Combined Cross Layer Design and HARQ for TDD Multiuser Systems with Outdated CSIT

A new hybrid automatic repeat request (HARQ) scheme is proposed for multiple-input multiple-output (MIMO) systems when the acknowledgment (ACK) bundling is applied for packet retransmissions. In the proposed HARQ scheme, both Chase combining (CC) and incremental redundancy (IR) are utilised for a retransmission request, and the proposed HARQ scheme is called a multiple retransmission strategy-based HARQ (MRS-HARQ). During the reception process of the MRS-HARQ, IR packets obtain signal-to-noise ratio gains using the extended detection with CC packets and the improved IR packets are utilised to eliminate the interference from the CC packets. This sequential reliability improvement allows the MRS-HARQ to decrease the occurrence of the deficient transmissions, and the proposed MRS-HARQ can achieve an improved error performance and throughput over the conventional CC-based and IR-based HARQ schemes with the ACK bundling.

In the fifth generation (5G) wireless communication system, the non‐orthogonal multiple access (NOMA) scheme has recently been proposed as a possible candidate for improving spectral efficiency. We look at power‐domain NOMA in this study, in which, multiple simultaneous transmissions are allowed at the same channel with different transmission powers. To achieve reliable transmissions in NOMA, the hybrid automatic repeat request (HARQ) scheme can be integrated into NOMA. The performance of a downlink NOMA system using the Type I HARQ method is investigated in this research. This type of HARQ does not entail expensive device which is considered one of the requirements for a massive 5G‐based Internet of Things network. Unfortunately, in the literature, it has been shown that deriving closed‐form expressions for the outage probabilities of HARQ‐aided NOMA systems is intractable due to the incorporation of multiple fractional random variables. Consequently, in this article, we follow a simple yet efficient methodology to study our considered HARQ‐aided NOMA system. The HARQ‐assisted NOMA system on the downlink is modeled as an absorbing discrete‐time Markov chain (DTMC). Thereafter, under perfect and imperfect channel estimation, we use this model to examine system performance in terms of outage probability and estimated number of retransmissions. Interestingly, we demonstrate that our DTMC‐based analysis is straightforward, repeatable, and accurate. Moreover, in this article, we propose a cooperative HARQ (CHARQ) scheme for the downlink NOMA system. According to CHARQ, the users cooperate with the base station in the retransmission process that will result in improving the performance of NOMA. Monte Carlo simulations have been conducted to not only verify the accuracy of our DTMC‐based analysis, but also manifest the superiority of CHARQ over HARQ.

In this paper, we propose a cross-layer design which combines adaptive modulation and coding (AMC) at the physical layer with a hybrid automatic repeat request (HARQ) protocol at the data link layer to minimize the packet error rate (PER) and maximize the spectral efficiency. By using Markov model to predict the channel condition of next frame according to the second order statistics characteristics of the former frame, we calculate the conditional probability density function and joint probability density function of signal to noise ratio (SNR). Further, we derive the packet error rate and average spectral efficiency in closed-form for transmission over Nakagami-m fading channels. Numerical results show that the proposed scheme can obtain lower PER and higher spectral efficiency c ompared with traditional HARQ protocol s. The cross-layer design scheme combing type-III HARQ with AMC can achieve the highest spectral efficiency and the lowest PER than type-I HARQ and type-II HARQ.

In this paper, we propose a data-driven joint modulator and demodulator based on meta-learning for hybrid automatic repeat request (HARQ) schemes, which include Type-I HARQ, HARQ with chase combining (HARQ-CC), and HARQ with incremental redundancy (HARQ-IR). Data-driven deep learning (DL) techniques have proven particularly effective for enabling wireless systems to adapt to complex scenarios with unknown or imperfect channel conditions that are difficult to characterize analytically. Most existing DL approaches to realize data-driven communication frameworks are based on joint source-channel coding (JSCC). However, the difficulty in detecting transmission errors makes JSCC unsuitable for HARQ systems. To address this limitation, we propose a novel architecture that combines classical channel coding with DLbased modulation and demodulation. Specifically, we employ an autoencoder to implement both the modulator and demodulator. To quickly adapt to time-varying fading channels, the ModelAgnostic Meta-Learning (MAML) algorithm is leveraged to accelerate the convergence of the model as well as enhance the reliability of HARQ. The MAML framework is divided into two phases, including the pre-training phase to acquire shared initialization parameters across various channel conditions and the fine-tuning phase to rapidly adapt to specific channel states. Simulation results demonstrate that the proposed architecture offers dramatic improvements in convergence speed and generalization capabilities, and meanwhile boosts the reliability of HARQ schemes.

