Robust Beamforming Design for SWIPT-Based Multi-Radio Wireless Mesh Network with Cooperative Jamming

In this letter, we propose a novel simultaneous wireless information and power transfer (SWIPT) scheme, namely the frequency-splitting (FS) SWIPT, which separates the power and data signals in the frequency domain. The proposed FS SWIPT scheme is advantageous in that it can maximize the efficiency of the high power amplifier (HPA) in the transmitter and reduce the harmonic distortion caused by the nonlinearity of the HPA. We design a receiver circuit for the FS SWIPT by using a circulator and filters. We analyze the FS and conventional power-splitting (PS) SWIPT schemes in consideration of the nonlinearity of the HPA. We show that the proposed FS SWIPT greatly outperforms the PS SWIPT in terms of the harvested power and signal-to-noise ratio (SNR).

Simultaneous wireless information and power transfer (SWIPT) is a prospective technology that can handle the energy consumption and communication requirements in the Internet of Things. Resonant beam SWIPT (RB-SWIPT) scheme utilizes narrow optical beam as carrier and with spatially separated resonator structure, which can support high power and high rate SWIPT for mobile devices. However, the performance of original RB-SWIPT systems is limited by returning beam interference and transmission loss. In this paper, we propose a RB-SWIPT scheme for transmission-enhanced and anti-interference. The telescope internal modulator (TIM) and second harmonic generator (SHG) are adopted in the proposed system. The TIM can compress beams to reduce the transmission loss. The SHG can generate frequency-doubled beams to avoid interference. To evaluate the proposed system, we establish mathematical models to depict the beam transmission, energy conversion, electric power output and data receiving. Numerical results illustrate that the proposed system can achieve 18 bit/s/Hz spectral efficiency and deliver 8 W power over 100 m distance.

The Internet of Things (IoT) is a significant branch of the ongoing advances in the Internet and mobile communications. Yet, the use of a large number of IoT devices can severely worsen the spectrum scarcity problem. The usable spectrum resources are almost entirely occupied, and thus, the increasing demands of radio access from IoT devices cannot be met. To tackle this problem, the Cognitive Internet of Things (CIoT) has been proposed. In a CIoT network, secondary users, i.e., sensors and actuators, can access the licensed spectrum bands provided by licensed primary users (such as cellular telephones). Security is a major concern in CIoT networks. However, the traditional encryption method at upper layers (such as symmetric and asymmetric ciphers) may not be suitable for CIoT networks since these networks are composed of low-profile devices. In this paper, we address the security issues in spectrum-leasing-based CIoT networks using physical layer methods. Considering that the CIoT networks are cooperative in nature, we propose to employ cooperative jamming to achieve secure transmission. In our proposed cooperative jamming scheme, a certain secondary user is employed as the helper to harvest energy transmitted by the source and then uses the harvested energy to generate an artificial noise that jams the eavesdropper without interfering with the legitimate receivers. The goal is to minimize the Signal to Interference plus Noise Ratio (SINR) at the eavesdropper subject to the Quality of Service (QoS) constraints of the primary traffic and the secondary traffic. We formulate the minimization problem into a two-stage robust optimization problem based on the worst-case Channel State Information of the Eavesdropper (ECSI). By using Semi-Definite Programming (SDP), the optimal solutions of the transmit covariance matrices can be obtained. Moreover, in order to build an incentive mechanism for the secondary users, we propose an auction framework based on the cooperative jamming scheme. The proposed auction framework jointly formulates the helper selection and the corresponding energy allocation problems under the constraint of the eavesdropper's SINR. By adopting the Vickrey auction, truthfulness and individual rationality can be achieved. Simulation results demonstrate the effective performance of the cooperative jamming scheme and the auction framework.

A good alternative to extend the lifetime of wireless devices placed in remote locations is to be able to obtain energy through a technique generally called Simultaneous Wireless Information and Power Transfer (SWIPT). Furthermore, since relays are commonly used to expand the coverage of wireless systems, an interesting choice could be they also harvest energy for its operation. It is shown in this work that, taking advantage of known modulation formats and having available the Channel State information (CSI), it is possible to make the power transmission more efficient. Using a SWIPT scheme known as Time Switching (TS), a study is carried out to highlight novel improvements in energy efficiency and outage probability.

Secrecy rate (SR) optimization in millimeter wave (mmWave) Internet of Things (IoT) systems with simultaneous wireless information and power transfer (SWIPT) is studied in this article. Adopting the SWIPT architecture, energy-constrained devices get charged by the radio-frequency waves transmitted from a base station. The hybrid precoding technique is applied to reduce the implementation cost by separately designing a digital precoder and an analog precoder. Also, we adopt the artificial noise (AN)-assisted transmission method to maximize the SR. In this problem, we aim to jointly optimize the digital precoding vector, AN covariance matrix, and power-splitting ratio under the nonlinear energy harvesting (EH)-constraints. Then, we propose a semidefinite relaxation-based alternating optimization algorithm for the case of perfect channel state information (CSI) and imperfect CSI. Finally, simulation results show that the proposed algorithms are effective to improve the SR.

