Two-dimensional scattering centre extraction based on multi-input multi-output radars

Space time coding plays quite an important role in the design of multi-input multi-output (MIMO) radar. It has been shown that the correlation characteristics of waveform set have a great impact on the performance of target detection and localisation for MIMO radar. In this study, the target detection and localisation performance of co-located MIMO radar is analysed theoretically and experimentally, when correlated (not ideally orthogonal or fully coherent) waveforms are transmitted. The relationship between transmit–receive beam pattern improvement and correlation coefficients of transmitted waveforms is investigated. The signal to interference and noise ratio varying with correlation coefficients in range-Doppler matched processing is defined and analysed. Furthermore, Cramer–Rao bound for target direction of arrival estimation and target detection probability in the Neyman–Pearson criteria are derived when transmitting correlated waveforms. It is shown that the MIMO radar detection and localisation performance is much dependent with the correlation level of transmitted waveforms, which can be quite useful for MIMO radar orthogonal waveform design. Numerical simulation validates the theoretical analysis.

Use of multiple transmit and receive antennas have become a popular research area in radar community after the success of the same concept in communication. It is shown by Fishler et al. that multi-input multi-output (MIMO) radar has considerable advantages compared to traditional radar and phased array radar systems. In this paper, detection performance of MIMO radar using Neyman-Pearson detector is investigated in K-distributed sea clutter for a practical scenario. Also, spikiness of K-distributed MIMO radar clutter is discussed with respect to the number of nodes.

Based on the array architecture of multiple transmitting/receiving antennas, Multi-Input Multi-Output (MIMO) radar provides a new mechanism for radar imaging technology. In order to explore the processing approach to this imaging mechanism, the two dimensional (2D) imaging model of MIMO radar is established first, and the spatial sampling ability is analyzed from the concept of spatial convolution of the antenna elements. The target spatial spectral filling format of MIMO radar with monochromatic transmitting signal is described. High-resolution imaging capability of MIMO radar is analyzed according to spatial spectral coverage and the corresponding imaging algorithm is presented. Finally, field imaging experiment is used to demonstrate the superior imaging performance of MIMO radar.

The concept of multi-input multi-output (MIMO) radar has drawn considerable attention in recent years. One of the key technologies to enable the MIMO radar is to design the orthogonal signals to support simultaneous transmission from multiple antennas, because the orthogonality characteristics have a keen impact on the performance of the MIMO radar. In this paper, a novel approach to generate and process mutually orthogonal waveforms based on orthogonal frequency division multiplexing (OFDM) signals is proposed. The ambiguity function of the suggested waveforms is derived and analyzed based on the statistical derivation. A corresponding multi-channel signal processing scheme at the receiver part is proposed to eliminate the Doppler influence and suppress the cross-channel interference. Numerical simulation results based on the Monte Carlo method are presented to validate the theoretical derivation and analysis. The findings indicate that the inter-channel interference for moving targets can be eliminated and that the proposed interleaved OFDM signals are a suitable waveform set for the MIMO radar applications.

New correlated MIMO radar covariance matrix design with low side lobe levels and much lower complexity

Multi-input multi-output (MIMO) radar systems have taken considerable attention among radar community in recent years. As stated in some publications MIMO radars have serious performance advantages compared to single-input single-output (SISO) radars. Although MIMO radars perform well theoretically, they have some practical problems. One of these problems is the data transmission rate required by MIMO radars. Quantization directly affects the amount of data to be transmitted. In this paper effects of quantization on MIMO radar performance is covered.

This letter discusses the problem of direction of departure (DOD) and direction of arrival (DOA) estimation for multi-input multi-output (MIMO) radar, and derives a reduced-dimension multiple signal classification (MUSIC) algorithm therein. The proposed algorithm, which only requires one-dimension search, can avoid the high computational cost within two-dimension MUSIC (2D-MUSIC) algorithm. We illustrate that the algorithm has better performance ESPRIT algorithm, and has very close performance to 2D-MUSIC algorithm. Further our algorithm requires no pair matching. Simulation results verify the usefulness of our algorithm.

A novel target detection algorithm for large array multi-input multi-output (MIMO) radar in spatially correlated noise is proposed in this paper using canonical correlation technique (CCT). In the signal model, two separate sub-arrays are employed as the receive array of a transmit diversity MIMO radar system. Assume that the elementary noise in each sub-array has spatial correlation, and the number of receive elements is large and grows as the same rate with the snapshots. The detection statistics is constructed based on the generalized likelihood ratio test (GLRT) criterion and the sample canonical correlation coefficient between the two subarrays. The expression of decision threshold is derived via the Tracy-Widom distribution of order 2 in random matrix theory. The simulation results show that the detection performance of the proposed algorithm is better than that of the conventional condition number (CN)-based algorithm in the presence of spatially correlated noise and large array.

