Effect of quantization on MIMO radar performance

This article presents two-dimensional (2-D) scattering centres' parameter estimation based on linear uniform multi-input multi-output (MIMO) radars. Unlike single-input single-output (SISO) radars, MIMO radars transmit multiple detection signals at the same time. We assume that each antenna of a MIMO radar transmits signals with a set of different spread spectrum codes so as to distinguish the echoes from all antennas. Then, with spread spectrum and de-spread spectrum techniques, each antenna of a MIMO radar could distinguish its own stepped-up frequency echoes transmitted by itself. In this article, we take m sequences as spread spectrum codes and assume that the ratio between the MIMO radars array aperture and the target distance is much less than 1, then we use 2-D fast Fourier transform (FFT) and matrix extended matrix pencil (MEMP) methods to extract 2-D scattering centres' parameters after MIMO radar have received de-spread echoes. Simulations illustrate that both SISO radars and linear uniform MIMO radars using the spread spectrum technique can get similar estimation results, and the MEMP method can afford super-resolution estimation results, whereas the 2-D FFT method is more useful when the number of MIMO radar array elements are no more than the number of scattering centres.

Use of multiple transmit and receive antennas have become a popular research area in radar community after the success of the same concept in communication. It is shown by Fishler et al. that multi-input multi-output (MIMO) radar has considerable advantages compared to traditional radar and phased array radar systems. In this paper, detection performance of MIMO radar using Neyman-Pearson detector is investigated in K-distributed sea clutter for a practical scenario. Also, spikiness of K-distributed MIMO radar clutter is discussed with respect to the number of nodes.

Space time coding plays quite an important role in the design of multi-input multi-output (MIMO) radar. It has been shown that the correlation characteristics of waveform set have a great impact on the performance of target detection and localisation for MIMO radar. In this study, the target detection and localisation performance of co-located MIMO radar is analysed theoretically and experimentally, when correlated (not ideally orthogonal or fully coherent) waveforms are transmitted. The relationship between transmit–receive beam pattern improvement and correlation coefficients of transmitted waveforms is investigated. The signal to interference and noise ratio varying with correlation coefficients in range-Doppler matched processing is defined and analysed. Furthermore, Cramer–Rao bound for target direction of arrival estimation and target detection probability in the Neyman–Pearson criteria are derived when transmitting correlated waveforms. It is shown that the MIMO radar detection and localisation performance is much dependent with the correlation level of transmitted waveforms, which can be quite useful for MIMO radar orthogonal waveform design. Numerical simulation validates the theoretical analysis.

Based on the array architecture of multiple transmitting/receiving antennas, Multi-Input Multi-Output (MIMO) radar provides a new mechanism for radar imaging technology. In order to explore the processing approach to this imaging mechanism, the two dimensional (2D) imaging model of MIMO radar is established first, and the spatial sampling ability is analyzed from the concept of spatial convolution of the antenna elements. The target spatial spectral filling format of MIMO radar with monochromatic transmitting signal is described. High-resolution imaging capability of MIMO radar is analyzed according to spatial spectral coverage and the corresponding imaging algorithm is presented. Finally, field imaging experiment is used to demonstrate the superior imaging performance of MIMO radar.

The concept of multi-input multi-output (MIMO) radar has drawn considerable attention in recent years. One of the key technologies to enable the MIMO radar is to design the orthogonal signals to support simultaneous transmission from multiple antennas, because the orthogonality characteristics have a keen impact on the performance of the MIMO radar. In this paper, a novel approach to generate and process mutually orthogonal waveforms based on orthogonal frequency division multiplexing (OFDM) signals is proposed. The ambiguity function of the suggested waveforms is derived and analyzed based on the statistical derivation. A corresponding multi-channel signal processing scheme at the receiver part is proposed to eliminate the Doppler influence and suppress the cross-channel interference. Numerical simulation results based on the Monte Carlo method are presented to validate the theoretical derivation and analysis. The findings indicate that the inter-channel interference for moving targets can be eliminated and that the proposed interleaved OFDM signals are a suitable waveform set for the MIMO radar applications.

