Minimum achievable rate maximised resource allocation for relay‐assisted massive MIMO systems with SWIPT

This paper presents a ASK modulation based modeling of Simultaneous Wireless Information and Power Transfer (SWIPT) system in LabVIEW. It supports in designing of SWIPT based system which able to harvest RF energy along with transfer of information simultaneously. At the receiver end, both RF energy harvesting (EH) and information decoding (ID) paths are modeled. RF energy harvesting path consists of RF rectifier and low pass filter. While ID path contains RF envelope detector and ASK demodulator. For the simulation verification of SWIPT system, a 2-ASK modulated RF signal is used at 900MHz. This modeling provides flexible parameters selection for the simulation of SWIPT system which helps in understanding and development of SWIPT system.

Simultaneous wireless information and power transfer (SWIPT) has emerged as a viable technique to energize and connect low-power autonomous devices and enable future Internet of Things (IoT). A major challenge of SWIPT is the energy consumption of the receiver of such low-power devices. An attractive low-power solution consists of an integrated information decoder (ID) and energy harvester (EH) architecture for SWIPT receiver (IntRx) where the received radiofrequency (RF) signal is first rectified before being used for information decoding. Such architecture eliminates the need for energy-consuming RF components, such as local oscillators and mixers. This article proposes a novel modulation and demodulation method for the IntRx SWIPT architecture based on pulse position modulation (PPM) where information is encoded in the position of the pulse. The new method transmits high amplitude pulses to increase the peak-to-average power ratio (PAPR) of the transmit signal and exploits the EH's nonlinearity so as to boost the harvested dc power. Simultaneously, the information can be decoded from the rectifier signal by simply finding the position of the pulse in a certain symbol duration. We have analyzed both the information and the power transfer performance of the newly proposed PPM for IntRx SWIPT theoretically, numerically, and experimentally. To that end, we have established a SWIPT system testbed in an indoor environment by prototyping a base station to transfer information-power signal and the IntRx SWIPT receiver, including ID and EH blocks. The performance evaluation of the PPM was carried out in various conditions, and the results have been compared and contrasted to conventional signals. Theoretical, numerical, and experimental results highlight the significant benefits of the proposed PPM scheme to enhance the power transfer performance and operate information decoding with low-power consumption.

This chapter examines simultaneous wireless information and power transfer (SWIPT) scenarios. It discusses the main SWIPT receivers, namely, separate and co-located receivers. The chapter provides numerical examples on the performance of the designed SWIPT precoding strategy. It focuses on a co-located SWIPT system, where a HAP serves a set S of devices performing both energy harvesting and information decoding in a given frequency band. The chapter illustrates some numerical results on the performance of the time switching and power splitting protocols. It also discusses some specific promising approaches to boost the performance of SWIPT systems for general wireless energy transfer (WET)-powered internet of things networks. WET and SWIPT systems are subject to non-linear responses that are often model-intractable unless too strong assumptions are adopted. The chapter concludes with an overview of some potential techniques to enable efficient SWIPT in future networks.

In this paper, we investigate the simultaneous wireless information and power transfer (SWIPT) in a multiple-input multiple-output (MIMO) amplify-and-forward relay communication system, where the relay is an energy harvesting (EH) node and harvests the energy the signals transmitted from the source. The harvested energy is partially used to forward signals from the source to the destination, and the remaining energy is stored for other usages. The SWIPT in relay-assisted communication is interesting as long as the relay stores energy from the source and the destination receives successfully the data from the source. In this context, we propose to investigate the source and relay precoders that characterize the relationship between the achievable stored energy at the relay and the achievable source-to-destination rate, namely, the rate-stored energy (R-E) tradeoff region. First, we consider the ideal scheme, where there is the simultaneous operation of the EH and information decoding (ID) receivers at the relay. Then, we consider practical schemes, such as the power splitting and the time switching that separate the operation of EH and ID receivers over power domain or time domain, respectively. Moreover, we study the case of imperfect channel state information at the relay and the destination, and characterize its impact on the achievable R-E region. Through the simulation results, we show the effect of the position of the relay and the channel uncertainty on the achievable R-E regions of all the schemes when the used energy at the relay is constant or variable. We also show that, although it provides an outer bound on the achievable rate-energy region in one-hop MIMO systems, the ideal scheme provides only an upper bound on the maximum achievable end-to-end rate and not an outer bound on the R-E region.

