Multi‐objective optimization power control for code division multiple access systems

In recent years, more and more wireless communications systems are required to provide also a positioning measurement. In code division multiple access (CDMA) communication systems, the positioning accuracy is significantly degraded by the multiple access interference (MAI) caused by other users in the system. This MAI is commonly managed by a power control mechanism, and yet, MAI has a major effect on positioning accuracy. Probability control is a recently introduced interference management mechanism. In this mechanism, a user with excess power chooses not to transmit some of its symbols. The information in the nontransmitted symbols is recovered by an error-correcting code (ECC), while all other users receive a more reliable data during these quiet periods. Previous research had shown that the implementation of a probability control mechanism can significantly reduce the MAI. In this paper, we show that probability control also improves the positioning accuracy. We focus on time-of-arrival (TOA) based positioning systems. We analyze the TOA estimation performance in a generalized CDMA system, in which the probability control mechanism is employed, where the transmitted signal is noncontinuous with a symbol transmission probability smaller than 1. The accuracy of the TOA estimation is determined using appropriate modifications of the Cramer-Rao bound on the delay estimation. Keeping the average transmission power constant, we show that the TOA accuracy of each user does not depend on its transmission probability, while being a nondecreasing function of the transmission probability of any other user. Therefore, a generalized, noncontinuous CDMA system with a probability control mechanism can always achieve better positioning performance, for all users in the network, than a conventional, continuous, CDMA system.

In recent years, the joint decoding of combined source and channel coding have shown the capability of delivering performances exceeding that of separately decoded schemes. In this paper, a well-known joint source/channel coding scheme is investigated for possible use in future 4th Generation (4G) direct sequence spread spectrum multiple access (DS/SSMA) code division multiple access (CDMA) communication systems. Due to the availability of potentially large sets of sequences with good correlation characteristics, the DS/SSMA CDMA system considered in this paper employs complex spreading sequences (CSS). A multiuser CSS-based DS/SSMA CDMA communication system was implemented as test platform for the joint source/channel coding scheme. Several families of CSSs, including Zadoff-Chu (ZC), double sideband constant envelope linearly interpolated root-of-unity filtered general chirp-like (DSB CE-LI-RU Filtered GCL), analytical bandlimited complex (ABC) and quadriphase (QPH) sequences are investigated on this platform. Simulated bit error rate (BER) performances are presented for uncoded, separate source and channel coded and joint source/channel coded systems under realistic multipath fading channel conditions.

Multiple access interference (MAI) appears in Code Division Multiple Access (CDMA) systems when the communication channel is a multi-path channel and the spreading codes are not orthogonal. Orthogonality between spreading codes cannot be maintained at the CDMA receiver because the codes may be asynchronous due to channel delay and multi-path spread. The receiver cannot perfectly separate the different signals of the multiple access users, and the resultant MAI limits the capacity of CDMA systems. MAI is a function of the cross correlation property between used spreading codes. In this paper we focus on the cross correlation of the spreading codes, we propose a method to find spreading codes with minimum magnitude of cross correlation. Employing these codes will reduce the resultant MAI in the CDMA system; hence it will increase the system capacity. A great enhancement is shown by comparing found minimum cross correlation spreading codes (MCCSC) with Hadamard and Gold codes.

Improvement of the capacity of the CDMA (code division multiple access) system is a major objective. The capacity of the system is mainly limited by the signal to noise ratio, where the noise comes from the channel background and from MAI (multiple access interference). Usually, the way to improve the capacity is to decrease the MAI; this is why orthogonal codes are adopted by the IS-95 standard. One problem is that the number of orthogonal codes is constrained by the dimensionality of the signal space. So in IS-95, there are only 64 orthogonal codes available when the number chips for each sequence is 64. To solve this problem, a non-orthogonal code called WBE (Welch bound equality) sequences (Massey and Mittelholzer 1991) is used in this paper The criterion to construct the code is to minimize the MAI. Two methods are used to construct the WBE sequences: from a linear cyclic code or from a Hadamard matrix. In order to improve the performance of the WBE sequence set, an iteration receiver (Sari et al. 1999) is applied. The conclusion obtained is that when the number of users is slightly greater than the signal space dimensionality, after the first iteration, the performance is only marginally worse than the orthogonal CDMA system.

