Microstrip patch antennas for a mobile communications system at 60 GHz

A highly innovative global broadband mobile communication system concept

Nowadays the wireless communication system development requires the low cost, low profile; minimal weight antenna development which is accomplished of continuing great presentation completed a wide frequency range. This upcoming technology fashion has motivated the MSPA (Microstrip Patch Antenna) design. This paperwork presents design and analysis of 2 patches (2 by 1) and 4 patches (4 by 1) Rectangular Microstrip Patch Array (RMSPA) Antennas with corporate feed network systems for S band applications at 2.45 GHz. This S band frequency range is mostly used for mobile satellite communication systems an also used in Bluetooth, Zigbee, Wi-Fi communication technologies. In the proposed work, 4.5 dielectric constant and 1.65 mm thickness of the substrate is used. The primary of this research work is to present an RMSPA antenna design and analysis using CSTMWS software “Computer Simulation Technology Micro Wave Studio” and investigate the performance of 2 elements patch arrays with that of a 4 elements patch arrays for the same 2.45 GHz operating frequency. It also made the study and investigation between the 2 elements and 4 elements corporate feed systems in terms of reflection coefficient (return loss), VSWR, bandwidth, directivity, gain, and radiation pattern. The main intension of this paperwork is to achieve an extraordinary directivity with enhanced gain and reduced losses at S band frequency range.

IntroductionThe popularity of mobile communication systems has increased remarkably during the last decade and the market demand still continues to increase.As a fundamental part of these systems, antenna is one of the most important design issues in modern mobile communication units.Although there are several similar definitions, an antenna can be mainly described as a device, which transforms the electromagnetic waves in an antenna to radiating waves in an unbounded medium such as air in transmitting mode and vice versa in receiving mode.Because antennas are dependent on frequency, they are designed to operate for certain frequency bands.The rapid growth of mobile communication systems has forced to the use of novel antennas for base and mobile station applications (mobile phone, notebook computer, personal digital assistants (PDA), etc.).Earlier, mobile systems were designed to operate for one of the frequency bands of 2G (second generation) systems, which are Digital Cellular System (DCS), Personal Communications Service (PCS) and Global System for Mobile Communications (GSM) networks.Currently, many mobile communication systems use several frequency bands such as GSM 900/1800/1900 bands (890-960 MHz and 1710-1990 MHz); Universal Mobile Telecommunication Systems (UMTS) and UMTS 3G expansion bands (1900-2200 MHz and 2500-2700 MHz); and Wi-Fi (Wireless Fidelity)/Wireless Local Area Networks (WLAN) bands (2400-2500 MHz and 5100-5800 MHz) where the list of frequently used frequency bands is given in Table 1 ( Best, 2008).Conventionally, because a single antenna can not operate at all of these frequency bands of mobile communication, multiple different antennas covering these bands separately should be used.However, usage of many antennas is usually limited by the volume and cost constraints of the applications.Therefore, multiband and wideband antennas are essential to provide multifunctional operations for mobile communication.A multiband antenna in a mobile communication system can be defined as the antenna operating at distinct frequency bands, but not at the intermediate frequencies between bands.For example, a triple band antenna for GSM 900/1800/1900 bands can cover the frequency bands 890-960 MHz and 1710-1990 MHz (Ali et al., 2003); however, it does not operate properly at the frequencies such as 1200 MHz or 2500 MHz.On the other hand, a wideband antenna operates at every frequency points within a given frequency band.For example, a wideband antenna covering UMTS, extended UMTS and WLAN 2400 bands functions at every frequency points www.intechopen.com

