Efficient spatial covariance estimation for asynchronous co-channel interference suppression in MIMO-OFDM systems

This paper investigates low complexity detection for multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems with co-channel interference (CCI). We firstly derive minimum mean square error (MMSE) detection based on sorted QR decomposition (SQRD) and modified MMSE SQRD detection for MIMO-OFDM systems with CCI. Although better performance can be achieved by the new detectors than liner MMSE (LMMSE) detection, the computational complexity is still high due to the required matrix inversion operation. In order to overcome such an issue and design low complexity detection method for MIMO-OFDM systems with CCI, then, we propose an improved MMSE SQRD detector by utilizing a regularization method. The simplification of the regularization parameter calculation in the proposed method is then discussed. Simulation results show that the error performance of the proposed method approaches modified MMSE SQRD detection in presence of CCI, while keeping a much lower complexity.

International audience

Performance analysis of multicell multiuser MIMO MC DS/CDMA system with MMSE user-ordered SIC technique

In a companion paper, we have studied the zero-forcing (ZF) transceiver with decision feedback equalizer (DFE) over slowly time-varying narrowband multiinput multioutput (MIMO) channels. The space-time generalized triangular decomposition (ST-GTD) was used for the design of ZF-DFE transceivers. The space-time geometric mean decomposition (ST-GMD) ZF transceiver minimizes both the arithmetic mean square error (MSE) at the feedback detector and the average uncoded bit error rate (BER) in moderate high signal-to-noise ratio (SNR). This paper addresses the design problem of DFE transceiver without zero-forcing constraint. In the first part, a channel independent temporal precoder is superimposed on the conventional block-wise GMD-based minimum mean square error (MMSE) DFE transceiver to take advantage of the temporal diversity. In the second part, ST-GTD is applied for the design of MMSE DFE transceivers. With accurate channel prediction and space-time powerloading, the proposed ST-GMD MMSE transceiver minimizes the arithmetic MSE at the feedack detector, and maximizes Gaussian mutual information. For practical applications, the ST-GTD MMSE transceiver which does not require channel prediction but shares the same asymptotic BER performance with the ST-GMD MMSE system is also developed. In the convex region, our analysis shows that the proposed MMSE transceivers has better BER performance than the conventional GMD-based MMSE transceiver; the average BERs of the proposed systems are nonincreasing functions of the ST-block size. The superior performance of ST-GMD MMSE transceiver over the ST-GMD ZF transceiver is also verified analytically.

In orthogonal frequency-division multiplexing (OFDM) systems, it is generally assumed that the channel response is static in an OFDM symbol period. However, the assumption does not hold in high-mobility environments. As a result, intercarrier interference (ICI) is induced and the system performance is degraded. A simple remedy for this problem is the application of the zero-forcing (ZF) and minimum mean square error (MMSE) equalizers. Unfortunately, the direct ZF method requires the inversion of an NxN ICI matrix, where N is the number of subcarriers. When N is large, the computational complexity can become prohibitively high. As for the direct MMSE method, in addition to an NxN matrix inverse, it requires an extra NxN matrix multiplication, making the required computational complexity higher compared to the direct ZF method. In this dissertation, we first propose a low-complexity ZF method to solve the problem in single-input-single-output (SISO) OFDM systems. The main idea is to explore the special structure inherent in the ICI matrix and to apply Newton's iteration for matrix inversion. With our formulation, fast Fourier transforms (FFTs) can be used in the iterative process, reducing the complexity from O(N^3) to O(Nlog_2 N) . Also, the required number of the iteration is typically one or two. We also analyze the convergence behavior of the proposed method and derive the theoretical output signal-to-interference-noise-ratio (SINR). For the MMSE method, we first reformulate the MMSE solution in a way that the extra matrix multiplication can be avoided. Similar to the ZF method, we then exploit the structure of the ICI matrix and apply Newton's iteration to reduce the complexity of the matrix inversion. For a multiple-input-multiple-output (MIMO) OFDM system, the required complexity of the ZF and MMSE methods becomes more intractable. We then manage to extend the proposed ZF and MMSE methods for SISO-OFDM systems to MIMO-OFDM systems. It turns out that the computational complexity can be reduced even more significantly. Simulation results show that the performance of the proposed methods is almost as good as that of the direct ZF and MMSE methods, while the required computational complexity is reduced dramatically. Finally, we explore the application of the proposed methods in mobility-induced ICI mitigation for OFDM multiple access (OFDMA) systems, and in carrier frequency offset (CFO) induced ICI mitigation for OFDMA uplink systems. As that in OFDM systems, the proposed methods can reduce the required computational complexity, effectively.

