Multi-service photonic network

In optical switching paradigm, there are three approaches; optical circuit switching, optical packet switching, and optical burst switching (OBS). OBS is a technology that takes the best features of packet switching and circuit switching by providing a flexible infrastructure for carrying IP traffic and at the same time ensuring efficient utilization of the fiber link. In this paper we propose an effective contention resolution scheme to achieve minimum burst loss at core nodes. Algorithm of zero burst loss for bimodal burst switching is extended from single node star network topology to two node star topology. Scheduling at the core node, typically an optical cross connect (OXC), is performed in two modes i.e., Mode 0 & Mode 1. Mode 0 is for burst transmission between all directly connected edge nodes whereas Mode 1 is for burst transmission through remote core node to a particular destination edge node. Synchronization of the reservation request between the core nodes is a critical task in such a topology. In order to achieve minimum burst loss, using a small length of fiber delay line in recirculation mode results in an effective strategy.

Optical burst switching (OBS) is a switching technology that can efficiently operate in the optical core network using WDM technology and can also develop the future optical internet. The OBS switching technology presents a trade-off between the two switching technologies: optical circuit switching (OCS) and optical packet switching (OPS). This switching approach increases resource utilization compared with OCS technology and avoids the technological barriers of OPS networks. In OBS networks, many packets are assembled into one data burst at the edge node and a burst header packet (BHP) is sent before the burst transmission by an offset time in order to reserve the required resources in core nodes. This can cause security issues in the network and more specifically denial of service attacks that can occur if a source node is compromised. In this paper, we study a specific denial of service attack which we refer to as "BHP flooding attack", which prevents legitimate traffics from reserving the required resources at intermediate core nodes. We also propose the design of a reconfigurable BHP flooding countermeasure module that allows to counter against this type of attacks in an OBS network.

Optical Circuit Switching (OCS) provides a good support for the services requiring high bandwidth and Quality of Service (QoS). When the character of network traffic changes from voice-oriented to data-oriented, OCS must cooperate with new switching mechanisms such as Optical Burst Switching (OBS) to improve performance. So a Hybrid Optical Switching (HOS) system is proposed. In HOS, different traffics are classified and both OBS and OCS can be processed. At the same time, delay buffer mechanisms, which are Fiber Delay Line (FDL) and electronic buffering, are introduced in HOS to solve the contention of OBS bursts. And a wavelengths classification mechanism, which assigns some wavelengths dedicated to OCS traffics, is provided to guarantee the QoS of OCS. To analyze the performance in theory, models based on Markovian theory and iterative method are provided. The results got by theory are accurate compared with simulations. The use of delay buffer can decrease the blocking probability of OBS and increase resource utilization. Wavelength classification mechanism benefits to improve OCS's performance.

Modeling and performance analysis of a data center network (DCN) combining optical packet switching (OPS) and agile optical circuit switching (OCS) in a unified platform are presented. Hybrid optoelectronic packet routers which combine optical switching fabric and electronic buffers are used, supporting 100 Gbit/s (25 Gbit/s × 4 wavelengths) optical packets. OCS transmission is implemented by a novel “express path,” (ExP) an instant wavelength path on demand, which enables certain flows following the ExP with no packet contention, whereas ordinary OPS packets are switched with a deflection routing algorithm and buffering for contention resolution. This architecture can support OCS for large and reliability-sensitive data transferring and OPS for latency-sensitive applications. The performance of the network is investigated via numerical simulations of top-of-rack switch (ToR)-to-ToR traffic in an N-dimensional (up to 4096 node) torus topology. We have made the following observations: 1) torus topology results in high throughput and can be scaled out by increasing the dimension; 2) contention resolution between OPS and agile OCS is needed and our proposed strategies enhance the overall performance; and 3) in a lightly to moderately loaded case of OPS traffic, more than 100 ExPs can be supported simultaneously with acceptable affect on OPS.

