Optimal Global Positioning System/European Geostationary Navigation Overlay Service Positioning Model Using Smartphone

EGNOS Performance Navigation on Board Oceanographic Hespérides Vessel

The European Geostationary Navigation Overlay Service (EGNOS) thanks to geostationary satellites covers an area of whole Europe, including Baltic and North Sea. It allows to fix the coordinates of object position with typical absolute accuracy of 1,5 m. Previous research have shown that relative accuracy is usually higher than absolute one [Nowak A., 2010; Nowak A., 2011], so probably it could be possible to use EGNOS to determine direction in space. The research described in the paper concerned relative accuracy of three homogeneous EGNOS receivers, in context of the ability to determine the ship’s hull spatial orientation. Theoretical basis, the process of the experiment and the results of recorded data analysis were described. The research were conducted in the summer of 2014. Three homogenous Leica Viva series receivers were used. They were configured to receive a differential messages of the EGNOS system. Recorded data were analyzed in context of fixes relative accuracy. On the basis of achieved results, a conclusion about the possibility of construction the measurement system for the automatic determination of the ship’s hull spatial orientation angles in real time was drawn. The further research directions were pointed out, too.

Concerns over accuracy, availability, integrity, and continuity have limited the integration of Global Positioning System (GPS) and Global Navigation Satellite System (GLONASS) for safety-critical applications. More recent augmentation systems, such as the European Geostationary Navigation Overlay Service (EGNOS) and the North American Wide Area Augmentation System (WAAS) have begun to address these concerns. Augmentation architectures build on the existing GPS/GLONASS infrastructures to support location based services in Safety of Life (SoL) applications. Much of the technical development has been directed by air traffic management requirements, in anticipation of the more extensive support to be offered by GPS III and Galileo. WAAS has already been approved to provide vertical guidance for aviation applications. During the next twelve months, the full certification of EGNOS for SoL applications is expected. This paper discusses similarities and differences between the safety assessment techniques used in Europe and North America.

Future Global Navigation Satellite systems (GNSS) have significantly improve the performance of current navigation systems, providing new and enhanced capabilities. This enables the implementation of innovative and advanced services and applications more and more close to the user needs. In this framework, the road sector is one of the major potential market for GNSS applications and therefore it is very promising for future European Geostationary Navigation Overlay Service (EGNOS) and GALILEO related applications. Specifically, a very important commercial opportunity is represented by the tolling-related applications. The paper describes the vehicular remote tolling (VeRT) project sponsored by Galileo Joint Undertaking (GJU) and performed in the frame of the first GJU call under the EC VI Framework Programme, giving attention, in particular, to the communication network issues.

Knowledge of the state of the upper atmosphere, and in particular its ionospheric part, is very important in several applications affected by space weather, especially the communications and navigation systems that rely on radio transmission. To better classify the ionosphere and forecast its disturbances over Europe, a data collection endeavour called the European Digital Upper Atmosphere Server (DIAS) was initiated in 2004 by a consortium formed around several European ionospheric stations that transmit in real-time ionospheric parameters automatically scaled. The DIAS project is a collaborative venture of eight institutions funded by the European Commission eContent Programme. The project seeks to improve access to digital information collected by public European institutes and to expand its use. The main objective of the DIAS project is to develop a pan-European digital data collection describing the state of the upper atmosphere, based on real-time information and historical data collections provided by most of the operating ionospheric stations in Europe. Various groups of users require data specifying upper atmospheric conditions over Europe for nowcasting and forecasting purposes. The DIAS system is designed to distribute such information. The successful operation of DIAS is based on the effective use of observational data in operational applications through the development of new added-value ionospheric products and services that best fit the needs of the market. DIAS is a unique European system, and its continuous operation will efficiently support radio propagation services with the most reliable information. DIAS began providing services to users in August 2006. The Need for Accurate Ionospheric Products Radio frequency communications and satellite positioning and navigation systems are applications most affected by ionospheric disturbances. Such disturbances can cause drastic and large-scale changes in the usable ranges of high frequency (HF) or below HF bands affecting standard ground-to-ground and submarine communication systems. The characteristics of an ionospheric propagation channel, whether it is HF or transionospheric frequencies, are highly variable on timescales ranging from a few seconds to the 11-year solar cycle. Even during its quietest periods, the Sun produces electromagnetic radiation and solar wind, both of which can affect a variety of geomagnetic and ionospheric phenomena, which in turn affect radio waves propagating through the ionosphere. Hence day-to-day and hour-to-hour changes in propagation channel characteristics can occur.