A Bayesian estimation approach for enhancing speech signals which have been degraded by statistically independent additive noise is motivated and developed. In particular, minimum mean square error (MMSE) and maximum a posteriori (MAP) signal estimators are developed using hidden Markov models (HMMs) for the clean signal and the noise process. It is shown that the MMSE estimator comprises a weighted sum of conditional mean estimators for the composite states of the noisy signal, where the weights equal the posterior probabilities of the composite states given the noisy signal. The estimation of several spectral functionals of the clean signal such as the sample spectrum and the complex exponential of the phase is also considered. A gain-adapted MAP estimator is developed using the expectation-maximization algorithm. The theoretical performance of the MMSE estimator is discussed, and convergence of the MAP estimator is proved. Both the MMSE and MAP estimators are tested in enhancing speech signals degraded by white Gaussian noise at input signal-to-noise ratios of from 5 to 20 dB. >

Equalisation is one of the most important algorithms to improve the Bit-Error-Rate (BER) performance in communication systems. In general, equalisation can be classified into two categories: linear and non-linear equalisation. The linear equalisers include Zero Forcing (ZF), and Minimum Mean Square Error (MMSE) equalisers. The non-linear equalisers include ZF and MMSE equalisers that are based on Successive Interference Cancellation (SIC). The ZF equaliser suffers from noise enhancement. The MMSE equaliser can mitigate the noise enhancement using the estimated Signal-to-Noise Ratio (SNR). The ZF-SIC and MMSE-SIC equalisers suffer from error propagation, and high computational complexity, respectively. In this paper, the Orthogonal Frequency Division Multiplexing (OFDM) system is modulated and demodulated using Inverse Discrete Wavelet Transform (IDWT), and DWT instead of Inverse Discrete Fourier Transform (IDFT) and DFT, respectively. Also, we propose a Joint Low-complexity Regularised ZF-SIC (JLRZF-SIC) equaliser that jointly performs the equalisation, and Carrier Frequency Offset (CFO) compensation with lower complexity using banded matrix approximation. The proposed JLRZF-SIC equaliser can accomplish the equalisation, and CFO compensation processes with low-complexity compared to the corresponding MMSE-SIC equaliser. Simulation results show that the proposed JLRZF-SIC equaliser outperforms different linearand non-linear equalisers.

The performance of linear filters degrade drastically when applied to mitigate intersymbol interference caused by channels with frequent nulls in their spectral characteristics like, e.g., time-dispersive radio channels. In such cases, the well-known decision feedback equalizer (DFE) is one possible nonlinear approach to improve the quality of the receiver. However, adapting the DFE filter coefficients to equalize time-varying channels is computationally intense, especially if the dimension of the observation vector is very high. In this paper, we apply the conjugate gradient (CG) algorithm to a conventional minimum mean square error (MMSE) DFE in order to reduce its computational complexity. Moreover, we compare its performance to the one of MMSE DFE versions which are based on the computationally efficient least-mean-square (LMS) or recursive least-squares (RLS) algorithm, respectively. The analysis additionally includes a detailed investigation of computational complexity with respect to the required number of floating point operations (FLOPs). Simulation results when applied to a digital communications system show the ability of the CG based MMSE DFE to outperform either the LMS and the RLS based MMSE DFE although its computational complexity is even smaller in most of the cases.

We first develop a reduced-rank minimum mean square error (MMSE) detector for direct-sequence (DS) code division multiple access (CDMA) by forcing the linear MMSE detector to lie in a signal subspace of a reduced dimension. While a reduced-rank MMSE detector has lower complexity, it cannot outperform the full-rank MMSE detector. We then concentrate on the blind reduced-rank MMSE detector which is obtained from an estimated covariance matrix. Our analysis and simulation results show that when the desired user's signal is in a low-dimensional subspace, there exists an optimal subspace so that the blind reduced-rank MMSE detector lying in this subspace has the best performance. By properly choosing a subspace, we guarantee that the optimal blind reduced-rank MMSE detector is obtained. An adaptive blind reduced-rank MMSE detector, based on a subspace tracking algorithm, is developed. The adaptive blind reduced-rank MMSE detector exhibits superior steady-state performance and fast convergence speed.

Multiple-input multiple-output (MIMO) systems can achieve high data-rate and high capacity transmission. In MIMO systems, the scheme that weight substreams based on minimum mean square error (MMSE) criterion at the transmitter using feedback channel state information (CSI) achieves good performance (denoted hereafter as MMSE precoder). However, if the optimum number of substreams is not selected based on CSI and methods for reducing the performance degradation due to feedback delay is not used, MMSE precoder cannot achieve the full performance possible. In this paper, we propose an MMSE precoder with mode selection for MIMO systems, which selects both the number of substreams and the modulation scheme for each substream to minimize the average BER at a fixed rate. We evaluate the BER of the proposed MMSE precoder with two methods for reducing performance degradation due to feedback delay, channel prediction and receive weight robust to feedback delay. We also evaluate the BER of the proposed MMSE precoder with the method that combines channel prediction with receive weight robust to feedback delay. Simulation results show that the BER of the proposed MMSE precoder is improved compared to that of the conventional MMSE precoder using the fixed number of substreams. We also show that the method that combines channel prediction with receive weight robust to feedback delay can achieve good BER even when the large feedback delay exists.

