On optimal feedback allocation in multichannel wireless downlinks

In the multiuser multiple-input multiple-output (MU-MIMO) system, to reduce the influence of channel correlation on system performance, the base station (BS) should select the appropriate subset of user equipments (UEs) according to their channel state information (CSI). Due to a lack of channel reciprocity, the downlink CSI needs to be fed back to the BS in frequency division duplexing (FDD) mode. Some scholars have exploited kinds of deep neural networks (DNNs) for sensing and recovering CSI. However, user selection after all the CSI is reconstructed by DNNs will bring a great time delay. In this paper, we propose a deep learning-based CSI feedback scheme called US-CsiNet. Based on adversarial autoencoder (AAE), US-CsiNet can explicitly cover user schedule information while representing CSI. At the UE side, the encoder of US-CsiNet maps the CSI into codewords of which part are feature information for user schedule. Then the BS applies these partial codewords to separate the UEs into different groups and select active UEs. Finally, the decoder of AAE reconstructs the CSI of these active UEs. US-CsiNet can not only simplify the user selection process but also guarantee the accuracy of CSI reconstruction. The simulation results show that the proposed approach outperforms maximum channel gain (MCG) user selection algorithms and achieves the nearly same performance with semiorthogonal user selection (SUS) which needs full CSI of all users at the BS.

This paper considers a scenario in which multiple device-to-device (D2D) users can reuse the uplink resources of a cellular network to transmit directly to their corresponding receivers. The aggregated interference from the D2D users is limited by applying a threshold on the allowable interference in the base station. The problem is solved under two types of constraints, namely, the peak interference and average interference constraints. In the former, we assume that full channel state information (CSI) is available at the base station, and we optimize the allowable transmit power for the D2D users so that the number of coexisting D2D communications is maximized. We further define a quality-of-service constraint for the D2D users. In practice, however, it is difficult to have complete CSI at the base station as it imposes heavy signaling overhead. Therefore, in the latter scenario, we assume that no knowledge about the location of D2D users and their CSI are available at the base station. This approach does not impose any signaling overhead. Our results show that even with no CSI knowledge, we are able to improve the system performance in terms of throughput by allowing coexisting D2D communications while satisfying the cellular user's constraints.

Multiple transmit antennas can be employed in a downlink channel to serve multiple users under the assumption of perfect channel state information (CSI) of all users at the base station. In practice, however, the channel knowledge available at the base station is not perfect. For instance, in case of a time division duplex (TDD) system, the transmit CSI is the estimated uplink channel. On the other hand, in a frequency division duplex (FDD) system, feedback from the users is required to obtain transmit CSI. In this case, we assume the transmit CSI consists of a quantized version of the normalized estimated channel vector and the statistics of the channel norm of each user. In this work we consider the transceiver design of the downlink of a multiuser MISO system based on the minimum mean square error (MMSE) criterion with imperfect CSI as discussed above.

Unlike the time-division duplexing (TDD) systems, the downlink (DL) and uplink (UL) channels are not reciprocal anymore in the case of frequency-division duplexing (FDD). However, some long-term parameters, e.g. the time delays and angles of arrival (AoAs) of the channel paths, still enjoy reciprocity. In this paper, by efficiently exploiting the aforementioned limited reciprocity, we address the DL channel state information (CSI) feedback in a practical wideband massive multiple-input multiple-output (MIMO) system operating in the FDD mode. In particular, the base station (BS) can transmit the FFT-based pilots with the carefully-selected phase shifts to align the DL paths. Then the user can rely on the so-called time-domain aggregate channel (TAC) to derive the estimate of the DL CSI. Next, with the knowledge about the second-order statistics of the DL channels, the user is also able to compute feedback of reduced dimensionality. We demonstrate that each user can just feed back one scalar number per DL channel path for the BS to recover the DL CSIs. Comprehensive numerical results corroborate our designs.

Accurate channel state information (CSI) at base station (BS) is the key to achieve full multiplexing and diversity gain in traditional multiple-input multiple-output (MIMO) systems. In frequency-division-duplex (FDD) systems, it is obtained through downlink training and uplink feedback. However, the training and feedback overhead in massive MIMO systems is unacceptable for the large number of antennas equipped at BS. To reduce the CSI feedback overhead and improve CSI quantization accuracy, we propose a limited feedback scheme for spatio-temporal correlated massive MIMO channel. The proposed scheme jointly performs Karhunen-Loève transform (KLT) and polar-cap quantization on CSI. For the compactly deployed antennas at BS, there exists spatial correlation in massive MIMO channel. When the user equipment (UE) moves slowly, adjacent channels feature temporal correlation. The high dimensional and spatial correlated CSI is compressed through KLT. Then the compressed CSI is normalized to be isotropic to perform polar-cap quantization. Simulation results show that the proposed scheme is capable of improving the sum-rate performance with limited feedback bits for massive MIMO systems.

