A Novel Antenna Selection Algorithm for MIMO Systems under Correlated Channels

This chapter is attempted to provide a survey of the advanced concepts and related issues involved in Multiple Input Multiple Output (MIMO) systems. MIMO system technology has been considered as a really significant foundation on which to build the next and future generations of wireless networks. The chapter addresses advanced MIMO techniques such as polarization diversity and antenna selection. We gradually provide an overview of the MIMO features from basic to more advanced topics. The first sections of this chapter start by introducing the key aspects of theMIMO theory. TheMIMO systemmodel is first presented in a genericway. Then, we proceed to describe diversity schemes used in MIMO systems. MIMO technology could exploit several diversity techniques beyond the spatial diversity. These techniques essentially cover frequency diversity, time diversity and polarization diversity. We further provide the reader with a geometrically based models for MIMO systems. The virtue of this channel modeling is to adopt realisticmethods for modeling the spatio-temporal channel statistics from a physical wave-propagation viewpoint. Two classes for MIMO channel modeling will be described. These models involve the Geometry-based Stochastic ChannelModels (GSCM) and the Stochastic channel models. Besides the listedMIMO channel models already described, we derive and discuss capacity formulas for transmission over MIMO systems. The achieved MIMO capacities highlight the potential of spatial diversity for improving the spectral efficiency of MIMO channels. When Channel State Information (CSI) is available at both ends of the transmission link, the MIMO system capacity is optimally derived by using adaptive power allocation based on water-filling technique. The chapter continues by examining the combining techniques for multiple antenna systems. Combining techniques are motivated for MIMO systems since they enable the signal to noise ratio (SNR) maximization at the combiner output. The fundamental combing techniques are the Maximal Ratio Combining (MRC), the Selection Combining (SC) and the Equal Gain Combining(EGC). Once the combining techniques are analyzed, the reader is introduced to the beamforming processing as an optimal strategy for combining. The use of multiple antennas significantly improves the channel spectral efficiency. Nevertheless, this induces higher system complexity of the communication system and the communication system performance is effected due to correlation between antennas that need to be deployed at the same terminal. As such, the antenna selection algorithm for MIMO systems is presented. To elaborate on this point, we introduce Space time coding techniques for MIMO systems and we evaluate by simulation the performance of the communication system. Next, we emphasis on multi polarization techniques for MIMO systems. As a background, we presume that the reader has a thorough understanding of antenna theory. We recall the basic antenna theory and concepts that are used throughout the rest of the chapter. We rigorously introduce the 3D channel model over the Non-Line of Sight (NLOS) propagation channel for MIMO system with polarized antennas. We treat the depolarization phenomena and we study its effect on MIMO system capacity. The last section of the chapter provides a scenario for collaborative sensor nodes performing distributed MIMO system model which is devoted to sensor node localization in Wireless Sensor Networks. The localization algorithm is based on beamforming processing and was tested by simulation. Our chapter provides the reader by simulation examples for almost all the topics that have been treated for MIMO system development and key issues affecting achieved performance.

Traditional receiver algorithms developed for multiple-input multiple-output (MIMO) wireless communication systems are based on the assumption that the channel state information (CSI) is perfectly known at the receiver. However, in real environments the exact CSI is unavailable. In this paper, we address the problem of robustness of multiuser space-time block coded MIMO systems against imperfect CSI and develop a simple linear receiver which guarantees robustness against CSI errors with a certain selected probability. The proposed receiver is formulated via a probability-constrained optimization problem which is further relaxed using Chebyshev inequality to a much simpler second-order cone programming (SOCP) problem. Simulations demonstrate that the proposed receiver has a moderate performance degradation as compared to the exact solution to the original probability-constrained optimization problem, while offering much simpler implementation.

In this thesis we investigate the effects of the physical constraints such as antenna aperture size, antenna geometry and non-isotropic scattering distribution parameters (angle of arrival/departure and angular spread) on the performance of coherent and non-coherent space-time coded wireless communication systems. First, we derive analytical expressions for the exact pairwise error probability (PEP) and PEP upper-bound of coherent and non-coherent space-time coded systems operating over spatially correlated fading channels using a moment-generating function-based approach. These analytical expressions account for antenna spacing, antenna geometries and scattering distribution models. Using these new PEP expressions, the degree of the effect of antenna spacing, antenna geometry and angular spread is quantified on the diversity advantage (robustness) given by a space-time code. It is shown that the number of antennas that can be employed in a fixed antenna aperture without diminishing the diversity advantage of a space-time code is determined by the size of the antenna aperture, antenna geometry and the richness of the scattering environment. In realistic channel environments the performance of space-time coded multipleinput multiple output (MIMO) systems is significantly reduced due to non-ideal antenna placement and non-isotropic scattering. In this thesis, by exploiting the spatial dimension of a MIMO channel we introduce the novel use of linear spatial precoding (or power-loading) based on fixed and known parameters of MIMO channels to ameliorate the effects of non-ideal antenna placement on the performance of coherent and non-coherent space-time codes. The spatial precoder virtually arranges the antennas into an optimal configuration so that the spatial correlation between all antenna elements is minimum. With this design, the precoder is fixed for fixed antenna placement and the transmitter does not require any feedback of channel state information (partial or full) from the receiver. We also derive precoding schemes to exploit non-isotropic scattering distribution parameters of the scattering channel to improve the performance of space-time codes applied on MIMO systems in non-isotropic scattering environments. However, these schemes