In this paper, simultaneous wireless information and power transfer (SWIPT) concept is introduced for multi group multicast beamforming. Each user has a single antenna and a power splitter which divides the radio frequency (RF) signal into two for both information decoding and energy harvesting. The aim is to minimize the total transmission power at the base station while satisfying both signal-to-interference-plus-noise-ratio (SINR) and harvested power constraints at each user. Unlike unicast and certain broadcast scenarios, semidefinite relaxation (SDR) is not tight and global optimum solution cannot be found for this problem. We propose an iterative algorithm where a convex optimization problem is solved at each iteration. Both perfect and imperfect channel state information (CSI) at the base station are considered. Simulation results show that the proposed solution is very close to the SDR lower bound and a few number of iterations are enough for the algorithm convergence.

Simultaneous wireless information and power transfer (SWIPT) has emerged as a viable technique to energize and connect low-power autonomous devices and enable future Internet of Things (IoT). A major challenge of SWIPT is the energy consumption of the receiver of such low-power devices. An attractive low-power solution consists of an integrated information decoder (ID) and energy harvester (EH) architecture for SWIPT receiver (IntRx) where the received radiofrequency (RF) signal is first rectified before being used for information decoding. Such architecture eliminates the need for energy-consuming RF components, such as local oscillators and mixers. This article proposes a novel modulation and demodulation method for the IntRx SWIPT architecture based on pulse position modulation (PPM) where information is encoded in the position of the pulse. The new method transmits high amplitude pulses to increase the peak-to-average power ratio (PAPR) of the transmit signal and exploits the EH's nonlinearity so as to boost the harvested dc power. Simultaneously, the information can be decoded from the rectifier signal by simply finding the position of the pulse in a certain symbol duration. We have analyzed both the information and the power transfer performance of the newly proposed PPM for IntRx SWIPT theoretically, numerically, and experimentally. To that end, we have established a SWIPT system testbed in an indoor environment by prototyping a base station to transfer information-power signal and the IntRx SWIPT receiver, including ID and EH blocks. The performance evaluation of the PPM was carried out in various conditions, and the results have been compared and contrasted to conventional signals. Theoretical, numerical, and experimental results highlight the significant benefits of the proposed PPM scheme to enhance the power transfer performance and operate information decoding with low-power consumption.

The exponential growth of the Internet of Things (IoT) devices has resulted in huge power consumption issues in wireless devices. Cooperative communication with simultaneous wireless information and power transfer (SWIPT) is a promising technology to improve the coverage, capacity, power consumption, and reliability of the IoT networks. Relay selection plays a pivotal role in cooperative communications for improving the quality of service (QoS) of the network. In this paper, we propose a SWIPT based hybrid protocol to improve the QoS in terms of average end-to-end outage probability through proposed relay selection. Furthermore, we investigate the impact of time switching factor α and power splitting factor λ on the average outage probability and the amount of energy harvested. The simulation results demonstrate that by selecting the best relay through proposed relay selection, we observe maximum improvement of 94 % in terms of average end-to-end outage over the worst relay at transmit power of 38 dBm. Similarly, we observe an increase in the amount of energy harvested by approximately 90% over the worse relay at transmit power of 45 dBm.

The advent of 5G era and the increase of terminal’s numbers have led to increasing demand for spectrum resources and energy simultaneously. Therefore, this paper studies how to combine the cognitive radio (CR) and the Simultaneous Wireless Information and Power Transfer (SWIPT) technology effectively in a multiuser scenario, in which the spectrum utilization and energy efficiency are both improved. Firstly, the system model is designed of above cognitive SWIPT system, in which the cognitive users (CU) can choose spectrum access policy based on the amount of data transmission of licensed user. And then, according to cognitive users’ channel conditions and forwarding power, a concept of trust value and different relay selection policies is proposed. Subsequently, the according system ergodic capacity is analyzed. Finally, simulation results of system performance are provided to validate the analytical results. It shows that cognitive SWIPT technology can improve the system ergodic capacity and the spectrum access opportunities of cognitive users effectively, thereby improving the efficiency of energy and spectrum utilization.

The main challenges of sensing in harsh industrial and biological environments are the limited energy of sensor nodes and the difficulty of charging sensor nodes. Simultaneous wireless information and power transfer (SWIPT) is a non-invasive option to replenish energy. SWIPT harvests energy and decodes information from the same RF signal, which is influencing the design of a wireless sensor network. In multi-hop multi-flow wireless sensor networks, interference generally exists, and the interference has a different influence on SWIPT. Route, interference and SWIPT are dependent. However, existing works consider SWIPT link resource allocation with a given route or only select path for one flow without interference. Therefore, this paper firstly analyzes the influence of interference on SWIPT, and select the SWIPT routing with interference. We design an interference-based information and energy allocation model to maximize the link capacity with SWIPT. Then, we design an interference-aware route metric, formulate SWIPT routing problem, and design an interference-aware SWIPT routing algorithm. The simulation results show that as the number of flows increases, there is more likely to obtain performance gains from interference and SWIPT.