In wireless communication, multiple signals are utilized to receive and send information in the form of signals simultaneously. These signals consume little power and are usually inexpensive, with a high data rate during data transmission. An Multi Input Multi Output (MIMO) system uses numerous antennas to enhance the functionality of the system. Moreover, system intricacy and power utilization are difficult and highly complicated tasks to achieve in an Analog to Digital Converter (ADC) at the receiver side. An infinite number of MIMO channels are used in wireless networks to improve efficiency with Cross Entropy Optimization (CEO). ADC is a serious issue because the data of the accepted signal are completely lost. ADC is used in the MIMO channels to overcome the above issues, but it is very hard to implement and design. So, an efficient way to enhance the estimation of channels in the MIMO system is proposed in this paper with the utilization of the heuristic-based optimization technique. The main task of the implemented channel prediction framework is to predict the channel coefficient of the MIMO system at the transmitter side based on the receiver side error ratio, which is obtained from feedback information using a Hybrid Serial Cascaded Network (HSCN). Then, this multi-scaled cascaded autoencoder is combined with Long Short Term Memory (LSTM) with an attention mechanism. The parameters in the developed Hybrid Serial Cascaded Multi-scale Autoencoder and Attention LSTM are optimized using the developed Hybrid Revised Position-based Wild Horse and Energy Valley Optimizer (RP-WHEVO) algorithm for minimizing the "Root Mean Square Error (RMSE), Bit Error Rate (BER) and Mean Square Error (MSE)" of the estimated channel. Various experiments were carried out to analyze the accomplishment of the developed MIMO model. It was visible from the tests that the developed model enhanced the convergence rate and prediction performance along with a reduction in the computational costs.

New correlated MIMO radar covariance matrix design with low side lobe levels and much lower complexity

A novel target detection algorithm for large array multi-input multi-output (MIMO) radar in spatially correlated noise is proposed in this paper using canonical correlation technique (CCT). In the signal model, two separate sub-arrays are employed as the receive array of a transmit diversity MIMO radar system. Assume that the elementary noise in each sub-array has spatial correlation, and the number of receive elements is large and grows as the same rate with the snapshots. The detection statistics is constructed based on the generalized likelihood ratio test (GLRT) criterion and the sample canonical correlation coefficient between the two subarrays. The expression of decision threshold is derived via the Tracy-Widom distribution of order 2 in random matrix theory. The simulation results show that the detection performance of the proposed algorithm is better than that of the conventional condition number (CN)-based algorithm in the presence of spatially correlated noise and large array.

We propose the use of compressive sensing (CS) in the context of a multi-input multioutput (MIMO) radar system that is implemented by a small scale network. Each receive node compressively samples the incoming signal, and forwards a small number of samples to a fusion center. At the fusion center, all received data are jointly processed to extract information on the potential targets via the CS approach. Since CS-based MIMO radar would require many fewer measurements than conventional MIMO radar for reliable target detection, there would be power savings during the data transmission to the fusion center, which would prolong the life of the wireless network. First, we propose a direction of arrival (DOA)-Doppler estimation approach. Assuming that the targets are sparsely located in the DOA-Doppler space, based on the samples forwarded by the receive nodes, the fusion center formulates an ℓ1-optimization problem, the solution of which yields the target DOA-Doppler information. The proposed approach achieves the superior resolution of MIMO radar with far fewer samples than required by conventional approaches. Second, we propose the use of step frequency to CS-based MIMO radar, which enables high range resolution, while transmitting narrowband pulses. For slowly moving targets, a novel approach is proposed that achieves significant complexity reduction by successively estimating angle-range and Doppler in a decoupled fashion and by employing initial estimates to further reduce the search space. Numerical results show that the achieved complexity reduction does not hurt resolution. Finally, we investigate optimal designs for the measurement matrix that is used to linearly compress the received signal. One optimality criterion amounts to decorrelating the bases that span the sparse space of the incoming signal and simultaneously enhancing signal-to-interference ratio (SIR). Another criterion targets SIRimprovement only. It is shown via simulations that, in certain cases, the measurement matrices obtained based on the aforementioned criteria can improve detection accuracy as compared to the typically used Gaussian random measurement matrix.

Block synchronization is a prerequisite to data-dependent superimposed training (DDST) based channel estimation. Mainly designed for single input single output (SISO) system, the existing block synchronization algorithms can hardly work for multi-input multi-output (MIMO) system. A new joint block synchronization, channel and dc-offset estimation algorithm based on balanced zero correlation zone (ZCZ) sequence for MIMO system is proposed in this paper. Analysis and simulation results show that the new algorithm has the same performance for SISO systems as the existing algorithms when their block and cyclic prefix lengths are the same. While for MIMO systems, the performance of the proposed algorithm is much better than that of the existing algorithms.

This letter discusses the problem of direction of departure (DOD) and direction of arrival (DOA) estimation for multi-input multi-output (MIMO) radar, and derives a reduced-dimension multiple signal classification (MUSIC) algorithm therein. The proposed algorithm, which only requires one-dimension search, can avoid the high computational cost within two-dimension MUSIC (2D-MUSIC) algorithm. We illustrate that the algorithm has better performance ESPRIT algorithm, and has very close performance to 2D-MUSIC algorithm. Further our algorithm requires no pair matching. Simulation results verify the usefulness of our algorithm.