The capacity of multiple-input multiple-output (MIMO) wireless communication systems over spatially correlated Rayleigh distributed flat fading channels with complex Gaussian additive noise is investigated. Specifically, the probability density function of the mutual information between transmitted and received complex signals of MIMO systems is derived. Using this density the closed-form ergodic capacity (mean), delay-limited capacity, capacity variance and outage capacity formulas for spatially correlated channels are derived and then these formulas are evaluated numerically. Numerical results show how the channel correlation degrades the capacity of MIMO communication systems. It is also shown that the density of mutual information of correlated/uncorrelated MIMO systems can be approximated by a Gaussian density with derived mean and variance, even for a finite number of inputs and outputs.

In this work, we present a novel random parameter-based expectation-maximization (EM) algorithm for joint symbol detection and channel estimation in fast fading space-time trellis coded (STTC) multiple-input multiple-output (MIMO) wireless communication systems. Employing the EM framework with the MIMO channel as the random parameter, we demonstrate that this paradigm reduces to the optimal Kalman filter (KF)-based channel update in the E-step followed by a modified path metric-based maximum likelihood sequence decoder (MLSD) in the M-step. Further, we also present the pairwise error probability (PEP) upper bound for the frame error rate (FER) and the Bayesian Cramer-Rao bound (BCRB) for the proposed joint estimation scheme. Simulation results are presented to demonstrate the performance of the proposed technique and validate the analytical bounds.

This paper describes investigations into the antenna mutual coupling (MC) effect on channel estimation and capacity of a multiple-input multiple-output (MIMO) wireless communication system. The presented investigations close the gap existing in the previous works which assessed the effect of mutual coupling on MIMO capacity under the assumption of availability of perfect channel state information (CSI) at the receiver. The new approach assumes that the perfect CSI is not available due to channel estimation errors. The investigations are carried out for different spacing between array antenna elements producing a varying effect of mutual coupling on the channel estimation and the resulting MIMO channel capacity.

Independent component analysis for multiple-input multiple-output wireless communication systems

Multiple-input multiple-output (MIMO) wireless communication systems can achieve higher throughput through interference alignment. For a small number of users, determining the maximum possible degrees of freedom as well as the feasibility of interference alignment in MIMO systems is well studied. However, the issues of scheduling in systems employing interference alignment and serving a large number of users have received little attention so far. In this paper, we study the problem of joint scheduling, interference alignment, and packet admission control in MIMO wireless systems with the goal of maximizing system throughput subject to stability constraints. We formulate a stochastic network optimization problem and propose a scheduling and interference alignment (SIA) algorithm. In each time slot, SIA schedules some users among many competing ones to transmit data, and determines encoding and decoding matrices for the selected users. Packet admission control is performed in each time slot. In addition, we propose a heuristic semi-distributed algorithm (SDSIA), which has a lower computational complexity than the SIA algorithm. Via simulation, we evaluate the performance of SIA and SDSIA for different algorithm parameters and different numbers of users. We also compare the performance of SDSIA with other approaches which do not simultaneously exploit interference alignment and scheduling and find that the combination of these two techniques increases the achievable data rate dramatically.

We present a hybrid soft detector that has a good performance/complexity trade-off for a multiple-input multiple-output (MIMO) wireless communication system with known channel information. The new soft detector combines the merits of a simple unstructured least-squares (LS)-based soft detector and a list sphere decoder (LSD)-based soft detector for data bit detection. The former is computationally much more efficient than the latter at the cost of poorer performance. The poor performance of the former occurs mainly when the channel matrix is ill-conditioned. Whenever this happens, we use the LSD-based soft detector in the hybrid soft detector; otherwise, we use the LS-based one. Moreover, we provide a tight radius for a sphere decoder, a hard detector, via using the output of an LS-based hard detector. These two hard detectors are needed to determine if LS or LSD should be used in the hybrid soft detector. As an application example, we consider doubling the maximum data rate of the IEEE 802.11a conformable wireless local area networks by a MIMO system with two transmit and two receive antennas. For this application, the new soft detector is about 10 times faster than the LSD-based one and is about 10 times slower than the LS-based one. Yet the packet error rate due to using the new soft detector is quite close to that of using the LSD-based one.

Multiple-input multiple-output (MIMO) wireless communication systems rely upon the knowledge of channel state information (CSI) at the receiver for data detection and decoding. In this paper, a better performance and reduced complexity channel estimation method is proposed for MIMO systems based on matrix factorization. This technique is applied on least squares (LS) channel estimation for performance improvement. Experimentation results indicate that the proposed method not only alleviates the performance of channel estimation but also significantly reduces the complexity caused by matrix inversion. The performance evaluations are validated through computer simulations using MATLAB® 7.0 in terms of BER. Simulation results show that the performance and complexity of the proposed method clearly outperforms the conventional LS channel estimation method.