In this study a hybrid approach that employs a genetic algorithm (GA) and a multi-stage detector (MSD) for multi-user detection problems in code division multiple access (CDMA) communications system is proposed. Using this approach, a genetic algorithm is used as the first stage of MSD to provide a good initial point for successive stages of MSD. Simulation results for the synchronous case are provided to show that the approach is promising.

This paper addresses the problem of real-time multimedia transmission in fiber-optic networks using code division multiple access (CDMA). We present a multirate optical fast frequency hopping CDMA (OFFH-CDMA) system architecture using fiber Bragg gratings (FBGs). In addition, we argue that, in multimedia applications, different services have different quality of service (QoS) requirements; hence, the user only needs to use the minimum required power to transmit the signal, such that the required signal-to-interference ratio (SIR) is met. We show that a variable bit rate optical communication system with variable QoS can be implemented by way of power control with great efficiency. Present-day multirate optical CDMA systems concentrate on finding the code structure that supports a variable rate system, neglecting the importance of the transmission power of active users on the multiple access interference (MAI) and, therefore, on the system capacity. We assign different power levels to each rate through a power control algorithm using variable optical attenuators, which minimizes the interference and, at the same time, provides variable QoS constraints for different traffic types. Although we are using a code family that preserves good correlation properties between codes of different lengths, simulations show a great improvement in the system capacity when power control is used.

This paper carries comprehensive comparison of Interleave Division Multiple Access (IDMA) and Code Division Multiple Access (CDMA) systems in terms of performance (BER) and behavior to different number of users. Performance analysis of two systems whose transmitter and receiver structures are almost same are studied under Additive White Gaussian Noise (AWGN) and performance differences are illustrated by simulation results. Although Multiple Access Interference (MAI) and Intersymbol Interference (ISI) can affect the performance of the CDMA system, simulation results illustrates that IDMA system model achieves this type of problem using their interleavers. Results also show that large number of users can easily be adapted by the IDMA scheme much easier than CDMA scheme.

The use of multiple antennas at the transmitter or receiver provides a powerful means, of increasing the capacity of wireless systems. The goal of this paper is to illustrate ways in which analogies with multiuser code division multiple access (CDMA) systems may be used to provide design insights for space-time communication systems, for both single and multiple users. Three examples are considered: (a) noncoherent space-time codes for transmit antenna diversity against Rayleigh fading, constructed using an analogy with a CDMA downlink; (b) optimal multiuser transmit beamforming on a cellular downlink, where the algorithm for computing beamforming weights is obtained by transforming the problem into a CDMA uplink with MMSE interference suppression and power control; (c) design of high bandwidth efficiency systems exploiting both transmit and receive antenna arrays, using analogies with CDMA systems with random and slowly time-varying spreading waveforms.

The cell capacity is determined for a direct-sequence code-division multiple-access (CDMA) communications system that employs power control of the transmitted signal in the presence of doubly selective fading. The influence of the power-control delay and the delay spectrum and Doppler spread of the channel on the cell capacity and the effectiveness of the power-control method is examined. The sensitivity of the performance of the power control to the chip rate of the direct-sequence waveform and the number of taps in the RAKE receiver is also discussed. Both open-loop and closed-loop power control. Are considered.

The capacity of CDMA (code-division multiple access) systems is limited by its other-user interference because all users in a cell share the same frequency band. To achieve maximum capacity, the 'near-far' problem needs to be dealt with. In practice, this is done through appropriate power control. Due to the interaction between the power control process, CDMA systems may become unstable if the desired SNR is not set appropriately. When CDMA systems are stable, the received power at the base station converges to the optimal power with a desired SNR (signal-to-noise ratio) setting. We analyze the associated power and the interference estimation in the discrete time domain and find the stability SNR upper bounds that can guarantee the system stability.

