPF methods and the nonlinear complementarity problem (NCP) method, this treatment has two remarkable advantages. First, it has a strong ability to handle the inequality constraints in OPF problems. Second, it reduces the number of dual variables in the KKT system. Based on the reformulated equations, the paper designs a projected semismooth Newton algorithm which has nice global and local convergence property. Furthermore, according to the weak-coupling property in power systems, the paper presents a decoupled semismooth Newton-type algorithm. The decoupled method solves the system of equations via solving two lower dimension problems. Therefore the method saves the computing cost in theory. Some standard IEEE systems are used to test the two algorithms, and numerical results show that the proposed algorithms are promising for solving OPF problems

Modified JAYA algorithm for optimal power flow incorporating renewable energy sources considering the cost, emission, power loss and voltage profile improvement

In recent decades, the energy market around the world has been reshaped to accommodate the high penetration of renewable energy resources. Although renewable energy sources have brought various benefits, including low operation cost of wind and solar PV power plants, and reducing the environmental risks associated with the conventional power resources, they have imposed a wide range of difficulties in power system planning and operation. Naturally, classical optimal power flow (OPF) is a nonlinear problem. Integrating renewable energy resources with conventional thermal power generators escalates the difficulty of the OPF problem due to the uncertain and intermittent nature of these resources. To address the complexity associated with the process of the integration of renewable energy resources into the classical electric power systems, two probability distribution functions (Weibull and lognormal) are used to forecast the voltaic power output of wind and solar photovoltaic, respectively. Optimal power flow, including renewable energy, is formulated as a single-objective and multi-objective problem in which many objective functions are considered, such as minimizing the fuel cost, emission, real power loss, and voltage deviation. Real power generation, bus voltage, load tap changers ratios, and shunt compensators values are optimized under various power systems’ constraints. This paper aims to solve the OPF problem and examines the effect of renewable energy resources on the above-mentioned objective functions. A combined model of wind integrated IEEE 30-bus system, solar PV integrated IEEE 30-bus system, and hybrid wind and solar PV integrated IEEE 30-bus system is performed using the equilibrium optimizer technique (EO) and other five heuristic search methods. A comparison of simulation and statistical results of EO with other optimization techniques showed that EO is more effective and superior and provides the lowest optimization value in term of electric power generation, real power loss, emission index and voltage deviation.

The three-phase optimal power flow (OPF) problem has recently attracted a lot of research interests due to the need to coordinate the operations of large-scale and heterogeneous distributed energy resources in unbalanced electric power distribution systems. The nonconvexity of the three-phase OPF problem is much stronger than that of the single-phase OPF problem. Instead of applying the semidefinite programming relaxation technique, this paper advocates a convex iteration algorithm to solve the nonconvex three-phase OPF problem. To make the convex iteration algorithm computationally efficient for large-scale distribution networks, the chordal conversion based technique is embedded in the convex iteration framework. By synergistically combining the convex iteration method and the chordal based conversion technique, the proposed three-phase OPF algorithm is not only computationally efficient but also guarantees global optimality when the trace of the regularization term becomes zero. At last, to further improve the computational performance, a greedy grid partitioning algorithm is proposed to decompose a single large matrix representing a distribution network to many smaller matrices. The simulation results using standard IEEE test feeders show that the proposed algorithm is computationally efficient, scalable, and yields global optimal solutions while resolving the rank conundrum.

The optimal power flow (OPF) problem minimizes the operating cost of an electric power system. Applications of convex relaxation techniques to the non-convex OPF problem have been of recent interest, including work using the Lasserre hierarchy of "moment" relaxations to globally solve many OPF problems. By preprocessing the network model to eliminate low-impedance lines, this paper demonstrates the capability of the moment relaxations to globally solve large OPF problems that minimize active power losses for portions of several European power systems. Large problems with more general objective functions have thus far been computationally intractable for current formulations of the moment relaxations. To overcome this limitation, this paper proposes the combination of an objective function penalization with the moment relaxations. This combination yields feasible points with objective function values that are close to the global optimum of several large OPF problems. Compared to an existing penalization method, the combination of penalization and the moment relaxations eliminates the need to specify one of the penalty parameters and solves a broader class of problems.

Many modern power networks are partitioned in nature, with disjoint components of the overall network controlled by competing operators. The problem of solving the Optimal Power Flow (OPF) problem in a distributed manner is therefore of significant interest. For networks in which the high-level structure has tree topology, we analyze a dual decomposition approach to solving a recent convex relaxation of the OPF problem for the overall network in a distributed manner. Incorporating higher-order dynamics in terms of local auxiliary variables, we prove a result of guaranteed convergence to the solution set for sufficiently small values of the step size.