The landscape of Global Navigation Satellite Systems (GNSS) signals is undergoing significant change. The parallel development of new, more robust and versatile signals along with two new GNSS systems with global reach is having a dramatic impact on the development of GNSS receivers. Receiver manufacturers are continually developing and implementing unique signal acquisition and tracking algorithms, advanced integrity monitoring algorithms, advanced multipath mitigation algorithms and a host of other enhancements in an effort to improve the performance of GNSS receivers and make their products stand out in a crowded field. The objective of this research is to develop a methodology for comparing the pseudorandom noise (PRN) code tracking performance of various receivers. While the overall performance of a receiver depends on many more factors, effective PRN code tracking is fundamental to the operation of a GNSS receiver. The methodology developed in this research requires three fundamental measurements from the receiver under test – code pseudorange, carrier pseudorange and carrier-to-noise-density ratio (C/No). These measurements are generated by all GNSS receivers but may not always be available to the user. Therefore, this methodology can only be performed on receivers that output these values. This methodology might be useful as a tool to evaluate the suitability of various receivers in certain environments or applications (e.g., weak signal environments, high dynamic environments, unfriendly radio frequency (RF) interference environments, etc.) and also as a means of comparing the relative performance of receivers in those environments or applications. Expectations for the research were that the data collection and analysis techniques would generate code loop tracking jitter plots that closely tracked with theoretical curves. In addition, it was expected that different receivers would yield slightly different jitter plots giving them a unique “signature.” Finally, it was expected that some receivers might incorporate scalar code tracking loops and others might incorporate vector tracking loops. The methodology was developed and refined using three receivers from three popular manufacturers, each with a unique set of capabilities. Raw data was collected from each receiver and processed using purpose built algorithms to estimate the code loop tracking jitter for each signal for each receiver. The code loop tracking observations for each of the three receivers tested were compared with theoretical curves generated using closed form equations published in previous papers. In most cases, the data compared favorably. However, there were some significant outliers that are worthy of additional research and analysis. In addition, the jitter plots for one receiver tested indicated that it used scalar code tracking loops and the jitter plots for the other two receivers indicated that they use vector tracking loops. It appears to be possible to determine if a receiver uses scalar tracking loops or vector tracking loops based on the jitter estimates generated in this research. This research indicated that the methodology might be a useful tool for 2 characterizing GNSS receivers and, eventually evaluating their performance in various environments. However, more data collection and analysis is required to further validate and refine the methodology. Also, more analysis of the signals that yielded “non-conforming” jitter plots should be examined in more detail.

European Geostationary Navigation Overlay Service (EGNOS) is a satellite navigation system that was developed to assist in the positioning GPS and GLONASS. With precision fed information about the location it can be applied to maritime transport, land and air. In the article analyzed and interpretated were all parameters that describe the operation of EGNOS for two categories of approaches with vertical and horizontal guidance, and for one category of precision approach.

Atmospheric refraction in the troposphere causes the propagation speed of electromagnetic signals to be less than the light speed. This creates a difference between the actual propagation path delay and the distance of the geometrical straight-line path, i.e., a quantity known as the tropospheric delay. As classical imaging algorithms for spaceborne synthetic aperture radar (SAR) do not take the tropospheric delay into account, imaging filters are designed based on the assumption of rectilinear propagation with the light speed. Therefore, a residual phase exists in imaging results, which affects focusing quality under the condition of high resolution. In order to compensate for the impact of tropospheric delay on focusing performance, this paper modifies the spaceborne SAR echo model and then proposes an imaging compensation algorithm. The key to this algorithm is to fit a range delay coefficient based on the European Geostationary Navigation Overlay Service model of zenith delay and Niell mapping function, which projects the zenith delay onto the looking direction. After range compensation, classical imaging, and azimuth compensation, which compose the proposed algorithm, the processed results are well focused.

This study introduces EDU-MAT COPERNICUS, an innovative educational platform that integrates augmented reality (AR) with satellite technologies to support mathematics and geoscience learning among primary school students. The platform features interactive mathematical tasks embedded in a narrative led by the avatar of Nicolaus Copernicus and incorporates real-world data from Earth observation systems such as Copernicus, Galileo, and European Geostationary Navigation Overlay Service (EGNOS). Designed using a user-centred approach and grounded in cognitive load theory, the prototype was evaluated through interviews with 10 mathematics tutors, user testing with 30 students, and feedback from parents. Findings suggest that AR-enhanced tasks improve students’ spatial reasoning, engagement, and motivation to learn mathematics. Teachers expressed interest in using AR tools but highlighted the need for training and integration with existing curricula. While the platform aligns with current trends in STEM (Science, Technology, Engineering, and Mathematics) education and digital pedagogy, challenges such as unequal access to technology and the small scale of testing remain. Future research should explore broader implementation and assess long-term learning outcomes. EDU-MAT Copernicus demonstrates strong potential as a scalable, interactive learning tool that combines mathematical thinking with space education in both formal and informal learning environments.

