CO2Solubilities in Amide-based Brønsted Acidic Ionic Liquids

Carbon dioxide (CO2) absorption in several imidazolium-based ionic liquids (ILs), pyridinium-based ionic liquids and a tetraalkylammonium-based poly(ionic liquid) (PIL), poly[(p-vinylbenzyl) trimethylammonium hexafluorophosphate] P[[VBTMA][PF6], was studied. The trend of CO2 solubility in all of the ILs increases dramatically with decreasing absorption temperature. Based on the same bis(triflamide) [Tf2N] anion, imidazolium, pyridinium and trihexyltetradecylphosphonium-based ionic liquids all show relatively similar CO2 solubilities, which were higher than for the [ES] anion. The highest CO2 absorption was found in a poly(ionic liquid) P[[VBTMA][PF6]], however, the monomer also showed higher CO2 capacity than the other ionic liquids. The poly(ionic liquid) is remarkable in that it can adsorb 77% of its body weight of CO2 with a selectivity over nitrogen of 70 : 1. The absorbed CO2 gas can be readily desorbed from ionic liquids and poly(ionic liquid) and the selectivity for CO2 over N2 was consistent over repeated cycles. The materials can be reused several times for consecutive sorption/desorption cycles, without loss of performance in a large-scale reactor and therefore represent serious candidates for use in commercial adsorbers.

Imidazolium-based ionic liquids (ILs) incorporating the tricyanomethanide ([TCM(-)]) anion are studied using an optimized classical force field. These ILs are very promising candidates for use in a wide range of cutting-edge technologies and, to our knowledge, it is the first time that this IL family is subject to a molecular simulation study with the use of a classical atomistic force field. The [C4mim(+)][TCM(-)] ionic liquid at 298.15 K and at atmospheric pressure was used as the basis for force field optimization which primarily involved the determination of the Lennard-Jones parameters of [TCM(-)] and the implementation of three quantum mechanical schemes for the calculation of the partial charge distribution and the identification of the appropriate scaling factor for the reduction of the total ionic charge. The optimized force field was validated by performing simulations of the 1-alkyl-3-methylimidazolium tricyanomethanide ([Cnmim(+)][TCM(-)], n = 2, 4, 6, and 8) IL family at various temperatures. The results for density, self-diffusivity and viscosity are in very good agreement with the available experimental data for all ILs verifying that the force field reliably reproduces the behaviour of the imidazolium-based [TCM(-)] IL family in a wide temperature range. Furthermore, a detailed analysis of the microscopic structure and the complex dynamic behaviour of the ILs under study was performed.

Previously we showed that CO2 could be used to extract organic molecules from ionic liquids without contamination of the ionic liquid. Consequently a number of other groups demonstrated that ionic liquid/CO2 biphasic systems could be used for homogeneously catalyzed reactions. Large differences in the solubility of various gases in ionic liquids present the possibility of using them for gas separations. More recently we and others have shown that the presence of CO2 increases the solubility of other gases that are poorly soluble in the ionic liquid phase. Therefore, a knowledge and understanding of the phase behavior of these ionic liquid/CO2 systems is important. With the aim of finding ionic liquids that improve CO2 solubility and gaining more information to help us understand how to design CO2-philic ionic liquids, we present the low- and high-pressure measurements of CO2 solubility in a range of ionic liquids possessing structures likely to increase the solubility of CO2. We examined the CO2 solubility in a number of ionic liquids with systematic increases in fluorination. We also studied nonfluorinated ionic liquids that have structural features known to improve CO2 solubility in other compounds such as polymers, for example, carbonyl groups and long alkyl chains with branching or ether linkages. Results show that ionic liquids containing increased fluoroalkyl chains on either the cation or anion do improve CO2 solubility when compared to less fluorinated ionic liquids previously studied. It was also found that it was possible to obtain similar, high levels of CO2 solubility in nonfluorous ionic liquids. In agreement with our previous results, we found that the anion frequently plays a key role in determining CO2 solubility in ionic liquids.

Thermodynamic modeling of CO 2 solubility in ionic liquid with heterosegmented statistical associating fluid theory

In this work, the PC-SAFT equation of state (EoS) has been used to model the solubility of acid gases (CO2 and H2S) in two imidazolium-based ionic liquids (ILs) ([C8-mim][PF6] and [C8-mim][Tf2N]). Parameters of pure ILs were estimated using experimental densities. Two strategies were considered to model densities of pure ILs. In strategy 1, ILs were modeled as nonassociating compounds and in strategy 2 ILs were considered as self-associating molecules and both association sites were assigned to each ILs. According to the results, the associating contribution should be taken into account in order to accurately correlate the properties of ILs. The solubility of CO2 and H2S in ionic liquids was then studied. In order to describe the experimental gas solubilities quantitatively, binary interaction parameters between the ILs and the gases were applied, which were allowed to depend linearly on temperature. After fitting a binary interaction parameter kij on experimental VLE data, the model was able to describe accurately the solubility of acid gases in these two ionic liquids. Using second strategy, an average deviation of less than 2.2% and 3.2% in the calculation of the mole fraction of CO2 and H2S in ILs (x2) were obtained, respectively.