In this article, a cooperative non-orthogonal multiple access (NOMA) mobile edge computing (MEC) network aided by reconfigurable intelligent surfaces (RIS) and simultaneous wireless information and power transfer (SWIPT) is considered, where the transmitters offload parts of their computing tasks to the MEC server via a relay and an RIS for enhancing the transmission environment. The goal is to minimize the task delay and energy consumption for the considered networks by jointly designing the RIS's reflection beamforming vector, the power splitting (PS) ratio, the power allocation factors of the relay, as well as the offloading transmit power and the offloading task ratio. To solve the proposed problems, an iterative optimization algorithm based on the successive convex approximation (SCA) method and the penalty method is proposed to decompose the formulated problems into two sub-problems. In particular, we jointly optimize the PS ratio, the power allocation coefficients and the edge computing resource based on the SCA technology, and then the penalty method is used to optimize the RIS's reflecting beamforming vector. Simulation results illustrate that the proposed NOMA-MEC networks aided by RIS and SWIPT are superior to the conventional orthogonal multiple access MEC networks with SWIPT aided by RIS in terms of task delay and energy consumption.

Deep learning driven physical layer security for a simultaneously wireless information and power transfer network

The main challenges of sensing in harsh industrial and biological environments are the limited energy of sensor nodes and the difficulty of charging sensor nodes. Simultaneous wireless information and power transfer (SWIPT) is a non-invasive option to replenish energy. SWIPT harvests energy and decodes information from the same RF signal, which is influencing the design of a wireless sensor network. In multi-hop multi-flow wireless sensor networks, interference generally exists, and the interference has a different influence on SWIPT. Route, interference and SWIPT are dependent. However, existing works consider SWIPT link resource allocation with a given route or only select path for one flow without interference. Therefore, this paper firstly analyzes the influence of interference on SWIPT, and select the SWIPT routing with interference. We design an interference-based information and energy allocation model to maximize the link capacity with SWIPT. Then, we design an interference-aware route metric, formulate SWIPT routing problem, and design an interference-aware SWIPT routing algorithm. The simulation results show that as the number of flows increases, there is more likely to obtain performance gains from interference and SWIPT.

In this paper, the problem of joint mode switching and power adaptation is studied for simultaneous wireless information and power transfer (SWIPT) over a fading channel. The receiver dynamically switches between information decoding (ID) and energy harvesting (EH) modes while the transmitter dynamically adapts the transmit power. Considering the nonlinearity of practical EH circuits, a realistic nonlinear EH model is adopted rather than the idealistic linear EH model. To characterize the ultimate performance tradeoff between ID and EH, an optimization problem is formulated to maximize the average harvested energy under the constraints on the average achievable rate and the average transmit power, which is a nonconvex and combinatorial problem. To solve this problem, first, the optimal power adaptation scheme for the nonlinear EH receiver that operates only in the EH mode is proposed. Using this scheme, the jointly optimal solution for the mode switching and power adaptation is then derived. By comparing the obtained results to the existing results, various useful and interesting insights into the optimized SWIPT system with nonlinear EH are presented. An important insight into the impact of nonlinear EH is that, to exploit the high energy conversion efficiency of the nonlinear circuit, the EH mode has to be selected only in the moderate range of channel gains. Also, in the EH mode, the power has to be adapted to the short-term power threshold only for the moderate channel gains.

In this paper, a bidirectional relaying (BR) non-orthogonal multiple access (NOMA) with simultaneous wireless information and power transfer (SWIPT) termed as BR NOMA-SWIPT is proposed and investigated for the Internet of Things (IoT) relay networks. Here, multiple NOMA users in one group can communicate or exchange information with multiple NOMA users in another group through a common energy harvesting (EH) based relay. The EH based relay exploits the radio frequency (RF) energy supplied by the two NOMA user groups to recharge itself, and then it exchanges the information between them. Specifically, the two groups of NOMA users transmit the information intended for the exchange to the relay node using the uplink NOMA protocol. The relay node first harvests the RF energy through the signals of the two group of NOMA users, and then it carries out the exchange of information between two NOMA user groups by using the downlink NOMA protocol. To the best of our knowledge, there is no existing study or research on BR NOMA with SWIPT. Therefore, in this paper, we examine in detail, the performance of BR NOMA-SWIPT enabled IoT relay networks. Specifically, we study a popular EH time switching (TS) relaying architecture with BR and NOMA. We also study the effect of both perfect successive interference cancellation (pSIC) and imperfect SIC (ipSIC) on the proposed BR NOMA-SWIPT system. Analytical expressions for the outage probability and ergodic capacity are mathematically derived. The analytical results of our proposed system model are validated by the simulation results, and representative performance comparisons are presented thoroughly, which not only provides practical insights into the effect of different system parameters on the overall network performance, but it also demonstrates that our proposed BR NOMA-SWIPT can attain significant throughput and capacity gains as compared to conventional BR multiple access schemes.