We propose the use of compressive sensing (CS) in the context of a multi-input multioutput (MIMO) radar system that is implemented by a small scale network. Each receive node compressively samples the incoming signal, and forwards a small number of samples to a fusion center. At the fusion center, all received data are jointly processed to extract information on the potential targets via the CS approach. Since CS-based MIMO radar would require many fewer measurements than conventional MIMO radar for reliable target detection, there would be power savings during the data transmission to the fusion center, which would prolong the life of the wireless network. First, we propose a direction of arrival (DOA)-Doppler estimation approach. Assuming that the targets are sparsely located in the DOA-Doppler space, based on the samples forwarded by the receive nodes, the fusion center formulates an ℓ1-optimization problem, the solution of which yields the target DOA-Doppler information. The proposed approach achieves the superior resolution of MIMO radar with far fewer samples than required by conventional approaches. Second, we propose the use of step frequency to CS-based MIMO radar, which enables high range resolution, while transmitting narrowband pulses. For slowly moving targets, a novel approach is proposed that achieves significant complexity reduction by successively estimating angle-range and Doppler in a decoupled fashion and by employing initial estimates to further reduce the search space. Numerical results show that the achieved complexity reduction does not hurt resolution. Finally, we investigate optimal designs for the measurement matrix that is used to linearly compress the received signal. One optimality criterion amounts to decorrelating the bases that span the sparse space of the incoming signal and simultaneously enhancing signal-to-interference ratio (SIR). Another criterion targets SIRimprovement only. It is shown via simulations that, in certain cases, the measurement matrices obtained based on the aforementioned criteria can improve detection accuracy as compared to the typically used Gaussian random measurement matrix.

For target localization with radar, time of arrival (TOA), angle of arrival (AOA) and frequency of arrival (FOA) informations can be used in cooperation. In general, TOA information is enough to localize a target. Moreover, if the target velocity should be estimated, the target velocity is able to estimated by using doppler frequency. In this paper, the Cramer-Rao Bound (CRB) is shown for Multi Input, Multi Output (MIMO) radar with widely separated antennas case. CRB's are compared for different targets and transmitter-receiver configurations.

A MIMO (multi-input multi-output) radar system, unlike a standard phased-array radar, can choose freely the probing signals transmitted via its antennas to maximize the power around the locations of the targets of interest, or more generally to approximate a given transmit beampattern, and also to minimize the cross-correlation of the signals reflected back to the radar by the targets of interest. In this paper, we show how the above desirable features can be achieved by designing the covariance matrix of the probing signal vector transmitted by the radar. Moreover, in a numerical study, we show that the proper choice of the probing signals can significantly improve the performance of adaptive MIMO radar techniques. Additionally, we demonstrate the advantages of several MIMO transmit beampattern designs, including a beampattern matching design and a minimum sidelobe beampattern design, over their phased- array counterparts.

We examine the moving range-spread target in distributed multi-input multi-output (MIMO) radar. More precisely, a knowledge-aided (KA) model for nonhomogenous disturbance is proposed. We model the covariance matrices for different transmit-receive (Tx-Rx) pairs as random matrices, which share the same matrix structure but with different power levels for the non-homogeneous clutter powers across different Tx-Rx pairs. Two detectors are proposed. The first is a KA generalized likelihood ratio test (GLRT) without range training. The second is an ad-doc KA GLRT with range training. Computer simulations and analyses show the performance improvements offered by the proposed detectors in heterogeneous scenarios.

In this paper, under the situation of multiple interference regions, an optimal antenna placement problem for a distributed Multi-Input Multi-Output (MIMO) radar is studied. Considering multiple interference regions, we solve the antenna placement problem by utilizing antenna placement method based on Multi-Objective Particle Swarm Optimization (MOPSO). However, it is not clear when to stop the iteration for which no knowledge about the optimum result is available. Hence, computational resource may be wasted over iterations. Nevertheless, time and computational resource is limited in real application. Therefore, to obtain the optimal placement result with limited time and computational resource, an iteration convergence criterion based on interval distance is proposed. The iteration convergence criterion can be used to stop the optimization process efficiently when the optimal antenna placement algorithm reaches the desired convergence level. Finally, numerical results are provided to verify the validity of the proposed algorithm.

Bi-capon beamforming for MIMO radar based on rank-reduced correlation matrix

This paper presents an approach for jointly estimating target locations and uncertain multipath propagation channel parameters with a multi-input multi-output (MIMO) radar system. The multipath channel is modelled with geometrical features such as flat planes and point reflectors, whose locations are uncertain. The practical issue of data association between radar returns and multipath modes in the presence of missed detections and false alarms is solved via a multihypothesis data association algorithm. Simulation results demonstrate enhanced target tracking performance in the presence of multipath even when the direct path is occasionally unobservable. (6 pages)