We develop an integrated optical packet and circuit switching node in which signaling via optical packet switching is implemented. We demonstrate 80 (8λ × 10) Gbit/s optical packet switching with <;1E-4 packet-loss-rate, 8-lightpaths establishment, and dynamic wavelength-resources control.

We propose and implement an enhanced moving average (MA) based dynamic resource allocation method for optical packet and circuit integrated (OPCI) networks. In the OPCI networks, optical packet switching (OPS) and optical circuit switching (OCS) share the total bandwidth in a fiber by allocating separate wavelength resources to them. In this work, we leverage an exponential moving average (EMA) as an enhanced MA. Every time a signaling process for path establishment or release occurs at a node, the proposed method employs the EMA of number of in-use paths to reallocate wavelengths to OCS and OPS while the conventional method employs the absolute number of in-use paths. When the EMA reaches or becomes less than a threshold value, the dynamic resource allocation is executed. As results of simulations and a verification experiment, we show that the proposed method can reduce the amount of routing processes without suffering from blocking of path establishments in comparison to the conventional method. In addition, it is expected that the proposed method can effectively allocate vaster amount of bandwidth to OPS without suffering from the blocking and achieve better system performances for OPS.

An optical packet and circuit integrated network (OPCInet) will allow diverse services, enhanced functional flexibility, and efficient energy consumption, as optical packet switching (OPS) and optical circuit switching (OCS) links are provided on the same infrastructure. In this paper, we design and develop a control system consisting of header processing for optical packets, signaling and routing for optical path setup, and wavelength resource control and link switching between OPS and OCS for the efficient use of resources. Our onboard optical packet header processor is capable of 16-bit longest prefix matching by embedding a 0.6W (5% of TCAM technology on the same condition), 200 million search-per-second (equivalent to 100 Gbps) forwarding engine LSI, and a statistical memory LSI for retaining the statistical information of processed headers. Reactive control automatically selects a packet or circuit link according to the statistical traffic information from the header processor and works with signaling for optical paths. We present an experimental demonstration of a new control system using a previously developed OPCInet testbed.

DWDM multi-mode switching network provides a unified approach to DWDM-based communications by allowing electronic packet switching (EPS), optical burst switching (OBS) and optical circuit switching (OCS) to be carried in the same network, and on the same router platform. In this paper, we present a sub-millisecond dynamic optical path setup scheme for the multi-mode switching router. More specifically, we devised a reconfigurable asymmetric optical burst switching (RA-OBS) scheduling scheme which integrates burst scheduling in the OBS mode, connection setup/teardown in the OCS mode, and channel reconfiguration in the EPS mode in a seamless fashion. The proposed scheme allows wavelengths to be dynamically shared among three different switching modes in real-time. The performance of the proposed integrated scheduler has been verified using OBS-ns2 simulator as well as in a hardware testbed. In particular, we have implemented the proposed integrated multi-mode scheduler in FPGA hardware in an optical switching testbed, and have demonstrated application triggered real-time sub-millisecond optical path setup. Another key contribution is that the proposed approach brings out the practical value of optical burst switching, which has stayed mostly in the theoretical regime in the past decade. We show that a truly dynamic optical network can be built with off-the-shelf optical components.

In this paper the end-to-end TCP performance of a hybrid network composed of multiple Ethernet Passive Optical Networks (EPONs) in the access segment connected to the same edge node of a core network is evaluated. Three possible core network paradigms are considered: Optical Circuit Switching (OCS), Optical Burst Switching (OBS) and Optical Packet Switching (OPS). TCP performance is evaluated through simulations with ns-2. The hybrid network scalability is assessed by varying the number of EPONs connected to the same edge node and the number of Optical Network Units (ONUs) per EPON. Interoperability issues between access and core are investigated and the impact of the most important network parameters is highlighted. The three transfer modes considered for the core network are properly compared under different input conditions, discussing the related trade-offs that may lead to the most suitable choice based on the specific application scenario. Finally, some design issues are investigated with reference to emerging Long-Range EPON (LR-EPON) solutions.