One of the major advantages of a code division multiple access (CDMA) system is the flexibility in frequency assignment, which allows all the users to share the same frequency band and, possibly, to partially overlay the spectrum allocation of different services. However, before synchronism to the desired sequence is achieved, the presence of multiple access interference (MAI) is a major impairment which determines the performance of the code acquisition sub-system. It has been argued that the acquisition performance in the presence of MAI may pose limits to the capacity of a CDMA system which are more stringent than those coming from bit error probability specifications. We introduce a general definition for acquisition-based capacity of a CDMA system. This quantity is evaluated for an acquisition sub-system with non-coherent correlator/detector and straight serial search in the time uncertainty region. The effect of imperfect power control is also analysed, showing that the capacity may be substantially decreased when the residual standard deviation of the received power level is above 1 dB. >

This paper is concerned with the performance analysis of a slotted downlink channel in a wireless code division multiple access (CDMA) communication system with integrated packet voice/data transmission. The system model consists of a base station (BS) and mobile terminals (MT), each of which is able to receive voice and/or data packets. Packets of accepted voice calls are transmitted immediately while accepted multipacket data messages are initially buffered in first in, first out (FIFO) queues created separately for each destination. The BS distinguishes between silence and talkspurt periods of voice sources, so that packets of accepted data messages can use their own codes for transmission during silent time slots. To fulfill QoS requirements for both traffic types, the number of simultaneous packet transmissions over the downlink channel must be limited. To perform this task, a fair, single-priority multiqueueing scheduling scheme is employed. Discrete-time Markov processes are used to model the system operation. Statistical dependence between queues is the main difficulty which arises during the analysis. This dependence leads to serious computational complexity. The aim of this paper is to present an approximate analytical method which enables one to evaluate system performance despite the dependence. Therefore, it is assumed that the system is heavily loaded with data traffic, and a heuristic assumption is made that makes the queueing analysis computationally tractable. Typical system performance measures (i.e., the data message blocking probability, the average data throughput and delay) are evaluated, however, due to the accepted heuristic assumption, the analysis is approximate and that is why computer simulation is used to validate it.

Channel estimation techniques for code-division multiple access (CDMA) systems need to combat multiple access interference (MAI) effectively. Most existing estimation techniques are designed for CDMA systems with short repetitive spreading codes. However, current and next generation wireless systems use long spreading codes whose period is much larger than the symbol duration. In this paper, we derive the maximum likelihood channel estimate for long code CDMA systems over multipath channels using training sequences and approximate it using an iterative algorithm to reduce the computational complexity in each processing window. The asymptotic convergence of the mean of the iterative estimate to the actual channel is also shown. The effectiveness of the iterative channel estimator is demonstrated in terms of squared error in estimation as well as the bit error rate performance of a multistage detector based on the channel estimates. Finally, the proposed iterative channel estimation technique is extended to track slowly varying multipath fading channels using decision feedback. Thus, an MAI resistant multiuser channel estimate with reasonable computational complexity is derived for long code CDMA systems over multipath fading channels.

The presence of intersymbol interference (ISI), in addition to multiple access interference, severely hampers the performance of a code-division multiple-access (CDMA) communication system. In such a situation, channel coding can be used to obtain better performance, but at the cost of a reduction in rate of flow of information. In this paper, it is shown with the help of simulation results that the chip-interleaved CDMA system effectively combats ISI without requiring additional channel coding. The system differs from the conventional CDMA system in the sense that, the chip sequence resulting from the pseudo noise (PN) sequence modulation is interleaved before transmission. Two receivers are proposed, one based on the turbo equalization method which employs a maximum a posteriori equalizer of exponential complexity and the other based on minimum-mean square error-optimized iterative interference cancellation principles which is of linear complexity. Simulation results are provided which show that error rates close to the no-ISI single-user case can be obtained. The shortcomings of the coded CDMA with turbo detection system in the presence of ISI are also discussed.

This paper deals with fading and/or near-far effects with or without power control on the evaluation of the sum capacity of finite dimensional Code Division Multiple Access (CDMA) systems. CDMA systems under consideration have binary or finite non-binary inputs and signature matrices. Important results of this paper are that the knowledge of the received power variations due to input power differences, fading and/or near-far effects can significantly improve the sum capacity.