- Book Chapter
11
- 10.1016/b978-044450810-2/50006-3
Chapter 4 - Multiple Effect Evaporation
- Jan 01, 2002
- Fundamentals of Salt Water Desalination
- Hisham El-Dessouky + 1 more +1
Chapter 4 - Multiple Effect Evaporation
Visual basic computer package for thermal and membrane desalination processes
Chapter 4 - Multiple Effect Evaporation
Chapter 4 - Multiple Effect Evaporation
Multiple-effect evaporation desalination systems. thermal analysis
Multiple-effect evaporation desalination systems. thermal analysis
Energy and Economic Advantages of Using Solar Stills for Renewable Energy-Based Multi-Generation of Power and Hydrogen for Residential Buildings
The multi-generation systems with simultaneous production of power by renewable energy, in addition to polymer electrolyte membrane electrolyzer and fuel cell (PEMFC-PEMEC) energy storage, have become more and more popular over the past few years. The fresh water provision for PEMECs in such systems is taken into account as one of the main challenges for them, where conventional desalination technologies such as reverse osmosis (RO) and mechanical vapor compression (MVC) impose high electricity consumption and costs. Taking this point into consideration, as a novelty, solar still (ST) desalination is applied as an alternative to RO and MVC for better techno-economic justifiability. The comparison, made for a residential building complex in Hawaii in the US as the case study demonstrated much higher technical and economic benefits when using ST compared with both MVC and RO. The photovoltaic (PV) installed capacity decreased by 11.6 and 7.3 kW compared with MVC and RO, while the size of the electrolyzer declined by 9.44 and 6.13%, and the hydrogen storage tank became 522.1 and 319.3 m3 smaller, respectively. Thanks to the considerable drop in the purchase price of components, the payback period (PBP) dropped by 3.109 years compared with MVC and 2.801 years compared with RO, which is significant. Moreover, the conducted parametric study implied the high technical and economic viability of the system with ST for a wide range of building loads, including high values.
Read moreDistillation of oil field produced water for reuse on irrigation water: evaluation of pollutants removal and ecotoxicity
Desalination is one of the earliest forms of saline water treatment and it is still used throughout the world. In this work, a single-effect mechanical vapor compression (MVC) process was investigated to produce water for irrigation of non-edible cultures from oil-field produced water. Distillation was able to produce a condensate presenting very low amounts of 84 analyzed pollutants. Ecotoxicological assays with Pseudokirchneriella subcapitata algae, Danio rerio fish, lettuce (Lactuca sativa) and earthworm (Eisenia fetida) were performed in condensate. The condensate was non-toxic for all tested organisms, except for P. subcapitata algae that showed some level of chronic toxicity caused by ammonium nitrogen. This toxic effect was confirmed by conducting a series of ecotoxicological assays with condensate samples after ammonia removal (stripping). The condensate presented quality acceptable for irrigation of non-edible crops.
Read moreHybrid desalination system of mechanical vapor recompression based on membrane distillation
The microporous PTFE membrane was used for membrane distillation (MD) experiment and presented ultra-high efficiency of desalination. A hybrid desalination system combining membrane distillation and mechanical vapor compression (MD+MVR) had been developed on the basis of the MD experiment. The system featured that the latent heat and part of sensible heat of vapor from the MVR were recovered to heat the MD process, and the heating process occurred in the same module as the MD process. Models were built according to the energy and mass conservation for the system description. Based on the simulation and experimental data, when the system was assigned a treatment capacity 1000 kg h-1 for 1% saline water and with corresponding 875 kg h-1 fresh water production, it would be stuffed with 75.24 m2 of PTFE membrane and expense only 3.31 kW of electrical power, under 353 K of feed temperature in membrane module and 26 kPa of compressor suction pressure. The compressor power requirement would trade off the heat transfer area with variation of the heat transfer temperature difference. The higher the salinity concentration in the residual concentrate after distillation was, the higher the compressor power, membrane area and heat exchanger area would be.