Interference alignment with receive antenna partitioning for SWIPT-enabled fog RANs

This paper studies a multi-hop decode-and-forward (DF) simultaneous wireless information and power transfer (SWIPT) system where a source sends data to a destination with the aid of multi-hop relays which do not depend on an external energy source. To this end, we apply power splitting (PS) based SWIPT relaying protocol so that the relays can harvest energy from the received signals from the previous hop to reliably forward the information of the source to the destination. We aim to solve two optimization problems relevant to our system model. First, we minimize the transmit power at the source under the individual quality-of-service (QoS) threshold constraints of the relays and the destination nodes by optimizing PS ratios at the relays. The second is to maximize the minimum system achievable rate by optimizing the PS ratio at each relay. Based on convex optimization techniques, the globally optimal PS ratio solution is obtained in closed-form for both problems. By setting the QoS threshold constraint the same for each node for the source transmit power problem, we discovered that either the minimum source transmit power or the maximum system throughput can be found using the same approach. Numerical results demonstrate the superiority of the proposed optimal SWIPT PS design over conventional fixed PS ratio schemes.

In this paper, we provide a comprehensive literature survey on simultaneous wireless information and power transfer (SWIPT) in multi-antenna systems. We first review recent contributions on the theory analysis of SWIPT from information theoretic standpoint and introduce the tradeoff between information transfer and power transfer under various settings. Then, we focus on the utilization of multi-antenna techniques to solve existing problems of SWIPT. Contributions on the implementation aspects of multi-antenna SWIPT are summarized. The performance of SWIPT is evaluated by different metrics, therefore, we review the works on dynamic SWIPT optimization based on objective function using multi-antenna techniques. In addition, the implementation of SWIPT brings up secure issue. Thus, we summarize recent works on secure SWIPT. Finally, we present researches combining SWIPT with state-of-the-art techniques due to potential application in different scenarios.

Far-field wireless power transfer (WPT) and simultaneous wireless information and power transfer (SWIPT) have become increasingly important in radio frequency (RF) and communication communities recently. The problem of modulation design for SWIPT has however been scarcely addressed. In this paper, a modulation scheme based on asymmetric phase-shift keying (PSK) is considered, which improves the SWIPT rate-energy tradeoff region significantly. The nonlinear rectifier model, which accurately models the energy harvester, is adopted for evaluating the output direct current (DC) power at the receiver. The harvested DC power is maximized under an average power constraint at the transmitter and a constraint on the rate of information transmitted via a multi-carrier signal over a flat fading channel. As a consequence of the rectifier nonlinearity, this work highlights that asymmetric PSK modulation provides benefits over conventional symmetric PSK modulation in SWIPT and opens the door to systematic modulation design tailored for SWIPT.

This letter puts forth a novel way to manage interference in simultaneous wireless information and power transfer (SWIPT) systems by utilizing physical-layer network coding (PNC). We consider multi-user multiple-input single-output (MU-MISO) broadcast channels. Unlike the conventional zero-forcing scheme, the PNC-SWIPT scheme introduced in this letter does not eliminate the interfering signals at the receivers. The PNC-SWIPT scheme cancels out the undesired messages over a finite field during PNC demodulation for information decoding (ID). It preserves the interfering signals which are beneficial energy sources for energy harvesting (EH). Simulation results show that the PNC-SWIPT scheme achieves superior EH performance than conventional interference mitigation schemes, such as zero-forcing (ZF) and maximizing EH precoding (Max EH), while maintaining the same ID performance. The performance improvement of the PNC-SWIPT scheme mainly comes from canceling out the interference at the receivers from the aspect of data by PNC, without eliminating the interfering signals which are beneficial energy sources.

In 5G wireless networks, the system capacity and the number of users will be significantly increased. However, the energy consumed for the communication will also be increased, which results in low system energy efficiency. Simultaneous wireless information and power transfer (SWIPT) can enable the user to perform energy harvesting from the radio-frequency signals parallel with the information decoding, which can effectively improve the system energy efficiency. In this paper, we study the energy efficiency optimization problem for the orthogonal frequency-division multiplexing-based 5G wireless networks with SWIPT, in which the subcarrier and power allocation are jointly optimized to maximize the system energy efficiency for single user and multiple user cases. For those two cases, through mathematical transforming, we use the Dinkelbach iterative method and the Lagrange dual method to solve the non-convex energy efficiency optimization problem. Simulation results show that compared with other algorithms, our proposed algorithm can achieve higher energy efficiency.