In cellular systems, deploying a large number of antennas at the base station (BS), also called massive multiple-input multiple-output (MIMO), can offer a huge improvement in system throughput. This performance gain achieved through coherent beamforming highly depends on having accurate channel state information (CSI) at the BS. Initially, massive MIMO was considered promising only for time division duplexing (TDD) systems because the downlink training overhead in frequency division duplexing (FDD) systems could be large. To reduce the overhead in FDD systems, we propose efficient eigenspace training and precoding. In the downlink training, the prebeamforming matrix is designed based on the spatial fading correlation to probe the channel and minimize the mean squared error (MSE) in channel estimation. In data transmission, the precoding matrix is designed based on instantaneous CSI to manage the inter-user interference. Our algorithms achieve significant savings in the downlink training because the overhead is associated with the dimension of prebeamforming matrix and no longer limited by the number of BS antennas. Compared with joint spatial division and multiplexing, our algorithms offer much lower MSE and, under some conditions, higher sum rates.

In a wireless multi-user system using multiple antennas, full multiplexing gain can be achieved through perfect channel state information (CSI) at the base station (BS). However, because of the limitations on the feedback rate and of standard requirements, such as the 3GPP, it is difficult to obtain perfect CSI, or even partial CSI with the extremely large number of feedback bits needed at the region of high signal-to-noise ratios (SNR) in practical systems. Instead of a feedback channel resource, this paper considers another resource for the system, a cooperation channel, which can be used by users to participate in cooperation in a broadcast fading channel. The cooperation among users in a multi-user system has the effect of transforming it into a cooperative point-to-point MIMO system. This paper analyzes the cooperation channel gain and the mobile power used in a cooperation channel to maintain a constant rate gap against the zero-forcing beamforming scheme with full CSI at the BS. In addition, the performance results of this proposed cooperation strategy are provided by computer simulations.

In a massive multiple-input multiple-output (MIMO) system, channel state information (CSI) is essential for the base station (BS) to achieve high performance gain. The user equipment (UE) needs to estimate CSI and then feeds it back to the BS in the frequency division duplexing (FDD) mode. Effective compression of CSI will significantly reduce the cost of channel feedback, and many deep learning (DL) based channel compression schemes have been proposed to achieve this goal. In this paper, rather than viewing CSI as images as in most existing works, we propose a new perspective of viewing CSI as an information sequence and analogize CSI feedback to a machine translation task. Further, we propose a novel sequence to sequence (Seq2Seq) model for CSI feedback composed of only recurrent neural networks and a small-scale fully connected layer, avoiding the convolution and pooling structure commonly used in current DL-based works. The advantage of this scheme is that it fully integrates the physical characteristics of the MIMO channel in the spatial domain into the structure of the neural network and avoids the loss of some prominent unsmooth or discontinuous features caused by the inappropriate convolution and pooling operation. Simulation results show that the proposed Seq2Seq model outperforms other DL-based CSI compression techniques under various communication scenarios.

Network MIMO is a technology being developed towards lifting the interference limits on wireless network through collaborative transmissions from multiple base stations. However its great potential is shadowed by the stringent requirement of high speed/capacity backbones facilitating information exchange, including data, control signals, and channel state information amongst the base stations. In this paper, we propose a user-selective collaboration scheme to mitigate the backbone requirement by reducing the information exchange required. We define a certain threshold for users in each base station and only those users exceeding the threshold will be served by multiple base stations collaboratively. The other users will be served by a single base station as in a conventional non-collaborative transmission. The threshold is determined in such a way that the users with collaborative transmissions enjoy maximized sum rates whereas the others without collaborative transmissions sacrifice only marginal potential collaboration gain in terms of achievable maximized sum rates. As the amount of information to be exchanged will be a square function of the number of users served by the collaborative base stations, the user-selective scheme can reduce the backhaul overhead significantly.

In this paper we consider a time slotted cognitive radio (CR) network with N wireless channels and M secondary users (SUs). We focus on a random access policy where each SU stochastically decides whether to access idle channels or not based on the given access probability (AP) that is adapted to the channel state information (CSI), if possible. The AP plays an important role in the random access policy because it can control the number of SUs who can access idle channels in a simple manner and hence alleviate packet collisions among SUs. We assume that each SU can access at most L idle channels simultaneously at a time slot whenever possible.

Massive multiple-input multiple-output (MIMO) is believed to deliver unrepresented spectral efficiency gains for 5G and beyond. However, a practical challenge arises during its commercial deployment, which is known as the “curse of mobility”. The performance of massive MIMO drops alarmingly when the velocity level of user increases. In this paper, we tackle the problem in frequency division duplex (FDD) massive MIMO with a novel Channel State Information (CSI) acquisition framework. A joint angle-delay-Doppler (JADD) wideband precoder is proposed for channel training. Our idea consists in the exploitation of the partial channel reciprocity of FDD and the angle-delay-Doppler channel structure. More precisely, the base station (BS) estimates the angle-delay-Doppler information of the UL channel based on UL pilots using Matrix Pencil (MP) method. It then computes the wideband JADD precoders according to the extracted parameters. Afterwards, the user estimates and feeds back some scalar coefficients for the BS to reconstruct the predicted DL channel. Asymptotic analysis shows that the CSI prediction error converges to zero when the number of BS antennas and the bandwidth increases. Numerical results with industrial channel model demonstrate that our framework can well adapt to high speed (350 km/h), large CSI delay (10 ms) and channel sample noise.

