• Home
  • Search
  • Reactive Ion Etching Techniques for Silicon Sidewall Angle Control in Microengineering
  • Cite Icon8
  • https://doi.org/10.1149/1.2069480Copy DOI Icon

Reactive Ion Etching Techniques for Silicon Sidewall Angle Control in Microengineering

Show More
  • Abstract
  • Literature Map
  • Citations
  • Similar Papers
Abstract

This paper describes reactive ion etching (RIE) techniques with silicon substrates for initial processing of semiconductor field emitter array cathodes for vacuum microelectronics. A secondary focus is process research for optical reflecting gratings for opto‐ and micromechanical devices. These applications each require control of the sidewall angle and apex radius. In this paper, we describe micromachining control of trenches with remainder sidewall angles varying from 15–60° and resulting apex ridge radii of as small as 40 nm. A fluorine‐based chemistry with oblique angles for the incident beam (tilted substrates) and overetching is used. The use of both deep UV‐hardened photoresist and aluminum as RIE shadowmasks is compared. Unannealed aluminum as a shadowmask for RIE micromachining has the advantage of lower etch/sputtering rates and higher process temperature tolerance compared to photoresist in the RIE system. Etch environments in the pressure range 30–80 mTorr with flow rates of 20/2 seem, RF power 100–200 W, and etch duration 30 min are described. Both tilted and untilted substrates mountings were studied. Under these conditions, the surface erosion is primarily a combination of ion milling and chemical etch mechanisms. Both P‐type and N‐type substrates of 100 nm diam wafers were used. Relatively sharp single‐ and double‐ridged silicon structures were obtained using the photoresist shadowmask on untilted substrates. The photoresist shadowmask provides an advantage over Al only for the sidewall orientation where we were able to specify a condition for obtaining a smooth optically reflective surface. The more vertical sidewall angles obtainable with the unannealed Al shadowmask should permit fabrication of field emitter cone or ridge cathodes on pedestals with higher height‐to‐width ratios. A field cathode pedestal with a more vertical sidewall results in a higher electric field at the electron emission tip or ridge.

Similar Papers
  • Research Article

Fabrication of Micro-Gap Structure by Reactive Ion Etching Technique (RIE) for Future Reproductivity of Nanogap Biosensor

  • Jun 10, 2015
  • Advanced Materials Research
  • Q Humayun +1
  • Research Article
  • Citations3

플라즈마기반 표면 Texturing 공정에 따른 다결정 실리콘 웨이퍼 표면물성과 태양전지 동작특성 연구

  • May 30, 2011
  • Journal of the Korean Vacuum Society
  • Kwang-Mook Park +4
  • Conference Article

A More Rapid Approach in Revealing the Physical Status of Polyfuses and Thin Film Fuses in a Multilayer Integrated Circuit

  • Nov 01, 2015
  • Proceedings - International Symposium for Testing and Failure Analysis
  • Jason H Lagar +2
  • Research Article
  • Citations33

Comparative study on dry etching of polycrystalline diamond thin films

  • Jul 19, 2011
  • Vacuum
  • Tibor Izak +5
  • PDF
  • Research Article
  • Citations10

Broadband photonic crystal antireflection

  • Jan 01, 2012
  • Journal of the European Optical Society-Rapid Publications
  • M Malekmohammad +7
  • PDF
  • Research Article
  • Citations7

Ultra-Low-Reflective, Self-Cleaning Surface by Fabrication Dual-Scale Hierarchical Optical Structures on Silicon

  • Dec 15, 2021
  • Coatings
  • Miaomiao Duan +7
  • Research Article
  • Citations2

Optical Properties Characterization of InGaN/GaN near UV Photodetector with Surface Nano-Structure Fabricated by Nano-Imprinting

  • Nov 01, 2011
  • Advanced Materials Research
  • Jing Zhang +1
  • Book Chapter

Introduction

  • May 28, 1998
  • M Sugawara
  • Research Article
  • Citations47

Deep trench plasma etching of single crystal silicon using SF6/O2 gas mixtures

  • May 01, 1992
  • Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
  • Christopher P D’Emic +2
  • Research Article

Strong enhancement of emissions from nanostructured ZnO thin films grown by plasma‐assisted molecular‐beam epitaxy on nanopored Si(001) substrates

  • Jul 01, 2008
  • physica status solidi (a)
  • Jun-Ho Choi +10
  • Research Article

THERMOREGULATION SYSTEM FOR BIOSENSORS BASED ON FIELD-EFFECT TRANSISTORS WITH A NANOWIRE CHANNEL

  • Mar 05, 2024
  • Vestnik Moskovskogo Universiteta, Seriya 3: Fizika, Astronomiya
  • G.V Nibudin +9
  • Research Article
  • Citations9

Lateral Silicon Field-Emission Devices using Electron Beam Lithography

  • May 01, 2000
  • Japanese Journal of Applied Physics
  • Sangyeon Han +5
  • Research Article
  • Citations4

Realization of nanopillars on GaAs quantum well structure grown by molecular beam epitaxy

  • Jul 08, 1999
  • Microelectronics Journal
  • M Manimaran +1
  • Research Article

Spectrally Resolved Cathodoluminescence Determination of Dopant Diffusion In InP/InGaAsP Based Multi Quantum Well Fabry-Perot Lasers

  • Jan 01, 1999
  • MRS Proceedings
  • C Zanotti-Fregonara +8
  • Research Article
  • Citations44

Deep Reactive Ion Etching of Lead Zirconate Titanate Using Sulfur Hexafluoride Gas

  • May 01, 1999
  • Journal of the American Ceramic Society
  • Shinan Wang +3
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.