Energy delay tradeoff (EDT) is a fundamental tradeoff that can play a crucial role in understanding the energy efficiency of various transmission schemes. For hybrid automatic repeat request (HARQ) protocols, EDT can be well defined. In this paper, in order to understand the EDT for wireless multiuser systems, we consider downlink channels where the HARQ with incremental redundancy (HARQ-IR) protocol is employed for reliable transmissions to users. For a given total power, the power allocation is studied and its impact on EDT is investigated. It is shown that the multiuser diversity (MD)-based power allocation becomes preferable when a long effective delay is allowed.

Hybrid automatic repeat request (HARQ) is a high-performance communication protocol, leading to the effective use of the wireless channel and the resources with only limited feedback about the channel state information (CSI) to the transmitter. In this paper, the throughput of HARQ with incremental redundancy (IR) and fixed transmission rate is studied in the presence of statistical queuing constraints imposed as limitations on buffer overflow probabilities. In particular, tools from the theory of renewal processes and stochastic network calculus are employed to characterize the maximum arrival rates that can be supported by the wireless channel when HARQ-IR is adopted. Effective capacity is employed as the throughput metric, and a closed-form expression for the effective capacity of HARQ-IR is determined for small values of the quality-of-service (QoS) exponent. The impact of the fixed transmission rate, queuing constraints, and hard-deadline limitations on the throughput is investigated, and comparisons with type-I HARQ and HARQ with Chase Combining are provided.

We consider the design of adaptive hybrid automatic retransmission request (ARQ) with incremental redundancy (IR) in which the transmission rates of different blocks in one hybrid ARQ process can be different. The throughput of adaptive IR hybrid ARQ in block fading channels is formed based on the renewal-reward theorem. Two types of input signals are considered, namely, Gaussian inputs and practical turbo coded modulation. For Gaussian inputs, the error probability after each transmission is obtained from the outage rate. For turbo coded modulation, we obtain the error rate after each transmission block by applying union-Bhattacharyya (UB) bound for parallel channels. The throughput optimization is then formed to seek the optimal transmission rates. The results show that adaptive IR HARQ provides higher throughput than non-adaptive IR HARQ and chase combining in the moderate-to-high SNR region.

We consider energy optimization for incremental redundancy (IR) hybrid automatic repeat request (HARQ) over independent block-fading channels. We optimize the code rates in different transmission rounds to minimize the overall energy consumption of HARQ, subject to an overall packet error rate constraint. Numerical results show that the proposed IR HARQ outperforms both HARQ without combining and pure FEC without retransmission. For example, at an average channel SNR of 8dB, the energy consumption of the proposed IR combining HARQ system is reduced by 13% compared to a HARQ system without combining when the maximum number of transmissions is two.

This paper presents a cross-layer design of adaptive modulation and coding (AMC) with truncated hybrid automatic repeat request (HARQ) for one-to-many multicast transmission, in order to increase the spectral efficiency under the quality-of-service (QoS) constraints. For adaptive transmission over the channel common to the multicast group users, the AMC mode is chosen with the minimum SNR among the users to guarantee the target performance of all users. In the meanwhile, the minimum SNR required to support an AMC mode is aggressively designed by allowing retransmission with HARQ schemes. For the proposed design, we derive the average packet error rate, average number of transmission, and spectral efficiency and provide the performance numerically obtained. Numerical results show that the cross-layer design for multicast provides a significant performance gain at a small number of retransmissions as in unicast. In particular, it is observed that AMC design with HARQ is more beneficial in the low SNR region where multicast performs worse than unicast.

Recently, the efficient use of energy has become an essential research topic for green communication. This paper studies the effect of optimal power controllers on the performance of delay-sensitive communication setups that utilize hybrid automatic repeat request (HARQ). The results are obtained for repetition time diversity (RTD) and incremental redundancy (INR) HARQ protocols. In all cases, the optimal power allocation, minimizing the outage-limited average transmission power, is obtained under both continuous and bursting communication models. Also, we investigate the system throughput in different conditions. The results indicate that the power efficiency is substantially increased if adaptive power allocation is utilized. For example, assume a Rayleigh fading channel with a maximum of two (re)transmission rounds with rates {1, [1/2]} nats-per-channel-use and an outage probability constraint 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-3</sup> . Then, compared with uniform power allocation, optimal power allocation in RTD reduces the average power by 9 and 11 dB in the bursting and continuous communication models, respectively. In INR, these values are obtained to be 8 and 9 dB, respectively.