In this paper, the effective capacity of a multiple-input multiple-output (MIMO) system in two different cases with receive antenna selection (RAS) and transmit antenna selection (TAS) schemes is investigated. A closed-form solution for the maximum constant arrival rate of this network with statistical delay quality of service (QoS) constraint is extracted in the quasi-static fading channel. This study is conducted in two different cases. When channel state information (CSI) is not available at the MIMO transmitter, implementation of TAS is difficult. Therefore, RAS scheme is employed and one antenna with the maximum instantaneous signal to noise ratio is chosen at the receiver. On the other hand, when CSI is available at the transmitter, TAS scheme is executed. In this case, one antenna is selected at the transmitter. Moreover, an optimal power-control policy is applied to the selected antenna and the effective capacity of the MIMO system is derived. Finally, this optimal power adaptation and the effective capacity are investigated in two asymptotic cases with the loose and strict QoS requirements. In particular, we show that in the TAS scheme with the loose QoS restriction, the effective capacity converges to the ergodic capacity. Then, an exact closed-form solution is obtained for the ergodic capacity of the channel here.

Nonlinearities play an imperative role in performance of wireless communication systems. In this paper, High Power Amplifiers (HPA) have been used to check the performance of the proposed system by analyzing its amplitude, phase and their joint distortions using Multiple-Input Multiple-Output (MIMO) wireless communication system. This paper takes-in account the overall effects of HPA that provokes nonlinearities at the transmitter's end in a communication system. Therefore, a novel method for the HPA nonlinearities mitigation has been proposed to improve the performance of amplitude, phase and joint distortions in MIMO communication systems. The simulation results show an improvement in the overall effect of the MIMO system and enhance the input response on the transmitter side. Furthermore, this method has been proposed to exploit the benefits of the MIMO system to improve the Symbol Error Rate (SER) versus Signal to Noise Ratio (SNR) curves for amplitude, phase and their joint distortions.

We propose a precoder design to minimize the codeword error rate of multiple-input multiple-output (MIMO) systems in the presence of channel estimation errors. Our proposed scheme only requires knowledge of the second-order statistics of the channel, noise and the estimation errors; an estimate of the instantaneous channel state information (CSI) is not required. Compared to the instantaneous CSI requirement, our assumption is more practical since obtaining an accurate CSI is challenging if the channel fluctuates rapidly, while the channel statistics are likely to remain unchanged for a much longer period. Furthermore, the feedback overhead from the receiver to the transmitter is greatly reduced. When compared to the case without transmit preceding, our proposed design achieves a significant improvement in error performance: (i) for a real 2 × 2 MIMO system with 4-PAM modulation and at codeword error rate of 104, our proposed precoder design achieves coding gains of up to 6 dB and (ii) for a real 4 × 4 MIMO system with BPSK modulation and at codeword error rate of 104, coding gains of up to 6.5 dB can be achieved.

Recently it has been shown that it is possible to improve the performance of multiple-input multiple-output (MIMO) systems by employing a larger number of antennas than actually used and selecting the optimal subset based on the channel state information. Existing antenna selection algorithms assume perfect channel knowledge and optimize criteria such as Shannon capacity or various bounds on error rate. This paper examines MIMO antenna selection algorithms where the set of possible solutions is large and only a noisy estimate of the channel is available. In the same spirit as traditional adaptive filtering algorithms, we propose simulation based discrete stochastic optimization algorithms to adaptively select a better antenna subset using criteria such as maximum mutual information, bounds on error rate, etc. These discrete stochastic approximation algorithms are ideally suited to minimize the error rate since computing a closed form expression for the error rate is intractable. We also consider scenarios of time-varying channels for which the antenna selection algorithms can track the time-varying optimal antenna configuration. We present several numerical examples to show the fast convergence of these algorithms under various performance criteria, and also demonstrate their tracking capabilities.

Multiple-input multiple-output (MIMO) wireless communication systems in combination with orthogonal frequency division multiple access and space division multiple access are flexible, spectrally efficient and of high capacity. These systems can allocate frequency, time, and space resources adaptively among mobile stations. Optimal resource allocation (RA) for maximizing the sum rate is usually too complex for practical applications, hence suboptimal algorithms are required. The performance of RA algorithms are degraded due to imperfections in channel state information at transmitter (CSIT). Thus, techniques that make the RA algorithm, robust against CSIT errors are favorable. In this paper, two novel suboptimal grouping algorithms are introduced that are shown to achieve better sum rate-complexity and fairness-complexity performances. A novel index is proposed to measure the efficiency of RA algorithms, which takes into account sum rate and complexity simultaneously. Moreover, the effect of erroneous CSIT on sum rate is investigated and it is shown that performance of the proposed RA algorithms with erroneous CSIT are superior to the existing schemes. Finally, fairness performance of the proposed RA algorithms are evaluated, which are shown to be the same if not superior to other existing algorithms.