Distributed model predictive control with actuator saturation for Markovian jump linear system

Designing a stabilized distributed model predictive control (DMPC) with constraints is an open and important problem for a class of large-scale distributed systems, which are composed by both weakly and strongly coupled subsystems. This paper proposes a design of DMPC network to stabilize this class of large-scale systems. A coupling degree-based clustering method is first designed to classify subsystems into some middle-scale subsystems (M-subsystem) off-line according to the adjacent matrix, so that these M-subsystems are weakly coupled with each other. Then, each M-subsystem is controlled by a virtual model predictive control (MPC), which is realized by several individual controllers with running iterative cooperative DMPC algorithm, since the solution of cooperative DMPC is able to converge to a fixed point without coupling constraints. Each MPC communicates with the corresponding interacted M-subsystems’ MPCs once in a control period for exchanging future state evolution estimation. All the subsystem-based MPCs are composed of the proposed peer-to-peer DMPC network. In addition, an additional consistency and stabilization constraints are added to guarantee the recursive feasibility and stability of the overall system. The convergence of the iterative DMPC algorithm for each M-subsystem and the stabilization analysis of the overall system are provided. The simulation results show the efficiency of the proposed method. Note to Practitioners —The proposed method is designed for the systems, which are composed of both strong and weak coupling subsystems and are controlled in a distributed structure. The aim of this method is to design a distributed model predictive control (MPC) network for the operational optimization of entire system. The designed control structure and the distributed MPC algorithm with the proposed method could guarantee the recursive feasibility and asymptotic stability of the entire system. To apply this method, the first step is to obtain the models of each subsystem. Then, design the distributed MPC network structure according to the proposed cluster algorithm, which determines the set of subsystems that each virtue MPC controls. Next step is to configure the network information exchanging among these subsystems and construct the optimization problem of each subsystem. Finally, use the existing quadratically constrained quadratic program solvers to calculate the optimal control laws and apply these optimal control laws to the corresponding subsystems. This method can be used in large-scale chemical processes, air conditioner systems for multizone buildings, distributed energy generation systems, and so on.

In this study, a distributed model predictive control algorithm is presented for the polytopic uncertain system subject to randomly occurring actuator saturation and packet loss. The global system is decomposed into several subsystems, and a novel distributed controller model is established to account for both the actuator saturation and packet loss in a unified representation by using two sets of Bernoulli distributed white sequences with known conditional probabilities. By transforming the non‐linear feedback law into a convex hull of linear feedback laws, the distributed controllers for subsystems are obtained by solving a linear matrix inequality (LMI) optimisation problem. Finally, two simulation examples are employed to show the effectiveness of the techniques proposed in this study.

In this paper, we study the distributed model predictive control (MPC) of polytopic uncertain systems with quantised communication and packet dropouts. The model of the whole plant is divided into a certain number of incomplete subsystems. Due to the nature of the distributed control structure, there is generally a lack of information about the state of the overall system. Each subsystem shares its information with neighbour subsystems via reliable connection. Distributed MPC controllers are designed for each subsystem by solving the linear matrix inequalities optimisation problem. The distributed state feedback laws are quantised and transmitted via communication network. An iterative algorithm is presented to make coordination among distributed state feedback laws. The communication is assumed to be affected by random packet dropouts in a representation of Bernoulli distributed white sequences with known conditional probabilities. A case study is carried out to demonstrate the effectiveness of the proposed distributed MPC technique.

In this study, an approach to design robust distributed model predictive control (MPC) is proposed for polytopic uncertain networked control systems with time delays. To reduce the computational complexity and improve the flexibility, the entire system is decomposed into multiple smaller dimensional subsystems. For each subsystem, the proposed robust distributed MPC algorithm requires solving multiple linear matrix inequality optimisation problems to minimise an upper bound on a robust performance objective. An augmented polytopic uncertainty description is invoked to handle the input delays. The conservativeness of distributed MPC algorithm is reduced by utilising a sequence of feedback control laws. An iterative on‐line algorithm for robust distributed MPC is developed to coordinate the distributed MPC controllers. Convergence and robust stability of the proposed distributed MPC are investigated. A numerical example is carried out to demonstrate the effectiveness of the proposed algorithm.

Distributed model predictive control for linear systems under communication noise: Algorithm, theory and implementation

Partitioned Based Cooperative Distributed Model Predictive Control for Large-Scale Nonlinear Systems

This paper concerns a distributed model predictive control (DMPC) strategy in which each controller views the signals from other subsystems as disturbance inputs in its local model. The DMPC controllers exchange predictions on the bounds of their state trajectories and incorporate this information into their local DMPC problems. They also impose their own predicted state bounds as constraints in subsequent DMPC iterations to guarantee their subsystem satisfies the bounds broadcast to the other controllers. Each controller solves a local min-max problem on each iteration to optimize performance with respect to worst-case disturbances. Parameterized state feedback is introduced into the DMPC formulation to obtain less conservative solutions and predictions. The paper presents sufficient conditions for feasibility and stability. The approach is illustrated with an example.