The subject of research in this article is the process of building a mobile communication system that operates under electronic countermeasures. The aim is to develop recommendations for building a wireless mobile communication system that operates effectively in a complex interfering electromagnetic environment. The strategy for building a mobile wireless communication system is based on the use of a grouping of low-altitude UAVs with ultra-wideband signal technology circulating in control and communication channels, with the integration of artificial intelligence elements into its structure. The objective of this study is to ensure the stable and secure operation of a wireless mobile communication system despite electronic countermeasures. The methods of analytical, temporal positional pulse coding, and fuzzy logical inference were used to make decisions on the transfer of service in the network. The following results were obtained. A strategy for building a wireless mobile communication system despite electronic countermeasures has been developed. It is shown that in order to obtain high noise immunity of control and communication channels and to protect information from interception, wireless ultra-wideband communication technology should be used. This will provide large volumes and speeds of information transmission. A technical solution for the design of an ultra-wideband transceiver antenna system is proposed. Moreover, it is recommended to use the results of data processing in a fuzzy decision-making system for the transfer of service between mobile network nodes in conditions of interference. Conclusions. The scientific novelty of the obtained results is as follows. The use of ultra-wideband channels makes it possible to increase the number of control and communication channels in a wireless mobile system almost unlimitedly. The preliminary distribution of orthogonal codes between the channels realizes the process of control and communication without the interception of information and mutual interference. The use of the time-position-pulse coding method prevents the occurrence of intercharacter distortions of the encoding ultrashort pulses. This also reduces the level of distortion of information signals caused by multipath propagation, which guarantees the security of information in the system. The use of a fuzzy decision-making system for the transfer of services between mobile network nodes allows dynamically changing the network topology in real time and maintaining high quality of service under electronic countermeasures.

The key technical elements in designing digital mobile satellite communication systems are identified, and tradeoff studies on the transmission parameters of the satellite link, which were based on experience with an experimental system and the results of field trials, on digital maritime and aeronautical satellite communication systems, are described. The future evolution of the various new communication services to be offered in the digital mobile communication systems are discussed. In the digital mobile satellite communication systems which will be operated under the condition of low C/N and with a signal-level fluctuation due to multipath fading etc., it has been found that the most important requirement is to establish the frame synchronization quickly and maintain it stably in addition to the stable carrier/clock tracking, under this severe link condition. >

Wide-band digital indoor and future mobile communication systems are being developed in the quasi-millimeter and millimeter wave frequency bands. In such high-speed systems, the degradation of transmission quality by multipath fading constitutes a limiting barrier. Multipath fading, which results from reflection, refraction and scattering of radio waves by buildings and other structures, gives rise to more than one path reaching the receiver and produces a distorted version of the transmitted signal. In mobile and indoor communication systems it cannot be eliminated, therefore the multipath channel must be well characterized in order to reduce its effect in the design of such systems. The objective of this research is to study the multipath fading and delay spread effects due to buildings in an urban propagation channel. In particular, the effects of the building materials, shapes and number of buildings on multipath fading are being studied.

This paper presents the design of a compact planar inverted-F antenna (PIFA) suitable for mobile handset applications. The prototype of the proposed antenna designs to satisfy specific bandwidth specifications of present-day mobile cellular communication systems, including the global system for mobile communication (GSM; 890-960 MHz), the digital communication system (DCS; 1710-1880 MHz), the personal communication system (PCS; 1850- 1990 MHz), and the universal mobile telecommunication system (UMTS; 1920- 2170 MHz). Therefore, it could be applicable for the existing and future mobile communication systems. Design details and experimental results are also presented and discussed.

In this paper, we describe the development of a GSM-derived regional mobile satellite communication system. We first discuss the market needs of a regional mobile communication system, and stress the technical requirements for such a system to be successful in the commercial world. We then point out the advantages of deriving such a system from the popular GSM standard and discuss the similarities and differences between the two systems. We then describe a system designed by Lockheed Martin Corp., known as ACeS, which serves the telecommunication needs of Asia. The ACeS system works in both the cellular and satellite environments and is designed to make optimal use of the similarities and differences to the GSM system. We end the paper by discussing some challenges in the evolving area of mobile satellite communication systems.

Mobile communication systems rely on radiofrequency waves to operate. Given the popularity and ubiquity of mobile communication devices as well as network densification, the level of Electromagnetic Field (EMF) exposure to the public is expected to rise significantly over the next few years. Although there is no clear evidence linking short-term exposure to EMF emission from wireless communication systems with adverse health effects, the International Agency for Research on Cancer (IARC) has concluded that EMF radiation is possibly carcinogenic. To cope with the concerns of the general public, the European Environmental Agency has recommended non-technical precautionary approaches to minimize exposure to EMF emissions. Rather than relying on these non-technical approaches, EMF, latency, network resilience and connection density, alongside traditional criteria such as spectral efficiency and energy efficiency are expected to take centre stage in the development of 5G systems. This book focuses on innovative EMF exposure research for future generations of mobile and wireless communications. This timely publication highlights the novel work done on reducing EMF emissions in future mobile communication systems and how to develop smart integrated technical solutions.