Non-orthogonal multiple access (NOMA) is considered as a multiple access technique for supporting massive number of devices with high spectral efficiency. Simultaneous wireless information and power transfer (SWIPT) is an efficient solution for fully autonomous and sustainable communication networks. In this paper, application of SWIPT in networks employing cooperative NOMA (CNOMA) is investigated with imperfect channel state information (CSI). Performance of the CNOMA network with SWIPT is investigated in a multi-tier downlink scenario with macro-base stations (MBSs) and femto-base stations (FBSs). The distribution of MBSs and FBSs follow Poisson point process model. Unlike solution in the existing literature, instead of using only the superimposed signal for energy harvesting (EH), in this work, the cooperating node/user employs EH using interference from the adjacent base stations. Expressions for outage probability and throughput are derived at the user pair (comprising a cell-center user and a cell-edge user) served using NOMA. Comparison of the proposed EH system with the existing solutions is highlighted. Monte Carlo simulations are carried out to validate the analytical results.

In this paper, we provide a comprehensive literature survey on simultaneous wireless information and power transfer (SWIPT) in multi-antenna systems. We first review recent contributions on the theory analysis of SWIPT from information theoretic standpoint and introduce the tradeoff between information transfer and power transfer under various settings. Then, we focus on the utilization of multi-antenna techniques to solve existing problems of SWIPT. Contributions on the implementation aspects of multi-antenna SWIPT are summarized. The performance of SWIPT is evaluated by different metrics, therefore, we review the works on dynamic SWIPT optimization based on objective function using multi-antenna techniques. In addition, the implementation of SWIPT brings up secure issue. Thus, we summarize recent works on secure SWIPT. Finally, we present researches combining SWIPT with state-of-the-art techniques due to potential application in different scenarios.

Wireless mesh networks (WMNs) are gaining significant momentum as a promising technology for the next-coming state-of-the-art wireless networking. Among many factors, the performance of WMNs would be largely affected by the properness of the deployed routing protocols and the efficient usage of wireless resources. Routing protocols are required to well capture WMNs' features while wireless channels should be used efficiently in order to accommodate high amount of traffics over the mesh backbone. Recently, a Tree-based Routing (TBR) protocol become a popular state-of-the-art proactive routing protocol and its tree-based broadcasting become an often used technique. Though TBR protocol is well-suited for WMNs' architecture and the skewed nature of traffic toward the root, the protocol in its current form faces issues which has to be addressed. Specifically, when some or all nodes are equipped with multiple radios, to reduce collision and co-channel interference, not only the parent-child relationship but also the sibling relationship need to be constructed by the TBR protocol in the multi-channel WMNs. In this paper, we propose a hybrid tree-based protocol for concurrent routing and channel assignment over WMNs. The protocol makes use of sibling links to mitigate the aforementioned shortcomings of TBR protocol. Moreover, in order to address high backbone traffic, the protocol integrates a receiver-based channel assignment scheme. The protocol efficiently deploys the parent-child topological relationships of nodes to enhance efficiency of broadcast transmissions over receiver-based multi-channel WMNs. Simulation results over NS-2 network simulator reveal that our proposed hybrid tree-based protocol achieves much higher performance than the utilization of the original receiver-based CA and TBR protocol.

Join trajectory optimization and communication design for UAV-enabled OFDM networks

Fog computing is a promising solution to enable delay-sensitive applications in the Internet of Things (IoT). In this article, based on the simultaneous wireless information and power transfer (SWIPT) technology, we investigate the joint offloading of tasks and energy (JOTE) in fog-enabled IoT networks. Specifically, the task node is allowed to offload energy and tasks to multiple neighboring helper nodes in a time-division multiple access (TDMA) manner. When there are no task queues in the nodes, the offloading decision for each task is independent. We first find the offloading strategy to minimize the task execution delay as well as the energy consumption for a specific task and then, analyze the condition under which the JOTE is beneficial. We show that it becomes more and more desirable to offload both the tasks and the energy from the task node as the number of helper nodes gets large. When there are task queues in the nodes, the offloading decision for each task becomes temporally correlated. We then characterize the optimal strategies to offload the tasks and energy jointly over multiple time slots. An online offloading policy based on the Lyapunov optimization is then proposed to minimize the time average expected delay while stabilizing the system operation. Comprehensive numerical results corroborate our theoretical results and demonstrate the superior performance of the proposed JOTE algorithms.