• Home
  • Search
  • Universal Voltage Conveyor and Current Conveyor in Fast Full-Wave Rectifier
  • Cite Icon2
  • https://doi.org/10.11601/ijates.v1i2-3.8Copy DOI Icon

Universal Voltage Conveyor and Current Conveyor in Fast Full-Wave Rectifier

  • Abstract
  • Literature Map
  • References
  • Citations
  • Similar Papers
Abstract

This paper deals about the design of a fast voltage-mode full-wave rectifier, where universal voltage conveyor and second-generation current conveyor are used as active elements. Thanks to the active elements, the input and output impedance of the non-linear circuit is infinitely high respectively zero in theory. For the rectification only two diodes and three resistors are required as passive elements. The performance of the circuit is shown on experimental measurement results showing the dynamic range, time response, frequency dependent DC transient value and RMS error for different values of input voltage amplitudes.

Similar Papers
  • Conference Article
  • Citations6

Continuous-Time Multifunctional Filters with Wide Bandwidth Using Universal Voltage Conveyors

  • Apr 01, 2007
  • Martin Minarcik +1
  • Research Article
  • Citations2

Practical design of the voltage controllable quadrature oscillator for operation in MHz bands employing new behavioral model of variable-voltage-gain current conveyor of second generation

  • Sep 29, 2018
  • Journal of Computational Electronics
  • Roman Sotner +3
  • Book Chapter

Synthetic impedances using current conveyors and their variants

  • Jun 01, 2020
  • Raj Senani +3
  • Conference Article
  • Citations6

Synthesis of immittance function using current conveyors

  • Jun 07, 1988
  • M Ishida +3
  • Research Article
  • Citations16

A new approach to designing active MMIC tuning elements using second-generation current conveyors

  • Jan 01, 1996
  • IEEE Microwave and Guided Wave Letters
  • J.H Sinsky +1
  • Conference Article
  • Citations4

General View on Fractional-Order All-Pass Filters Using Generalized Current Conveyors

  • Jul 01, 2020
  • Norbert Herencsar
  • Research Article
  • Citations46

A First-Order Fully Cascadable Current-Mode Universal Filter Composed of Dual Output CCIIs and a Grounded Capacitor

  • Feb 25, 2016
  • Journal of Circuits, Systems and Computers
  • Erkan Yuce +1
  • Conference Article

The design methods of current-mode nth-order filters

  • Jun 28, 2000
  • Wang Xiufang +1
  • Research Article

Synthesis of biquadratic filters from current conveyors

  • Jan 01, 1993
  • Electronics and Communications in Japan (Part II: Electronics)
  • Katsuji Ikeda +1
  • Research Article
  • Citations63

Multiphase sinusoidal oscillator using second-generation current conveyors

  • Apr 01, 1995
  • International Journal of Electronics
  • Dong-Shiuh Wu +3
  • PDF
  • Research Article
  • Citations28

A Novel Electronic Interface for Micromachined Si-Based Photomultipliers

  • Oct 08, 2018
  • Micromachines
  • Leonardo Pantoli +4
  • Research Article
  • Citations5

Bandwidth Aspects in Second Generation Current Conveyors

  • Nov 01, 2002
  • Analog Integrated Circuits and Signal Processing
  • Luís Nero Alves +2
  • Research Article
  • Citations3

Three inputs and one output voltage-mode universal biquadratic filter using one CCII and one CCIII

  • Sep 27, 2023
  • Journal of Integrated Circuits and Systems
  • Jiun-Wei Horng
  • Conference Article
  • Citations1

Narrow BP active filters with reduced noise and sensitivity using current conveyors

  • Jun 01, 2013
  • Bojan Gaspar +2
  • Research Article
  • Citations10

Parasitic compensation in CCI-based circuits for reduced power consumption

  • May 26, 2010
  • Analog Integrated Circuits and Signal Processing
  • Bilgin Metin +1
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.