Abstract. Currently, there is a need to develop new technical solutions for antenna systems for mobile radio communication systems with improved electrical and mass-dimensional characteristics. As a result of the analysis of the currently conducted fundamental and applied research, it was found that the use of various composite structures (metamaterials) can improve the characteristics of antennas and antenna-feeder path devices. At the same time, there is an urgent scientific and technical problem of developing adequate electrodynamic and mathematical models of antennas and antenna-feeder path devices based on metamaterials for the correct calculation of their characteristics. The purpose of the work is theoretical and experimental studies of the characteristics of a two-element common-mode antenna array with a reflector made of a spiral metamaterial for mobile radio communication systems. The above research results have shown that the use of such antenna arrays is advisable when both types of polarization (vertical and horizontal) are required. Such an antenna array can increase the efficiency of communication systems, for example, in a wooded area. The proposed common-mode antenna array with a chiral metamaterial reflector can be used on mobile objects of digital and analog radio communication systems operating, including in the mode of pseudorandom tuning of the operating frequency.

The demand for wireless mobile communications services is growing at an explosive rate, with the anticipation that communication to a mobile device anywhere on the globe at all times will be available in the near future. An array of antennas mounted on vehicles, ships, aircraft, satellites, and base stations is expected to play an important role in fulfilling the increased demand of channel requirement for these services, as well as for the realization of the dream that a portable communications device the size of a wristwatch be available at an affordable cost for such services. This paper is the first of a two-part study. It provides a comprehensive treatment, at a level appropriate to nonspecialists, of the use of an antenna array to enhance the efficiency of mobile communications systems. It presents an overview of mobile communications as well as details of how an array may be used in various mobile communications systems, including land-mobile, indoor-radio, and satellite-based systems. It discusses advantages of an array of antennas in a mobile communications system, highlights improvements that are possible by using multiple antennas compared to a single antenna in a system, and provides details on the feasibility of antenna arrays for mobile communications applications.

In the past decade, wireless communications experienced an explosive growth period and became an integral part of modern society. The convenience and flexibility offered by mobile communications have made it one of the fastest growing areas of telecommunications. Mobile communication systems have experienced rapid growth in the number of users as well as the range of services provided during the last two decades. The Global System for Mobile communications, GSM, is a pan-European Mobile communication system in the 900 MHz band which was first introduced in the early years of this decade. An increasing demand for data transmission services over the GSM system has been driven by the wide use of the internet applications. In this thesis, we focus on the survey of GSM for wireless communication, which is one of the most widely deployed second generation wireless cellular systems in the world. While voice was the primary service provided early communication systems, current systems offer other transmission services. One of the most commonly used cellular systems is based on the Global System for Mobile communication, GSM, standard. We briefly introduce the GSM System configuration and major properties. It included five parts. It is about service and features, architecture of GSM system, channel and frame structure of GSM, GSM security features, data in the GSM System.

We calculate the availability of circuit service to a user in a mobile satellite communication system. The availability, i.e., the percentage of time the user can expect to communicate reliably using the communication system is a function of the power available to the user and the channel (Rician or Rayleigh fading) encountered by the user. In a mobile satellite communication system, the channel is a function of user position, the number of satellites visible to the user, and their positions. Using a simulation of the constellation orbits and an associated channel model, we calculate the availability provided by various proposed mobile satellite communication systems that use LEO and MEO satellites. A conclusion of this paper is that the visibility of multiple satellites is imperative for high availability.

When the mechanisms of fading channels were first modeled in the 1950s and 1960s, the ideas were primarily applied to over-the-horizon communications covering a wide range of frequency bands. The 3-30 MHz high-frequency (HF) band is used for ionospheric communications, and the 300 MHz-3 GHz ultra-high-frequency (UHF) and 3-30 GHz super-high-frequency (SHF) bands are used for tropospheric scatter. Although the fading effects in a mobile radio system are somewhat different than those in ionospheric and tropospheric channels, the early models are still quite useful to help characterize fading effects in mobile digital communication systems. This tutorial addresses Rayleigh fading primarily in the UHF band. That affects mobile systems such as cellular and personal communication systems (PCS). Part I of the tutorial itemizes the fundamental fading manifestations and types of degradation.

Simulation studies of the effects of user mobility on the handoff performance of mobile communications