Read moreOptimization of Low-Grade Solar Thermal Desalination Powerplant
An optimized design for a solar-powered desalination plant is proposed in this study, motivated by the increasing demand for freshwater. The main objective of this paper is to investigate the viability of a Mechanical Vapor Compression (MVC) desalination system powered by a Regenerative Organic Rankine Cycle utilizing a low-grade solar thermal energy system within 200°C –400°C. The success criteria of the desalination plant are based on the recovery ratio, flow rate, and specific power consumption. The test matrix includes feed concentrations of up to 35 ppt and boiler temperatures ranging from 200 °C to 400 °C, typical of Low-grade solar collectors. Comparative analysis of power output for different cycles has been presented, and the results indicate that for heat sources below 400°C, the application of regenerative ORC is recommended. The results show that the Regenerative Rankine cycle can achieve a thermal efficiency of up to 33%. The study examined both compression and vacuum modes of the MVC desalination plant. It was found that MVC could achieve lower specific power consumption (kWh/m3) when the cycle was operated under vacuum conditions.
Read moreEnergetic comparison for leaching waste liquid from citric juice production using both reverse osmosis and multiple-effect evaporation
Energetic comparison for leaching waste liquid from citric juice production using both reverse osmosis and multiple-effect evaporation
Read moreReverse Osmosis
Reverse osmosis uses nonporous membranes and can separate down to the ionic level, e.g. seawater in the rejection of dissolved salt. This chapter focuses on reverse osmosis because of its widespread use in desalination applications. The reverse osmosis process and membrane principles and applications are addressed through a review of the role of osmosis, reverse osmosis equipment, describing equations, other membrane processes, and membrane process applications. The membranes used for reverse osmosis processes are characterized by a high degree of semi-permeability, high water flux, mechanical strength, chemical stability, and relatively low operating and high capital costs. Ultrafiltration, microfiltration, and gas permeation are also briefly reviewed. Six illustrative examples of concepts and implementation of reverse osmosis and membrane desalination processes are provided at the end of the chapter.
Read moreSeawater feed reverse osmosis preheating appraisal, Part II: system performance
The present work evaluates the seawater feed Reverse Osmosis (RO) preheating system process. In this respect, the basic transport equations, which describe the system elements, are used for determining the performance of the process operating parameters and for assessing the feed preheating process. A seawater membrane, FTSW30HR-380, was used to perform this study. In Part I of the work, the leading element, which governs the whole system, was studied. Also, the limitations of the leading element operating parameters were determined. In the recent work, a computer program is developed using the RO-governing process equations to obtain the system design and projection for the seawater feed preheating assessment, which enabled the determination of the whole system by solving the system elements, one by one. Also, an evaluation of the power needed for freshwater production. The RO system feed preheating is studied for feed temperatures ranging from 15°C to 45°C. The study shows that the permeate salt concentration increases as the feed temperature increases and the system salt rejection decreases. The present study concluded that the permeate productivity decreases with the increase in the feed temperature. Results also show that the product's specific power consumption is dependent on the number of elements used, and energy recovery. In the case of the maximum available number of elements, it is found that the feed temperature increases as the specific power consumption increases, with or without brine pressure energy recovery. However, in the case of a constant number of elements, seven elements, the specific power consumption decreases as the feed temperature increases.
Read moreThermoeconomic analysis of some existing desalination processes
Thermoeconomic analysis of some existing desalination processes
The mechanically driven heat recovery system of vapour compression desalters
The mechanically driven heat recovery system of vapour compression desalters
Membrane desalination and water re-use for agriculture: State of the art and future outlook
Membrane desalination and water re-use for agriculture: State of the art and future outlook
Comparison of energy consumption in desalination by capacitive deionization and reverse osmosis
Comparison of energy consumption in desalination by capacitive deionization and reverse osmosis
Design analysis of MVC desalination unit powered by a grid connected photovoltaic system
Design analysis of MVC desalination unit powered by a grid connected photovoltaic system
Improvement of Condensation Heat Transfer by Surface Modifications
Improvement of Condensation Heat Transfer by Surface Modifications