Optical Wireless CDMA Receiver with Hard Limiters and Successive Interference Cancellers

It is well-known that multiuser detection techniques such as successive interference cancellation (SIC) can obtain significant performance improvement over traditional matched filter receivers in code division multiple access (CDMA) systems. Due to its simplicity and usefulness, the SIC structure has received significant attention for several years. In this letter, we make three contributions to the understanding of this receiver structure. First, we derive a closed form expression for received power profile of linear SIC with arbitrary spreading gain and SINR requirements. Second, using this expression we examine the performance of SIC under various ordering criteria based on spreading gain, path loss, and SINR/BER requirement. Third, we show that using a very simple and well-known sorting algorithm, we can obtain a cancellation order and set of power control levels which are very near the optimum in terms of minimizing total transmit power.

This paper discusses the uplink performance of an indoor data collection system. A base station (BS) collects information sent asynchronously from multiple transmitters using the optical code division multiple access (CDMA) technique. The communication performance may degrade because of the near-far problem caused by variations in the propagation path length between each transmitter and the BS receiver. We apply spatial diversity to mitigate the interference and improve the error rate performance. In our proposed method, the correlation values are normalized at each photodetector, and the largest value is selected for symbol estimation. The obtained results show that a performance improvement can be achieved using the proposed method for a small number of users.

This paper carries comprehensive comparison of Interleave Division Multiple Access (IDMA) and Code Division Multiple Access (CDMA) systems in terms of performance (BER) and behavior to different number of users. Performance analysis of two systems whose transmitter and receiver structures are almost same are studied under Additive White Gaussian Noise (AWGN) and performance differences are illustrated by simulation results. Although Multiple Access Interference (MAI) and Intersymbol Interference (ISI) can affect the performance of the CDMA system, simulation results illustrates that IDMA system model achieves this type of problem using their interleavers. Results also show that large number of users can easily be adapted by the IDMA scheme much easier than CDMA scheme.

A CDMA scheme based on perfect Gaussian integer sequences

The atmospheric two-dimensional optical code-division multiple-access (CDMA) systems using pulse-position modulation (PPM) and Turbo-coded were presented. We analyzed the bit-error rate (BER) of the proposed system using pulse-position modulation (PPM) with considering the effects of the scintillation, avalanche photodiode noise, thermal noise, and multi-user interference. We showed that the atmospheric two dimensional (2D) optical PPM CDMA systems can realize high-speed communications when the logarithm variance of the scintillation is less than 0.1, and the turbo-coded atmospheric optical CDMA system has better bit error rate(BER) performance than the atmospheric optical PPM CDMA systems without turbo-coded. We also showed that the turbo-coded system has better performance than the multi-user detection system.

In this paper we introduce a successive interference cancellation (SIC) scheme for direct sequence optical code division multiple access (DS-OCDMA) systems using pulse position modulation (PPM). Considering double-padded modified prime code (DPMPC) as a signature sequence code, results show that the system has better performance in terms of both capacity and bit error rate (BER) as compared to the one without cancellation scheme, where the system with SIC scheme can support up to 88 users while the system without SIC scheme can support only 38 users at similar BER=10

Successive interference cancellation (SIC) for code division multiple access (CDMA) systems, together with a suitable power control, is an attractive technique to reduce multiuser access interference in uplink transmissions. In this paper we propose a receiver design which minimizes the system transmit power while ensuring a constant signal to noise plus interference ratio (SNIR) at each user detection point by using a suitable order of user detection. Indeed, the problem is a joint optimization of power control and ordering of user detection and its optimum solution is NP-hard. Hence, we derive both a suboptimal greedy algorithm and a randomized search which explores many solutions. All these approaches are evaluated in an uplink multiuser scenario for the UMTS-TDD standard in terms of bit error rate and power consumption.

We present a successive interference cancellation (SIC) scheme for a multicarrier (MC) direct-sequence code-division multiple-access (CDMA) system, using band-limited spreading waveforms to prevent self-interference. In every subband, the SIC receiver successively detects the interferers' signals and substracts them from the user-of-interest. A comparison is made among SIC, a minimum mean-squared error (MMSE) receiver, and matched filter (MF) detection with maximal-ratio combining (MRC). We also consider suboptimal combining using pilot symbol-assisted modulation (PSAM) to make the system more realistic. Analytic bit-error probabilities for SIC, MMSE, and MF in correlated Rayleigh fading channels are derived. The theoretical results for SIC, MMSE, and MF are shown to agree well with simulations. In particular, SIC and MMSE are shown to achieve better performance than MF with MRC; when the number of users is small, SIC provides better performance than does MMSE. Further, the correlation among different subcarriers is studied, and only large subcarrier correlation coefficients result in an obvious worsening of performance. Finally, we derive results for the performance degradation that an SIC scheme experiences in MC CDMA due to phase and timing tracking errors. It is shown that SIC can still retain a performance advantage over MF-MRC, although the advantage of SIC decreases with increasing tracking errors, especially when subcarrier correlation coefficients are small.