On burst assembly in optical burst switching networks—A performance evaluation of just-enough-time

Hybrid optical networks (HONs) are the combination of different switching mechanisms such as Optical Circuit Switching (OCS), Optical Burst Switching (OBS) and Optical Packet Switching (OPS). The basic idea behind HONs is to integrate the advantages of different switching mechanisms. HONs are classified into three classes as: (1) parallel hybrid optical networks, (2) integrated hybrid optical networks, (3) client-server hybrid optical networks. In this article, we describe these classes in detail and a new integrated hybrid optical network called EISM (Efficient Integration of Switching Mechanisms in all-optical networks) is introduced. The proposed EISM method could perform optimally while considering some implementation criteria; such criteria include network bandwidth utilization, implementation complexity and also the domain of network performance by combining four switching mechanisms-OCS, long-OBS, short-OBS and OPS.

Hybrid optical switching (HOS) is a switching paradigm that aims to combine optical circuit switching, optical burst switching, and optical packet switching on the same network. This paper proposes a novel integrated control plane for an HOS core node. The control plane makes use of a unified control packet able to carry the control information for all the different data formats and employs an appropriate scheduling algorithm for each incoming data type. Three possible node architectures are presented and an analytical model is introduced to analyze their power consumption. Also, the concept of increase in power efficiency is introduced to compare the considered architectures. The performance and power consumption analysis of the node have been carried out through the use of a simulation model developed specifically for the scope. The obtained results show the effectiveness of HOS networks.

In optical packet switching (OPS)-based data center networks (DCNs), it is preferred to set up temporal optical circuit switching (OCS) paths for large-data transmission that requires high reliability. However, inappropriate OCS path selection could severely affect the original OPS traffic. This is because an OCS path may break the network topology and cause OPS packet circulations. We propose to maintain bypassing routes for every link of the OCS path when it is established. Then, the OPS packets can bypass the OCS links by being deflected to the bypassing routes. Therefore, this method facilitates the coexistence of OCS in OPS-based DCNs. Numerical simulations demonstrate the benefit achieved by our proposal compared with non-bypassing-route scenarios.

The service evolution and the rapid increase in traffic levels fuel the interest toward switching paradigms enabling the fast allocation of Wavelength Division Multiplexing WDM channels in an on demand fashion with fine granularities (microsecond scales). For this reason, in the last years, different optical switching paradigms have been proposed (Sabella et al., 2000): optical-packet switching (OPS), optical-burst switching (OBS), wavelength-routed OBS, etc. Among the various all-optical switching paradigms, OPS attracts increasing attention. Owing to the high switching rate, Semiconductor Optical Amplifier (SOA) is a key technology to realize Optical Packet Switches. We propose some Optical Packet Switch (OPS) architectures and illustrate their realization in SOA technology. The effectiveness of the technology in reducing the power consumption is also analyzed. The chapter is organized in three sections. The main blocks (Switching Fabric, Wavelength Conversion stage, Synchronization stage) of an OPS are illustrated in Section 2 where we also show some examples of realizing wavelength converters and synchronizers in SOA technology. Section 3 introduces SOA-based single-stage and multi-stage switching fabrics. Finally the SOA-based OPS power consumption is investigated in Section 4.

Optical Burst Switching (OBS) networks provide a practical alternative to optical packet switching and optical circuit switching by separating control information from the primary data, sending the former on a separate control channel. However, this separation also renders OBS networks susceptible to a denial- or degradation-of-service attack (intentional or otherwise) when the data provisioned by a header packet on the control channel does not materialize. This paper addresses the problem of detecting and characterizing such problems and describes a method based on monitoring network traffic on the control and data channels. The method is evaluated on a publicly available dataset.