ABSTRACTIn this work, synthesis of robust distributed model predictive control (MPC) is presented for a class of linear systems subject to structured time-varying uncertainties. By decomposing a global system into smaller dimensional subsystems, a set of distributed MPC controllers, instead of a centralised controller, are designed. To ensure the robust stability of the closed-loop system with respect to model uncertainties, distributed state feedback laws are obtained by solving a min–max optimisation problem. The design of robust distributed MPC is then transformed into solving a minimisation optimisation problem with linear matrix inequality constraints. An iterative online algorithm with adjustable maximum iteration is proposed to coordinate the distributed controllers to achieve a global performance. The simulation results show the effectiveness of the proposed robust distributed MPC algorithm.

SummaryIn this paper, a distributed output feedback model predictive control (OFMPC) algorithm is presented for the polytopic uncertain system subject to randomly occurring actuator saturation and packet loss. Compared with the intensively applied state feedback control in MPC, the OFMPC is more feasible to the real world because the system states are often unmeasurable. With taking both actuator saturation and packet loss into account, the presented OFMPC algorithm is more practical. Moreover, by splitting the controller inputs into two independent parts, the presented dynamic output feedback control (DOFC) strategy provides more freedom to the controller design. With the global system decomposed into some subsystems, the computation complexity is reduced, thus the online designing time can be saved. By defining the estimation error function and forming an augmented system to handle the DOFC and by transforming the nonlinear feedback law into a convex hull of linear feedback laws, the distributed controllers are obtained by solving a linear matrix inequality (LMI) optimization problem. Finally, some simulation examples are employed to show the effectiveness of the techniques proposed in this paper. Copyright © 2015 John Wiley & Sons, Ltd.

Fil: Giovanini, Leonardo Luis. Consejo Nacional de Investigaciones Cientificas y Tecnicas. Centro Cientifico Tecnologico Conicet - Santa Fe. Instituto de Investigacion en Senales, Sistemas e Inteligencia Computacional. Universidad Nacional del Litoral. Facultad de Ingenieria y Ciencias Hidricas. Instituto de Investigacion en Senales, Sistemas e Inteligencia Computacional; Argentina

Multiobjective State-Feedback Control Design with Non-Common LMI Solutions: A Subspace Approach

Combined environmental and economic dispatch of smart grids using distributed model predictive control

In this paper a method is proposed to design an anti-windup scheme for discrete time linear systems with input saturations and actuator additive failures. This method provides a fault tolerant system reconfiguration mechanism with a control law which compensates for the estimated actuator additive faults and maintains the overall system stability in spite of actuator saturations. The design approach is derived from the solution of linear matrix inequalities (LMI) to guarantee the stability regions. For that purpose the fault tolerant control method is based on a linear quadratic regulator (LQR) and a fault estimator for compensation purposes. This method was tested in realistic simulations with the software Carins (CNES) on a pressure and mass flow rate model of a cryogenic test bench cooling circuit.

This work focuses on a class of nonlinear control problems that arise when new control systems which may use networked sensors and/or actuators are added to already operating control loops to improve closed‐loop performance. In this case, it is desirable to design the pre‐existing control system and the new control system in a way such that they coordinate their actions. To address this control problem, a distributed model predictive control method is introduced where both the pre‐existing control system and the new control system are designed via Lyapunov‐based model predictive control. Working with general nonlinear models of chemical processes and assuming that there exists a Lyapunov‐based controller that stabilizes the nominal closed‐loop system using only the pre‐existing control loops, two separate Lyapunov‐based model predictive controllers are designed that coordinate their actions in an efficient fashion. Specifically, the proposed distributed model predictive control design preserves the stability properties of the Lyapunov‐based controller, improves the closed‐loop performance, and allows handling input constraints. In addition, the proposed distributed control design requires reduced communication between the two distributed controllers since it requires that these controllers communicate only once at each sampling time and is computationally more efficient compared to the corresponding centralized model predictive control design. The theoretical results are illustrated using a chemical process example. © 2009 American Institute of Chemical Engineers AIChE J, 2009

This is a position paper on the current state of the art in distributed Model Predictive Control (MPC) and our view on its future potential. We present results from a recent survey of 35 distributed MPC approaches. For this, we propose a way in which distributed MPC approaches can be categorized for comparison. We also link the potential that these approaches have to the domain of other fields such as integrated environmental optimal decision making and cyber-physical systems. Many challenges for realizing these links have to be faced. We present our views on how the advances in several highly active research domains could be used to overcome these challenges. As such, this paper is intended as a starting point for the exploration of various novel research cooperations.