최근 대용량, 초고속 통신 서비스의 비중이 높아짐에 따라 배열 안테나를 사용하는 MIMO(Multi-Input Multi-Output) 시스템의 활용이 중요하게 평가되고 있다. 하지만 기존의 MIMO 시스템은 다수의 안테나를 사용하기 때문에 안테나의 개수만큼 RF(Radio Frequency) 체인이 요구되며, 이로 인해 복잡도와 전력 소모가 크다는 단점을 가진다. 이러한 기존 MIMO 시스템의 단점을 해결하기 위해서 단일 능동 소자와 다수의 기생 소자를 이용하는 방식의 ESPAR(Electronically Steerable Parasitic Array Radiator) 안테나를 사용하는 빔 공간 MIMO 시스템에 대한 연구가 활발히 진행되고 있다. ESPAR 안테나를 사용하는 빔 공간 MIMO 시스템은 단일 RF 체인으로 구성되어 있기 때문에 기존 MIMO 시스템의 단점을 해결할 수 있다. 본 논문에서는 시스템의 보안성을 향상시키기 위해 QPSK(Quadrature Phase Shift Keying) 변조 방식의 ESPAR 안테나를 사용하는 빔 공간 MIMO 시스템에 비예측성, 비주기성, 구현의 용이성, 민감한 초기조건 등의 특징을 가지고 있는 카오스 통신 알고리즘을 적용하여 QPSK 변조 방식의 ESPAR 안테나를 사용하는 카오스 빔 공간 MIMO 시스템을 구성하고 성능을 평가한다. Recently, utilization of MIMO(Multi-Input Multi-Output) system using array antennas is evaluated significantly according to the extension of high-capacity and high-speed communication services. However, MIMO system has disadvantages such as high-complexity and high-power-consumption, because RF(Radio Frequency) chain is required as antenna number, and several array antenna is used in conventional MIMO system. In order to solve these problems, research about beamspace MIMO system using ESPAR(Electronically Steerable Parasitic Array Radiator) antenna that has single RF chain by using one active antenna and several parasitic elements has been studied actively. Beamspace MIMO system using ESPAR antenna is possible to solve the problems of conventional MIMO system, because this system is composed by single RF chain. In this paper, in order to improve the system security, chaos communication algorithm that has characteristics such as non-periodic, non-predictability, easy implementation and initial condition is applied to QPSK (Quadrature Phase Shift Keying) modulated beamspace MIMO system. We design the chaos QPSK modulated beamspace MIMO system, and evaluate SER performance of this system.

The paper proposes an approach to second order sliding mode control for multi-input multi-output (MIMO) nonlinear uncertain systems. Second order sliding mode techniques for single-input single-output (SISO) systems show, with respect to standard sliding mode control, the same properties of robustness and precision, feature a higher order accuracy and can be exploited to eliminate the chattering effect. The application of second order sliding mode control to MIMO nonlinear systems is a challenging matter. The presented MIMO control method applies to a quite large class of nonlinear processes affected by uncertainties of general nature; the control design is simple; the conditions of existence on the controllers are weak. The proposed procedure represents a general approach to the second order sliding mode control of MIMO systems

Transmit diversity schemes have been studied for high spectral-efficiency and high bit-rate transmission, such as multi-input multi-output (MIMO) systems. In this paper, a novel dual polarized ceiling-mounted antenna is designed and simulated. In the MIMO systems, forward error correction coding is essential for high quality communications. At the two typical scenes, the single-input single-output system compared with two single polarized antennas and an dual polarized antenna MIMO system is tested. It is shown that the MIMO system have improved throughput level obviously. The dual polarized ceiling-Mounted dual streams MIMO antenna will save much construction cost in the long-term evaluation systems in the future, which can be called the “green” MIMO antenna.

Multi input multi output (MIMO) system with the multiple antennas at both the transmitter and receiver is the emerging technology in the modern wireless system. MIMO systems are well adopted due to its high spectral efficiency and high data rates. For the detection of MIMO systems, a powerful technique called Lattice Reduction (LR) algorithm are used to obtain the better orthogonality in the channel matrices and is aided with the linear and low complexity detectors such as Zero forcing(ZF) and Minimum mean square error (MMSE) for the reduction in complexity. In this paper we propose a new algorithm called Enhanced lattice reduction algorithm to improve the error performance for the linear detectors with the lesser complexity and also it is aided with the non linear precoding called Tomlinson-Harashima precoding (THP) in the presence of channel state information (CSI). Lattice reduction aided with THP improves the performance linearly. BER performance of the proposed algorithm is determined and it is compared with the other LR aided algorithms in the literature.