The work of cooperative perception realized by mmWave Vehicle to everything (V2X) [3] has pointed out that vehicles require much network bandwidth to exchange sensor information for safe automated driving; e.g., they require higher than 1Gbps V2V bandwidth to ensure safe velocity of 70 km/h. On the other hand, some research works have shown that channel state information (CSI) feedback is able to mitigate interference for 5G frequency division duplexing (FDD) mmWave massive MIMO systems. Existing approaches either do not consider the characteristics of FDD mmWave V2X systems or assume all channels are ideal, i.e., uncorrelated and identical. To achieve higher throughput and low overhead for FDD mmWave V2X systems, there are two major issues: (1) how to acquire an accurate CSI under the environment of non-identical channels, and (2) how to effectively use such information to improve overall system throughput. Our idea is to jointly consider the characteristics of the angle of arrival (AoA) method and Khler manifolds to design of codebook feedback approach for mmWave V2X massive systems. That is, to get an accurate CSI, we leverage the measurement method with the idea of the AoA approach. With this AoA measurement, we propose a novel Khler manifolds codebook feedback approach and determine an optimal bit allotment over each mmWave V2X link for achieving better interference reduction as well as lower overhead for V2X CSI exchange. In addition, our analytic results validate that proposed AoA Khler manifolds codebook feedback scheme is more adequate than the traditional CSI feedback with regard to interference reduction. Simulations show that the proposed AoA Khler manifolds codebook feedback scheme can significantly improve the vehicle rate and reduce the overhead for V2V CSI exchange.

In frequency-division duplexing (FDD) massive multiple-input multiple-output (MIMO) systems, 1-bit compressed sensing (CS)-based superimposed channel state information (CSI) feedback has shown many advantages, while still faces many challenges, such as low accuracy of the downlink CSI recovery and large processing delays. To overcome these drawbacks, this paper proposes a deep learning (DL) scheme to improve the 1-bit compressed sensing-based superimposed CSI feedback. On the user side, the downlink CSI is compressed with the 1-bit CS technique, superimposed on the uplink user data sequences (UL-US), and then sent back to the base station (BS). At the BS, based on the model-driven approach and assisted by the superimposition-interference cancellation technology, a multi-task detection network is first constructed for detecting both the UL-US and downlink CSI. In particular, this detection network is jointly trained to detect the UL-US and downlink CSI simultaneously, capturing a globally optimized network parameter. Then, with the recovered bits for the downlink CSI, a lightweight reconstruction scheme, which consists of an initial feature extraction of the downlink CSI with the simplified traditional method and a single hidden layer network, is utilized to reconstruct the downlink CSI with low processing delay. Compared with the 1-bit CS-based superimposed CSI feedback scheme, the proposed scheme improves the recovery accuracy of the UL-US and downlink CSI with lower processing delay and possesses robustness against parameter variations.

Coordinated multi-point transmission/reception (CoMP), in which base stations cooperation during the downlink, has been considered as a attractive way of achieving higher performance and mitigating interference, especially for terminals at cell edges. In this paper, distributed precoding for multicell-MISO downlink CoMP is considered. Most previous work in the area is on the assumption that base stations have knowledge of both data symbols and full channel state information (CSI), which leads to heavy exchange of channel state information and signal information over backhaul links . In this paper, several distributed precoding strategies (Distributed MRT, distributed ZF, distributed LVSINR and DVSINR) for multicell-MISO downlink CoMP are analyzed, which supposes that each base station only has local CSI and the precoders can be devised at each BS in a distributed manner, and Monte Carlo simulations demonstrate the performance of such strategies.

In Multi-user MIMO (MU-MIMO) downlink system, suitable user selection schemes can improve spatial diversity gain. In most of previous studies, it is always assumed that the base station (BS) knows full channel state information (CSI) of each user, which does not consider the reality. However, there are only limited feedback bits in real system. Besides, user fairness is often ignored in most of current user selection schemes. To discuss the user fairness and limited feedback, in this paper, the user selection scheme with limited feedback bits is proposed. The BS utilizes codebook precoding transmitting strategy with LTE codebook. Furthermore, this paper analyzes the influence of the number of feedback bits and the number of users on user fairness and system sum capacity. Simulation results show that in order to achieve better user fairness, we can use fewer bits for feedback CSI when the number of user is small, and more feedback bits when the number of users is large.