Time-resolved fluorescence spectra and fluorescence anisotropy decay of 2-aminoquinoline (2AQ) have been measured in eight room-temperature ionic liquids, including five imidazolium-based aromatic ionic liquids and three nonaromatic ionic liquids. The same experiments have also been carried out in several ordinary molecular liquids for comparison. The observed time-resolved fluorescence spectra indicate the formation of pi-pi aromatic complexes of 2AQ in some of the aromatic ionic liquids but not in the nonaromatic ionic liquids. The fluorescence anisotropy decay data show unusually slow rotational diffusion of 2AQ in the aromatic ionic liquids, suggesting the formation of solute-solvent complexes. The probe 2AQ molecule is likely to be incorporated in the possible local structure of ionic liquids, and hence the anisotropy decays only through the rotation of the whole local structure, making the apparent rotational diffusion of 2AQ slow. The rotational diffusion time decreases rapidly by adding a small amount of acetonitrile to the solution. This observation is interpreted in terms of the local structure formation in the aromatic ionic liquids and its destruction by acetonitrile. No unusual behavior upon addition of acetonitrile has been found for the nonaromatic ionic liquids. It is argued that the aromaticity of the imidazolium cation plays a key role in the local structure formation in imidazolium-based ionic liquids.

Chapter 1 - Conversion of biomass to chemicals using ionic liquids

Modeling gas solubility in ionic liquids with the SAFT-γ group contribution method

Modeling of H2S solubility in ionic liquids using deep learning: A chemical structure-based approach

The spontaneous spreading of thin liquid films over substrate surfaces is attracting much attention due to its broad applications. Under particular conditions, surfactants deposited on substrates exhibit unstable spreading. In spite of the large effects of the stability of the spreading on the accuracy and efficiency of industrial processes that use the spreading, understanding how the stability of the spreading process is governed by the physical and chemical properties of the system is still little known. Recently, ionic liquids have been characterized as a new kind of surfactant due to their special properties. Here, we investigate the stability of the spreading of deposited imidazolium-based ionic liquids on an aqueous substrate. We focus mainly on the effects that the water solubility of the ionic liquids has on the stability. Hydrophobic ionic liquids exhibit spreading that has a highly periodic and petal-like unstable spreading front, whereas hydrophilic ionic liquids spread without such a regular spreading front and their spreading area shrinks after reaching its maximum. We propose a model for the generation of unstable spreading of hydrophobic ionic liquids, i.e., the unstable spreading front is created by the penetration of oncoming water in front of the spreading tip into the more viscous spreading ionic liquid layer, like the viscous fingering that occurs in a Hele-Shaw cell. However, the direction of the penetration is the opposite of the direction that the interface moves (the spreading direction), which is contrary to that in viscous fingering.

A comparative study of ammonia solubility in imidazolium-based ionic liquids with different structural compositions

Evaluation of interaction between imidazolium-based chloride ionic liquids and calf thymus DNA

Anti-corrosion properties of new imidazolium-based ionic liquids as a function of cation structure

Promoting fluid transportation in porous media has important applications in energy, pedology, bioscience, etc. For this purpose, one effective way is to prevent swelling through surface modification; however, it is far from enough in real cases, such as ultra-low permeability reservoirs and tight oils. In this study, we considered the comprehensive effects of inhibiting clay swelling, flocculation performance, reducing water clusters and interfacial tension and developed a series of imidazole-based tetrafluoroborate ionic liquids (ILs) with different lengths of alkyl chains. Through measurements of anti-swelling rates, XRD, SEM, 17O NMR, molecular dynamics simulation, zeta potential, flocculation evaluation, interfacial tension and a core flooding experiment based on ultra-low permeability reservoirs, the relationships between the molecular structure and physicochemical properties of ILs have been revealed. Interestingly, one of the selected ILs, imidazole-based tetrafluoroborate ILs (C8-OMImBF4), shows excellent performance, which is helpful to design an effective strategy in promoting fluid transportation in narrow spaces.

Dilute sulfuric acid and acidic ionic liquids are pretreatment methods used to selectively hydrolyze hemicellulose from lignocellulosic biomasses. In this work, a comparison between these techniques is carried out by treating sugarcane bagasse both with 1-ethyl-3-methylimidazolium hydrogen sulfate at different ionic-liquid and water contents and with H 2 SO 4 at the same conditions and equivalent ionic liquid molar contents. Results from the use of ionic liquid showed that it was possible to tune the biomass treatment either to achieve high hemicellulose hydrolysis yields of 72.5 mol% to very low furan and glucose co-production, or to obtain furfural at moderate yields of 18.7 mol% under conditions of low water concentration. In comparison to the use of ionic liquid, sulfuric acid pretreatment increased hemicellulose hydrolysis yields by 17%, but the 8.6 mol% furfural yield was also higher, and these yields were obtained at high water concentration conditions. Besides, no such tuning ability of the biomass treatment conditions can be made.