Accuracy, integrity, continuity and availability are the basic quality parameters extremely important in satellite navigation. The article presents results of research using the European Geostationary Navigation Overlay Service (EGNOS) that belongs to the group of Satellite Based Augmentation Systems (SBAS). The measurement data adopted for analysis were recorded in years: 2012, 2014, 2015, 2017 and 2018 in the north-eastern Poland. Results of the analysis showed a significant reduction in the maximum GPS / EGNOS positioning error values from 2014 onwards (compared to results from 2012). In general, values of parameters characterizing accuracy, integrity and availability meet the requirements for EGNOS applications in APV-1 and LPV-200 aviation procedures. It the case of continuity the requirements are not met.

The Global Positioning System (GPS) offers many advantages over conventional methods for the determination of subject speed during biomechanical studies. Recent advances in GPS technology, in particular the implementation of the Wide-Angle Augmentation System and European Geostationary Navigation Overlay Service (WAAS/EGNOS), mean that small, highly portable units are available offering the potential of superior accuracy in the determination of both position and speed. This study set out to examine the accuracy of a WAAS-enabled GPS unit for the determination of position and speed. Comparison with the new and published data showed significant enhancements in both position and speed accuracy over a non-WAAS system. Position data collected during straight line cycling showed significantly lower sample-to-sample variation (mean absolute deviation from straight line 0.11 vs. 0.78 m) and greater repeatability from trial to trial (mean absolute deviation from actual path 0.37 vs. 4.8 m) for the WAAS-enabled unit compared to the non-WAAS unit. The speed determined by the WAAS-enabled GPS receiver during cycling in a straight line was within 0.2 ms −1 of the actual speed measured for 57% of the values with 82% lying within 0.4 m s −1, however, the data tended towards underestimation of speed during circle cycling, with 65% of values within 0.2 m s −1 and 87% within 0.4 m s −1 of the actual value. Local dGPS and dual frequency techniques are more accurate still, however, traditional differential GPS (dGPS), employing FM radio transmission of correction data to a separate receiver, now offers no advantage over WAAS and appears redundant.

This paper explores the potential of conducting precision approach training by using the European Geostationary Navigation Overlay Service instead of conventional landing systems. Our method allows flight schools to perform training precision approaches at their base airport, independent of navigation infrastructure only available at larger airports. The usage of a cost-effective satellite- to ground-based augmentation system converter enables aircraft to conduct localizer performance approaches with vertical guidance which are independent of an aircraft's database. To validate the operational concept, three point-in-space precision approach look-alike procedures were developed for Essen/Mühlheim Regional Airport respecting the surrounding complex airspace structure. Subsequently, the designed approaches were evaluated through flight trials using a prototype ground-based augmentation system receiver for general aviation. Results show sufficient performance of the technical equipment as well as the feasibility of the design of the developed procedures for precision approach training.

The paper presents the SafePort project. The aim of the project is the realization of a system close to the market able to provide a safe and efficient control of the transit of all vessels in a port from the port entrance to their berths and out again using the European Geostationary Navigation Overlay Service (EGNOS) Safety of Life (SoL) information. After the description of the basic concepts the system wants to leverage on, an overview of all the modules is provided. The paper is focused on the implementation and tests of the Portable Pilot Unit called SafePilot which exploits EGNOS SoL feature in order to provide to the whole system a reliable information about vessel positioning. Test results for the validation of the SafePilot concept are shown.

Chapter 24 - Recent Geoeffective Space Weather Events and Technological System Impacts

In addition to flying Government payloads as secondary missions on commercial communications satellites, Space Systems/Loral (SS/L) has conducted formal studies addressing the commercial aspect of hosted secondary payloads, including a business model based on data purchase rather than space asset procurement. Demonstrating the hosted payload concept, the Internet Router in Space (IRIS) was launched in 2009 on an Intelsat communications satellite, while a European Geostationary Navigation Overlay Service (EGNOS) payload for GPS satellite augmentation is currently being integrated on an SES Astra Satellite. The paper will provide an overview of how these hosted payloads were accommodated alongside the main communications payload and integrated into the mission.