A parallel combinatory (PC)-hybrid pulse interval modulation-optical code division multiple access (hPIM-OCDMA) system is proposed. In the PC-hPIM-OCDMA system, a user chooses e among K code sequences assigned to the user and sends e2b-ary PIM symbols for a given frame, where b is the number of bits per PIM symbol. The PC-hPIM-OCDMA system can offer higher bit rate than hPIM-OCDMA systems, and then it can reduce the effect of MAI, without reducing the bit rate. The bit error rate (BER) of PC-hPIM-OCDMA is derived, by considering that the dominant interference is MAI, which is caused by cross-correlation of strict optical orthogonal codes (SOOCs). Numerical results show that the PC-hPIM-OCDMA system can offer lower BER and accommodate more users than hPIM-OCDMA systems.

We proposed newly two-dimensional (2- D ) spectral amplitude coding optical code division multiple access (OCDMA) scheme using modified double weight (MDW) code capable of suppressing phase-induced intensity noise (PIIN). The architecture of the spectral/spatial MDW OCDMA system with the property of multi-access interference cancellation is presented. The proposed code exhibits good cross-correlation property. At the optimized data transmission rate of 0.745 Gbps, 2-D MDW, M = 63, N = 3, reaches maximum cardinality of 200% increases compared to 2- D perfect difference code, M = 57, N = 3. The performance is severely deteriorated if the data rate further increases above 0.745 Gbps. The proposed code meets the optical transmission requirements at 10−9 bit error rate error floor, with lowest effective transmitted power ( P sr), −17.5 dBm, in comparison to the others through minimizing interference noise that result in PIIN suppression. The proposed system reaches optimum requirements performance in terms of cardinality, data transmission rate, and low effective transmitted power.

Successive interference cancellation (SIC) has been used in multi-rate code division multiple access (CDMA) systems to eliminate the co-channel interference. In SIC, the required transmission power of a certain user can be reduced if it is detected late in the cancellation order as the interferences caused by the users that are detected before have been cancelled. In this work, we study the power control strategy based on different orderings for the SIC given the knowledge of the battery capacity of the mobiles. In particular we propose different ordering schemes for SIC for different optimization objectives such as minimizing the total power, maximizing the minimum transmission/connection time for a group of users within the same cell and maximizing the total amount of data transmitted for a group of users. Experimental results show that significant improvement can be achieved by using the proposed ordering methods.

This paper studies detecting matrices in random dense and sparse Code Division Multiple Access (CDMA) systems. Detecting matrices were originally introduced in the coin weighing problem. Such matrices can be used in CDMA systems in over-loaded scheme where the number of users is greater than the number of chips. We drive some conditions in the large system limit for binary and bipolar random CDMA systems to ensure that any random matrix is a detecting matrix. Furthermore, we extend our results to sparse random ternary matrices that have been using in the sparse CDMA literature. Finally, a construction method for the sparse detecting matrices is introduced.

For high-speed code division multiple access (CDMA) systems, interchip interference that is caused by multipath propagation becomes severe and cannot be ignored. Together with the multiple access interference due to nonideal conditions in CDMA, they become major obstacles to overall system performance. In this paper, both batch and adaptive algorithms based on linear prediction are proposed for joint blind equalization and multiuser detection for asynchronous CDMA systems. It is shown that the new methods are insensitive to estimation error of propagation delay or chip timing. In addition, the adaptive algorithm is computationally efficient. Simulation results show that the proposed methods are also near-far resistant and compare favorably to many existing methods.

Multiple access interference (MAI) appears in Code Division Multiple Access (CDMA) systems when the communication channel is a multi-path channel and the spreading codes are not orthogonal. Orthogonality between spreading codes cannot be maintained at the CDMA receiver because the codes may be asynchronous due to channel delay and multi-path spread. The receiver cannot perfectly separate the different signals of the multiple access users, and the resultant MAI limits the capacity of CDMA systems. MAI is a function of the cross correlation property between used spreading codes. In this paper we focus on the cross correlation of the spreading codes, we propose a method to find spreading codes with minimum magnitude of cross correlation. Employing these codes will reduce the resultant MAI in the CDMA system; hence it will increase the system capacity. A great enhancement is shown by comparing found minimum cross correlation spreading codes (MCCSC) with Hadamard and Gold codes.

The use of multiple antennas at the transmitter or receiver provides a powerful means, of increasing the capacity of wireless systems. The goal of this paper is to illustrate ways in which analogies with multiuser code division multiple access (CDMA) systems may be used to provide design insights for space-time communication systems, for both single and multiple users. Three examples are considered: (a) noncoherent space-time codes for transmit antenna diversity against Rayleigh fading, constructed using an analogy with a CDMA downlink; (b) optimal multiuser transmit beamforming on a cellular downlink, where the algorithm for computing beamforming weights is obtained by transforming the problem into a CDMA uplink with MMSE interference suppression and power control; (c) design of high bandwidth efficiency systems exploiting both transmit and receive antenna arrays, using analogies with CDMA systems with random and slowly time-varying spreading waveforms.