Compared with ordinary linear antenna arrays or planar antenna arrays, space conformal antenna array has many advantages, such as the flexibility and accuracy of the beam. However, conventional algorithms cannot be applied to the designing of conformal antenna arrays, so the weighted minimum mean square error algorithm is proposed. In this paper, a new iterative phase correction algorithm is presented to improve the weighted minimum mean square error (MMSE) algorithm. By using the new algorithm, the shape of the beam can be controlled more flexibly, and more interferences can be resisted compared with the weighted minimum mean square error algorithm. The simulation results show an improved performance in beamforming.

We generalize the multiuser (CDMA spread spectrum) communication systems to the fading environments. We first extend Verdu's (1986) conventional optimum receiver to Rayleigh-fading environments and then evaluate its performance. Having no knowledge of the received power at the receiving end, we therefore need an estimator to efficiently estimate the received signal strength of each user in fading environments. A linear minimum mean square error (LMMSE) unbiased estimator is proposed to attain this goal. By using the minimum mean square error (MMSE) Bayesian estimation, we further propose the LMMSE bit estimator for efficient demodulation. Its performance is close to the optimum multiuser receiver but with a much simpler polynomial complexity. To further reduce the complexity, we extend the LMMSE estimator to the sequential LMMSE estimator. In sequential estimation, we do not need to implement the matched filter banks and to perform the matrix inversion when estimating. In addition, it converges after approximately 2k iterations, where k is the number of users. With this fast convergence property and the simple structure, the sequential LMMSE estimator provides an attractive alternative to the implementation of a multiuser system.

In present days, there has been a race among the communication systems in different schemes and generations. Gradually the transmission rate of data is increasing tremendously and breaking the previous generation's record. Now people are thinking of transmitting data beyond imagination. Using multiple antennas both at transmitter and receiver side, MIMO wireless technology efficiently provides very high spectral efficiency, boost the data transmission rate, enhance link reliability and improve system coverage. While transmitting data over mobile radio channels at high bit rates, the impulse response of the channel can be extended over a lot of symbol periods, leading fading and Inter-symbol interference (lSI). Equalizers are used to minimize Fading and interference effects. The analysis of the paper is studying the performance of Minimum mean square error method in terms of BER for MIMO (2×2) and (3×3) wireless channels. Binary Phase Shift Keying (BPSK) modulation technique was used in Rayleigh flat fading channel. Simulating in MATLAB results show that Minimum mean square error (MMSE) receivers is good for noise free channel and is successful in removing ISI. Successive interference method with optimal ordering outperforms the MMSE however a few problems arise because of iterative nature of the algorithm.

In this paper, the minimum mean square error (MSE) convergence of the RBF equalizer is evaluated and compared with the linear equalizer based on the theoretical minimum MSE. The basic idea of comparing these two equalizers comes from the fact that the relationship between the hidden and output layers in the RBF equalizer is also linear. As extensive studies of this research, various channel models are selected, which include linearly separable channel, slightly distorted channel, and severely distorted channel models. The theoretical minimum MSE for both RBF and linear equalizers were computed, compared and the sensitivity of minimum MSE due to RBF center spreads was analyzed.

Linear precoding plays an important role in the spatial multiplexing multiple-input multiple-output (MIMO)-orthogonal frequency-division multiplexing (OFDM) systems which are considered one of the primary candidates for the physical-layer techniques in the next-generation wireless communication systems. It requires the channel state information (CSI) at the transmitter to adapt the transmitted signal to the channel conditions. In most communication systems, the CSI is estimated at the receiver and fed back to the transmitter. However, the error performance in a precoded MIMO-OFDM system is significantly degraded due to the long feedback delay that causes the outdated CSI at the transmitter. In this paper, a novel approach using multi-block linear channel prediction is proposed to combat the feedback delay in a limited feedback precoded spatial multiplexing MIMO-OFDM system. The time-varying channel is modeled by autoregressive (AR) process, whose coefficients are obtained by linear minimum mean square error (MMSE) method. To increase prediction range, block-based channel samples are used to establish the AR model, and multiple blocks are employed to iteratively predict the CSI. Simulation results show that the performance degradation caused by large feedback delay can well be mitigated.