Performance of Shortest Path Algorithms in Network Flow Problems

Decision support for truckload carriers in one-shot combinatorial auctions

Chapter 1 Applications of network optimization

We consider the quickest flow problem in dynamic networks with a single source s and a single sink t: given an amount of flow F, find the minimum time needed to send it from s to t, and the corresponding optimal flow over time.We introduce new mathematical formulations and derive optimality conditions for the quickest flow problem. Based on the optimality conditions, we develop a new cost-scaling algorithm that leverages the parametric nature of the problem. The algorithm solves the quickest flow problem with integer arc costs in O(nm log(n2/m) log(nC)) time, where n, m, and C are the number of nodes, arcs, and the maximum arc cost, respectively.Our algorithm runs in the same time bound as the cost-scaling algorithm by Goldberg and Tarjan [10, 11] for solving the min-cost flow problem. This result shows for the first time that the quickest flow problem can be solved within the same time bound as one of the fastest algorithms for the min-cost flow problem. As a consequence, our algorithm will remain one of the fastest unless the quickest flow problem can be shown to be simpler than the min-cost flow problem.

In this paper, we present a new strongly polynomial time algorithm for the minimum cost flow problem, based on a refinement of the Edmonds-Karp scaling technique. Our algorithm solves the uncapacitated minimum cost flow problem as a sequence of O(n log n) shortest path problems on networks with n nodes and m arcs and runs in O(n log n(m + n log n)) time. Using a standard transformation, this approach yields an O(m log n(m + n log n)) algorithm for the capacitated minimum cost flow problem. This algorithm improves the best previous strongly polynomial time algorithm, due to Z. Galil and E. Tardos, by a factor of n2/m. Our algorithm for the capacitated minimum cost flow problem is even more efficient if the number of arcs with finite upper bounds, say m′, is much less than m. In this case, the running time of the algorithm is O((m′ + n) log n(m + n log n)).

We study a type of network flow problem that we call the minimum-cost F-graph flow problem. This problem generalizes the typical minimum-cost network flow problem by allowing the underlying network...

We consider the quickest flow problem in dynamic networks with a single source s and a single sink t: given an amount of flow F, find the minimum time needed to send it from s to t, and the corresponding optimal flow over time. We introduce new mathematical formulations and derive optimality conditions for the quickest flow problem. Based on the optimality conditions, we develop a new cost-scaling algorithm that leverages the parametric nature of the problem. The algorithm solves the quickest flow problem with integer arc costs in O(nm log(n2/m) log(nC)) time, where n, m, and C are the number of nodes, arcs, and the maximum arc cost, respectively. Our algorithm runs in the same time bound as the cost-scaling algorithm by Goldberg and Tarjan [10, 11] for solving the min-cost flow problem. This result shows for the first time that the quickest flow problem can be solved within the same time bound as one of the fastest algorithms for the min-cost flow problem. As a consequence, our algorithm will remain one of the fastest unless the quickest flow problem can be shown to be simpler than the min-cost flow problem.

An introduction to dynamic generative networks: Minimum cost flow

Decomposition based approaches are recalled from primal and dual point of view. The possibility of building partially disaggregated reduced master problems is investigated. This extends the idea of aggregated-versus-disaggregated formulation to a gradual choice of alternative level of aggregation. Partial aggregation is applied to the linear multicommodity minimum cost flow problem. The possibility of having only partially aggregated bundles opens a wide range of alternatives with different trade-offs between the number of iterations and the required computation for solving it. This trade-off is explored for several sets of instances and the results are compared with the ones obtained by directly solving the natural node-arc formulation. An iterative solution process to the route assignment problem is proposed, based on the well-known Frank Wolfe algorithm. In order to provide a first feasible solution to the Frank Wolfe algorithm, a linear multicommodity min-cost flow problem is solved to optimality by using the decomposition techniques mentioned above. Solutions of this problem are useful for network orientation and design, especially in relation with public transportation systems as the Personal Rapid Transit. A single-commodity robust network design problem is addressed. In this, an undirected graph with edge costs is given together with a discrete set of balance matrices, representing different supply/demand scenarios. The goal is to determine the minimum cost installation of capacities on the edges such that the flow exchange is feasible for every scenario. A set of new instances that are computationally hard for the natural flow formulation are solved by means of a new heuristic algorithm. Finally, an efficient decomposition-based heuristic approach for a large scale stochastic unit commitment problem is presented. The addressed real-world stochastic problem employs at its core a deterministic unit commitment planning model developed by the California Independent System Operator (ISO).

Preemptive priority-based algorithms for fuzzy minimal cost flow problem: An application in hazardous materials transportation

Wasserstein distributionally robust shortest path problem

Reduced costs obtained from the optimal simplex tableau are not necessarily correct under degeneracy in network flow problems with side constraints. In one application, simplex reduced costs were shown not to be good when applied to actual operations, while reoptimization to find all true reduced costs was too time-consuming. An efficient algorithm to obtain approximate reduced costs was developed in the research to offset these disadvantages. The algorithm combines the uses of Lagrangian relaxation, a minimum-cost network flow algorithm, and a shortest path algorithm. In theory, the approximate reduced costs prove to be a better lower bound than are simplex reduced costs. Numerical experiments have been performed to show its potential usefulness in practice. © 1996 John Wiley & Sons, Inc.

Given a directed graph G = (N,A) with arc capacities u and a minimum cost flow problem defined on G, the capacity inverse minimum cost flow problem is to find a new capacity vector u' for the arc set A such that a given feasible flow x' is optimal with respect to the modified capacities. Among all capacity vectors u' satisfying this condition, we would like to find one with minimum ||u' - u|| value. We consider two distance measures for ||u' - u||, rectilinear and Chebyshev distances. By reduction from the feedback arc set problem we show that the capacity inverse minimum cost flow problem is NP-hard in the rectilinear case. On the other hand, it is polynomially solvable by a greedy algorithm for the Chebyshev norm. In the latter case we propose a heuristic for the bicriteria problem, where we minimize among all optimal solutions the number of affected arcs. We also present computational results for this heuristic.

The multiple pairs shortest path problem (MPSP) arises in many applications where the shortest paths and distances between only some specific pairs of origin-destination (OD) nodes in a network are desired. The traditional repeated single-source shortest path (SSSP) and all pairs shortest paths (APSP) algorithms often do unnecessary computation to solve the MPSP problem. We propose a new shortest path algorithm to save computational work when solving the MPSP problem. Our method is especially suitable for applications with fixed network topology but changeable arc lengths and desired OD pairs. Preliminary computational experiments demonstrate our algorithm’s superiority on airline network problems over other APSP and SSSP algorithms.

A theoretical and experimental study of a new algorithm for minimum cost flow in dynamic graphs

In this work, we contribute a parallel implementation of the network simplex algorithm that is used for the solution of minimum cost flow problem. In the network simplex algorithm, finding an entering arc requires searching through many arcs to decide which one should be included in the spanning tree solution on the next iteration. We propose finding the entering arc in parallel as it often takes the majority of the execution time. A usual strategy is to pick the arc violating the optimality the most out of all possible candidates. Scanning all arcs can take quite some time, so it is common to consider only a fixed number of arcs which is referred as the block search pivoting rule. Arc scans can easily be done in parallel to find the best candidate as the calculations are independent of each other. We used shared memory parallelism using OpenMP along with vectorization using AVX instructions. We also tried adjusting block sizes to increase the parallel portion of the algorithm. Our dataset consists of various natural and synthetic graphs with sizes up to a billion arc. Our experiments show speedups up to four are possible, though they are typically lower.