Hybrid ARQ (HARQ) has been shown to be an effective transmission strategy to improve the performance and capacity of relayed transmission in cooperative wireless networks. In contrast to the conventional HARQ, the retransmitted packets in cooperative systems do not need to come from the original source but could instead be sent by relays that overhear the transmission. This paper proposes an improved HARQ scheme with an adaptive relaying protocol (ARP). The proposed HARQ- ARP scheme combines the retransmission mechanisms (repetition coding and incremental redundancy), the distributed turbo coding (DTC) and the adaptive relaying strategy. They can effectively avoid the problem of both error propagation and noise amplification encountered in current cooperative communication systems. A performance analysis is carried out for the proposed scheme. The analysis and simulation results show that the proposed HARQ scheme can achieve a superior frame error rate (FER) to the existing HARQ relaying methods in all signal to noise ratio (SNR) regions.

In this paper, we investigate the throughput performance of single-packet and multi-packet hybrid-automatic repeat request (HARQ) with blanking for downlink non-orthogonal multiple access (NOMA) systems. While conventional single-packet HARQ achieves high throughput at the expense of high latency, multi-packet HARQ, where several data packets are sent in the same channel block, can achieve high throughput with low latency. Previous works have shown that multi-packet HARQ outperforms single-packet HARQ in orthogonal multiple access (OMA) systems, especially in the moderate to high signal-to-noise ratio regime. This work amalgamates multi-packet HARQ with NOMA to achieve higher throughput than the conventional single-packet HARQ and OMA, which has been adopted in the legacy mobile networks. We conduct theoretical analysis for the throughput per user and also investigate the optimization of the power and rate allocations of the packets, in order to maximize the weighted-sum throughput. It is demonstrated that the gain of multi-packet HARQ over the single-packet HARQ in NOMA systems is reduced compared to that obtained in OMA systems due to inter-user interference. It is also shown that NOMA-HARQ cannot achieve any throughput gain with respect to OMA-HARQ when the error propagation rate of the NOMA detector is above a certain threshold.

In this paper, we propose a cross-layer design (CLD) scheme combining rate adaptation and four types of hybrid automatic repeat request (HARQ) for multiband orthogonal frequency division multiplexing (MB-OFDM) ultra wideband (UWB) systems following the ECMA-368 standard. The time varying property is incorporated into standard UWB channel models for the purpose of investigating rate adaptation. To accurately accommodate fast time-varying channel conditions, we propose to embed the selected rate information into the acknowledgement (ACK) frames. It is shown that the proposed CLD scheme combining rate adaptation and HARQ can provide higher throughput than the HARQ-only schemes. Among the four types of HARQ schemes, HARQ Type-III has the best throughput performance while Type I has the worst.

This paper presents performance analysis and cross-layer design approaches for hybrid ARQ (HARQ) protocol in wireless networks which employ adaptive modulation and coding (AMC) at the physical layer and are subject to time-correlated fading channels. Utilizing a Markov channel model which accounts for the temporal correlation in successive parity transmissions by the adaptive rate HARQ protocol, we derive the system throughput and the packet loss probability based on a rate compatible punctured convolutional (RCPC) code family. As an application, we then present a cross-layer AMC design which takes into account the performance gain of the HARQ protocol at the link layer. The results illustrate that including AMC in the HARQ protocol leads to a substantial throughput gain, but the channel correlation strongly diminishes the performance of the HARQ protocol in terms of throughput and packet loss rate.

Predictor antenna (PA) system is referred to as a system with two sets of antennas on the roof of a vehicle, where the PAs positioned in the front of the vehicle are used to predict the channel state observed by the receive antennas (RAs) that are aligned behind the PAs. In this letter, we study the effect of spatial mismatch on the accuracy of channel state information estimation, and analyze the delay-constrained average rate of hybrid automatic repeat request (HARQ)-based PA systems. We consider variable-length incremental redundancy (INR) HARQ protocol, and derive a closed-form expression for the maximum average rate subject to a maximum delay constraint. Moreover, we study the effect of different parameters such as the vehicle speed, the antenna distance and the rate allocation on the system performance. The results indicate that, compared to the open-loop case, the delay-limited average rate is considerably improved with our proposed PA-HARQ scheme.